Rheological and Thermal Properties of the PLA Modified by Electron Beam Irradiation in the Presence of Functional Monomer

Polylactic acid (PLA) has been modified by electron beam radiation in the presence of glycidyl methacrylate (GMA) to enhance the melt strength of PLA. The modified PLA was prepared by varying both the amount of GMA and the irradiation dose and was characterized by observing the thermal properties, the melt viscoelastic properties and the gel fraction. For comparison, virgin PLA was also irradiated. All irradiated virgin PLA had a lower complex viscosity and a storage modulus compared to virgin PLA due to irradiation-induced chain scission. However, these properties were remarkably improved due to formation of long chain branching and retarding chain scission if GMA was introduced in this system. The increase in melt viscoelastic property was much dependent on the irradiation dose. At optimum doses of radiation, it showed maximum complex viscosity and storage modulus. The PLA irradiated with 20 kGy in the presence of 3 phr GMA showed a complex viscosity of about 10 times higher and a storage modulus of 100 times higher than those of virgin PLA at 0.1 rad/s. Gel fraction measurement revealed that chain scission and branching was more dominant than crosslinking. The biodegradability of irradiated PLA was slightly decreased by the presence of GMA.     

Effect of transpiration on Pb uptake by lettuce and on water soluble low molecular weight organic acids in rhizosphere

The effect of transpiration (high and low) on Pb uptake by leaf lettuce and on water soluble low molecular weight organic acids (LMWOAs) in rhizosphere has been studied. After two weeks of growth the plants were cultured in greenhouse for more four weeks and two days. Pb(NO(3))(2) solutions of different concentrations (100, 200, and 300 mg l(-1) of Pb) were then added to the quartz sand pots of different plants and studies were initiated. Blank experiments (without treating the quartz sand pots with Pb(NO(3))(2) solutions) were also run in parallel. No significant differences in the growth of the plants with the concentrations of added Pb(NO(3))(2) solutions were observed by both low and high transpirations at the end of the 0, 3rd, and 10th days of studies. The total evaporation of the volatiles during 10 days did not depend on the concentration of Pb(2+) but with high transpiration the rate of evaporation was significantly higher than with low transpiration. Uptake of Pb by shoots and roots of the plants was found to be proportional to the concentration of various Pb(NO(3))(2) solutions added and more accumulation was observed in roots than in shoots at the end of 3rd and 10th days. High transpiration created more Pb uptake than low transpiration did. One volatile acid, propionic acid and nine non-volatile acids, lactic, glycolic, oxalic, succinic, fumaric, oxalacetic, D-tartaric, trans-aconitic, and citric acids in rhizosphere quartz sands were identified and quantified by gas chromatography (GC) analysis. D-Tartaric and citric acids were major among the non-volatile acids. The amount of LMWOAs in rhizosphere quartz sands increased with the higher amount of Pb uptake and also with the duration of studies. The total quantities of the LMWOAs in the rhizosphere quartz sands were significantly higher under high transpiration with 300 mg l(-1) Pb solution addition at the end of 10th day. The present study shows prominent correlation between transpiration and uptake of heavy metal and interesting correlation between Pb contaminated level and quantity of water soluble LMWOAs in rhizosphere quartz sands. The latter thus deserves of further studies.     

The adsorptive capacity of vapor-phase mercury chloride onto powdered activated carbon derived from waste tires

