Influence of different nitrogen rich supplements during cultivation of <Emphasis Type="Italic">Pleurotus </Emphasis><Emphasis Type="Italic">florida</Emphasis> on corn cob substrate

The cultivation of white rot edible fungus Pleurotus florida was performed in polybags. The corn cob was employed as basal substrate while eight different additives such as urea, ammonium sulphate, gram flour, soybean meal, ground nut cake and molasses were used with corn cob. Three different levels of variable combinations with corn cob were evaluated in response to different parameters of mushroom viz., mycelial growth, spawn running, primordial initiation, fruit body yield and its biological efficiency. Each additive at different combinations showed variable impact on the different stages of mushroom life cycle. The primordial initiation was observed for the first time during 20.2–35.1 days. The biological efficiencies in every supplemented set were increased over un-supplemented control set. Increasing the level of additives, the biological efficiency was negatively affected at higher levels. The cotton seed cake was found the best supplement producing 93.75% biological efficiency while soybean meal was the second best additive producing 93.00% yield. The highest growth rate, rapid mycelia run, early primordial initiation, highest yield and biological efficiency were recorded in the combination of corn cob and cotton seed cake at 2% (98 + 2) level.     

Seasonal appearance of Chlorophyceae phytoplankton bloom by river discharge off Paradeep at Orissa Coast in the Bay of Bengal

Characteristics of the monsoonal bloom of phytoplankton at Orissa Coast in the Bay of Bengal were studied through bimonthly observation from April 2001 to December 2002. Three photosynthetic pigments chlorophyll-a (Chl a), chlorophyll-b (Chl b) and carotenoid (Car) were analyzed by absorption spectroscopic method. The seasonal variation of Chl a included phytoplankton bloom in the coastal area during monsoon period. The water column integrated Chl a reached to 68 mg m(-2) at the station-1(St1), and amounted to 20 mg m(-2) at 30 km off the river mouth during August 2001. In contrast the same amount was found at 15 km off the Mahanadi river mouth during August 2002. Salinity during this period varied from 5 psu at the St1 to 27 psu at the edge of the bloom area. The total amount of river discharge in the monsoon period calculated from daily river discharge data reported by Water Resources Department in India was 84 x 10(9) m(3) during 2001 and 20 x 10(9) m(3) during 2002. Both nitrate and phosphate concentrations showed negative quadratic relationship with salinity throughout the observation period. Extrapolated nitrate and phosphate concentration discharge from the Mahanadi river were 10.8 and 4 microg-at l(-1), respectively. Microscopic identification revealed dominance of fluvial Chlorophyceae and diatoms during the monsoon period showing influence of the freshwater discharge.     

Impact of climate change on cereal production: evidence from lower-middle-income countries

Environmental Science and Pollution Research - This study empirically examines the impact of climate change on cereal production in selected lower-middle-income countries with a balanced panel...     

Recent trends and current practices for secondary processing of zinc and lead. Part I: lead recovery from secondary sources.

Implementation of stricter environmental laws and economic reasons has forced all the metallurgical industries to go for eco-friendly technologies to produce metal and other related products. However, generation of wastes is an integral part of metallurgical industries. If the wastes/residues are hazardous in nature, they generally have to be treated or/and disposed of in safe and designated dumping sites. If these wastes/residues are non-hazardous in nature, then they may be suitable for use as secondary raw material to recover metals such as lead, copper etc., which are in growing demand all over the world. The processing of lead secondaries is important because of their relative high metal content, as well as the low energy and cost involved in recovering the metal. This paper mainly focuses on the current practices and recent trends in the secondary processing of lead. Various processes, particularly hydrometallurgical ones, already developed or in the development stages, are discussed. Attempts made by various Council of Scientific and Industrial Research (CSIR) Laboratories including the National Metallurgical Laboratory (NML) and industries such as Binani Zinc to develop eco-friendly processes for the recovery of lead from secondary raw materials are also described.     

Carbon, nitrogen, and phosphorus budget in scampi (Macrobrachium rosenbergii) culture ponds

