Field trial of a new aeration system for enhancing biodegradation in a biopile

The influence of a new aeration system on the biopile performance was investigated. The purpose was to increase biodegradation efficiency by optimising airflow through the pile. During a 1-month field trial, the performance of a new system using two perforated vertical pipes with wind-driven turbines was compared with that of a standard pile configuration with two horizontal perforated pipes. Both piles were composed of a similar mix of diesel-contaminated soils, woodchips, compost and NPK fertiliser. Hydrocarbons were recovered using solvent extraction, and determined both gravimetrically and by gas chromatography. Total heterotrophs, pH and moisture content were also assessed. Air pressure measurements were made to compare the efficiency of suction in the pipes. Results at the end of the experiment showed that there was no significant difference between the two piles in the total amount of hydrocarbon biodegradation. The normalised degradation rate was, however, considerably higher in the new system than in the standard one, suggesting that the vertical venting method may have improved the efficiency of the biological reactions in the pile. The pressure measurements showed a significant improvement in the suction produced by the new aeration system. However, many factors other than the airflow (oxygen supply) may influence and limit the biodegradation rates, including moisture content, age of contaminants and the climatic conditions. Additional experiments and modelling need to be carried out to explore further the new aeration method and to develop criteria and guidelines for engineering design of optimal aeration schemes in order to achieve maximum biodegradation in biopiles.     

Uncertainties and recommendations

An assessment of the impacts of changes in climate and UV-B radiation on Arctic terrestrial ecosystems, made within the Arctic Climate Impacts Assessment (ACIA), highlighted the profound implications of projected warming in particular for future ecosystem services, biodiversity and feedbacks to climate. However, although our current understanding of ecological processes and changes driven by climate and UV-B is strong in some geographical areas and in some disciplines, it is weak in others. Even though recently the strength of our predictions has increased dramatically with increased research effort in the Arctic and the introduction of new technologies, our current understanding is still constrained by various uncertainties. The assessment is based on a range of approaches that each have uncertainties, and on data sets that are often far from complete. Uncertainties arise from methodologies and conceptual frameworks, from unpredictable surprises, from lack of validation of models, and from the use of particular scenarios, rather than predictions, of future greenhouse gas emissions and climates. Recommendations to reduce the uncertainties are wide-ranging and relate to all disciplines within the assessment. However, a repeated theme is the critical importance of achieving an adequate spatial and long-term coverage of experiments, observations and monitoring of environmental changes and their impacts throughout the sparsely populated and remote region that is the Arctic.     

Development and validation of a method for analysis of "dioxin-like" PCBs in environmental samples from the steel industry

A method, previously used for determination of 2,3,7,8-substituted polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs), has been modified for quantitative analysis of "dioxin-like" polychlorobiphenyls (PCBs) in environmental samples from the steel industry. The existing sample clean-up procedure, involving liquid chromatography on multi-layered silica and Florisil columns, has been extended to include a third chromatography stage on a basic alumina stationary phase. The additional clean-up stage is required for PCB analysis in order to eliminate interferences from relatively large concentrations of saturated cyclic and aliphatic hydrocarbons. Samples were analysed for WHO-12 congeners using high resolution gas chromatography/high resolution mass spectrometry (HRGC/HRMS) and standard solutions of the method US EPA 1668A. Replicate analysis of method blanks revealed background contamination for PCBs 118, 105 and 77, which are generally abundant in ambient air. These contaminants were taken into account using a subtraction method. The entire procedure was validated by replicate analysis (N = 3) of a certified reference sediment. The RSD for each WHO-12 congener was below 15%, 13C12-labelled PCB internal standard recoveries were in the range 70-95%. A waste dust sample collected in the electrostatic precipitator of a UK sinter plant was analysed for determination of PCDD/Fs and WHO-12 PCBs and exhibited a PCDD/F I-TEQ of 148.5 +/- 21.2 ngkg(-1) and a WHO-TEQ of 7.2 +/- 1.5 ngkg(-1). WHO-12 congeners contributed only 4.6% to the overall TEQ and PCB 126 was the major congener contributing to the WHO-TEQ (96%). The contribution to the overall TEQ of the waste dust sample was mainly attributed to PCDF followed by PCDD, which accounted for 86.6% and 8.7% to the overall TEQ, respectively.     

