乌鲁木齐市大气环境质量现状及其变化趋势分析

本文对乌鲁木齐市大气环境质量及其发展趋势作了简要的分析,说明目前市大气属煤烟-沙尘型污染区,氮氧化物和二氧化硫随着国民经济能耗的增加有发展的趋势,其它污染物仍稳定在目前水平,或稍有下降.     

聚硅酸硫酸氯化铝铁絮凝剂的制备及絮凝性能

以粉煤灰为原料制备了无机高分子絮凝剂聚硅酸硫酸氯化铝铁(PSiAFCS),用PSiAFCS处理以硅藻土为原料配制的模拟废水.实验结果表明,在n(Al3+):n(SO4-2)=11、PSiAFCS加入量为2.5mg/L、废水pH为6.0～11.0,温度为60℃、静置时间为20 min、废水初始浊度为50.00～500.00 NTU的范围内,PSiAFCS的絮凝效果良好,浊度去除率大于96%.PSiAFCS对赣江水的浊度去除效果优于聚硅酸氯化铝铁(PSiAFC)和聚合氯化铝(PAC).PSiAFCS加入量为2.5 mg/L时,水样的剩余浊度最低,为0.52 NTU,浊度去除率达98.27%,达到GB5749-2006<生活饮用水卫生标准>中浊度小于1.00 NTU的要求.     

Arsenic stabilization by zero-valent iron,bauxite residue,and zeolite at a contaminated site planting Panax notoginseng

Panax notoginseng (Burk.) F.H. Chen, a rare traditional Chinese medicinal herb, is a widely used phytomedicine used all over the world. In recent years, the arsenic contamination of the herb and its relative products becomes a serious problem due to elevated soil As concentration. This study aimed to evaluate the effects of different types and dosages of amendments on As stabilization in soil and its uptake by P. notoginseng. Results showed that comparing to control treatment, the As concentrations of P. notoginseng declined by 49–63%, 43–61% and 52–66% in 0.25% zero-valent iron (Fe(0)), 0.5% bauxite residue, and 1% zeolite treatment, respectively; whereas the biomasses were elevated by 62–116%, 45–152% and 114–265%, respectively. The As(III) proportions of P. notoginseng increased by 8%, 9%, and 8%, and the transfer factors of As from root to shoot increased by 37%, 42% and 84% in the optimal treatments of Fe(0), bauxite residue, and zeolite. For soil As, all the three amendments could transform the non-specifically adsorbed As fraction to hydrous oxides Fe/Al fractions (by Fe(0) and red mud) or specifically adsorbed As fraction (by zeolite), therefore reduced the bioavailability of soil As. With a comprehensive consideration of stabilization efficiency, plant growth, environmental influence, and cost, Fe(0) appeared to be the best amendment, and zeolite could also be a good choice. In conclusion, this study was of significance in developing As contamination control in P. notoginseng planting areas, and even other areas for medicinal herb growing.     

抗压实验法厌氧颗粒污泥机械强度的测定及影响因素分析

通过首先对厌氧颗粒污泥样品进行筛分,然后测定其机械强度,解决了实际操作过程中现有抗压实验法出现的精确度与重现性较差的问题。通过对不同来源厌氧颗粒污泥样品机械强度的测定、对比分析发现,厌氧颗粒污泥的机械强度大小与反应器的规模、反应器所采用水力负荷存在一定的正相关性,且与其主要金属元素（Ca、Fe和Mg）含量的大小存在着密切的关系。     

The effect of conservation tillage in managing climate change in arid and semiarid areas—a case study in Northwest China

Mitigation and Adaptation Strategies for Global Change - Coastal cities are exposed to high risks due to climate change, as they are potentially affected by both rising sea levels and increasingly...     

