Impact of Ni(II), Zn(II) and Cd(II) on biogassification of potato waste

A study was conducted on anaerobic digestion of potato waste and cattle manure mixture, inoculated with 12% inoculum and diluted to 1:1 substrate water ratio at 37 +/- 1 degrees C. Initially pH of substrate was found to be 4.5 to 5.0. Lime and sodium bicarbonate solutions were employed to adjust the pH to 7.5. Biogas production continued up to 10 and 7 days, when lime and sodium bicarbonate solutions were used to adjust the pH, respectively. Biogassification potential was studied in response to different ratio of waste and cattle manure. Biogas production rate was higher when potato waste and cattle manure were used in 50:50 ratio. Effect of two different concentrations (2.5 and 5.0 ppm) of three heavy metals viz. (Ni (II), Zn (II) and Cd (II)) on anaerobic digestion of substrate (potato waste--cattle manure, 50:50) was studied. At 2.5 ppm, all the three heavy metals increased biogas production rate over the control value. The percentage increase in biogas production over the control was highest by Cd, followed by Ni and Zn. In all the treatments, methane content of biogas increased with increase in time after feeding. Various physico-chemical parameters viz. total solids, total volatile solids, total organic carbon and chemical oxygen demand considerably declined after 7 days of digestion and decline was greater in presence of heavy metals as compared to control. The physico-chemical parameters revealed maximum decrease in the presence of 2.5-ppm concentrations of heavy metals with the substrate. Among all the three heavy metals employed in the study, Cd++ at 2.5 ppm was found to produce maximum biogas production rate. The use of three heavy metals to enhance biogas production from potato and other horticultural waste is discussed.     

Comparative assessment of coal tars obtained from 10 former manufactured gas plant sites in the eastern United States

A comparative analysis was performed on eleven coal tars obtained from former manufactured gas plant sites in the eastern United States. Bulk properties analyzed included percent ash, Karl Fisher water content, viscosity and average molecular weight. Chemical properties included monocyclic- and polycyclic-aromatic hydrocarbon (PAH) concentrations, alkylated aromatic concentrations, and concentrations of aliphatic and aromatic fractions. It was found that there was at least an order-of-magnitude variation in all properties measured between the eleven coal tars. Additionally, two coal tars obtained from the same manufactured gas plant site had very different properties, highlighting that there can be wide variations in coal tar properties from different samples obtained from the same site. Similarities were also observed between the coal tars. The relative chemical distributions were similar for all coal tars, and the coal tars predominantly consisted of PAHs, with naphthalene being the single-most prevalent compound. The C(9-22) aromatic fraction, an indicator of all PAHs up to a molecular weight of approximately 276 gmole(-1), showed a strong power-law relationship with the coal tar average molecular weight (MW (ct)). And the concentrations of individual PAHs decreased linearly as MW (ct) increased up to ca. 1000 gmole(-1), above which they remained low and variable. Implications of these properties and their variation with MW (ct) on groundwater quality are discussed. Ultimately, while these similarities do allow generalities to be made about coal tars, the wide range of coal tar bulk and chemical properties reported here highlights the complex nature of coal tars.     

Recycling — an environmentally friendly and income generating activity towards sustainable solid waste management. Case study — Dar es Salaam City, Tanzania

Traditionally solid waste management has evolved as mainly the removal of municipal wastes by hauling them out of the city boundaries and dumping them ‘there’. This is in conformity with the ‘out of sight out of mind’ philosophy. However, with the ever increasing tonnage of refuse due to the expansion of urban centers, which implies increased collection, transportation and disposal costs, recycling is currently accepted as a sustainable approach to solid waste management. This paper reports on the findings of a study, conducted in the city of Dar es Salaam between the years 1993 and 1995, on the scavenging activities and recycling trends of some selected items in Dar es Salaam. Apart from the discussions on existing solid waste generation rates (2000 tonnes/day), composition (60% being organic/or vegetable matter) and their management in Dar es Salaam, the paper also presents data obtained through a survey of Vingunguti dump site and other waste collection centers. It was established that there are currently about 600 solid waste scavengers in Dar es Salaam, approximately 109 of whom operate at Vingunguti dump site and others at 14 different collection centers. Many of them opted for scavenging due to unemployment. The study findings indicate that their average monthly income exceeded the official minimum wage (at the time of study) enabling them to support their families. This demonstrates the potential of recycling to generate gainful employment with implied lower crime rates among the unemployed. Recycling activities in the city were observed to be not only a critical source of raw materials for small-scale industries, in the absence of which they would cease to operate, but also a widely accepted environmentally friendly technology for solid waste management. Out of 294 tonnes of studied waste materials (paper, metal, plastic, glass and textiles) only 4 tonnes are recovered and recycled. The remaining 290 tonnes/day of recyclable material are left to pollute the environment or are collected and transported for final disposal and, therefore, unnecessarily contribute to the shortening of the life span of the dump site. Finally, the paper gives some recommendations for improved recycling activity so as to make it an important means of reducing the overall volume of waste materials to be transported and deposited in the dump site and at the same time provide a potential opportunity for employment for unskilled workers.     

