喷射时刻对柴油甲醇组合燃烧发动机颗粒物排放的影响

为了进一步减少甲醇掺烧后的柴油机颗粒物排放,在一台由增压中冷的高压共轨柴油机改造成的柴油甲醇组合燃烧(DMCC—diesel/methanol compound combustion)发动机上详细研究了柴油喷射时刻对两种燃料共燃时的颗粒物生成及其排放的影响.试验工况选择重型柴油机常用的A50工况.试验结果表明,当柴油在上止点后喷射时,颗粒物排放的数量浓度随着甲醇替代率的增加而减少,当上止点前喷射时,颗粒物的数量浓度先减少后增加.随着喷射时刻的提前,颗粒中超细颗粒所占比例增大.随着喷射时刻的推迟,甲醇替代率降低颗粒物质量浓度的作用增强,同时甲醇替代率降低颗粒物几何平均直径的作用减弱.     

纳米TiO2添加剂对DMDF发动机大负荷燃烧及PM排放影响的试验研究

在一台电控增压中冷四缸柴油机的进气道上加装一套电控喷射装置,使其运行柴油/甲醇双燃料(DMDF)模式.研究了甲醇中Ti O_2添加剂的添加量及同一添加剂添加量在不同甲醇分散系喷射量时对发动机大负荷工况的燃烧和颗粒物(PM)排放的影响.结果表明,在甲醇中添加适量(30和100 mg·kg~(-1))的纳米Ti O_2能够使爆发压力升高,对燃烧有一定的促进作用,但添加过量(100 mg·kg~(-1))会对燃烧产生不利影响.加入纳米Ti O_2后,干炭烟烟度排放和积聚态颗粒数明显降低,在添加剂添加量为1000 mg·kg~(-1)时,最大降幅分别达到26.8%和29.4%,而核态颗粒物排放变化不大.在相同添加剂添加量下,增加甲醇分散系替代率R_m会使放热始点后移,放热更加集中,爆发压力增大,干炭烟烟度和颗粒物排放均大幅度降低.在添加剂添加量为100 mg·kg~(-1)时,与R_m=10%相比,R_m=40%时爆发压力增加0.94 MPa,放热率峰值增加53.5%,烟度、核态颗粒数、积聚态颗粒数和颗粒物总数的降幅分别达66.9%、42.3%、67.0%和58.0%.     

感应电芬顿降解二甲基砷的效果与机理研究

二甲基砷作为甲基砷的主要种类之一,主要由含砷废水的排放和农药滥用进入环境水体,进而严重威胁着人类的健康.通过改进电芬顿反应中Fe~(2+)的投加方式,构建了以铁棒为感应阳极、RuO_2/Ti网为阳极、2个活性炭纤维为双阴极的感应电芬顿体系.为探究感应电芬顿体系对二甲基砷的降解效果与机理,考察了反应过程中初始pH、电流密度、反应物初始浓度等因素对二甲基砷去除效果的影响.结果表明,在初始pH值为3,电流密度为2 m A·cm~(-2),二甲基砷初始浓度为5 mg·L~(-1)的最佳条件下,经感应电芬顿反应240 min后,二甲基砷去除率高达94.4%.在此体系中,感应铁电极不断释放的Fe~(2+)与阴极产生的H_2O_2发生电芬顿反应产生羟基自由基将二甲基砷降解为一甲基砷、As(Ⅲ)和As(V),同时,铁离子水解生成的铁的羟基络合物将二甲基砷、一甲基砷、As(III)和As(V)吸附在其表面,从而达到二甲基砷的高效去除.     

关于我国发展循环经济的思考

循环经济在我国还处于研究探索的阶段,其理论基础和实践途径有待进一步发展.发展循环经济,建设资源节约型社会,需要积极发挥政府的主导作用,努力实现企业行为的转变,大力倡导社会公众的积极参与,以及尽快建设绿色技术支撑体系.但是,我国的现实情况是,政府在循环经济发展中主导作用不强;企业生态化转型滞后;公众对发展循环经济的意识淡薄.     

Preparation and Properties of a Chitosan–Hyaluronic Acid-Polypyrrole Conductive Hydrogel Catalyzed by Laccase

Electro conductive hydrogels, consisting of chitosan (CS), hyaluronic acid (HA), and polypyrrole (PPy), were prepared via an in situ enzymic polymerization of pyrrole in the CS–HA hydrogel, using laccase as the catalyst. This CS–HA–PPy composite hydrogel showed good conductivity. The chemical structure and morphology of this conductive hydrogel were studied by Fourier transform infrared spectroscopy, scanning electron microscopy, and X-ray diffraction technique. For CS–HA–PPy and CH–HA hydrogel, the temperature at which fastest decomposition occurred was 260 and 244 °C, respectively. That means the thermal stability of CS–HA–PPy is better than CS–HA hydrogel. The conductive hydrogel also showed excellent swelling and deswelling behaviors.     

