Use of cholinesterase activity in monitoring chlorpyrifos exposure of steer cattle after topical administration

The aim of this work was to study the pharmacokinetic behavior and the inhibitory effect of acetylcholinesterase (AChE) and butyrylcholinesterase (BChE) activities of chlorpyrifos (CPF) in steer cattle after pour-on administration. Determination of cholinesterase activity in plasma and erythrocyte was carried out according to Ellman kinetic method. CPF was analyzed by gas chromatography. AChE was the predominant form of cholinesterase analyzed, with low levels of BChE in plasma. Following the treatment with CPF, the maximum inhibitory effect on AChE or BChE were 50.88 ± 11.57 and 42.66 ± 12.01%, respectively. The chlorpyrifos plasma concentrations observed were low and they presented a high variability. Chlorpyrifos peak plasma concentration (10.42 ± 4.76 μ g/L) was reached at 8.42 ± 13.97 h. The pesticide was not detected in plasma after 48 h post treatment. The values of area under the curve (AUC) were 118.48 ± 87.46 μ g· h/L and mean resistance time (MRT) were 13.38 ± 10.41 h. The pour-on exposure to the organophosphate chlorpyrifos significantly reduced AChE and BChE activity in steer cattle and the recovery was not reached on 50 days post-treatment.     

Is Urban Stream Restoration Worth It?1

Kenney, Melissa A., Peter R. Wilcock, Benjamin F. Hobbs, Nicholas E. Flores, and Daniela C. Martínez, 2012. Is Urban Stream Restoration Worth It? Journal of the American Water Resources Association (JAWRA) 48(3): 603-615. DOI: 10.1111/j.1752-1688.2011.00635.x Abstract: Public investment in urban stream restoration is growing, yet little has been done to quantify whether its benefits outweigh its cost. The most common drivers of urban stream projects are water quality improvement and infrastructure protection, although recreational and aesthetic benefits are often important community goals. We use standard economic methods to show that these contributions of restoration can be quantified and compared to costs. The approach is demonstrated with a case study in Baltimore, Maryland, a city with a legal mandate to reduce its pollutant load. Typical urban stream restoration costs of US$500-1,200 per foot are larger than the cost of the least expensive alternatives for management of nitrogen loads from stormwater (here, detention ponds, equivalent to $30-120 per foot of restored stream) and for protecting infrastructure (rip-rap armoring of streambanks, at $0-120 per foot). However, the higher costs of stream restoration can in some cases be justified by its aesthetic and recreational benefits, valued using a contingent valuation survey at $560-1,100 per foot. We do not intend to provide a definitive answer regarding the worth of stream restoration, but demonstrate that questions of worth can be asked and answered. Broader application of economic analysis would provide a defensible basis for understanding restoration benefits and for making restoration decisions.     

Phenol and nitrophenols in the air and dew waters of Santiago de Chile

Phenol, nitrophenols and dinitrophenols were measured in air and dews in downtown Santiago de Chile. In both systems, phenol, 2-nitrophenol (2-NP), and 4-nitrophenol (4-NP) were the compounds found in higher concentrations and with major frequency. Temporal profiles in air were compatible with a significant direct incorporation from mobile sources. The data can be explained in terms of a faster removal of 2-NP than 4-NP, with the former predominating in fresh air masses and 4-NP in more aged samples. All these compounds, as well as dinitrophenols, were found in dew waters. Simultaneous measurements in air and dew indicate that phenol present in dew exceeds that expected in equilibrated samples, while the opposite occurs with 4-NP. This last result is associated to mass transfer limitations for the highly water soluble nitroderivative.     

Pesticide residue dynamics in passion fruits: Comparing field trial and modelling results

We evaluated the exposure to pesticides from the consumption of passion fruits and subsequent human health risks by combining several methods: (i) experimental field studies including the determination of pesticide residues in/on passion fruits, (ii) dynamic plant uptake modelling, and (iii) human health risk assessment concepts. Eight commonly used pesticides were applied onto passion fruits cultivated in Colombia. Pesticide concentrations were measured periodically (between application and harvest) in whole fruits and fruit pulp. Measured concentrations were compared with predicted residues calculated with a dynamic and crop-specific pesticide uptake model, namely dynamiCROP. The model accounts for the time between pesticide application and harvest, the time between harvest and consumption, the amount of spray deposition on plant surfaces, uptake processes, dilution due to crop growth, degradation in plant components, and reduction due to food processing (peeling). Measured and modelled residues correspond well (r² = 0.88-0.99), with all predictions falling within the 90% confidence interval of the measured values. A mean error of 43% over all studied pesticides was observed between model estimates and measurements. The fraction of pesticide applied during cultivation that is eventually ingested by humans is on average 10⁻⁴-10⁻⁶, depending on the time period between application and ingestion and the processing step considered. Model calculations and intake fractions via fruit consumption based on experimental data corresponded well for all pesticides with a deviation of less than a factor of 2. Pesticide residues in fruits measured at recommended harvest dates were all below European Maximum Residue Limits (MRLs) and therefore do not indicate any violation of international regulatory thresholds.     

