As(V)在金红石TiO_2颗粒表面吸附特性及机理

通过静态动力学和热力学吸附实验,研究了温度、共存离子以及溶质的初始浓度对As(V)在金红石TiO2颗粒表面吸附的影响,探讨了As(V)在金红石TiO2颗粒表面吸附特性及机理。结果表明,在As(V)初始浓度为10 mg/L,pH为7的条件下,25℃时的吸附量0.41 mg/g高于30℃时的吸附量0.31 mg/g,As(V)在金红石TiO2上的吸附为放热过程。CaCl2和MgCl2的添加对As(V)在金红石TiO2表面吸附起到明显的促进作用。T=25℃,Ca2+或Mg2+浓度为10 mmol/L时,As(V)吸附量分别为0.64和0.56 mg/g,Ca2+比Mg2+对As(V)吸附促进作用强。As(V)在金红石TiO2的吸附等温线符合Frendlich方程,Lagergren二级动力学方程能较好地描述As(V)在金红石TiO2颗粒表面吸附的动力学过程。     

新型硅镁胶(MgO·2SiO_2)对模拟放射性废水中Co~(2+)的吸附性能

以泡花碱和氯化镁为原料合成出了一种新型硅镁胶(MgO·2SiO2)吸附材料,用傅里叶红外光谱仪对其进行了表征,并对模拟放射性废水中的Co2+进行吸附实验。结果表明,控制合成pH在10.50~11.00,可以得到目标硅镁胶(MgO·2SiO2),在460 cm-1处出现了较强的吸收峰,这是由Mg—O伸缩振动和Si—Mg—O弯曲振动引起。在500℃焙烧4h后,可以得到吸附性能良好的硅镁胶,随着溶液pH的升高,去除率增大,在pH为4~8时达到最大。25℃时,最大吸附量可达135.5 mg/g,吸附过程符合Langmuir等温吸附方程和准二级动力学方程。重复使用4次,对Co2+的吸附量仍然达到130 mg/g,说明硅镁胶是一种可重复利用的吸附剂。     

宝钢焦化废水处理脱氮研究与实践

针对上海提高新排放标准中总氮(TN)≤35 mg/L的要求,对焦化废水进行了脱氮研究。选取现场缺氧-好氧-好氧(A-O-O)工艺中前两段的A-O生化沉淀池1出水,在SBR内进行反硝化脱氮实验,考察葡萄糖、葡萄糖+乙酸钠、甲醇和甲醇+乙酸钠单一或复合碳源及投加反硝化菌种对脱氮的影响,确定最佳碳源为甲醇+乙酸钠,最佳反硝化水力停留时间为16 h。当反硝化菌液投加浓度为1 mg/L时,SBR出水TN满足达标排放要求。结合实验结果对宝钢焦化废水原有AO-O工艺改造升级为A-O-A-O二段脱氮工艺,并对生化出水实施进一步的物化混凝处理。改造后,工艺长期运行稳定,最终出水完全达到上海市污水综合排放标准(DB 31/199-2009)TN≤35 mg/L的要求,并满足氰化物、氟化物以及COD的排放要求。     

Some technical issues in managing PCBs

Polychlorinated biphenyls (PCBs) were important industrial chemicals featuring high thermal and chemical stability and low flammability. They were widely used as dielectric and thermal fluid in closed electro-technical applications (transformers, capacitors…) and also in numerous dispersive uses, ranking from auto-copying paper to sealant or coatings. During the 1960s, severe environmental consequences started becoming apparent. The stability of PCBs contributed to their persistence in the environment, their lipophilic character to bio-magnification. Fish-eating species seemed threatened in their existence. In Japan and in Taiwan, thousands of people consumed PCB-contaminated oil. The production of PCBs stopped completely during the 1980s. Usage could continue in closed applications only. In this paper, particular attention is given to two issues: the cleaning of PCB electric transformers and the potential impact of PCB-containing building materials. Other contributions will cover the management and treatment of PCB-contaminated soil, sludge or fly ash. The complete survey is being prepared by request of the Knowledge Center for Engineers and Professionals.     

Influence of soil and hydrocarbon properties on the solvent extraction of high-concentration weathered petroleum from contaminated soils

Petroleum ether was used to extract petroleum hydrocarbons from soils collected from six oil fields with different history of exploratory and contamination. It was capable of fast removing 76–94 % of the total petroleum hydrocarbons including 25 alkanes (C₁₁–C₃₅) and 16 US EPA priority polycyclic aromatic hydrocarbons from soils at room temperature. The partial least squares analysis indicated that the solvent extraction efficiencies were positively correlated with soil organic matter, cation exchange capacity, moisture, pH, and sand content of soils, while negative effects were observed in the properties reflecting the molecular size (e.g., molecular weight and number of carbon atoms) and hydrophobicity (e.g., water solubility, octanol–water partition coefficient, soil organic carbon partition coefficient) of hydrocarbons. The high concentration of weathered crude oil at the order of 10⁵ mg kg^?1 in this study was demonstrated adverse for solvent extraction by providing an obvious nonaqueous phase liquid phase for hydrocarbon sinking and increasing the sequestration of soluble hydrocarbons in the insoluble oil fractions during weathering. A full picture of the mass distribution and transport mechanism of petroleum contaminants in soils will ultimately require a variety of studies to gain insights into the dynamic interactions between environmental indicator hydrocarbons and their host oil matrix.     

