Dissolved oxygen content as an index of water quality in San Vicente Bay,Chile (36 degrees 45'S)

The present report describes some effects of industrial and municipal effluents on the waters of San Vicente Bay. Analyses ofthe main substances contained in the fishing industry effluentsuggest rating criteria based on the oxygen saturation of thewater as an assessment of organic pollution. Six cruises were carried out throughout the Bay, from June to December 1996. Watersamples were analyzed for dissolved oxygen, oil and grease content, and sediment samples for organic matter content. Waterparameters (salinity, temperature) were used to characterize theBay's hydrography, and to calculate values for oxygen saturation. The measurements demonstrated a local broad range of oxygen deficit, with a maximum of 45% in the winter to 95% in the spring. In November more than 65% of the Bay's area showed oxygendeficits greater than 40%. Organic matter was unusually high insediments along the northern sector of the Bay. The results suggest that the oxygen depletion was a representative parameterfor establishing a relative scale of water quality in this Bay.     

Polybrominated diphenyl ethers (PBDEs) in human milk from Australia

Polybrominated diphenyl ethers (PBDEs) are flame retardants added to a multitude of products to reduce flammability. PBDEs have been widely detected and quantified in biota and humans in many industrialised countries from the Northern Hemisphere. However data concerning the levels of these compounds in the Australian population and environment remain limited. The objectives of this study were to determine PBDE concentrations and congener profiles in Australian human milk and compare this to concentrations found in other countries. Pooled human milk samples obtained from mothers residing in 12 regions of Australia were analysed by HRGC/HRMS for 18 PBDE congeners. In total, 157 human milk samples collected in 2002 and 2003 were divided into 17 regional pools. PBDEs were detected in all pools of human milk from Australia. The mean+/-standard deviation and median summation operatorPBDE concentrations were 11.1+/-3.2 and 11.0 ng g(-1) lipid, respectively with a range of 6.1-18.7 ng g(-1) lipid. The congener profile was dominated by BDE-47 followed by BDE-99, -100, -153, -154 and -183. Regional differences were evaluated, but no trends were observed. The data suggest regional differences are likely to be small if they exist at all. The concentrations of PBDEs found in Australian human milk were lower than those reported from North America but higher than those reported from Europe and Asia. Our results suggest that the exposure pathways which contribute to the PBDE body burden in the Australian population require a better understanding in order to determine future policy regarding their use and disposal.     

International Legal Instruments and Regional Environmental Protection

Efficient environmental protection requires global, as well as regional ecological strategies. During the last decade numerous attempts at regional and global environmental protection have been made. But industrial environmental protection is still, above all, a national matter. National emission limit values and international technological standards still neglect to a large extent the regional aspects of pollution prevention. Recent normative texts (international standards, European directives) can be seen as the first step to filling this gap. They represent different evolutionary stages on the way from merely technocentric to regionally integrated environmental protection. We investigate the potential of some of these normative texts to operationalise regional environmental strategies. For this purpose we will provide a framework for evaluation centred on the following questions: ? Is the installation/project/organisation perceived as part of its specific environment? ? Can local immission standards be developed on the basis of a functional classification of ecosystems? ? Are methods of integrated ecological evaluation supported? The framework will be applied to examine the European directives on Environmental Impact Assessment and Integrated Pollution Prevention and Control and two ISO (International Standardisation Organisation) standards on Environmental Management Systems (ISO 14001 and 14004) with regard to basic requirements for operationalising integrated regional environmental protection.     

Heavy metals in source-separated compost and digestates

The production of compost and digestate from source-separated organic residues is well established in Europe. However, these products may be a source of pollutants when applied to soils. In order to assess this issue, composts, solid and liquid digestates from Switzerland were analyzed for heavy metals (Cd, Co, Cr, Cu, Ni, Pb and Zn) addressing factors which may influence the concentration levels: the treatment process, the composition, origin, particle size and impurity content of input materials, the season of input materials collection or the degree of organic matter degradation.Composts (n = 81) showed mean contents being at 60% or less of the legal threshold values. Solid digestates (n = 20) had 20–50% lower values for Cd, Co, Pb and Zn but similar values for Cr, Cu and Ni. Liquid digestates (n = 5) exhibited mean concentrations which were approximately twice the values measured in compost for most elements. Statistical analyses did not reveal clear relationships between influencing factors and heavy metal contents. This suggests that the contamination was rather driven by factors not addressed in the present study.According to mass balance calculations related to Switzerland, the annual loads to agricultural soils resulting from the application of compost and digestates ranged between 2% (Cd) and 22% (Pb) of total heavy metal loads. At regional scale, composts and digestates are therefore minor sources of pollution compared to manure (Co, Cu, Ni, Zn), mineral fertilizer (Cd, Cr) and aerial deposition (Pb). However, for individual fields, fertilization with compost or digestates results in higher heavy metal loads than application of equivalent nutrient inputs through manure or mineral fertilizer.     