Experiments were conducted for the study of nutrient budget in ten farmer's ponds (0.2–0.5 ha) in Orissa, India with a mean water depth of 1.0–1.2 m. Scampi (Macrobrachium rosenbergii) were stocked in these ponds at stocking density of 3.75–5.0/m². The average initial body weight of scampi was 0.02 mg. The culture period was for 4 months. Feed was the main input. Total feed applied to these ponds ranged from 945 to 2261 kg pond/cycle (crop). The feed conversion ratio varied 1.65 to 1.78. In addition to feed, rice straw, urea, and single super phosphate were applied to these ponds in small amounts for plankton production. At harvest time, the average weight of scampi varied from 60–90 g. The budget showed that feed was the major input of nitrogen (N), phosphorus (P), and carbon in these ponds. The inorganic fertilizer (urea and single super phosphate), organic fertilizer (rice straw and yeast extract), and inlet water, either from the initial fills or from rainwater, were the source of all other N, P, and organic carbon (OC) to these ponds. Total N applied to these ponds through all these inputs ranged from 44.45 to 103.98 kg N per crop, 12.23 to 28.79 kg P per crop, and from 381.54 to 905.22 kg OC per crop, respectively. Among all the inputs, feed alone accounted for 95.34 % N, 97.98 % P, and 94.27 % OC, respectively. Recovery of 16.34 to 38.66 kg N (average 29.27 kg), 1.28 to 3.02 kg P (average 2.29 kg), and 63.21 to 149.51 kg OC (average 113.20 kg), respectively, by the scampi harvest were observed in these ponds. Thus, harvest of scampi accounted for recovery of 35.18 to 39.01 (average 36.85 %) of added N, 10.09 to 10.97 (average 10.44 %) of added P, and 7.57 to 17.12 (average 16.34 %) of added OC, respectively.     

Variations of physicochemical properties in Kalpakkam coastal waters, east coast of India, during southwest to northeast monsoon transition period

A significant variation in physicochemical properties of the Kalpakkam coastal waters, eastern part of India, was observed during the event of southwest to northeast monsoon transition. Increase in nitrate, total nitrogen, and silicate concentrations were noticed during post-transition period. Ammonia concentration was at peak during transition period as compared to pre- and post-transition periods. Hypo-saline condition (~23 psu) was observed during post-transition as the surface water salinity decreased by ~10 psu from the pre-transitional values. Turbidity, suspended particulate matter, phosphate and total phosphorous values decreased marginally, coinciding with northward to southward current reversal. A drastic decrease (eightfold) in chlorophyll-a concentration was observed in the coastal water during post-transition period.     

Remediation technologies for heavy metal contaminated groundwater

The contamination of groundwater by heavy metal, originating either from natural soil sources or from anthropogenic sources is a matter of utmost concern to the public health. Remediation of contaminated groundwater is of highest priority since billions of people all over the world use it for drinking purpose. In this paper, thirty five approaches for groundwater treatment have been reviewed and classified under three large categories viz chemical, biochemical/biological/biosorption and physico-chemical treatment processes. Comparison tables have been provided at the end of each process for a better understanding of each category. Selection of a suitable technology for contamination remediation at a particular site is one of the most challenging job due to extremely complex soil chemistry and aquifer characteristics and no thumb-rule can be suggested regarding this issue. In the past decade, iron based technologies, microbial remediation, biological sulphate reduction and various adsorbents played versatile and efficient remediation roles. Keeping the sustainability issues and environmental ethics in mind, the technologies encompassing natural chemistry, bioremediation and biosorption are recommended to be adopted in appropriate cases. In many places, two or more techniques can work synergistically for better results. Processes such as chelate extraction and chemical soil washings are advisable only for recovery of valuable metals in highly contaminated industrial sites depending on economical feasibility.     

A fast Bayesian method for updating and forecasting hourly ozone levels

A Bayesian hierarchical space-time model is proposed by combining information from real-time ambient AIRNow air monitoring data, and output from a computer simulation model known as the Community Multi-scale Air Quality (Eta-CMAQ) forecast model. A model validation analysis shows that the model predicted maps are more accurate than the maps based solely on the Eta-CMAQ forecast data for a 2 week test period. These out-of sample spatial predictions and temporal forecasts also outperform those from regression models with independent Gaussian errors. The method is fully Bayesian and is able to instantly update the map for the current hour (upon receiving monitor data for the current hour) and forecast the map for several hours ahead. In particular, the 8 h average map which is the average of the past 4 h, current hour and 3 h ahead is instantly obtained at the current hour. Based on our validation, the exact Bayesian method is preferable to more complex models in a real-time updating and forecasting environment.     

A Comparative Ergonomics Postural Assessment of Potters and Sculptors in the Unorganized Sector in West Bengal,India

Potters and sculptors perform their work in very awkward postures. The purpose of this study was to analyse these postures. The modified Nordic questionnaire was used to analyse musculoskeletal discomfort. Rapid entire body assessment (REBA) and rapid upper limb assessment (RULA) were used to evaluate the subjects’ postures. There were no significant differences between times of discomfort and the group of subjects. However, there were significant differences in discomfort in different body parts. The analysis indicated that various body postures were harmful to the subjects and that there were profound deviations from natural curvature of various body parts due to awkward body postures. Ergonomics intervention was required to improve the quality of life.