Groundwater NO3 and F Contamination Processes in Pushkar Valley, Rajasthan as Reflected from 18O Isotopic Signature and 3H Recharge Studies

Agricultural activity in the Pushkar Valley, Rajasthan is constrained due to limited availability of good quality water. In this context, occurrence of nitrate and fluoride in the groundwater was investigated and reported. Integration of stable isotope (18O) data with recharge characteristics (based on 3H-tracer studies) helps in clearly characterizing the processes controlling contamination by point and non-point sources. High nitrate and fluoride groundwaters are associated with high 18O waters. This indicates that significant quantities of evaporated (isotopically enriched) surface run-off water and rain water infiltrate along with nitrate and fluoride salts in the soil. The applicability of this approach under different hydrometeorological conditions is also confirmed.     

Cost-effective control of SO2 emissions in Asia

Despite recent efforts to limit the growth of SO(2) emissions in Asia, the negative environmental effects of sulphur emissions are likely to further increase in the future. This paper presents an extension of the RAINS-Asia integrated assessment model for acidification in Asia with an optimisation routine that can be used to identify cost-effective emission control strategies that achieve environmental targets for ambient SO(2) concentrations and sulphur deposition at least costs. Example scenarios developed with this optimisation module demonstrate a potential for significant cost savings in Asia, if emission controls are allocated to those sources that have the largest environmental impact and are cheapest to control. It is shown that strategies that simultaneously address harmful population exposure and the risk of vegetation damage from acid deposition result in the most cost-effective use of resources spent for emission controls.     

Disaster Management for Nandira Watershed District Angul (Orissa) India, Using Temporal Remote Sensing Data and Gis

NALCO – the largest exporter of aluminium in India has a power plant of 720 MW capacity in Nandira watershed in Angul district of Orissa. The power plant utilises local coal to generate thermal power and disposes of large amount of ash which accumulates in slurry form at nearby two ash ponds. These ash ponds were breached on 31 December 2000, causing ash accumulation for entire regime of the Nandira river. An attempt has been made towards preparation of recovery and rehabilitation plan for NALCO using temporal Remote Sensing data and GIS. Indian remote sensing satellite data for pre-breach condition 12 December 2000, during breach event 31 December 2000 and post-breach condition 4 and 6 January 2001 has been digitally analysed for Nandira watershed. The satellite data of coarse spatial resolution provides the absence and presence of fresh sediment deposition along Nandira watershed and Brahmani river pertaining to pre-breach and post-breach conditions respectively on regional scales. The temporal comparison of fine resolution has clearly highlighted the aerial extent of damage caused by the disaster for entire watershed on local scales. The GIS has helped in demarcation of freshly accumulated ash at interval of 500 m along the river length as well as in delineation of maximum ash accumulation across the river width. The study has clearly demonstrated the use of temporal Remote Sensing data in conjunction with GIS for disaster management in terms of recovery and rehabilitation plan preparation of the Nandira watershed.     

Kinetic parameters for the removal of lead and chromium from wastewater using activated carbon developed from fertilizer waste material

The waste slurry generated in fertilizer plants in India has been converted into a cheap carbonaceous adsorbent material. The prepared adsorbent has been characterised and used for the removal of lead and chromium metals. The kinetics of adsorption and the extent of adsorption at equilibrium are dependent on the physical and chemical characteristics of the adsorbate, adsorbent and experimental system. Results of laboratory scale studies conducted to delineate the effect of such parameters on the kinetics of adsorption of metal ions are reported. Parameters evaluated include: hydronium ion concentration, temperature, initial adsorbate concentration, size of adsorbent, and amount of adsorbent. On the basis of these studies the various physical parameters such as effective diffusion coefficient, activation energies and entropy of activation are evaluated, as these provide some information regarding the mechanistic aspects. Mass transfer coefficient values suggest a rapid transport of the adsorbate from bulk to solid phase.     

Site security for chemical process industries

Chemical process industries such as oil refineries, fertiliser plants, petrochemical plants, etc., which handle hazardous chemicals, are potential targets for deliberate actions by terrorists, criminals and disgruntled employees. Security risks arising out of these threats are real and must be assessed to determine whether the security measures employed within the facility are adequate or need enhancement. The essential steps involved are threat analysis, vulnerability analysis, security countermeasures, and emergency response. Threat analysis involves the study of identifying sources, types of threats, and their likelihood. Vulnerability analysis identifies the weaknesses in a system that adversaries can exploit. Depending on the threat likelihood and vulnerabilities, various security countermeasures are suggested to improve the plant security. Appropriate emergency response measures that could mitigate the consequences of a successful attack and concepts of inherently safer processes in the light of process security are also discussed in the paper. It is recognised that serious terrorist threats exist to the transport system of hazardous chemicals (by road, rail cars, ships, pipelines, etc.). However, that is not a part of this study, which concentrates on process plants and hazardous materials within immovable boundaries. A case study of a fertiliser plant is used to show the application of ideas presented.     

Estimation and allocation of solid waste to bin through geographical information systems.

This study presents a geographical information system (GIS)-based procedure for the precise estimation of solid waste generation, computed using the local population density and income group distribution. Using a triangulated irregular network (TIN) in a GIS environment, the procedure further determines the command area for waste allocation to a particular bin which is generally located so the route slopes towards the collection points for ease of transportation by cart pullers. Computational results of bin location, type, size and the frequency of removal are presented for a typical urban area with known population density, income group distribution, road network and topology.