Automotive shredder residue (ASR) characterization for a valuable management

Car fluff is the waste produced after end-of-life-vehicles (ELVs) shredding and metal recovery. It is made of plastics, rubber, glass, textiles and residual metals and it accounts for almost one-third of a vehicle mass. Due to the approaching of Directive 2000/53/EC recycling targets, 85% recycling rate and 95% recovery rate in 2015, the implementation of automotive shredder residue (ASR) sorting and recycling technologies appears strategic. The present work deals with the characterization of the shredder residue coming from an industrial plant, representative of the Italian situation, as for annual fluxes and technologies involved. The aim of this study is to characterize ASR in order to study and develop a cost effective and environmentally sustainable recycling system. Results show that almost half of the residue is made of fines and the remaining part is mainly composed of polymers. Fine fraction is the most contaminated by mineral oils and heavy metals. This fraction produces also up to 40% ashes and its LHV is lower than the plastic-rich one. Foam rubber represents around half of the polymers share in car fluff. Moreover, some chemical–physical parameters exceed the limits of some parameters fixed by law to be considered refuse derived fuel (RDF). As a consequence, ASR needs to be pre-treated in order to follow the energy recovery route.     

Biochemical biomarkers in Nile tilapia (Oreochromis niloticus) after short-term exposure to diesel oil, pure biodiesel and biodiesel blends

Fossil fuels such as diesel are being gradually replaced by biodiesel, a renewable energy source, cheaper and less polluting. However, little is known about the toxic effects of this new energy source on aquatic organisms. Thus, we evaluated biochemical biomarkers related to oxidative stress in Nile tilapia (Oreochromis niloticus) after two and seven exposure days to diesel and pure biodiesel (B100) and blends B5 and B20 at concentrations of 0.01 and 0.1 mL L⁻¹. The hepatic ethoxyresorufin-O-deethylase activity was highly induced in all groups, except for those animals exposed to B100. There was an increase in lipid peroxidation in liver and gills in the group exposed to the higher concentration of B5. All treatments caused a significant increase in the levels of 1-hydroxypyrene excreted in the bile after 2 and 7 d, except for those fish exposed to B100. The hepatic glutathione-S-transferase increased after 7 d in animals exposed to the higher concentration of diesel and in the gill of fish exposed to the higher concentration of pure diesel and B5, but decreased for the two tested concentrations of B100. Superoxide dismutase, catalase and glutathione peroxidase also presented significant changes according to the treatments for all groups, including B100. Biodiesel B20 in the conditions tested had fewer adverse effects than diesel and B5 for the Nile tilapia, and can be suggested as a less harmful fuel in substitution to diesel. However, even B100 could activate biochemical responses in fish, at the experimental conditions tested, indicating that this fuel can also represent a risk to the aquatic biota.     

Characterisation of PM10 emissions from woodstove combustion of common woods grown in Portugal

A series of source tests was performed to evaluate the chemical composition of particle emissions from the woodstove combustion of four prevalent Portuguese species of woods: Pinus pinaster (maritime pine), Eucalyptus globulus (eucalyptus), Quercus suber (cork oak) and Acacia longifolia (golden wattle). Analyses included water-soluble ions, metals, radionuclides, organic and elemental carbon (OC and EC), humic-like substances (HULIS), cellulose and approximately l80 organic compounds. Particle (PM₁₀) emission factors from eucalyptus and oak were higher than those from pine and acacia. The carbonaceous matter represented 44–63% of the particulate mass emitted during the combustion process, regardless of species burned. The major organic components of smoke particles, for all the wood species studied, with the exception of the golden wattle (0.07–1.9% w/w), were anhydrosugars (0.2–17% w/w). Conflicting with what was expected, only small amounts of cellulose were found in wood smoke. As for HULIS, average particle mass concentrations ranged from 1.5% to 3.0%. The golden wattle wood smoke presented much higher concentrations of ions and metal species than the emissions from the other wood types. The results of the analysis of radionuclides revealed that the ²²⁶Ra was the naturally occurring radionuclide more enriched in PM₁₀. The chromatographically resolved organics included n-alkanes, n-alkenes, PAH, oxygenated PAH, n-alkanals, ketones, n-alkanols, terpenoids, triterpenoids, phenolic compounds, phytosterols, alcohols, n-alkanoic acids, n-di-acids, unsaturated acids and alkyl ester acids.     

Remediation procedure used for contaminated soil and underground water: A case study from the chemical industry

This is a case study of contamination by a non-aqueous phase liquid (NAPL) that leaked from a chemical plant. The remediation procedure adopted for the initial phase of the plume migration was a plastic diaphragm wall coupled with a series of water extraction wells designed to avoid environmental impact on the surrounding ecosystems. Monitoring has shown that the containment is successful, and additional measures that contribute to accelerating remediation have been adopted. The authors wished to investigate how remediation might be further enhanced. The use of in situ aeration coupled with a system of soil vapor extraction (AS/SVE) has been chosen, since the remediation of sites with characteristics similar to those in this study, if based exclusively on dissolved-phase control, would take several decades to be completed. The transport of contaminant plumes has been simulated by using an analytical model to evaluate the effectiveness of the natural attenuation of the contaminant. The results of the simulation have confirmed the limited effectiveness of the natural attenuation of the contaminant, as well as the effective increase of remediation that would occur if the AS/SVE system is applied. A sensitivity analysis that included several combinations of increments of parameters that correspond to the decay rate of the source and the dissolved plume has simulated what might happen if the AS/SVE system is implemented.     

