Development of an analytical method for analysis of flubendiamide,des-iodo flubendiamide and study of their residue persistence in tomato and soil

Flubendiamide is a new insecticide that has been found to give excellent control of lepidopterous pests of tomato. This study has been undertaken to develop an improved method for analysis of flubendiamide and its metabolite des-iodo flubendiamide and determine residue retention in tomato and soil. The analytical method developed involved extraction of flubendiamide and its metabolite des-iodo flubendiamide with acetonitrile, liquid-liquid partitioning into hexane-ethyl acetate mixture (6:4, v v^?1) and cleanup with activated neutral alumina. Finally the residues were dissolved in gradient high pressure liquid chromatography (HPLC) grade acetonitrile for analysis by HPLC. The mobile phase, acetonitrile-water at 60:40 (v v^?1) proportion and the wavelength of 235 nm gave maximum peak resolution. Using the above method and HPLC parameters described, nearly 100 % recovery of both insecticides were obtained. There was no matrix interference and the limit of quantification (LOQ) of the method was 0.01 mg kg^?1. Initial residue deposits of flubendiamide on field-treated tomato from treatments @ 48 and 96 g active ingredient hectare^?1 were 0.83 and 1.68 mg kg^?1,respectively. The residues of flubendiamide dissipated at the half-life of 3.9 and 4.4 days from treatments @ 48 and 96 g a.i. ha^?1, respectively and persisted for 15 days from both the treatments. Des-iodo flubendiamide was not detected in tomato fruits at any time during the study period. Residues of flubendiamide and des-iodo flubendiamide in soil from treatment @ 48 and 96 g a.i. ha^?1 were below detectable level (BDL, < 0.01 mg kg^?1) after 20 days. Flubendiamide completely dissipated from tomato within 20 days when the 480 SC formulation was applied at doses recommended for protection against lepidopterous pests.     

Incineration at Bayou Bonfouca Remediation Project

The Bayou Bonfouca hazardous waste site is located in Slidell, Louisiana, approximately 96 kilometers (60 miles) northeast of New Orleans. This site is ranked number 1,006 on the National Priorities List of Superfund sites. The U.S. Environmental Protection Agency (EPA) conducted a remedial investigation in 1986 and determined the primary potential exposure sources to be groundwater, surface waste piles, and contaminated sediment in Bayou Bonfouca. Based on the results of investigations, EPA and the Louisiana Department of Environmental Quality chose a remedy that involves dredging contaminated sediment from the bayou, excavating contaminated waste piles and soil, and incinerating the solid wastes in a transportable incinerator. The site remedy, which included incineration, was specified in the Record of Decision signed in March 1987.

Of the total 142,000 megagrams (Mg) (157,000 tons) of waste to be incinerated, approximately 119,000 Mg (132,000 tons) consist of hazardous sediment from the bayou; 22,600 Mg (25,000 tons) consist of lightly contaminated soils and waste piles, cellulosic materials, and other miscellaneous wastes on the ground. The solid wastes are primarily low heat content sediment and soils and cellulosic materials with polyaromatic hydrocarbon (PAH) concentrations from milligrams per kilogram (parts per million) levels up to two percent. The dredged bayou sediment will be dewatered in six, 115-cubiometer (150-cubic-yard) plate and frame filter presses before processing in the incinerator. A rotary-kiln-based single train incinerator is deployed at Bayou Bonfouca to process the solid waste feed.

On-site pilot studies indicated that the PAHs in groundwater could be removed by on-site pumping, treatment, and discharge of treated effluent to the bayou. The groundwater treatment plant went on-stream in June 1991. Treatment involves oil/water separation, filtration, carbon bed adsorption, and aeration.

IT Corporation-OH Materials, a joint venture, was awarded a contract in May 1991 and a notice to proceed in February 1992 to remediate and restore the Bayou Bonfouca site. The remediation project includes air quality monitoring and controls, site preparation, dredging and excavation, bayou bank stabilization and monitoring, equipment mobilization and erection, the trial burn, incineration, demobilization, and site closure. The project completed a successful trial burn in November 1993, and the commercial operation began in December 1993. The expected duration of the project is 40 months from mobilization to site closure.     

