Toward a robust analytical method for separating trace levels of nano-materials in natural waters: cloud point extraction of nano-copper(II) oxide

Cloud point extraction (CPE) factors, namely Triton X-114 (TX-114) concentration, pH, ionic strength, incubation time, and temperature, were optimized for the separation of nano-sized copper(II) oxide (nCuO) in aqueous matrices. The kinetics of phase transfer was studied using UV–visible spectroscopy. From the highest separation rate, the most favorable conditions were observed with 0.2 %?w/v of TX-114, pH?=?9.0, ionic strength of 10 mM NaCl, and incubation at 40 °C for 60 min, yielding an extraction efficiency of 89.2?±?3.9 % and a preconcentration factor of 86. The aggregate size distribution confirmed the formation of very large nCuO–micelle assemblies (11.9 μm) under these conditions. The surface charge of nCuO was also diminished effectively. An extraction efficiency of 91 % was achieved with a mixture of TX-100 and TX-114 containing 30 wt.% of TX-100. Natural organic and particulate matters, represented by humic acid (30 mg/L) and micron-sized silica particles (50 mg/L), respectively, did not significantly reduce the CPE efficiency (<10 %). The recovery of copper(II) ions (20 mg/L) in the presence of humic acid was low (3–10 %). The spiked natural water samples were analyzed either directly or after CPE by inductively coupled plasma mass spectrometry following acid digestion/microwave irradiation. The results indicated the influence of matrix effects and their reduction by CPE. A delay between spiking nCuO and CPE may also influence the recovery of nCuO due to aggregation and dissolution. A detection limit of 0.04 μg Cu/L was achieved for nCuO.     

Review of environmental aspects and waste management of stone cutting and fabrication industries

Iran is the second largest stockholder of construction stones with 10 % of world production ;and there are more than 4000 stone cutting and fabrication industries (SCFIs). In the processing of raw stones, a considerable part of stone is turned into waste. Generated wastes include excess parts of different stones and sludge. The present paper reviews the state of SCFIs waste management using multiple data sources including site, analysis of effluent and sludge samples, and conducting interviews with people who are involved in 286 SCFIs in Qom and Tabriz. The results revealed that currently almost 35 to 52.5 % of raw stones were converted to solid wastes depending on stone cutting and processing methods, type of stones and their quality, which seemed a high percentage. Also, the effluents between 0.8 and 2.8 m³ were generated per ton of processed stone. Based on the analysis of heavy metals with atomic absorption spectroscopy, sludge samples contained a considerable amount of Pb, Cu, Cr, and Cd. It was also found that the lack of specific recycling, reuse and disposal programs and suitable supervision has led to uncontrolled disposal of stone wastes and sludge in different areas. However, there are good opportunities for reuse and recycling of the SCFIs wastes.     

Concentration and characterization of airborne particles in Tehran’s subway system

Particulate matter is an important air pollutant, especially in closed environments like underground subway stations. In this study, a total of 13 elements were determined from PM₁₀ and PM_2.5 samples collected at two subway stations (Imam Khomeini and Sadeghiye) in Tehran’s subway system. Sampling was conducted in April to August 2011 to measure PM concentrations in platform and adjacent outdoor air of the stations. In the Imam Khomeini station, the average concentrations of PM₁₀ and PM_2.5 were 94.4?±?26.3 and 52.3?±?16.5 μg m^?3 in the platform and 81.8?±?22.2 and 35?±?17.6 μg m^?3 in the outdoor air, respectively. In the Sadeghiye station, mean concentrations of PM₁₀ and PM_2.5 were 87.6?±?23 and 41.3?±?20.4 μg m^?3 in the platform and 73.9?±?17.3 and 30?±?15 μg m^?3, in the outdoor air, respectively. The relative contribution of elemental components in each particle fraction were accounted for 43 % (PM₁₀) and 47.7 % (PM_2.5) in platform of Imam Khomeini station and 15.9 % (PM₁₀) and 18.5 % (PM_2.5) in the outdoor air of this station. Also, at the Sadeghiye station, each fraction accounted for 31.6 % (PM₁₀) and 39.8 % (PM_2.5) in platform and was 11.7 % (PM₁₀) and 14.3 % (PM_2.5) in the outdoor. At the Imam Khomeini station, Fe was the predominant element to represent 32.4 and 36 % of the total mass of PM₁₀ and PM_2.5 in the platform and 11.5 and 13.3 % in the outdoor, respectively. At the Sadeghiye station, this element represented 22.7 and 29.8 % of total mass of PM₁₀ and PM_2.5 in the platform and 8.7 and 10.5 % in the outdoor air, respectively. Other major crustal elements were 5.8 % (PM₁₀) and 5.3 % (PM_2.5) in the Imam Khomeini station platform and 2.3 and 2.4 % in the outdoor air, respectively. The proportion of other minor elements was significantly lower, actually less than 7 % in total samples, and V was the minor concentration in total mass of PM₁₀ and PM_2.5 in both platform stations.     

