试论生态文明制度体系的构建

建立健全生态文明制度体系是推进我国生态文明建设的重点。党的十八届三中全会通过的《中共中央关于全面深化改革若干重大问题的决定》指出,生态文明制度体系应当包括决策制度、评价制度、管理制度与考核制度等内容。立足社会主义制度建设的中国特色,针对我国生态文明建设的具体需求,本文将生态文明制度体系解构为四大板块:绿色高效决策制度、生态有价评估制度、生态环境监管制度与生态优先考核制度,并进一步明确了各项制度构建工作的具体内容。生态文明制度体系的构建和不断完善,将为全面建成人与自然和谐的美丽中国提供系统保障。     

Adsorption/desorption of arsenite and arsenate on chitosan and nanochitosan

Equilibrium sorption studies of anionic species of arsenite, As(III) ions and arsenate As(V) ions onto two biosorbents, namely, chitosan and nanochitosan, have been investigated and compared. The results and trends in the sorption behavior are novel, and we have observed during the sorption process of the As(III) and As(V) on chitosan, a slow process of desorption occurred after an initial maximum adsorption capacity was achieved, before reaching a final but lower equilibrium adsorption capacity. The same desorption trend, however, is not observed on nanochitosan. The gradual desorption of As(III) and As(V) in the equilibrium sorption on chitosan is attributed to the different fractions of the dissociated forms of arsenic on the adsorbent surface and in solution and the extent of protonation of chitosan with the changing of solution pH during sorption. The change of solution pH during the sorption of arsenite ions on chitosan was also influenced by the interaction between the buffering effect of the arsenite species in the aqueous medium and the physical properties of chitosan. The final equilibrium adsorption capacity of chitosan for As(III) and As(V) was found to be around 500 and 8000 μg/g, respectively, whereas the capacities on nanochitosan are 6100 and 13,000 μg/g, respectively.

     

大肠杆菌吸附-化学还原法用废含金催化剂制备金纳米线

采用大肠杆菌吸附-化学还原法,以大肠杆菌(ECCs)为模板、十六烷基三甲基溴化铵为保护剂、抗坏血酸为还原剂,由废含金催化剂制备金纳米线(AuNWs)。采用XRD,SEM,TEM等技术对AuNWs进行表征。研究了AuNWs对罗丹明6G(R6G)和4-巯基苯甲酸(4-MBA)的拉曼散射信号的增强效果。实验结果表明:在制备过程中加入微生物ECCs,可使金回收率提高约20百分点;当溶液pH小于4时,反应2 h后,有大量呈线状的AuNWs聚集沉降,金回收率可达99%1以上。表征结果显示,AuNWs呈多晶结构,晶格间距为0.23 nm。表面增强拉曼散射分析表明,AuNWs对R6G和4-MBA具有良好的拉曼光谱增强性能。     

Understanding implications of consumer behavior for wildlife farming and sustainable wildlife trade

Unsustainable wildlife trade affects biodiversity and the livelihoods of communities dependent upon those resources. Wildlife farming has been proposed to promote sustainable trade, but characterizing markets and understanding consumer behavior remain neglected but essential steps in the design and evaluation of such operations. We used sea turtle trade in the Cayman Islands, where turtles have been farm raised for human consumption for almost 50 years, as a case study to explore consumer preferences toward wild‐sourced (illegal) and farmed (legal) products and potential conservation implications. Combining methods innovatively (including indirect questioning and choice experiments), we conducted a nationwide trade assessment through in‐person interviews from September to December 2014. Households were randomly selected using disproportionate stratified sampling, and responses were weighted based on district population size. We approached 597 individuals, of which 37 (6.2%) refused to participate. Although 30% of households had consumed turtle in the previous 12 months, the purchase and consumption of wild products was rare (e.g., 64–742 resident households consumed wild turtle meat [i.e., 0.3–3.5% of households] but represented a large threat to wild turtles in the area due to their reduced populations). Differences among groups of consumers were marked, as identified through choice experiments, and price and source of product played important roles in their decisions. Despite the long‐term practice of farming turtles, 13.5% of consumers showed a strong preference for wild products, which demonstrates the limitations of wildlife farming as a single tool for sustainable wildlife trade. By using a combination of indirect questioning, choice experiments, and sales data to investigate demand for wildlife products, we obtained insights about consumer behavior that can be used to develop conservation‐demand‐focused initiatives. Lack of data from long‐term social–ecological assessments hinders the evaluation of and learning from wildlife farming. This information is key to understanding under which conditions different interventions (e.g., bans, wildlife farming, social marketing) are likely to succeed.     

Mainstreaming human and large carnivore coexistence through institutional collaboration

Achieving coexistence between large carnivores and humans in human-dominated landscapes (HDLs) is a key challenge for societies globally. This challenge cannot be adequately met with the current sectoral approaches to HDL governance and an academic community largely dominated by disciplinary sectors. Academia (universities and other research institutions and organizations) should take a more active role in embracing societal challenges around conservation of large carnivores in HDLs by facilitating cross-sectoral cooperation to mainstream coexistence of humans and large carnivores. Drawing on lessons from populated regions of Europe, Asia, and South America with substantial densities of large carnivores, we suggest academia should better embrace the principles and methods of sustainability sciences and create institutional spaces for the implementation of transdisciplinary curricula and projects; reflect on research approaches (i.e., disciplinary, interdisciplinary, or transdisciplinary) they apply and how their outcomes could aid leveraging institutional transformations for mainstreaming; and engage with various institutions and stakeholder groups to create novel institutional structures that can respond to multiple challenges of HDL management and human–large carnivore coexistence. Success in mainstreaming this coexistence in HDL will rest on the ability to think and act cooperatively. Such a conservation achievement, if realized, stands to have far-reaching benefits for people and biodiversity.     