Impacts of population growth and economic development on water quality of a lake: case study of Lake Victoria Kenya water

Anthropogenic-induced water quality pollution is a major environmental problem in freshwater ecosystems today. As a result of this, eutrophication of lakes occurs. Population and economic development are key drivers of water resource pollution. To evaluate how growth in the riparian population and in the gross domestic product (GDP) with unplanned development affects the water quality of the lake, this paper evaluates Lake Victoria Kenyan waters basin. Waters quality data between 1990 and 2012 were analyzed along with reviews of published literature, papers, and reports. The nitrate-nitrogen (NO₃-N), soluble phosphorus (PO₄-P), chlorophyll a, and Secchi transparencies were evaluated as they are key water quality indicators. The NO₃-N increased from 10 μg l^?1 in 1990 to 98 μg 1^?1 in 2008, while PO₄-P increased from 4 μg l^?1 in 1990 to 57 μg l^?1 in 2008. The population and economic growth of Kenya are increasing with both having minimums in 1990 of 24.143 million people and 12.18 billion US dollars, to maximums in 2010 of 39.742 million people and 32.163 billion US dollars, respectively. A Secchi transparency is reducing with time, indicating an increasing pollution. This was confirmed by an increase in aquatic vegetation using an analysis of moderate resolution imaging spectroradiometer (MODIS) images of 2000 and 2012 of Kenyan waters. This study found that increasing population and GDP increases pollution discharge thus polluting lakes. One of major factors causing lake water pollution is the unplanned or poor waste management policy and service.     

The combined effects of urea application and simulated acid rain on soil acidification and microbial community structure

Our aim was to test the effects of simulated acid rain (SAR) at different pHs, when applied to fertilized and unfertilized soils, on the leaching of soil cations (K, Ca, Mg, Na) and Al. Their effects on soil pH, exchangeable H⁺ and Al³⁺ and microbial community structure were also determined. A Paleudalfs soil was incubated for 30 days, with and without an initial application of urea (200 mg N kg^?1soil) as nitrogen (N) fertilizer. The soil was held in columns and leached with SAR at three pH levels. Six treatments were tested: SAR of pH 2.5, 4.0 and 5.6 leaching on unfertilized soil (T1, T2 and T3), and on soils fertilized with urea (T4, T5 and T6). Increasing acid inputs proportionally increased cation leaching in both unfertilized and fertilized soils. Urea application increased the initial Ca and Mg leaching, but had no effect on the total concentrations of Ca, Mg and K leached. There was no significant difference for the amount of Na leached between the different treatments. The SAR pH and urea application had significant effects on soil pH, exchangeable H⁺ and Al³⁺. Urea application, SAR treated with various pH, and the interactions between them all had significant impacts on total phospholipid fatty acids (PLFAs). The highest concentration of total PLFAs occurred in fertilized soils with SAR pH5.6 and the lowest in soils leached with the lowest SAR pH. Soils pretreated with urea then leached with SARs of pH 4.0 and 5.6 had larger total PLFA concentrations than soil without urea. Bacterial, fungal, actinomycete, Gram-negative and Gram-positive bacterial PLFAs had generally similar trends to total PLFAs.     

辽河流域浑河沈阳段地表水重点控制有机污染物的筛选

采用美国环保局工业环境实验室提出的化学物质的“潜在危害指数法”,对辽河流域浑河沈阳段地表水和底质中检出的有机污染物的潜在危害进行了排序,参考国内外有毒化学品优先控制名单的筛选原则和方法,结合本流域的实际情况,制定出重点控制有机污染物的评分标准,提出辽河流域浑河沈阳段重点控制有机污染物名单。考虑到个别有机污染物在水中的浓度很低,但在底质中相对含量较高,所以将底质的检测结果也纳入评分标准。     

固相萃取-气相色谱法测定水样中马拉硫磷残留

采用C-18小柱萃取、毛细管柱分离、气相色谱氢火焰离子化检测器（FID）测定水样中的马拉硫磷,检测限为0．12μg／L。试验了样品流量和洗脱剂对回收率的影响,结果表明样品流量为6mL／min、二氯甲烷作洗脱剂时,回收率较好。测定蒸馏水、地下水和河水样品,相对标准偏差〈2．2％。加标回收率在79．0％-109％之间。     

水泥窑共处置废物过程中重金属的流向分布

为了探索水泥窑共处置危险废物过程中重金属流向分布规律,研究了不同温度条件下Cr、As、Pb在煅烧熟料、颗粒物和尾气中的残留率.在900、1 000、1 100、1 200、1 300和1 450℃温度条件下,将添加Cr、As和Pb化学试剂的生料分别进行煅烧,模拟重金属在水泥窑内不同温度带的煅烧过程.结果表明,6个温度条件下,Cr主要分布在熟料中并且呈现不规则变化;颗粒物中的Cr在1 200℃条件下分布量最大,所占比例为32.79%(w);在900℃和1450℃条件下,烟气中的Cr分布量最大,所占比例为0.24%(w).6个温度条件下As主要分布在熟料中并且1 000~1 450℃条件下稳定在81%~83%之间;在900℃条件下,As在熟料中的残留率最大,所占比例为97%(w);在1450℃条件下,As在尾气中的分布达到最大值,所占比例为0.0023%(w).6个温度条件下,Pb在熟料中的残留率随着温度升高而逐渐减少,挥发颗粒物中的含量呈现相反的趋势;尾气中Pb的含量随着温度的升高逐渐增加.