Analysis of some heavy metals in the riverine water, sediments and fish from river Ganges at Allahabad

The river Ganges has been one of the major recipients of industrial effluents in India. The present paper deals with the study related to occurrence and bioaccumulation of heavy metals (Cu, Cr, Cd, Pb, Zn) in the riverine water, sediment, and the muscles of two cat fish species, Channa punctatus (C. punctatus) and Aorichthys aor (A. aor) procured from the river Ganges at Allahabad. The data obtained after water analysis reflected the order of occurrence of heavy metals to be Zn > Pb > Cu > Cr > Cd, respectively. The analysis of heavy metals in sediment indicated that among the five heavy metals tested; Zn was maximally accumulated followed by Pb, Cr, Cu and Cd. The trend of heavy metals accumulation in fish muscles was found to be similar to that observed in sediment and water such as Zn > Pb > Cu > Cr > Cd. Data indicated that Zn accumulated maximally in the sediment as well as muscles of both of the fish species in comparison to other metals.     

Ferrate(VI) enhanced photocatalytic oxidation of pollutants in aqueous TiO<Subscript>2</Subscript> suspensions

Background, aim and scope  

Photocatalytic oxidation using UV irradiation of TiO₂ has been studied extensively and has many potential industrial applications, including the degradation of recalcitrant contaminants in water and wastewater treatment. A limiting factor in the oxidation process is the recombination of conduction band electrons (e ⁻ _cb) with electron holes (h_vb⁺) on the irradiated TiO₂ surface; thus, in aqueous conditions, the presence of an effective electron scavenger will be beneficial to the efficiency of the oxidation process. Ferrate (FeO₄²⁻) has received much recent attention as a water treatment chemical since it behaves simultaneously as an oxidant and coagulant. The combination of ferrate [Fe(VI)] with UV/TiO₂ photocatalysis offers an oxidation synergism arising from the Fe(VI) scavenging of e ⁻ _cb and the corresponding beneficial formation of Fe(V) from the Fe(VI) reduction. This paper reviews recent studies concerning the photocatalytic oxidation of problematic pollutants with and without ferrate.     

Health benefits valuation of regulatory intervention for air pollution control in thermal power plants in Delhi,India

This study estimates minimum marginal health benefits (morbidity reduction only) of air pollution control and total health benefits arising from regulatory intervention regarding the adoption of the World Bank emission guidelines (WBEG) for thermal power plants (TPPs) in Delhi. The Industrial Source Complex-Short-Term Version–3 (ISCST3) model has been used to estimate the contribution to air pollution from TPPs. The household health production function (avertive behaviour) has been used to value health benefits of air pollution control. The study revealed that the ambient air pollution due to TPPs is reduced by between 62.17% to 83.45% by adopting the WBEG. Annual marginal benefit due to reduction in exposure to air pollution by 1 μg m^?3 is estimated to be US$0.353 per person. Total annual health benefits for adopting the WBEG for TPPs are estimated at US$235.19 million. This study provides a novel methodology to evaluate health benefits of regulatory intervention.     

Utilization of molasses spentwash for production of bioplastics by waste activated sludge

Present study describes the treatment of molasses spentwash and its use as a potential low cost substrate for production of biopolymer polyhydroxybutyrate (PHB) by waste activated sludge. Fluorescence microscopy revealed the presence of PHB granules in sludge biomass which was further confirmed by fourier transform-infra-red spectroscopy (FT-IR) and ¹³C nuclear magnetic resonance (NMR). The processing of molasses spentwash was carried out for attaining different ratios of carbon and nitrogen (C:N). Highest chemical oxygen demand (COD) removal and PHB accumulation of 60% and 31% respectively was achieved with raw molasses spentwash containing inorganic nitrogen (C:N ratio = 28) followed by COD removal of 52% and PHB accumulation of 28% for filtered molasses containing inorganic nitrogen (C:N ratio = 29). PHB production yield (Y_p/s) was highest (0.184 g g^?1 COD consumed) for deproteinized spentwash supplemented with nitrogen. In contrast, the substrate consumption and product formation were higher in case of raw spentwash. Though COD removal was lowest from deproteinized spentwash, evaluation of kinetic parameters suggested higher rates of conversion of available carbon to biomass and PHB. Thus the process provided dual benefit of conversion of two wastes viz. waste activated sludge and molasses spentwash into value-added product-PHB.     