Interinstrument comparison of remote-sensing devices and a new method for calculating on-road nitrogen oxides emissions and validation of vehicle-specific power

Emissions of nitrogen oxides (NOx) by vehicles in real driving environments are only partially understood. This has been brought to the attention of the world with recent revelations of the cheating of the type of approval tests exposed in the dieselgate scandal. Remote-sensing devices offer investigators an opportunity to directly measure in situ real driving emissions of tens of thousands of vehicles. Remote-sensing NO₂ measurements are not as widely available as would be desirable. The aim of this study is to improve the ability of investigators to estimate the NO₂ emissions and to improve the confidence of the total NOx results calculated from standard remote-sensing device (RSD) measurements. The accuracy of the RSD speed and acceleration module was also validated using state-of-the-art onboard global positioning system (GPS) tracking. Two RSDs used in roadside vehicle emissions surveys were tested side by side under off-carriageway conditions away from transient pollution sources to ascertain the consistency of their measurements. The speed correlation was consistent across the range of measurements at 95% confidence and the acceleration correlation was consistent at 95% confidence intervals for all but the most extreme acceleration cases. VSP was consistent at 95% confidence across all measurements except for those at VSP ≥ 15 kW t^?1, which show a small underestimate. The controlled distribution gas nitric oxide measurements follow a normal distribution with 2σ equal to 18.9% of the mean, compared to 15% observed during factory calibration indicative of additional error introduced into the system. Systematic errors of +84 ppm were observed but within the tolerance of the control gas. Interinstrument correlation was performed, with the relationship between the FEAT and the RSD4600 being linear with a gradient of 0.93 and an R² of 0.85, indicating good correlation. A new method to calculate NOx emissions using fractional NO₂ combined with NO measurements made by the RSD4600 was constructed, validated, and shown to be more accurate than previous methods.

Implications: Synchronized remote-sensing measurements of NO were taken using two different remote-sensing devices in an off-road study. It was found that the measurements taken by both instruments were well correlated. Fractional NO₂ measurements from a prior study, measurable on only one device, were used to create new NO_x emission factors for the device that could not be measured by the second device. These estimates were validated against direct measurement of total NO_x emission factors and shown to be an improvement on previous methodologies. Validation of vehicle-specific power was performed with good correlation observed.     

Comparison on surface properties and desulfurization of MnO2 and pyrolusite blended activated carbon by steam activation

In this study, MnO₂ and pyrolusite were used as the catalysts to prepare modified activated carbon, that is, AC-Mn and AC-P, respectively, from coals by blending method and steam activation. The Brunauer–Emmett–Teller (BET) results indicated that the AC-P had higher surface areas and micropore volumes than the AC-Mn with the same blending ratio. The relative contents of basic functional groups (i.e., C = O, π-π*) on AC-P were slightly lower than those on AC-Mn, while both contained the same main metal species, namely, MnO. The desulfurization results showed that with 3 wt% of blending ratio, AC-Mn3 and AC-P3 had higher sulfur capacities at 220 and 205 mg/g, respectively, which were much higher than for the blank one (149.6 mg/g). Moreover, the AC-P had relatively higher sulfur capacity than the AC-Mn with the same contents of Mn, which might be attributed to the existence of other metals in pyrolusite. After the desulfurization process, MnO were gradually transferred into MnSO₄, and the relative contents of basic functional groups decreased evidently for both AC-Mn3 and AC-P3. The results demonstrated that pyrolusite could be one good alternative to MnO₂ to prepare modified activated carbon for desulfurization.

Implications: MnO₂ and pyrolusite were used as the additives to prepare modified activated carbon from coals by a blending method and by steam activation, that is, AC-Mn and AC-P, respectively. The AC-P had higher surface areas and micropore volumes than the AC-Mn with the same blending ratio. The AC-Mn and AC-P had higher sulfur capacities than a blank one. Moreover, the AC-P had relatively higher sulfur capacity than the AC-Mn with the same contents of Mn. The results demonstrated that pyrolusite could be one good alternative to MnO₂ to prepare modified activated carbon for desulfurizatio.     

Characteristic and mechanism of sorption and desorption of benzene on humic acid

Environmental Science and Pollution Research - The sorption/desorption behaviors of benzene, toluene, ethylbenzene, and xylene (BTEX) on soil organic matter (SOM) have a significant influence on...     

FAHP法在污泥板框调理剂综合评价中的应用

提出了一种新的污泥板框调理剂综合评价方法。传统的CST(毛细吸水时间)、污泥比阻、泥饼含水率等指标只能单一地评价泥饼脱水效果,为了实现对调理效果的综合评价,需要考虑药剂调理费用、运输处置成本、设备处理产能、滤液处理难度等多种因素。通过长期采集中试运行数据,考察了3种污泥板框调理剂对设备、泥饼、滤液和运行4个方面17个指标的影响。引入层次分析法和模糊数学综合评价法相结合的模糊层次分析法(FAHP)对3种污泥板框调理剂进行了综合评价,采用层次分析法确定指标权重;采用隶属函数对指标进行无量纲化处理,确定其隶属度,解决了指标间的可综合性问题;最后用加权平均法得出评价综合值,综合评价值表明,在这3种调理剂中,调理剂1的综合效果最优,更适合作为该厂的污泥板框脱水调理剂。