Impact and effectiveness of Bio-Coke conversion from biomass waste as alternative source of coal coke in Southeast Asia

Journal of Material Cycles and Waste Management - Growing concern over fossil fuel depletion and the environmental impact of greenhouse gases have driven the demand for solid biofuel energy as an...     

Marine macrophytes as effective lead biosorbents

Several species of seagrass and marine macrophytes were investigated for their biosorption performance in the removal of lead from aqueous solution. The effect of pH on the equilibrium of the seagrass Cymodocea nodosa as a biosorbent also was studied. It was found that increasing pH increased lead biosorption, with a maximum uptake of approximately 140 mg/g in the range pH 3.3 to 5. Equilibrium data at different pH levels were successfully fitted to competitive equilibrium models. In addition, the seaweeds belonging to different phyla (i.e., Chlorophyta, Heterokontophyta, and Rhodophyta) were studied for the effect of their structure on equilibrium at a constant pH 5. The brown algae (Heterokontophyta) showed the highest potential for lead sorption, with a maximum uptake of 220 mg/g for C. compressa and 140 mg/g for S. lomentaria. The green algae (Chlorophyta) showed lead uptake in the range 40 to 90 mg/g, and the red algae (Rhodophyta) was least effective, with uptake in the range 10 to 40 mg/g.     

Modification of Sulfur Dioxide Injury to Tobacco and Tomato by Varying Nitrogen and Sulfur Nutrition

The body of information presented in this paper is directed to plant scientists who are concerned with factors which modify the susceptibility of plants to air pollutants.

Tobacco and tomato plants grown in sand-solution culture with varying levels of nitrogen or sulfur were exposed to injurious levels of sulfur dioxide. Plants of both species which were deficient in either nutrient exhibited decreased susceptibility to the gas compared with plants grown at optimal levels of each nutrient. Foliage of these plants was also found to have increased stomatal resistance as measured by a porometer and decreased total sulfur accumulations. Plants grown at optimum levels of each nutrient showed increased susceptibility over that of the deficient plants. Stomatal resistance was lower and sulfur accumulation was greater than in the deficient plants. At the supra-optimal nitrogen and sulfur levels, there were differences in susceptibility. Over-abundant nitrogen appeared to decrease susceptibility whereas over-supplies of sulfur increased it.

The response of plants with deficient or optimal supplies of either nutrient might be explained by the effects of nutrition on stomatal activity and hence on ability to absorb SO₂S from the atmosphere, mineral deficiency being known to increase stomatal resistance, and mineral sufficiency, to decrease stomatal resistance by virtue of increased efficiency of water use. The difference in response between plants overfertilized with respect to nitrogen or sulfur is explained by the fact that sulfur is both nutrient and phytotoxicant at the same time. Having already been oyersupplied with sulfur by absorption from the nutrient substrate, the high-sulfur plants were unable to withstand additional sulfur accumulation from the atmosphere and hence were more severely injured.

Increased carbohydrate accumulation in the nitrogen- and sulfur-deficient plants might play an additional role in protection from SO2-injury.     

Yttrium recovery from primary and secondary sources: A review of main hydrometallurgical processes

Yttrium is important rare earths (REs) used in numerous fields, mainly in the phosphor powders for low-energy lighting. The uses of these elements, especially for high-tech products are increased in recent years and combined with the scarcity of the resources and the environmental impact of the technologies to extract them from ores make the recycling waste, that contain Y and other RE, a priority.The present review summarized the main hydrometallurgical technologies to extract Y from ores, contaminated solutions, WEEE and generic wastes. Before to discuss the works about the treatment of wastes, the processes to retrieval Y from ores are discussed, since the processes are similar and derived from those already developed for the extraction from primary sources.Particular attention was given to the recovery of Y from WEEE because the recycle of them is important not only for economical point of view, considering its value, but also for environmental impact that this could be generated if not properly disposal.     

Recovery of yttrium from fluorescent powder of cathode ray tube,CRT: Zn removal by sulphide precipitation

This work is focused on the recovery of yttrium and zinc from fluorescent powder of cathode ray tube (CRT). Metals are extracted by sulphuric acid in the presence of hydrogen peroxide. Leaching tests are carried out according to a 2² full factorial plan and the highest extraction yields for yttrium and zinc equal to 100% are observed under the following conditions: 3 M of sulphuric acid, 10% v/v of H₂O₂ concentrated solution at 30% v/v, 10% w/w pulp density, 70 °C and 3 h of reaction.Two series of precipitation tests for zinc are carried out: a 2² full factorial design and a completely randomized factorial design. In these series the factors investigated are pH of solution during the precipitation and the amount of sodium sulphide added to precipitate zinc sulphide. The data of these tests are used to describe two empirical mathematical models for zinc and yttrium precipitation yields by regression analysis. The highest precipitation yields for zinc are obtained under the following conditions: pH equal to 2–2.5% and 10–12% v/v of Na₂S concentrated solution at 10% w/v. In these conditions the coprecipitation of yttrium is of 15–20%.Finally further yttrium precipitation experiments by oxalic acid on the residual solutions, after removing of zinc, show that yttrium could be recovered and calcined to obtain the final product as yttrium oxide. The achieved results allow to propose a CRT recycling process based on leaching of fluorescent powder from cathode ray tube and recovery of yttrium oxide after removing of zinc by precipitation. The final recovery of yttrium is 75–80%.     

Inclusion of sex chromosomes in noninvasive prenatal testing in Asia,Australia, Europe and the USA: A survey study

Objective

To examine the extent to which sex chromosomes are included in current noninvasive prenatal testing (NIPT) and the reporting practices with respect to fetal chromosomal sex and sex chromosome aberrations (SCAs), in addition to an update on the general implementation of NIPT.

Method

A questionnaire addressing the research objectives was distributed by email to fetal medicine and clinical genetics experts in Asia, Australia, Europe and the USA.

Results

Guidelines on NIPT are available in the majority of the included countries. Not all existing guidelines address reporting of fetal chromosomal sex and SCAs. In most settings, NIPT frequently includes sex chromosomes (five Australian states, China, Hong Kong, Israel, Singapore, Thailand, USA and 23 of 31 European countries). This occurs most often by default or when parents wish to know fetal sex. In most settings, a potential SCA is reported by stating the risk hereof as “low” or “high” and/or by naming the SCA. Less than 50% of all pregnant women receive NIPT according to respondents from three Australian states, China, Israel, Singapore, Thailand and 24 of 31 European countries. However, this percentage, the genomic coverage of NIPT and its application as primary or secondary screening vary by setting.

Conclusion

In most of the studied countries/states, NIPT commonly includes sex chromosomes. The reporting practices concerning fetal chromosomal sex and SCAs are diverse and most commonly not addressed by guidelines. In general, NIPT is variably implemented across countries/states.