B-type esterases in the snail Xeropicta derbentina: an enzymological analysis to evaluate their use as biomarkers of pesticide exposure

The study was prompted to characterize the B-type esterase activities in the terrestrial snail Xeropicta derbentina and to evaluate its sensitivity to organophosphorus and carbamate pesticides. Specific cholinesterase and carboxylesterase activities were mainly obtained with acetylthiocholine (K_m = 77.2 mM; V_max = 38.2 mU/mg protein) and 1-naphthyl acetate (K_m = 222 mM, V_max = 1095 mU/mg protein) substrates, respectively. Acetylcholinesterase activity was concentration-dependently inhibited by chlorpyrifos-oxon, dichlorvos, carbaryl and carbofuran (IC50 = 1.35 × 10⁻⁵-3.80 × 10⁻⁸ M). The organophosphate-inhibited acetylcholinesterase activity was reactivated in the presence of pyridine-2-aldoxime methochloride. Carboxylesterase activity was inhibited by organophosphorus insecticides (IC50 = 1.20 × 10⁻⁵-2.98 × 10⁻⁸ M) but not by carbamates. B-esterase-specific differences in the inhibition by organophosphates and carbamates are discussed with respect to the buffering capacity of the carboxylesterase to reduce pesticide toxicity. These results suggest that B-type esterases in X. derbentina are suitable biomarkers of pesticide exposure and that this snail could be used as sentinel species in field monitoring of Mediterranean climate regions.     

Field Evidence of Dissolution and Degradation Rates Enhancement During ISCR and ENA Treatments of Chlorinated Solvents

This article presents field tests comparing two methods of treatment of chlorinated solvents undertaken at the same site. The site is an automobile factory where two chlorinated solvents (CS) plumes were identified. At the first source, in situ chemical reduction (ISCR) was applied, while at the second one, enhanced natural attenuation (ENA) was used. A set of specific multilevel sampling wells were installed approximately 20 m downgradient of the sources to estimate the efficiency of the treatments. The presence of a low‐permeability layer (source 1) or a thick oil lens (source 2) in the top part of the aquifer prevented the CS from reaching the bottom of the aquifer. These layers led to difficulties treating the contamination. At the ISCR and ENA treatment zones, the concentrations of tetrachloroethene (PCE) and trichloroethene (TCE) did not change significantly, while the concentration of metabolites (cis‐1,2‐DCE, vinyl chloride, and ethene) significantly increased 50 to 150 days after treatment. Due to high concentration of CS in the source zone, a mass balance calculation, including chlorine, was possible. It showed that around 1 to 2 percent of the injected products were used to reduce the CS. A detailed analysis and 1D analytical modeling of CS concentrations showed that the treatment led to a large (two to three times) increase in dissolution of the organic phase. This explains why, despite an efficient treatment, the PCE and TCE concentrations remained virtually unchanged. Degradation rates also increased due to the treatment. Due to some differences in the source‐zone chemistry, it was not possible to differentiate between the ISCR and ENA efficiencies. © 2013 Wiley Periodicals, Inc.     

Effect of the herbicide flumioxazin on photosynthetic performance of grapevine (Vitis vinifera L.)

Among the herbicides used in vineyards, the pre-emergence soil-applied flumioxazin (fmx) is a recently used molecule that inhibits chlorophyll biosynthesis in weed species. The aim of this work is to further characterize the effects of fmx on the non-target grapevine (Vitis vinifera L. cv. Chardonnay) using cutting as a model. Several photosynthesis parameters were estimated during 25 days after treatment with various fmx concentrations (from 0.5mM to 50mM). Measuring chlorophyll fluorescence it appeared that fmx or a by-product penetrated the plant throughout roots and spread throughout vessels. Besides the initial target, protox, fmx affected other functions related to photosynthesis. Fmx induced a simultaneous drop of both P(n), g(s) and T. Fmx caused stomatal closure, which partially explains the decrease of the net photosynthesis. The decline in F(v)/F(m) indicates that the photochemistry of PSII and its ability to reduce the primary acceptor Q(A) are also affected by fmx in grapevine. Fmx leads to a decrease in the coefficients of both photochemical and non-photochemical quenching. Simultaneous stomatal closure and decrease in the quantum yield of CO(2) assimilation indicate a change in energy metabolism following fmx stress. After ten days of fmx treatment, analyses of the response of net carbon assimilation in leaves to different intercellular CO(2) concentrations have shown a decrease of the maximum carboxylation velocity of RuBP. Stomatal closure, PSII photochemistry, change in energy metabolism and RuBP activity were affected by fmx treatment.     