Injection of powdered activated carbon (PAC) upstream of particulate removal devices (such as electrostatic precipitator and baghouses) has been used effectively to remove hazardous air pollutants, particularly mercury-containing pollutants, emitted from combustors and incinerators. Compared with commercial PACs (CPACs), an alternative PAC derived from waste tires (WPAC) was prepared for this study. The equilibrium adsorptive capacity of mercury chloride (HgCl2) vapor onto the WPAC was further evaluated with a self-designed bench-scale adsorption column system. The adsorption temperatures investigated in the adsorption column were controlled at 25 and 150 degrees C. The superficial velocity and residence time of the flow were 0.01 m/sec and 4 sec, respectively. The adsorption column tests were run under nitrogen gas flow. Experimental results showed that WPAC with higher Brunauer-Emmett-Teller (BET) surface area could adsorb more HgCl2 at room temperature. The equilibrium adsorptive capacity of HgCl2 for WPAC measured in this study was 1.49 x 10(-1) mg HgCl2/g PAC at 25 degrees C with an initial HgCI2 concentration of 25 microg/m3. With the increase of adsorption temperature < or = 150 degrees C, the equilibrium adsorptive capacity of HgCl2 for WPAC was decreased to 1.34 x 10(-1) mg HgCl2/g PAC. Furthermore, WPAC with higher sulfur contents could adsorb even more HgCl2 because of the reactions between sulfur and Hg2+ at 150 degrees C. It was demonstrated that the mechanisms for adsorbing HgCl2 onto WPAC were physical adsorption and chemisorption at 25 and 150 degrees C, respectively. Experimental results also indicated that the apparent overall driving force model appeared to have the good correlation with correlation coefficients (r) > 0.998 for HgCl2 adsorption at 25 and 150 degrees C. Moreover, the equilibrium adsorptive capacity of HgCl2 for virgin WPAC was similar to that for CPAC at 25 degrees C, whereas it was slightly higher for sulfurized WPAC than for CPAC at 150 degrees C.     

Ozonation of oxytetracycline and toxicological assessment of its oxidation by-products

Antibiotic formulation effluents are well known for their difficult elimination by traditional bio-treatment methods and their important contribution to environmental pollution due to its fluctuating and recalcitrant nature. In the present study the effect of ozonation on the degradation of oxytetracycline (OTC) aqueous solution (100mgl(-1)) at different pH values (3, 7 and 11) was investigated. Ozone (11mgl(-1) corresponds the concentration of ozone in gas phase) was chosen considering its rapid reaction and decomposition rate. The concentration of oxytetracycline, chemical oxygen demand (COD), biochemical oxygen demand (BOD) and BOD5/COD ratio were the parameters to evaluate the efficiency of the ozonation process. In addition, the toxic potential of the OTC degradation was investigated by the bioluminescence test using the LUMIStox 300 instrument and results were expressed as the percentage inhibition of the luminescence of the marine bacteria Vibrio fischeri. The results demonstrate that ozonation as a partial step of a combined treatment concept is a potential technique for biodegradability enhancement of effluents from pharmaceutical industries containing high concentration of oxytetracycline provided that the appropriate ozonation period is selected. At pH 11 and after 60min of ozonation of oxytetracycline aqueous solutions (100 and 200mgl(-1)) the BOD5/COD ratios were 0.69 and 0.52, respectively. It was also shown that COD removal rates increase with increasing pH as a consequence of enhanced ozone decomposition rates at elevated pH values. The results of bioluminescence data indicate that first by-products after partial ozonation (5-30min) of OTC were more toxic than the parent compound.     

Feasibility of using microalgal biomass cultured in domestic wastewater for the removal of chromium pollutants

The feasibility of obtaining and using the biomass of a microalga, Chlorella miniata, from domestic wastewater (DW) cultures for the removal of chromium(III) [Cr(III)] and chromium(VI) [Cr(VI)] was compared with that from commercial Bristol medium (BM). Results showed that Chlorella miniata cultured in DW under 16-8 hours light-dark cycle [DW(16-8)] had similar growth to that in BM [BM(16-8)], but these two biomass had different biochemical compositions, and the former one had lower carbohydrate and higher protein content. When cultured in domestic wastewater, a higher biomass was obtained under continuous illumination [DW(24-0)], and the cells had higher carbohydrate and lower protein concentrations than that of DW(16-8). The spectra of the Fourier transform infrared spectrometer revealed that the functional groups on the surface of the three kinds of biomass--DW(16-8), DW(24-0), and BM(16-8)--were comparable, except an additional peak at 1731 cm(-1) was found in the biomass cultured in domestic wastewater, which was probably the result of bacterial contamination. Although biochemical differences were found among the three kinds of microalgal biomass, similar biosorption performances to chromium pollutants were recorded, with approximately 75% Cr(III) and 100% Cr(VI) removed at equilibrium in Cr(III) and Cr(VI) experiments, respectively, when dead biomass was used as a biosorbent. Therefore, it is possible to culture Chlorella miniata in domestic wastewater and use the biomass for the removal of chromium pollutants.     