Uptake of 14C-atropine and/or its transformation products from soil by wheat (Triticum aestivum var Kronjet) and their translocation to shoots

Plant uptake of toxins and their translocation to edible plant parts are important processes in the transfer of contaminants into the food chain. Atropine, a highly toxic muscarine receptor antagonist produced by Solanacea species, is found in all plant tissues and can enter the soil and hence be available for uptake by crops. The absorption of atropine and/or its transformation products from soil by wheat (Triticum aestivum var Kronjet) and its distribution to shoots was investigated by growing wheat in soil spiked with unlabeled or ¹⁴C-labeled atropine. Radioactivity attributable to ¹⁴C-atropine and its transformation products was measurable in plants sampled at 15 d after sowing (DAS) and thereafter until the end of experiment. The highest accumulation of ¹⁴C-atropine and/or its transformation products by plants was detected in leaves (between 73 and 90% of the total accumulated) with lower amounts in stems, roots, and seeds (approximately 14%, 9%, and 3%, respectively). ¹⁴C-Atropine and/or its transformation products were detected in soil leachate at 30, 60, and 90 DAS and were strongly adsorbed to soil, with 60% of the applied dose adsorbed at 30 DAS, plateauing at 70% from 60 DAS. Unlabeled atropine was detected in shoots 30 DAS at a concentration of 3.9 ± 0.1 μg kg^?1 (mean ± SD). The observed bioconcentration factor was 2.3 ± 0.04. The results suggest a potential risk of atropine toxicity to consumers.     

Effect of Habitat Complexity on Richness, Abundance and Distributional Pattern of Forest Birds

Structurally complex forests provide more diverse conditions in comparison to homogenous forests because of greater variety of microhabitats and trees. This study assesses the association of bird species richness, abundance, and distributional pattern with habitat complexity (HC) in Kheyrud Forest in the north of Iran. Birds were surveyed during spring 2009 by 100 point counts. In each point count six habitat features related to the index of HC were computed and scored from 0 to 3. Then the scores were summed and divided into two groups of low and high complexity, HC ≤ 6 and HC > 6, respectively. To compare bird richness and abundance in different HCs, a two sample t-test was used. Presence and absence of bird species at each plot as a dependent variable were compared with the vegetation characteristics as an independent variable by means of the Canonical Correspondence Analysis. The results revealed bird species richness and abundance were significantly higher in more complex habitats. Bird species can be divided into two groups, the first group including species which associated with late successional stages and the second group, species belonging to early successional stages. Numbers of birds belonging to the first group declined in less complex forests, whereas the numbers of birds belonging to the second group increased. At the stand scale, our results reveal that bird abundance and richness are strongly associated with the complexity of vegetation structure in the study area.     

The use of date palm as a potential adsorbent for wastewater treatment: a review

Background

In tropical countries, the palm tree is one of the most abundant and important trees. Date palm is a principal fruit grown in many regions of the world. It is abundant, locally available and effective material that could be used as an adsorbent for the removal of different pollutants from aqueous solution.

Review

This article presents a review on the role of date palm as adsorbents in the removal of unwanted materials such as acid and basic dyes, heavy metals, and phenolic compounds. Many studies on adsorption properties of various low cost adsorbent, such as agricultural waste and activated carbons based on agricultural waste have been reported in recent years.

Conclusion

Studies have shown that date palm-based adsorbents are the most promising adsorbents for removing unwanted materials. No previous review is available where researchers can get an overview of the adsorption capacities of date palm-based adsorbent used for the adsorption of different pollutants. This review provides the recent literature demonstrating the usefulness of date palm biomass-based adsorbents in the adsorption of various pollutants.     

Linear and non-linear relationships mapping the Henry’s law parameters of organic pesticides

This work aims to predict the air to water partitioning for 96 organic pesticides by means of the Quantitative Structure–Property Relationships Theory. After performing structural feature selection with Genetics Algorithms and Replacement Method linear approaches, it is found that among the most important molecular features appears the Moriguchi octanol–water partition coefficient, and higher lipophilicities would lead to compounds having higher Henry’s law constants. We also compare the statistical performance achieved by four fully-connected Feed-Forward Multilayer Perceptrons Artificial Neural Networks. The statistical results found reveal that the best performing model uses the Levenberg–Marquardt with Bayesian regularization (BR) weighting function for achieving the most accurate predictions.     

Environmental monitoring of complex hydrocarbon mixtures in water and soil samples after solid phase microextraction using PVC/MWCNTs nanocomposite fiber

A novel nanocomposite based on incorporation of multiwalled carbon nanotubes (MWCNTs) in polyvinyl chloride (PVC) was prepared. Proposed nanocomposite was coated on stainless steel wire by deep coating. Composition of nanocomposite was optimized based on results of morphological studies using scanning electron microscopy. The best composition (83% MWCNTs:17% PVC) was applied as a solid phase microextraction fiber. Complex mixture of aromatic (BTEX) and aliphatic hydrocarbons (C₅–C₃₄) were selected as model analytes, and performance of proposed fiber in extraction of the studied compounds from water and soil samples was evaluated. Analytical merits of the method for water samples (LODs = 0.10–1.10 ng L⁻¹, r² = 0.9940–0.9994) and for soil samples (LODs = 0.10–0.77 ng kg⁻¹, r² = 0.9946–0.9994) showed excellent characteristics of it in ultra trace determination of petroleum type environmental pollutants. Finally, the method was used for determination of target analytes in river water, industrial effluent and soil samples.