Source apportionment of polycyclic aromatic hydrocarbons in surface soil in Tianjin, China

Principal component analysis and multiple linear regression were applied to apportion sources of polycyclic aromatic hydrocarbons (PAHs) in surface soils of Tianjin, China based on the measured PAH concentrations of 188 surface soil samples. Four principal components were identified representing coal combustion, petroleum, coke oven plus biomass burning, and chemical industry discharge, respectively. The contributions of major sources were quantified as 41% from coal, 20% from petroleum, and 39% from coking and biomass, which are compatible with PAH emissions estimated based on fuel consumption and emission factors. When the study area was divided into three zones with distinctive differences in soil PAH concentration and profile, different source features were unveiled. For the industrialized Tanggu-Hangu zone, the major contributors were cooking (43%), coal (37%) and vehicle exhaust (20%). In rural area, however, in addition to the three main sources, biomass burning was also important (13%). In urban-suburban zone, incineration accounted for one fourth of the total.     

Survey of heavy metal pollution and assessment of agricultural soil in Yangzhong district, Jiangsu Province, China

We investigated concentrations of Hg, Cd, Pb, Zn, Cu, As, Ni, and Cr in samples of soil, cereal, and vegetables from Yangzhong district, China. Compared to subsoils, the sampled topsoils are enriched in Hg, Cd, Cu, Pb, Zn, and As. High levels of Cd and Hg are observed in most agricultural soils. Concentrations of Cr and Ni show little spatial variation, and high Cu, Pb, and Zn contents correspond well to areas of urban development. High As contents are primarily recorded at the two ends of the sampled alluvion. The contents of Cd, Hg, and total organic carbon (TOC) increase gradually to maximum values in the upper parts of soil profiles, while Cr and Ni occur in low concentrations within sampled profiles. As, Pb, Cu, and Zn show patterns of slight enrichment within the surface layer. Compared to data obtained in 1990, Cd and Hg show increased concentrations in 2005; this is attributed to the long-term use of agrochemicals. Cr and Ni contents remained steady over this interval because they are derived from the weathering of parent material and subsequent pedogenesis. The measured As, Cu, Pb, and Zn contents show slight increases over time due to atmospheric deposition of material sourced from urban anthropogenic activity. Low concentrations of heavy metals are recorded in vegetables and cereals because the subalkaline environment of the soil limits their mobility. Although the heavy metal concentrations measured in this study do not pose a serious health risk, they do affect the quality of agricultural products.     

Influences of chemical activators on incinerator bottom ash

This research has applied different chemical activators to mechanically and thermally treated fine fraction (<14 mm) of incinerator bottom ash (IBA), in order to investigate the influences of chemical activators on this new pozzolanic material. IBA has been milled and thermally treated at 800 degrees C (TIBA). The TIBA produced was blended with Ca(OH)(2) and evaluated for setting time, reactivity and compressive strength after the addition of 0.0565 mole of Na(2)SO(4), K(2)SO(4), Na(2)CO(3), K(2)CO(3), NaOH, KOH and CaCl(2) into 100g of binder (TIBA+Ca(OH)(2)). The microstructures of activated IBA and hydrated samples have been characterized by X-ray diffraction (XRD) and thermogravimetry (TG) analysis. Thermal treatment is found to produce gehlenite (Ca(2)Al(2)SiO(7)), wollastonite (CaSiO(3)) and mayenite (Ca(12)Al(14)O(33)) phases. The thermally treated IBA samples are significantly more reactive than the milled IBA. The addition of Na(2)CO(3) can increase the compressive strength and calcium hydroxide consumption at 28-day curing ages. However, the addition of Na(2)SO(4), K(2)SO(4), K(2)CO(3), NaOH and KOH reduces the strength and hydration reaction. Moreover, these chemicals produce more porous samples due to increased generation of hydrogen gas. The addition of CaCl(2) has a negative effect on the hydration of TIBA samples. Calcium aluminium oxide carbonate sulphide hydrate (Ca(4)Al(2)O(6)(CO(3))(0.67)(SO(3))(0.33)(H(2)O)(11)) is the main hydration product in the samples with activated IBA, except for the sample containing CaCl(2).