Particulates, not plants, dominate nitrogen processing in a septage-treating aerated pond system

In pond and wetland systems for wastewater treatment, plants are often thought to enhance the removal of ammonium and nitrogen through the activities of root-associated bacteria. In this study, we examined the role of plant roots in an aerated pond system with floating plants designed to treat high-strength septage wastewater. We performed both laboratory and full-scale experiments to test the effect of different plant root to septage ratios on nitrification and denitrification, and measured the abundances of nitrifying bacteria associated with roots and septage particulates. Root-associated nitrifying bacteria did not play a significant role in ammonium and total nitrogen removal. Investigations of nitrifier populations showed that only 10% were associated with water hyacinth [Eichhornia crassipes (Mart.) Solms] roots (at standard facility plant densities equivalent to 2.2 wet g roots L(-1) septage); instead, nitrifiers were found almost entirely (90%) associated with suspended septage particulates. The role of root-associated nitrifiers in nitrification was examined in laboratory batch experiments where high plant root concentrations (7.4 wet g L(-1), representing a 38% net increase in total nitrifier populations over plant-free controls) yielded a corresponding increase (55%) in the non-substrate-limited nitrification rate (V(max)). However, within the full-scale septage-treating pond system, nitrification and denitrification rates remained unchanged when plant root concentrations were increased to 7.1 g roots L(-1) (achieved by increasing the surface area available for plants while maintaining the same tank volume). Under normal facility operating conditions, nitrification was limited by ammonium concentration, not nitrifier availability. Maximizing plant root concentrations was found to be an inefficient mechanism for increasing nitrification in organic particulate-rich wastewaters such as septage.     

In situ treatment of metals in contaminated soils with phytate

Batch experiments were conducted to evaluate the ability of various forms of phytate, the hexaphosphoric form of myo-inositol (IP6), to immobilize U, Ni, and other inorganic contaminants in soils and sediments. A Ca-phytate precipitate (Ca(n)-IP6), dodeca sodium-phytate (Na12-IP6), and hydroxyapatite (HA) were added to contaminated soil at rates of 0, 10, 25, and 50 g kg(-1) and equilibrated in 0.001 M CaCl2. The samples were then centrifuged, the solution pH was measured, and the supernatants were filtered prior to analysis for dissolved organic carbon (DOC), U, Ni, P, and other inorganic contaminants, such as As, Cr, Se, and Pb. The residual sediments were air-dried prior to characterization by analytical electron microscopy and extraction with the Toxicity Characteristic Leaching Procedure (TCLP). The solubility of several metals (e.g., U, Pb, Cu) increased with increasing Na12-IP6 when compared with the nonamended control. In some cases immobilization was observed at the lowest Na12-IP6 application rate (10 g kg(-1)) with an increase in solubility observed at the higher rates, demonstrating the importance of metal to ligand ratio. In contrast, Ca(n)-IP6 and HA decreased the solubility of U, Ni, Al, Pb, Ba, Co, Mn, and Zn. For example, soluble U decreased from 2242 to 76 microg kg(-1) and Ni from 58 to 9.6 mg kg with the Ca(n)-IP6 addition, similar to the results observed for HA. Arsenic and Se solubility increased for HA and both forms of IP6, but to a much greater degree for Na12-IP6, suggesting that the increase in pH observed for HA and Na12-IP6, combined with added competition from PO4 and IP6 for sorption sites, resulted in the release of sorbed oxyanion contaminants. The analytical electron microscopy results indicated that metals such as U and Ni were closely associated with secondary Al-rich precipitates in the HA-treated soils, rather than unreacted HA. The analytical electron microscopy results were less definitive for the Ca(n)-IP6-treated soil, although the residual P-containing material was enriched in Al, with lesser amounts of U and Ni.     

