Oxygen-enriched air for co-incineration of organic sludges with municipal solid waste: a pilot plant experiment

Pilot-plant experiments were performed to evaluate the effect of oxygen enrichment on the co-incineration of MSW and organic sludge from a wastewater treatment facility. Combustion chamber temperatures, stack gas concentrations, i.e., CO(2) and CO, and the residual oxygen were measured. The maximum ratio of organic sludge waste to total waste input was 30 wt.%. Oxygen-enriched air, 22 vol.% (dry basis) oxygen, was used for stable combustion. As the co-incineration ratio of the sludge increased, the primary and secondary combustion chamber temperatures were decreased to 900 and 750 degrees C, respectively, approximately 100 degrees C below the proper incineration. However, if the supplied air was enriched with 22 vol.% (dry basis) oxygen content, the incinerator temperature was high enough to burn the waste mixture containing 30 wt.% moisture sludge, with an estimated heating value of 6.72 MJ/kg. There are two main benefits of using oxygen enrichment in the co-incineration. First, the sensible heat can be reduced as the quantity of nitrogen in the flue gas will be decreased. Second, the unburned carbon formation is reduced due to the oxygen-enriched burning of the waste, despite an increase in the sludge co-incineration ratio.     

Kinetics of acetyl CoA: Arylamine N‐acetyltransferase from rapid and slow acetylator fish tissues

N‐acetyltransferase (NAT) activity was determined in 100 fish (Oreochromis mossambicus) livers using 2‐aminofluorene and p‐aminobenzoic acid as substrates. Overall, the liver NAT activity of the 50 females was higher than the liver NAT activity of the 50 males. The activities (mean ± SD) of NAT from kidney, blood, intestine, and liver of males was 0.42 ± 0.11, 0.12 ± 0.03, 0.12 ± 0.08, and 1.56 ± 0.54 nmol/min/mg protein for the acetylation of 2‐aminofluorene and 0.36 ± 0.09, 0.09 ± 0.01, 0.11 ± 0.04, and 0.46 ± 0.15 nmol/min/mg protein for the acetylation of p‐aminobenzoic acid. In kidney, blood, intestine, and liver from female fish, the activities obtained were 1.60 ± 0.12, 0.35 ± 0.07, 0.15 ± 0.09, and 1.89 ± 0.50 nmol/min/mg protein for 2‐aminofluorene and 0.95 ± 0.11, 0.27 ± 0.03, 0.13 ± 0.09, and 0.57 ± 0.12nmol/min/mg protein for p‐aminobenzoic acid. Kinetic constants for arylamine N‐acetyltransferase activity in kidney, blood, intestine, and liver from fish with rapid, intermediate, and slow acetylator activity were determined. Apparent K _m and V _max values for 2‐aminofluorene were 5.5 and 7‐fold higher for liver than for the other tissues. Apparent K _m and V _max values for p‐aminobenzoic acid were 3.5 and 4.7‐fold higher for liver than for the other tissues. Based on the 2‐aminofluorene NAT activity of liver, there appears to be a polymorphism in NAT activity with 16 rapid, 28 intermediate, and 56 slow acetylators among the 100 fish assayed. This is the first demonstration of acetyl CoA: arylamine N‐acetyltransferase activity in fresh water fish and could lead to the development of a fish model for monitoring the effect of pollution of water environments on native species.     

Paeonol promotes arylamine N‐acetyltransferase activity in human bladder tumor cells

Paeonol was used to determine effects of arylamine N‐acetyltransferase (NAT) activity in human bladder tumor cells. The NAT activity was measured by high performance liquid chromatography assaying for the amounts of N‐acetyl‐2‐aminofluorene (2‐AAF) and N‐acetyl‐p‐amino‐benzoic acid (N‐Ac‐PABA) and remaining 2‐aminofluorene (2‐AF) and p‐aminobenzoic acid (PABA). The NAT activity in human bladder tumor cells was promoted by paeonol in a dose‐dependent manner, i.e. the higher the concentration of paeonol, the higher the promotion of NAT activity. The data also indicated that paeonol increases the apparent values of K_m and K_max from human bladder tumor cells in cytosols and intact cells. This report is the first demonstration to show paeonol did promote human bladder tumor cell NAT activity.     

Measurement of traffic conflicts

Traditionally road accident statistics are used to assess the level of road safety and evaluate road safety programs. In some cases, the lack of good and reliable accident records have hampered proper analyses. A promising approach that overcomes this problem is the traffic conflict technique which relies on observations of critical traffic situations for safety analysis. However, despite the extent of work undertaken in traffic conflict research, there are still a number of issues on conflict measurement and application that have not been well understood by many safety analysts. This has resulted in a general lack of support for the wider application of the technique in safety analysis. This paper shows that one way of using the traffic conflict technique effectively is to ensure that conflicts are quantitatively defined, objectively measured and suitably applied. Before establishing the proposed framework for conflict analysis, the paper first discusses the problems and weaknesses often associated with conflict studies. Considerations for a conflict study based on the proposed approach are then presented and the case of an expressway merging is used to illustrate the method adopted.     