Atmospheric lead concentration distribution in Northern Taiwan

Atmospheric lead concentrations were measured randomly, approximately once per week, at five traffic sites in northern Taiwan from September 1994 to May 1995. Three types of theoretical distributions, lognormal, Weibull and gamma were selected to fit the frequency distribution of the measured lead concentration. Four goodness-of-fit criteria were used to judge which theoretical distribution is the most appropriate to represent the frequency distributions of atmospheric lead.The results show that atmospheric lead concentrations in total suspended particulates fit the lognormal distribution reasonably well in northern Taiwan. The intervals of fitted theoretical cumulative frequency distributions (CFDs) can successfully contain the measured data when the population mean is estimated with a 95% confidence interval. In addition, atmospheric lead concentration exceeding a critical concentration is also predicted from the fitted theoretical CFDs.     

A new joint publication

Special FeatureWaste Management Research in Korea

A new joint publication     

Performance of an immobilized cell biofilter for ammonia removal from contaminated air stream

The performance of a lab scale biofilter packed with biomedia, encapsulated by sodium alginate and polyvinyl alcohol was used for treating ammonia (NH(3)) gas at different loading rates. The metabolic end products during NH(3) oxidation were NH(4)(+), NO(3)(-) and NO(2)(-). It is noteworthy to mention that the immobilized cell biofilter required no separate acclimatization period and showed high removal efficiencies during the start of continuous experiments. The removal efficiency was nearly 100% when ammonia loading was 4.5gm(-3)h(-1) and the maximum elimination capacity achieved in this study was 5.5gNH(3)m(-3)h(-1) at a loading rate of 7.5gm(-3)h(-1). Shock loading studies were carried out to ascertain the response of the immobilized cells to fluctuations in inlet concentration and flow rate. The inlet loading rates were varied between 0.05 and 6gNH(3)m(-3)h(-1) during this phase of operation. The biofilter responded effectively to these shock loading conditions and recovered rapidly within 4-8h. Pressure drop values were consistently less and insignificant. The results from this study indicated that this immobilized cell biofilter could be considered as a potential option to treat NH(3) under steady and transient state operation.     

Uncertainty Reduction of the Flood Stage Forecasting Using Neural Networks Model1

Abstract: The Elman Discrete Recurrent Neural Networks Model (EDRNNM), which is one of the special types of neural networks model, is developed and applied for the flood stage forecasting at the Musung station (No. 1) of the Wi‐stream catchment, which is one of the International Hydrological Program representative basins, Korea. A total of 135 different training patterns, which involve hidden nodes, standardization process, data length, and lead‐time, are selected for the minimization of the architectural uncertainty. The model parameters, such as optimal connection weights and biases, are estimated during the training performance of the EDRNNM, and we apply them to evaluate the validation performance of the EDRNNM. Sensitivity analysis is used to reduce the uncertainty of input data information of the EDRNNM. As the results of sensitivity analysis, the Improved EDRNNM consists of four input nodes resulting from the exclusion of Dongkok station (No.5) in initial five input nodes group of the EDRNNM. The accuracy of flood stage forecasting during the training and validation performances of the Improved EDRNNM remains the same as that of the EDRNNM. The Improved EDRNNM, therefore, gives highly reliable flood stage forecasting. The best optimal EDRNNM, so called the Improved EDRNNM, is determined by elimination of the uncertainties of architectural and input data information in this study. Consequently, we can avoid unnecessary data collection and operate the flood stage forecasting system economically.