Rapidly eroding piñon-juniper woodlands in New Mexico: response to slash treatment

The pi?on (Pinus edulis Engelm.)-juniper [Juniperus monosperma (Engelm.) Sarg.] woodlands of Bandelier National Monument are experiencing accelerated erosion. Earlier studies suggest that causes of these rapidly eroding woodlands are related to an unprecedented rapid transition of ponderosa pine (Pinus ponderosa C. Lawson) savanna to pi?on-juniper woodlands as a result of cumulative historical effects of overgrazing, fire suppression, and severe drought. To study the effectiveness of slash treatment in reducing accelerated erosion, we used sediment check dams to quantify sediment yield from twelve paired microwatersheds (300-1100 m2) within an existing paired water-shed study. Six of the twelve microwatersheds were located in a 41-ha (treatment) watershed with scattered slash treatment, whereas six microwatersheds were located in an adjacent 35-ha untreated (control) watershed. The primary purpose of our research was to quantify the rates of sediment yield between the treated and control microwatersheds. Sediment yield was measured from 15 individual storms during the months of June-September (2000 and 2001). In response to slash treatment, mean seasonal sediment yield for 2000 equaled 2.99 Mg/ha in the control vs. 0.03 Mg/ha in the treatment and 2.07 Mg/ha in the control vs. 0.07 Mg/ha in the treatment in 2001. The practice of slash treatment demonstrates efficacy in reducing erosion in degraded pi?on-juniper woodlands by encouraging herbaceous recovery. Our data show that slash treatment increases total ground cover (slash and herbaceous growth) beyond a potential erosion threshold. Restored pi?on-juniper woodlands, as the result of slash treatment, provide a forest structure similar to pre-grazing and pre-fire suppression conditions and decrease catastrophic fire hazard.     

Using the ECLPSS software environment to build a spatially explicit component-based model of ozone effects on forest ecosystems

We have developed a modeling framework to support grid-based simulation of ecosystems at multiple spatial scales, the Ecological Component Library for Parallel Spatial Simulation (ECLPSS). ECLPSS helps ecologists to build robust spatially explicit simulations of ecological processes by providing a growing library of reusable interchangeable components and automating many modeling tasks. To build a model, a user selects components from the library, and then writes new components as needed. Some of these components represent specific ecological processes, such as how environmental factors influence the growth of individual trees. Other components provide simulation support such as reading and writing files in various formats to allow inter-operability with other software. The framework manages components and variables, the order of operations, and spatial interactions. The framework provides only simulation support; it does not include ecological functions or assumptions. This separation allows biologists to build models without becoming computer scientists, while computer scientists can improve the framework without becoming ecologists. The framework is designed to operate on multiple platforms and be used across networks via a World Wide Web-based user interface. ECLPSS is designed for use with both single processor computers for small models, and multiple processors in order to simulate large regions with complex interactions among many individuals or ecological compartments. To test Version 1.0 of ECLPSS, we created a model to evaluate the effect of tropospheric ozone on forest ecosystem dynamics. This model is a reduced-form version of two existing models: , which represents an individual tree, and , which represents forest stand growth and succession. This model demonstrates key features of ECLPSS, such as the ability to examine the effects of cell size and model structure on model predictions.     

Safety teams. Government and business organizations want them and use them, but are they legal?

BACKGROUND: Safety teams have become a popular means to recognize and prevent injuries in the workplace. In fact, organizations, such as OSHA, NIOSH, NIEHS, DOE, and the Ohio BWC, not only encourage safety teams, but have implemented them in their organizations. However, safety teams may not be legal as defined by NLRB Act Sections 2(5) and 8(a)(2). OBJECTIVE: To determine whether safety teams are illegal labor organizations. METHODS: A review of government regulations, safety programs, and safety teams was performed to create a framework of what types of safety programs/regulations are requested and/or required by a variety of government agencies. Next, these requirements were compared to existing case law on illegal labor organizations as defined by the NLRB. RESULTS: Most safety teams and programs, even those implemented by the Federal Government, are illegal labor organizations as defined by NLRB Act Sections 2(5) and 8(a)(2). CONCLUSIONS: The Federal Government needs to amend existing legislation and develop a revision of the NLRB Act that would allow safety teams to function legally in organizations without having to meet intrusive, constricting guidelines that may inhibit the value of safety teams. IMPACT ON INDUSTRY: Organizations must be aware that safety teams may be valuable in reducing job-related accidents and injuries but they may be illegal labor organizations.