Degradation of aqueous carbon tetrachloride by nanoscale zerovalent copper on a cation resin

Nanoscale zerovalent copper supported on a cation resin was successfully synthesized to enhance the removal of carbon tetrachloride (CCl(4)) from contaminated water. The use of the cation resin as a support prevents the reduction of surface area due to agglomeration of nanoscale zerovalent copper particles. Moreover, the cation resin recycles the copper ions resulting from the reaction between CCl(4) and Cu(0) by simultaneous ion exchange. The decline in the amount of CCl(4) in aqueous solution results from the combined effects of degradation by nanoscale zerovalent copper and sorption by the cation resin; thus the amount of CCl(4) both in aqueous solution and sorbed onto the resin were measured. The pseudo-first-order rate constant normalized by the surface-area and the mass concentration of nanoscale zerovalent copper (k(SA)) was 2.1+/-0.1 x 10(-2)lh(-1)m(-2), approximately twenty times that of commercial powdered zerovalent copper (0.04 mm). Due to the exchange between Cu(2+) and the strongly acidic ions (H(+) or Na(+)), the pH was between 3 and 4 in unbuffered solution and Cu(2+) at the concentration of less than 0.1 mg l(-1) was measured after the dechlorination reaction. In the above-ground application, resin as a support would facilitate the development of a process that could be designed for convenient emplacement and regeneration of porous reductive medium.     

Effect of flue gas desulfurization (FGD) by-product on water quality at an underground coal mine

In this paper, a field study was carried out to examine the effect of flue gas desulfurization (FGD) by-product on water quality at an underground coal mine in central-eastern Ohio. Flue gas desulfurizalion by-product was injected into the down-dip portions of the Robert-Dawson mine in an attempt to seal major seeps exiting the mine and to coat exposed pyritic surfaces. Immediately following grout injection, significant increases in acidity, iron, aluminum, sulfur, and calcium were observed at most surface and ground water locations near where grouting was carried out. Following this initial flush of elements, concentrations of most constituents have decreased to near pre-grouting levels. Data from the site and geochemical modeling suggest that an increase in water level or rerouting of drainage flow resulted in the dissolution of iron and aluminum sulfate salts and ferrihydrite. Dissolution of the FGD grout material resulted in increases in calcium and sulfate concentrations in the drainage waters. Water within the mine voids was saturated with respect to calcium sulfate and gypsum immediately following grout injection. Based on an analysis of core samples obtained from the site, acid mine drainage (AMD) was in contact with at least some portions of the grout and this resulted in grout weathering. Subsequent transport of calcium and sulfate to the underclay, perhaps by fracture flow, has resulted in the deposition of gypsum and calcium sulfate solids.     

Consumer Choice and Farmers’ Markets

The increasing popularity of local food consumption can be attributed to the heightened awareness of food safety concerns, carbon emissions produced from food transportation, and an understanding of how large corporations’ obtain their food supplies. Although there is increasing discussion on both the local and organic food movement independently, there is not a wide availability of literature examining the motivations and perceptions of consumers with regard to farmers’ markets. Issues such as perceptions about what type of food consumers are purchasing at markets, nor the main motivations for frequenting such establishments are discussed. Therefore the purpose of this study was to determine consumer motivations, benefits, and perceptions of farmers’ markets. Using the case study location of Toronto, Canada, this study surveyed 300 participants during the fall of 2011. Findings indicated that the main purpose for visiting famers’ markets is not solely to fulfill grocery needs. Quality of products offered and the ability to support the local community were the primary motivators to visit the markets.     

Enabling youth to advocate for workplace safety

Work-related injury rates for Canadian youth (ages 15–24) are alarmingly high compared to adult workers even though youth are less likely to be performing hazardous jobs. This paper reports on a document analysis of youth workplace safety education initiatives sponsored by national and provincial/territorial governmental and non-governmental agencies. Web-based documents were analyzed through the theoretical lens of self-advocacy. The self-advocacy framework highlights how youth can be agentic in altering high-risk workplaces by publicly articulating their own interests, needs, and rights (Test et al., 2005); thus, self-advocacy is a critical component in studying educational programs for youth safety. The analysis revealed that instruction on workplace safety identifies safety issues to workers and tells youth to work safely but does little to promote self-advocacy in young workers.     

Photocatalytic degradation of triclocarban in aqueous solution using a modified zeolite/TiO2 composite: kinetic,mechanism study and toxicity assessment

Environmental Science and Pollution Research - The current work aimed to investigate the degradation of the triclocarban (TCC) in aqueous solution using a modified zeolite/TiO2 composite (MZTC)...     

Conceptual frameworks and key questions for assessing the contribution of marine protected areas to shark and ray conservation

Marine protected areas (MPAs) are key tools in addressing the global decline of sharks and rays, and marine parks and shark sanctuaries of various configurations have been established to conserve shark populations. However, assessments of their efficacy are compromised by inconsistent terminology, lack of standardized approaches to assess how MPAs contribute to shark and ray conservation, and ambiguity about how to integrate movement data in assessment processes. We devised a conceptual framework to standardize key terms (e.g., protection, contribution, potential impact, risk, threat) and used the concept of portfolio risk to identify key attributes of sharks and rays (assets), the threats they face (portfolio risk), and the specific role of MPAs in risk mitigation (insurance). Movement data can be integrated into the process by informing risk exposure and mitigation through MPAs. The framework is operationalized by posing 8 key questions that prompt practitioners to consider the assessment scope, MPA type and purpose, range of existing and potential threats, species biology and ecology, and management and operational contexts. Ultimately, MPA contributions to shark and ray conservation differ according to a complex set of human and natural factors and interactions that should be carefully considered in MPA design, implementation, and evaluation.