Distribution in Portugal of some pollutants in the lichen Parmelia sulcata

During the months of July and August 1993 a lichen (Parmelia sulcata Taylor) collection campaign was held in Portugal where samples were obtained from olive tree bark at 228 sites, following a grid of 10 x 10 km along the Atlantic coast and 50 x 50 km in the interior of the country. The samples were analysed by instrumental neutron activation analysis and proton induced X-ray emission techniques. Concentration data patterns for the pollutants As, Cr, Hg, Ni, Pb, S, Sb, Se, and V were obtained for the whole country surface by making use of an extinction rule of 1/r(3), preventing any cut-off distance from being artificially introduced. Some pollution sources were identified: (1) oil-powered plants on the Lisbon-Setúbal axis (V, Ni), (2) coal-power plants in Porto and Sines (S, Se), (3) traffic in the northern area and the Lisbon-Setúbal axis (Pb), (4) a chemical industry south of Porto (Hg, As), and (5) soil influence (Cr, Sb). Arsenic and chromium results largely exceed, in a few areas, the concentrations acceptable to plants, and in a few spots also Hg, Ni, and Pb data.     

Festuca arundinacea,glutathione S-transferase and herbicide safeners: A preliminary case study to reduce herbicidal pollution

The expression of glutathione S-transferase (GST) activity in Festuca arundinacea was investigated in response to the following herbicide safeners: benoxacor, cloquintocet-mexyl, fenchlorazol-ethyl, fenclorim, fluxofenim and oxabetrinil. All the above compounds enhanced the GST activity tested towards the “model” substrate 1-chloro-2,4-dinitrobenzene (CDNB). Assays of GST activity towards the herbicides terbuthylazine (N ²-tert-butyl-6-chloro-N ⁴-ethyl-1,3,5-triazine-2,4-diamine) and butachlor (N-butoxymethyl-2-chloro-2′,6′-diethylacetanilide) as substrates also showed the ability of the safeners to enhance the enzyme activity towards both these herbicides, with the exception of cloquintocet-mexyl for the enzyme activity towards butachlor. As a consequence of the above effects at a macro-scale level, decreased herbicide accumulation and persistence were ascertained in response to the addition of the safener benoxacor to both terbuthylazine and butachlor treatments. These results are discussed in terms of capacity of benoxacor to induce herbicide detoxification in Festuca arundinacea with a view to utilizing them in reducing herbicide pollution.     

Validation and global uncertainty of a gas chromatographic with mass spectrometry method for fenamidone analysis in grapes and wines

Fenamidone is an imidazolinone fungicide recently introduced in viticulture practices. This work reports the validation and assessment of global uncertainty of a gas chromatographic with mass spectrometry method to analyze fenamidone in grapes and wines. This method consists in a simple and fast liquid-liquid extraction step followed by chromatographic determination. Limits of detection for fenamidone in grapes and wines were, respectively, 0.05 mg/kg and 0.06 mg/L, precision was below 9.4% and average recovery was 89 +/- 5%. In the concentration range from 0.05 to 1.00 mg/kg (or mg/L) of fenamidone, global uncertainty calculated following the EURACHEM/CITAC rules, and also by the Horwitz function, was below 25%. The EURACHEM/CITAC global uncertainty budget used gave lower estimates than those obtained from the Horwitz function.     

Photocatalytic and combined anaerobic-photocatalytic treatment of textile dyes

A photocatalytic process based on immobilized titanium dioxide was used to treat crude solutions of azo, anthraquinone and phthalocyanine textile dyes. In addition, the process was applied to the treat autoxidized chemically reduced azo dyes, i.e. representatives of recalcitrant dye residues after biological sequential anaerobic-aerobic treatment. Photocatalysis was able to remove more than 90% color from crude as well as autoxidized chemically reduced dye solutions. UV-absorbance and COD were also removed but to a lower extent (50% in average). The end products of photocatalytic treatment were not toxic toward methanogenic bacteria. The results demonstrate that photocatalysis can be used as a pre- or post-treatment method to biological anaerobic treatment of dye-containing textile wastewater.     

QuEChERS: a sample preparation for extraction of carbaryl from rat feces

Carbamate compounds are an important group of cholinesterase inhibitors. There is a need for creating awareness regarding the risks of the inadequate carbamate use in the residential areas due to potential adverse human effects. Carbaryl is a commonly used pesticide worldwide. A simple, fast, and high-throughput method was developed employing liquid chromatography with fluorescence detector to determine carbaryl residues in rat feces. The extraction was performed by using a rapid, easy, cheap, effective, reliable, and safe (QuEChERS) method, using acetonitrile as the extracting solvent. The parameters for the performance of the extraction method were optimized, such as ratio of mass of sample per volume of extraction solvent, QuEChERS content, and cleanup columns. Linear response was obtained for all calibration curves (solvent and matrix-matched) over the established concentration range (5–500 μg/L) with a correlation coefficients higher than 0.999. The achieved recovery was 97.9% with relative standard deviation values of 1.1% (n = 4) at 167 μg/kg fortified concentration level and the limits of detection and quantification were 27.7 and 92.3 µg/kg, respectively.