Respiratory tract retention of inhaled air pollutants: Report 1 : Mercury absorption by inhaling through the nose and expiring through the mouth at various concentrations

To study atmospheric mercury absorption in human respiratory passage-ways, mercury in expired air was measured in three different states of breathing: steady breathing, deep breathing and breath held after inspiration.In this study, air containing mercury was inhaled through the nose and expired through the mouth. The concentration of mercury in the exhaled air was determined by the technique of gold-amalgam trapping, heat vaporization, and flameless atomic absorption measurement.The subjects were 13 male adults, aged 25–62 years, and 38 cases were observed. Four different concentrations of mercury, 1–3, 4–6, 10–11, and 20–30 μg/m³ were used, and absorption for each was determined. When the concentration was 1–3 μg/m₃, the absorption was 74–92%, the average being 82.5%. At concentrations of 4–6, 10–11, and 20–30 μg/m₃, the absorption was 76.6–100%, 75.5–99.2%, and 79.9–95.9% respectively, and the average was 88.8%, 85.2%, and 87.7% respectively.A slightly higher rate of mercury absorption was observed in deep breathing than in steady breathing, and when expiration was suppressed for some time after inspiration, the rate increased remarkably to 97.4–99.7%. Prolonged retention of inhaled air containing mercury in the respiratory tract is believed to have caused the increased absorption.     

Simultaneous treatment of PVC and oyster-shell wastes by mechanochemical means

This work presents a new process for dechlorinating poly-vinyl chloride (PVC) by the use of oyster-shell waste. The process consists of milling of PVC waste with oyster-shell waste, followed by washing the milled sample with water. The milling of PVC and oyster-shell mixture results in size reduction and rupture in bonds, leading to mechanically induced reactions between the two to form CaCl2 and hydrocarbon with C=C bonds. Washing the milled mixtures with water at room temperature allows complete removal of chlorine from the milled sample. More than 95% of chlorine in PVC was removed when 2h grinding is conducted for the mixture. The present process could offer a potential route to the handling and disposal of oyster-shell and PVC wastes.     

Identification of methyl chloride-emitting plants and atmospheric measurements on a subtropical island

A survey of methyl chloride (CH3Cl)-emitting plants was performed at a subtropical island in Japan (Iriomote Island). Among the 187 species of tropical/subtropical plants investigated, 33 species from a variety of families were identified as CH3Cl-emitting plants. The strongest emitters were Osmunda banksiifolia, Cibotium balometz, Angiopteris palmiformis, Vitex rotundifolia, Vitex trifolia, and Excoecaria agalloch, each with CH3Cl emission rates exceeding 1microg (gdrywt)(-1)h(-1). The first three species are ferns, and the last three are halophilous plants. Based on our results, the character of CH3Cl emission is likely to be shared at the genus level but not always at the family level. The atmospheric CH3Cl distribution measured on Iriomote Island showed significant enhancement in forested sites (up to 2750 ppt) and a higher concentration on the downwind shore than on the upwind shore. As previously reported, our findings provide strong evidence for the high emission of CH3Cl from tropical/subtropical forests.     

Estrogen equivalent concentration of 13 branched para-nonylphenols in three technical mixtures by isomer-specific determination using their synthetic standards in SIM mode with GC-MS and two new diasteromeric isomers

Thirteen isomers of branched para-nonylphenols (para-NP) in three technical mixtures were isomer-specifically determined using their synthesized standards by SIM of structurally specific ions, m/z 135, 149 or 163 with GC–MS. Of the 13 isomers, four isomers, 4-(2,4-dimethylheptan-4-yl)phenol, 4-(4-methyloctan-4-yl)phenol, 4-(3-ethyl-2-methylhexan-2-yl)phenol (3E22NP) and 4-(2,3-dimethylheptan-2-yl)phenol synthesized for their determinations were first used as standard substances. The 13 isomers in the technical mixtures individually occurred at mass percent portion of more than 2%. The total mass percent portions in the mixtures from Tokyo Chemical Industry (TCI), Aldrich, and Fluka covered with 89 ± 2%, 75 ± 4% and 77 ± 2%, respectively. The abundance of 4-(3,6-dimethylheptan-3-yl)phenol in the three mixtures was the largest with 11.1 ± 2% to 9.9 ± 0.3%, while that of 4-(2-methyloctan-2-yl)phenol was the smallest with 2.9 ± 0.3% to 3.0 ± 0.2%. Additionally, structures of four new isomers of more than 1% portion present in a technical mixture were elucidated as two pairs of diastereomeric isomers: two types of 4-(3,4-dimethylheptan-4-yl)phenol (344NP) and those of 4-(3,4-dimethylheptan-3-yl)phenol (343NP). By estrogenic assay of 13 isomers with yeast estrogen screen system, the activity of 3E22NP was the highest, while that of 4-(3-methyloctan-3-yl)phenol was the least. Their relative activities to that of 3E22NP were individually calculated. Estrogenic equivalent concentrations of the three technical mixtures were predictively evaluated. The ratio of the EEC to the conventional concentration, total mass percent portions of the 13 isomers in technical mixtures were 0.208 for TCI, 0.206 for Aldrich and 0.205 for Fluka. The predicted estrogenic activity of measured concentration of para-NP in technical mixtures was approximately 5-fold greater than the measured estrogen agonist activity.     