Apple snails and their endosymbionts bioconcentrate heavy metals and uranium from contaminated drinking water

Purpose

The differential ability of apple snail tissues, endosymbionts, and eggs to bioaccumulate several metals (Sb, As, Ba, Br, Zn, Cr, Fe, Hg, Se, and U) was investigated.

Methods

Metal concentrations were determined by neutron activation analysis in several tissues, endosymbionts, and eggs from mature apple snails cultured in either drinking water or reconstituted water (prepared with American Society for Testing and Materials type I water).

Results

The highest bioconcentration factors (BCFs) in the midgut gland were found for Ba, Zn, Se, As, U, Br, and Hg (in decreasing order), while the highest in the kidney were for Ba, Br, and Hg. The foot showed the highest BCFs for Ba, Hg, Br, and Se (in decreasing order). Calcified tissues (uterus, shell) and eggs showed low BCFs, except for Ba. Both C corpuscles and gland tissue showed statistically higher BCFs than K corpuscles for Ba, Fe, U, Br, and Sb. The concentration of most of the studied elements was significantly lower in tissues and endosymbionts obtained from snails cultured in reconstituted water instead of drinking water. Snails cultured in reconstituted water and then exposed or not to Hg, As, and U (at the maximum contaminant level allowed by the US Environmental Protection Agency) also resulted in high levels accumulated in midgut gland, endosymbionts and kidney.

Conclusions

Our findings suggest that the midgut gland (and the symbionts contained therein), the kidney, and the foot of Pomacea canaliculata may be useful bioindicators of Hg, As and U pollution in freshwater bodies and that the unrestricted use of ampullariid snails as human and animal food must be considered with caution..     

A new bioseed for determination of wastewater biodegradability: analysis of the experimental procedure

A new bioassay proposed in the patent P201300029 was applied to a pre-treated wastewater containing a mixture of commercial pesticides to simulate a recalcitrant industrial wastewater in order to determine its biodegradability. The test uses a mixture of standardized inoculum of the lyophilized bacteria Pseudomonas putida with the proper proportion of salts and minerals. The results highlight that biodegradation efficiency can be calculated using a gross parameter (chemical oxygen demand (COD)) which facilitates the biodegradability determination for routine water biodegradability analysis. The same trend was observed throughout the assay with the dehydrated and fresh inoculums, and only a difference of 5 % in biodegradation efficiency (E _f) was observed. The obtained results showed that the P. putida biodegradability assay can be used as a commercial test with a lyophilized inoculum in order to monitor the ready biodegradability of an organic pollutant or a WWTP influent. Moreover, a combination of the BOD₅/COD ratio and the P. putida biodegradability test is an attractive alternative in order to evaluate the biodegradability enhancement in water pre-treated with advanced oxidation processes (AOPs).     

Chitosan/Hydrophilic Plasticizer-Based Films: Preparation,Physicochemical and Antimicrobial Properties