Physicochemical and biological quality of soil in hexavalent chromium-contaminated soils as affected by chemical and microbial remediation

Chemical and microbial methods are the main remediation technologies for chromium-contaminated soil. These technologies have progressed rapidly in recent years; however, there is still a lack of methods for evaluating the chemical and biological quality of soil after different remediation technologies have been applied. In this paper, microbial remediation with indigenous bacteria and chemical remediation with ferrous sulphate were used for the remediation of soils contaminated with Cr(VI) at two levels (80 and 1,276 mg kg^?1) through a column leaching experiment. After microbial remediation with indigenous bacteria, the average concentration of water-soluble Cr(VI) in the soils was reduced to less than 5.0 mg kg^?1. Soil quality was evaluated based on 11 soil properties and the fuzzy comprehensive assessment method, including fuzzy mathematics and correlative analysis. The chemical fertility quality index was improved by one grade using microbial remediation with indigenous bacteria, and the biological fertility quality index increased by at least a factor of 6. Chemical remediation with ferrous sulphate, however, resulted in lower levels of available phosphorus, dehydrogenase, catalase and polyphenol oxidase. The result showed that microbial remediation with indigenous bacteria was more effective for remedying Cr(VI)-contaminated soils with high pH value than chemical remediation with ferrous sulphate. In addition, the fuzzy comprehensive evaluation method was proven to be a useful tool for monitoring the quality change in chromium-contaminated soils.     

西宁市典型开放源颗粒物粒径组成特征分析

采用BT-9300S激光粒度仪分析了西宁市道路尘、扬尘、土壤尘、建筑尘4种典型开放源的粒径组成。结果表明,4种类型尘中大粒径颗粒物占主导地位,粒径大于10 μm颗粒占到全部颗粒的73.80%以上,可吸入颗粒物的含量仅占7.06%～26.20%;建筑尘的细颗粒物含量最高,粒径小于2.5、1 μm的颗粒含量分别为8.36%±4.25%、2.42%±1.02%;道路尘的细颗粒物含量最低,粒径小于2.5、1 μm的颗粒含量分别为2.30%±0.94%、0.73%±0.28%;4种类型尘的体积平均直径、面积平均直径、中位直径分别在37.70～87.99 μm、8.50～23.53 μm、28.95～74.98 μm之间,其中道路尘的3种粒径参数最大,建筑尘最小;开放源颗粒物的粒度分布曲线主要呈头长尾短的不对称单峰分布,累积频率曲线为两段式,存在较为明显的拐点。     

Chromium exhibits adverse effects at environmental relevant concentrations in chronic toxicity assay system of nematode Caenorhabditis elegans

Here we investigated whether the assay system (10-d) in Caenorhabditis elegans can be used to evaluate chronic toxicity of chromium (Cr(VI)) at environmental relevant concentrations ranging from 5.2 μg L⁻¹ to 260 μg L⁻¹. The results indicated that lethality, locomotion behavior as revealed by head thrash, body bend, and forward turn, metabolism as revealed by pumping rate and mean defecation cycle length, intestinal autofluorescence, and ROS production were severely altered in Cr chronically exposed nematodes at environmental relevant concentrations. The most surprising observations were that head thrash, body bend, intestinal autofluorescence, and ROS production in 13 μg L⁻¹ Cr exposed nematodes were significantly influenced. The observed adverse effects of Cr on survival, locomotion behavior, and metabolism were largely due to forming severe intestinal autofluorescence and ROS production. Therefore, our findings demonstrate the usefulness of chronic toxicity assay system in C. elegans in evaluating the chronic toxicity of toxicants at environmental relevant concentrations.     

面向灾害应用的遥感影像融合统一理论体系设计

由于缺乏统一的理论体系指导,目前遥感影像融合研究相对比较混乱。针对像素级融合统一理论框架的思想,指出了遥感影像融合研究的方向和思路,将像素级融合统一理论框架逐步向特征级和决策级推广,着重发展了一套遥感影像融合统一理论体系。在统一体系下,面向灾害监测应用,按照理论研究、方法研究和应用研究的3个层次进行该理论体系的设计。     

闸控河段水质浓度影响关键因子识别

由于闸门调度对河道内的水环境要素具有强烈的扰动作用,故闸控河段的水质变化过程较常规河道更为复杂。为了探析引起闸控河段水质浓度变化的主要制约因素,以槐店闸为研究对象,结合笔者进行的2次实验和其他时期的监测数据,通过偏相关分析和主成分分析的方法识别影响闸控河段水质浓度变化的关键因子,并利用多元线性回归方法分析得到闸控河段水质浓度变化与其关键因子的多元线性回归方程。经过分析初步得到,与高锰酸盐指数浓度变化率有关的关键因子为闸门开度、开启个数、高锰酸盐指数来水浓度、溶解氧含量、流速和水深;与氨氮浓度变化率有关的关键因子为闸门开度、开启个数、氨氮来水浓度、溶解氧含量和p H值。