Fire effects on stable isotopes in a Sierran forested watershed

This study tested the hypothesis that stable C and N isotope values in surface soil and litter would be increased by fire due to volatilization of lighter isotopes. The hypothesis was tested by: (1) performing experimental laboratory burns of organic and mineral soil materials from a watershed at combinations of temperature ranging 100 to 600 degrees C and duration ranging from 1 to 60 min; (2) testing field samples of upland soils before, shortly after, and 1 yr following a wildfire in the same watershed; and (3) testing field soil samples from a down-gradient ash/sediment depositional area in a riparian zone following a runoff event after the wildfire. Muffle furnace results indicated the most effective temperature range for using stable isotopes for tracing fire impacts is 200 to 400 degrees C because lower burn temperatures may not produce strong isotopic shifts, and at temperatures>or=600 degrees C, N and C content of residual material is too low. Analyses of field soil samples were inconclusive: there was a slightly significant effect of the wildfire on delta15N values in upland watershed analyses 1 yr postburn, while riparian zone analyses results indicated that delta13C values significantly decreased approximately 0.71 per thousand over a 9 mo post-fire period (p=0.015), and ash/sediment layer delta13C values were approximately 0.65 per thousand higher than those in the A horizon. The lack of field confirmation may have been due to overall wildfire burn temperatures being <200 degrees C and/or microbial recovery and vegetative growth in the field. Thus, the muffle furnace experiment supported the hypothesis, but it is as yet unconfirmed by actual wildfire field data.     

Effect of Tinospora cordifolia on the reduction of ultraviolet radiation‐induced cytotoxicity and DNA damage in PC12 cells

The safety of Tinospora cordifolia and its potential to protect against ultraviolet radiation‐induced cytotoxicity and DNA damage in PC12 cells were investigated. To evaluate the safety of T. cordifolia, cell viability and agarose gel electrophoresis were carried out using PC12 cells treated with 0 to 100 μg mL^?1 of methanol extract of T. cordifolia. T. cordifolia extracts did not show cytotoxicity ranging 0 to 100 μg mL^?1. In addition, T. cordifolia extracts significantly increased cell viability at 1 ng, 10 ng and 1 μg mL^?1 concentrations in serum‐deprived medium compared to control. To confirm the protective role against UV‐induced damage, PC12 cells alone or in the presence of 10 ng, 100 ng, or 1 μg mL^?1 of T. cordifolia extract were exposed to 250, 270 and 290 nm of UV radiation, which corresponded to doses of 120, 150 and 300 mJ cm^?2, respectively. Treatment with T. cordifolia extracts significantly increased the cell survival rate irradiated at 290 nm. In addition, T. cordifolia extracts significantly reduced cyclobutane pyrimidine dimer formation induced by UV irradiation at all wavelengths. In conclusion, T. cordifolia is not toxic and safe for cells. Our findings can support its application as phototherapy in the medical sector.     

Detection of dicofol and related pesticides in human breast milk from China, Korea and Japan

Previously, we demonstrated that the concentrations of DDTs were greater in breast milk collected from Chinese mothers than from Japanese and Korean mothers. To investigate dicofol as a possible source of the DDTs in human breast milk, we collected breast milk samples from 2007 to 2009 in China (Beijing), Korea (Seoul, Busan) and Japan (Sendai, Takarazuka and Takayama). Using these breast milk samples, we quantified the concentrations of dichlorobenzophenone, a pyrolysis product of dicofol (simply referred to as dicofol hereafter), dichlorodiphenyltrichloroethane and its metabolites (DDTs) using GC-MS. Overall, 12 of 14 pooled breast milk samples from 210 mothers contained detectable levels of dicofol (>0.1 ng g⁻¹ lipid). The geometric mean concentration of dicofol in the Japanese breast milk samples was 0.3 ng g⁻¹ lipid and significantly lower than that in Chinese (9.6 ng g⁻¹ lipid) or Korean breast milk samples (1.9 ng g⁻¹ lipid) (p < 0.05 for each). Furthermore, the ΣDDT levels in breast milk from China were 10-fold higher than those from Korea and Japan. The present results strongly suggest the presence of extensive emission sources of both dicofol and DDTs in China. However, exposure to dicofol cannot explain the large exposure of Chinese mothers to DDTs because of the trace levels of dicofol in the ΣDDTs. In the present study, dicofol was confirmed to be detectable in human breast milk. This is the first report to identify dicofol in human samples.     

Quantitative analysis of perfluorinated chemicals in media for in vitro fertilization and related samples

The actual standard in vitro fertilization (IVF) protocol recommends an overnight gamete co-incubation. All of the culture media used for human IVF are supplemented with serum or albumin. In the present study, we determined the concentrations of perfluorinated chemicals (PFCs) in IVF media (IVFM) and related samples by liquid chromatography with tandem mass spectrometry (LC/MS/MS). The results indicated that the concentrations of PFOS and PFOA in the protein source were higher than those in the IVFM samples. Compared with human plasma concentrations of PFCs, PFCs in all of the IVFM samples, such as PFBS, PFHxS and PFOA, were either not detected or present at only trace levels, even when protein source was added. LC/MS/MS could be used to determine PFCs in IVFM samples in future studies of the effects of PFC exposure on intrauterine insemination.     

TEMPO-Mediated Oxidation of Norway Spruce and Eucalyptus Pulps: Preparation and Characterization of Nanofibers and Nanofiber Dispersions

This study deals with 2,2,6,6-tetramethylpiperidine-1-oxyl (TEMPO)-mediated oxidation of cellulose. Softwood and hardwood pulp fibers were suspended in water and oxidized to various extents at pH 10 and 22 °C using sodium hypochlorite in the presence of TEMPO radical and sodium bromide. This reaction system is known to be the most efficient one for the introduction of both surface carboxyl and aldehyde groups. Important relationships between formation of these functional groups and the fibrillation yield, light transmittance of the water dispersions and degree of polymerization of the oxidized softwood and hardwood pulps were established in the present study. A birefringence test confirmed the presence of nanofibers which according to atomic force microscopy analyses had diameters in the 1.6–3.8 nm range.