The addition of plasticizers to biopolymer films is a good method for improving their physicochemical properties. The aim of this study was to evaluate the effect of chitosan (CHI) blended with two hydrophilic plasticizers glycerol (GLY) and sorbitol (SOR), at two concentrations (20 and 40 wt%) on their mechanical, thermal, barrier, structural, morphological and antimicrobial properties. The chitosan was prepared through the alkaline deacetylation of chitin obtained from fermented lactic from shrimp heads. The obtained chitosan had a degree of deacetylation (DA) of 84 ± 2.7 and a molecular weight of 136 kDa, which indicated that a good film had formed. The films composed of CHI and GLY (20 wt%) exhibited the best mechanical properties compared to the neat chitosan film. The percentage of elongation at break increase to over 700 % in the films that contained 40 % GLY, and these films also exhibited the highest values for the water vapor transmission rate (WVTR) of 79.6 ± 1.9 g m² h^?1 and a yellow color (b _o  = 17.9 ± 2.0) compared to the neat chitosan films (b _o  = 8.8 ± 0.8). For the structural properties, the Fourier transform infrared spectroscopy (FTIR) and X-ray diffraction analyses revealed an interaction in the acetamide group and changes in the crystallinity of plasticized films. The scanning electron micrographs revealed that all formulations of the chitosan films were smooth, and that they did not contain aggregations, pores or microphase separation. The thermal analysis using differential scanning calorimetry (DSC) revealed a glass transition temperature (Tg) of 130 °C for neat chitosan film, but the addition of SOR or GLY elicited a decrease in the temperature of the peak (120 °C). In addition, the antimicrobial activity of the chitosan films was evaluated against Listeria monocytogenes, and reached a reduction of 2 log after 24 h. The plasticizer concentration of 20 % GLY is sufficient for obtaining flexible chitosan films with good mechanical properties, and it could serve as an alternative as a packaging material to reduce environmental problems associated with synthetic packaging films.     

Advances in the recycling of plastic wastes for metallurgical coke production

This paper aims to provide useful knowledge on the use of plastic wastes as additives to coking blends for the production of metallurgical coke. It focuses on the influence that the composition of plastic wastes has upon the development of coal fluidity, the generation of pressure during the coking process and the quality of the cokes produced in a semipilot oven. Several plastic mixtures of two types of thermoplastics, polyolefins (HDPE, LDPE and PP) and aromatic polymers such as PET, were used. The overall addition rate of plastics to a medium-fluid coal blend was 2 wt%. It is shown that polyolefins, weaker modifiers of coal fluidity, may be employed to maintain coke quality but that they have a negative effect on the generation of coking pressure, while plastics of the aromatic type such as PET, a strong modifier of coal fluidity, can be used to counteract the generation of coking pressure. From the results, it is deduced that the protocol developed is useful for determining the optimum amount of each type of polymer (polyolefins and aromatic polymers) that is needed in order to counteract the generation of pressure during the coking process and to maintain the quality of the cokes.     

Seasonal variation of pharmaceutically active compounds in surface (Tagus River) and tap water (Central Spain)

Numerous studies have shown the presence of pharmaceutically active compounds (PhACs) in different environmental compartments, for example, in surface water or wastewater ranging from nanograms per litre to micrograms per litre. Likewise, some recent studies have pointed to seasonal variability, thus indicating that PhAcs concentrations in the aquatic environment may depend on the time of year. This work intended to find out (1) whether Tagus fluvial and drinking water were polluted with different groups of PhACs and (2) if their concentrations differed between winter and summer seasons. From the 58 substances analysed, 41 were found belonging to the main therapeutic groups. Statistical differences were seen for antibacterials, antidepressants, anxiolytics, antiepileptics, and cardiovascular drugs, with higher concentrations being detected in winter than in summer. These results might indicate that the PhACs analysed in this study undergo lower environmental degradation in winter than in summer. In order to confirm these initial results, a continuous monitoring should be performed especially on those PhACs that either because of an elevated consumption or an intrinsic chemical persistence are poorly degraded during winter months due to low temperatures and solar irradiation. It is especially important to identify which of these specific PhACs are in order to recommend their substitution by equally effective and safe substances but also environmentally friendly.     

Adverse birth outcomes in the vicinity of industrial installations in Spain 2004–2008

Industrial activity is one of the main sources of ambient pollution in developed countries. However, research analyzing its effect on birth outcomes is inconclusive. We analyzed the association between proximity of mother’s municipality of residence to industries from 24 different activity groups and risk of very (VPTB) and moderate (MPTB) preterm birth, very (VLBW) and moderate (MLBW) low birth weight, and small for gestational age (SGA) in Spain, 2004–2008. An ecological study was defined, and a “near vs. far” analysis (3.5 km threshold) was carried out using Hierarchical Bayesian models implemented via Integrated Nested Laplace Approximation. VPTB risk was higher for mothers living near pharmaceutical companies. Proximity to galvanization and hazardous waste management industries increased the risk of MPTB. Risk of VLBW was higher for mothers residing near pharmaceutical and non-hazardous or animal waste management industries. For MLBW many associations were found, being notable the proximity to mining, biocides and animal waste management plants. The strongest association for SGA was found with proximity to management animal waste plants. These results highlight the importance of further research on the relationship between proximity to industrial sites and the occurrence of adverse birth outcomes especially for the case of pharmaceutical and animal waste management activities.