Spatial mapping of city-wide PBDE levels using an exponential decay model

Passive air samplers (PAS) consisting of polyurethane foam (PUF) disks were deployed at 6 outdoor air monitoring stations in different land use categories (commercial, industrial, residential and semi-rural) to assess the spatial distribution of polybrominated diphenyl ethers (PBDEs) in the Brisbane airshed. Air monitoring sites covered an area of ~1143 km(2) and PAS were allowed to accumulate PBDEs in the city's airshed over three consecutive seasons commencing in the winter of 2008. The average sum of five (∑(5)) PBDEs (BDEs 28, 47, 99, 100 and 209) levels were highest at the commercial and industrial sites (12.7 ± 5.2 ng PUF(-1)), which were relatively close to the city center and were a factor of 8 times higher than residential and semi-rural sites located in outer Brisbane. To estimate the magnitude of the urban 'plume' an empirical exponential decay model was used to fit PAS data vs. distance from the CBD, with the best correlation observed when the particulate bound BDE-209 was not included (∑(5)-209) (r(2) = 0.99), rather than ∑(5) (r(2) = 0.84). At 95% confidence intervals the model predicts that regardless of site characterization, ∑(5)-209 concentrations in a PAS sample taken between 4-10 km from the city centre would be half that from a sample taken from the city centre and reach a baseline or plateau (0.6 to 1.3 ng PUF(-1)), approximately 30 km from the CBD. The observed exponential decay in ∑(5)-209 levels over distance corresponded with Brisbane's decreasing population density (persons/km(2)) from the city center. The residual error associated with the model increased significantly when including BDE-209 levels, primarily due to the highest level (11.4 ± 1.8 ng PUF(-1)) being consistently detected at the industrial site, indicating a potential primary source at this site. Active air samples collected alongside the PAS at the industrial air monitoring site (B) indicated BDE-209 dominated congener composition and was entirely associated with the particulate phase. This study demonstrates that PAS are effective tools for monitoring citywide regional differences however, interpretation of spatial trends for POPs which are predominantly associated with the particulate phase such as BDE-209, may be restricted to identifying 'hotspots' rather than broad spatial trends.     

Visibility-related fatalities related to construction equipment

The construction industry annually experiences one of the highest fatality rates among the industrial sectors in the United States. The factors that contribute to this reputation include the nature of the work, human behavior, the tools and equipment involved, and also the compact work zones. Industrial fatalities are investigated by the Occupational Safety and Health Administration (OSHA). While OSHA groups the causes of fatalities into a few general categories, too little information is gleaned to effectively target specific problem areas.To improve safety performance in the construction industry, it is necessary to understand the underlying causes of accidents. With targeted analysis, patterns emerge and causal factors can be identified. These findings may then be used to form the basis for recommendations that will help to improve construction worker safety. Little research has been conducted in this area.Research was conducted that isolated fatalities in which vision or lack of good visibility was the principle factor or contributing cause. The objective of examining the details surrounding these fatalities was to uncover the contributing factors and to identify the agents that compromised visibility. The study identified 659 fatality accidents from a data pool of 13511 OSHA-investigated cases. It was discovered that blind spots, obstructions and lighting conditions were the most common factors contributing to vision-related fatalities. This research also analyzed the specific conditions associated with particular pieces of construction equipment.     

Challenges for Community-Based Forest Management in the KoloAla Site Manompana

Following the IUCN 5th World Congress on Protected Areas in 2003, the then-President of Madagascar decided to increase the area of Madagascar’s protected areas from 1.7 to 6 million ha. To combine the aims of protection and timber production, a new concept was developed through the establishment of community-based forest management (CBFM) sites, called KoloAla. However, experience shows that similar management transfers to communities in Madagascar have only been successful in a very few cases. We aimed to explore the success to be expected of this new approach in the particular case of the Manompana corridor at Madagascar’s eastern coast. In a first step, the readiness of the corridor’s resource users for CBFM has been analysed according to the seven resource users’ attributes developed by Ostrom that predict an effective self-organized resource management. In a second step, we explored how KoloAla addresses known challenges of Madagascar’s CBFM. Analyses lead in a rather sober conclusion. Although KoloAla attempts to address the goals of poverty alleviation, biodiversity conservation and timber production under a single umbrella, it does so in a rather non-innovative way. Challenges with regard to the state’s environmental governance, agricultural inefficiency and thus deforestation remain unsolved.     

Evaluation of Online Information Sources on Alien Species in Europe: The Need of Harmonization and Integration

Europe is severely affected by alien invasions, which impact biodiversity, ecosystem services, economy, and human health. A large number of national, regional, and global online databases provide information on the distribution, pathways of introduction, and impacts of alien species. The sufficiency and efficiency of the current online information systems to assist the European policy on alien species was investigated by a comparative analysis of occurrence data across 43 online databases. Large differences among databases were found which are partially explained by variations in their taxonomical, environmental, and geographical scopes but also by the variable efforts for continuous updates and by inconsistencies on the definition of “alien” or “invasive” species. No single database covered all European environments, countries, and taxonomic groups. In many European countries national databases do not exist, which greatly affects the quality of reported information. To be operational and useful to scientists, managers, and policy makers, online information systems need to be regularly updated through continuous monitoring on a country or regional level. We propose the creation of a network of online interoperable web services through which information in distributed resources can be accessed, aggregated and then used for reporting and further analysis at different geographical and political scales, as an efficient approach to increase the accessibility of information. Harmonization, standardization, conformity on international standards for nomenclature, and agreement on common definitions of alien and invasive species are among the necessary prerequisites.