Acetochlor mineralization and fate of its two major metabolites in two soils under laboratory conditions

The degradation of the herbicide acetochlor, in a neoluvisol and in a calcosol were studied as a function of depth (0-25cm and 25-50cm) and temperature (25 degrees C and 15 degrees C) under controlled laboratory conditions during 58 and 90 days, respectively. The surface and sub-surface soil samples were respectively spiked with 1 and 0.01mgkg(-1) of 14C-acetochlor, the concentrations observed in previous field monitoring. The half-lives (DT50) varied from 1.4 to 14.9 days depending on the soil, temperature and applied concentration. The maximal mineralization (24%) was observed for the surface calcosol at 25 degrees C. The comparison of results obtained for sterilized and non-sterilized soils, the decrease of DT50 with the increase of temperature, the shape of CO2 emissions and the increase of number of aerobic endogenous microflora through the experiment suggested that biological process are dominant in degradation. A particular attention was paid to the formation and dissipation of metabolites ESA (ethanesulphonic acid) and OA (oxanilic acid) during the whole experiment. At 25 degrees C, ESA and OA were observed after three days, but as ESA concentration decreased over time in surface calcosol, it remained constant in surface neoluvisol. A difference in ESA/OA ratio depends on the soil with a predominance of OA in surface neoluvisol and a disappearance of OA in surface calcosol.     

From environmental data acquisition to assessment of gardeners’ exposure: feedback in an urban context highly contaminated with metals

Environmental Science and Pollution Research - Although growing vegetables in urban gardens has several benefits, some questions in relation with the safety of foods remain when the self-production...     

Can Offshore Wind Energy Be a Lever for Job Creation in France? Some Insights from a Local Case Study

The French government has launched three separate calls for tender in July 2011, March 2013, and December 2016 to install 3.5 GW of offshore wind. In addition to contributing to the fulfillment of environmental commitments, the deployment of offshore wind energy is expected to be a lever for economic development. To assess gross economic impacts, mainly in terms of job creation, we built a regional input-output model of the wind farm off Saint-Brieuc located in the region of Brittany, north-western France. Our model indicates that the project will have positive effects on Brittany’s economy. In particular, during the investment phase, the wind farm is expected to lead to €0.38 M/year/MW of added value and 6.03 full-time equivalent (FTE) jobs/year/MW. During the operation and maintenance (O&M) phase, the model predicts the generation of €0.15 M/year/MW of added value and 1.02 FTE jobs/year/MW. These results imply that the project will increase Brittany’s GDP slightly by 0.22 and 0.09% during the investment and O&M phases, respectively. Results also show that out of total wealth created in France, 38 and 66% will be created in Brittany as well as 32 and 51% of employment during respectively investment and O&M phases. A comparative analysis highlights in particular that economic impacts are generally stronger during the investment phase. It also demonstrates that the magnitude of economic impacts depends on the proportion of local industries in the supply chain. Policy implications of our model stress the need to revise the economic, technological, regulatory, and social frameworks within which the offshore wind industry currently operates in France to establish the conditions necessary for its development.     

Release of particles and metals into seawater following sediment resuspension of a coastal mine tailings disposal off Portmán Bay,Southern Spain

Environmental Science and Pollution Research - Portmán Bay in Southern Spain is one of the most extreme cases in Europe of anthropogenic impact on the marine ecosystem by the disposal of mine...     

Development of a standardized in vitro approach to evaluate microphysical, chemical, and toxicological properties of combustion-derived fine and ultrafine particles

Ultrafine particles represent a growing concern in the public health community but their precise role in many illnesses is still unknown. This lack of knowledge is related to the experimental difficulty in linking their biological effects to their multiple properties, which are important determinants of toxicity. Our aim is to propose an interdisciplinary approach to study fine(FP) and ultrafine(UFP) particles, generated in a controlled manner using a mini CAST(Combustion Aerosol Standard) soot ...     

Using data mining to predict soil quality after application of biosolids in agriculture

The amount of biosolids recycled in agriculture has steadily increased during the last decades. However, few models are available to predict the accompanying risks, mainly due to the presence of trace element and organic contaminants, and benefits for soil fertility of their application. This paper deals with using data mining to assess the benefits and risks of biosolids application in agriculture. The analyzed data come from a 10-yr field experiment in northeast France focusing on the effects of biosolid application and mineral fertilization on soil fertility and contamination. Biosolids were applied at agriculturally recommended rates. Biosolids had a significant effect on soil fertility, causing in particular a persistent increase in plant-available phosphorus (P) relative to plots receiving mineral fertilizer. However, soil fertility at seeding and crop management method had greater effects than biosolid application on soil fertility at harvest, especially soil nitrogen (N) content. Levels of trace elements and organic contaminants in soils remained below legal threshold values. Levels of extractable metals correlated more strongly than total metal levels with other factors. Levels of organic contaminants, particularly polycyclic aromatic hydrocarbons, were linked to total metal levels in biosolids and treated soil. This study confirmed that biosolid application at rates recommended for agriculture is a safe option for increasing soil fertility. However, the quality of the biosolids selected has to be taken into account. The results also indicate the power of data mining in examining links between parameters in complex data sets.