Top-down and bottom-up inventory approach for above ground forest biomass and carbon monitoring in REDD framework using multi-resolution satellite data

This study deals with the future scope of REDD (Reduced Emissions from Deforestation and forest Degradation) and REDD+ regimes for measuring and monitoring the current state and dynamics of carbon stocks over time with integrated geospatial and field-based biomass inventory approach. Multi-temporal and multi-resolution geospatial synergic approach incorporating satellite sensors from moderate to high resolution with stratified random sampling design is used. The inventory process involves a continuous forest inventory to facilitate the quantification of possible CO₂ reductions over time using statistical up-scaling procedures on various levels. The combined approach was applied on a regional scale taking Himachal Pradesh (India), as a case study, with a hierarchy of forest strata representing the forest structure found in India. Biophysical modeling implemented revealed power regression model as the best fit (R ²?=?0.82) to model the relationship between Normalized Difference Vegetation Index and biomass which was further implemented to calculate multi-temporal above ground biomass and carbon sequestration. The calculated value of net carbon sequestered by the forests totaled to 11.52 million tons (Mt) over the period of 20 years at the rate of 0.58 Mt per year since 1990 while CO₂ equivalent reduced from the environment by the forests under study during 20 years comes to 42.26 Mt in the study area.     

Efficiency evaluation of sewage treatment plants with different technologies in Delhi (India)

Physical, chemical and microbiological efficiencies of Sewage Treatment Plants (STPs) located in Delhi's watershed in context of different treatment technologies employed in these plants have been determined. There were in all seventeen STPs treating domestic wastewater which were studied over a period of 12 months. These STPs were based on Conventional Activated sludge process (ASP), Extended aeration (Ex. Aeration), physical, chemical and biological removal treatment (BIOFORE) and oxidation pond treatment process. Results suggests that except "Mehrauli" STP which was based on Extended aeration process and "Oxidation pond", effluents from all other STPs exceeded FC standard of 10(3) MPN/100 ml for unrestricted irrigation criteria set by National river conservation directorate (NRCD). Actual integrated efficiency (IE(a)) of each STP was evaluated and compared with the standard integrated efficiency (IE(s)) based upon physical, biological and microbiological removal efficiencies depending upon influent sewage characteristics. The best results were obtained for STPs employing extended aeration, BIOFORE and oxidation pond treatment process thus can be safely used for irrigation purposes.     

Biochemical responses in tree foliage exposed to coal-fired power plant emission in seasonally dry tropical environment

A biomonitoring study was conducted to investigate the responses of plants exposed to power plant emission in a dry tropical environment. For this purpose, five sampling sites were selected in the prevailing wind direction (NE) at different distance to thermal power plant (TPP) within 8.0 km range and a reference site was selected in eastern direction at a distance of 22.0 km. The two most common tree species, Ficus benghalensis L. (Evergreen tree) and Dalbergia sisso Roxb. (deciduous tree) were selected as test plants. Ambient sulphur dioxide (SO(2)), nitrogen dioxide (NO(2)), suspended particulate matter (SPM), respirable suspended particulate matter (RSPM), dust-fall rate (DFR) and plant responses such as leaf pigments (chlorophyll a, chlorophyll b and carotenoids), ascorbic acid, sugar and sulphate-sulphur (SO4(2-)-S) contents were measured. Ambient SO(2), NO(2), SPM, RSPM and DFR showed significant spatial and temporal variation at different sites. Considerable reduction in pigment (chlorophyll a, chlorophyll b and carotenoids) and sugar contents were observed at sites receiving higher pollution load. Ascorbic acid exhibited significant positive correlation with pollution load. Accumulation of SO4(2-)-S in leaf tissue showed significant positive correlation with ambient SO(2) concentration at all the sites. At the same time, SO4(2-)-S showed significant negative correlation with pigment and sugar content. D. sisso Roxb. tree was found to be more sensitive as compared to F. benghalensis L. tree.     

Kinetics of sorption of lead on bed sediments of River Hindon, India

A number of low cost waste sorbent have been used for removal of heavy metals, however, few studies have been carried out on the sorption process on riverbed sediments in their natural state of occurrence. Stream sediments adsorb certain solutes from streams, thereby significantly changing the solute composition, but little is known about quantitatively describing sorption phenomena and rates of these processes. In the present investigation, sorption of lead ions on river bed sediments of river Hindon, a tributary of river Yamuna, India has been studied to demonstrate the role of bed sediments in controlling metal pollution. The effect of various operating variables, viz., initial concentration, solution pH, sediment dose, contact time and particle size has been studied. The sorption of lead ions increased with respect to pH and sorbent dose and decreased with sorbent particle size. Two important geochemical phases, iron and manganese oxide, also play important role in the sorption process. The sorption data were analysed using Langmuir and Freundlich isotherm models to determine the mechanistic parameters related to the sorption process. Further, although lead ions have more affinity for the fine fraction of the sediment, but the overall contribution of coarser fraction to sorption is more as compared to clay and silt fraction. The kinetic data suggest that the sorption of lead on bed sediments is an endothermic process, which is spontaneous at low temperature. The uptake of lead is controlled by both bulk and intraparticle diffusion mechanism.