Minimization of the formation of disinfection by-products

The drinking water industry is required to minimize DBPs levels while ensuring adequate disinfection. In this study, efficient and appropriate treatment scheme for the reduction of disinfection by-product (DBPs) formation in drinking water containing natural organic matter has been established. This was carried out by the investigation of different treatment schemes consisting of enhanced coagulation, sedimentation, disinfection by using chlorine dioxide/ozone, filtration by sand filter, or granular activated carbon (GAC). Bench scale treatment schemes were applied on actual samples from different selected sites to identify the best conditions for the treatment of water. Samples were collected from effluent of each step in the treatment train in order to analyze pH, UV absorbance at 254 nm (UVA₂₅₄), specific UV absorbance at 254 nm (SUVA₂₅₄), dissolved organic carbon (DOC), haloacetic acids (HAAs) and trihalomethanes (THMs). The obtained results indicated that using pre-ozonation/enhanced coagulation/activated carbon filtration treatment train appears to be the most effective method for reducing DBPs precursors in drinking water treatment.     

Seasonal characteristics of chemically apportioned aerosol optical properties at Seoul and Gosan,Korea

Seasonal variations of aerosol optical properties in Seoul (polluted urban site) and Gosan (coastal background site), Korea, with an emphasis on the relative humidity were investigated using ground-based aerosol measurements and optical model calculations. The mass fraction of elemental carbon was 9–20%, but the optical contribution of these particles to light extinction was higher, up to 33–55% in Seoul. In Gosan, the contribution of non-sea-salt water-soluble aerosols on extinction was 81–93% due to the high mass fraction of these particles. Based on daily MODIS datasets, our analysis showed that the aerosol optical depths at Seoul and Gosan were highest in spring due to the influence of dust particles. The aerosol water content at Gosan, calculated using a thermodynamic equilibrium model, was higher than that at Seoul; this was attributed to the high relative humidity and high fraction of water-soluble aerosols at Gosan. At Seoul, despite abundant water vapors in summer, the possibility of hygroscopic growth of water-soluble aerosols was not more significant than that at Gosan.     

Temporal and geographical genetic variation in the amphipod Melita plumulosa (Crustacea: Melitidae): Link of a localized change in haplotype frequencies to a chemical spill

Anthropogenic effects such as contamination affect the genetic structure of populations. This study examined the temporal and geographical patterns of genetic diversity among populations of the benthic crustacean amphipod Melita plumulosa in the Parramatta River (Sydney, Australia), following an industrial chemical spill. The spill of an acrylate/methacrylate co-polymer in naphtha solvent occurred in July 2006. M. plumulosa were sampled temporally between December 2006 and November 2009 and spatially in November 2009. Genetic variation was examined at the mitochondrial cytochrome c oxidase subunit I locus. Notably, nucleotide diversity was low and Tajima’s D was significantly negative amongst amphipods collected immediately downstream from the spill for 10 months. We hypothesize that the spill had a significant localized effect on the genetic diversity of M. plumulosa. Alternate explanations include an alternate and unknown toxicant or a localized sampling bias. Future proposed studies will dissect these alternatives.     

Photocatalytic bacterial inactivation by polyoxometalates

The photocatalytic inactivation (PCI) of Escherichia coli (Gram-negative) and Bacillus subtilis (Gram-positive) was performed using polyoxometalate (POM) as a homogeneous photocatalyst and compared with that of heterogeneous TiO₂ photocatalyst. Aqueous suspensions of the microorganisms (10⁷–10⁸ cfu ml⁻¹) and POM (or TiO₂) were irradiated with black light lamps. The POM-PCI was faster than (or comparable to) TiO₂-PCI under the experimental conditions employed in this study. The relative efficiency of POM-PCI was species-dependent. Among three POMs (H₃PW₁₂O₄₀, H₃PMo₁₂O₄₀, and H₄SiW₁₂O₄₀) tested in this study, the inactivation of E. coli was fastest with H₄SiW₁₂O₄₀ while that of B. subtilis was the most efficient with H₃PW₁₂O₄₀. Although the biocidal action of TiO₂ photocatalyst has been commonly ascribed to the role of photogenerated reactive oxygen species such as hydroxyl radicals and superoxides, the cell death mechanism with POM seems to be different from TiO₂-PCI. While TiO₂ caused the cell membrane disruption, POM did not induce the cell lysis. When methanol was added to the POM solution, not only the PCI of E. coli was enhanced (contrary to the case of TiO₂-PCI) but also the dark inactivation was observed. This was ascribed to the in situ production of formaldehyde from the oxidation of methanol. The interesting biocidal property of POM photocatalyst might be utilized as a potential disinfectant technology.     

Background levels and dietary intake of PCDD/Fs in domestic and imported meat in South Korea

A survey was conducted in South Korea to determine residual levels and dietary intake of polychlorinated dibenzo-p-dioxins (PCDDs) and dibenzofurans (PCDFs) from meat. Altogether 119 domestic and 164 imported samples of beef, pork, and chicken were examined. The mean levels of PCDD/Fs in upper bound were 0.21, 0.22, and 0.04pg WHO-TEQ/g fat for beef, pork, and chicken, respectively. The low level of PCDD/Fs in chicken probably resulted from the low fat content in the samples used. The samples were separated into domestic and imported products in order to investigate the sources of contamination. PCDFs were the more dominant congeners in domestic beef and were similar to those found from emission of incineration. However, the congener profiles of domestic beef and incineration were difficult to compare because the environmental fate and animal metabolism were involved. The upper bound dietary intake of PCDD/Fs from beef, pork and chicken was calculated to be 0.04pg/WHO-TEQ/kgbw/day. The combined consumption of beef, pork, and chicken was found to be 84.8g per day for a person weighing 60kg and represented 5.7% of their total daily food intake.     

Characteristics of aerosol types during large-scale transport of air pollution over the Yellow Sea region and at Cheongwon,Korea, in 2008

Episodes of large-scale transport of airborne dust and anthropogenic pollutant particles from different sources in the East Asian continent in 2008 were identified by National Oceanic and Atmospheric Administration satellite RGB (red, green, and blue)-composite images and the mass concentrations of ground level particulate matter. These particles were divided into dust, sea salt, smoke plume, and sulfate by an aerosol classification algorithm. To analyze the aerosol size distribution during large-scale transport of atmospheric aerosols, aerosol optical depth (AOD) and fine aerosol weighting (FW) of moderate imaging spectroradiometer aerosol products were used over the East Asian region. Six episodes of massive airborne dust particles, originating from sandstorms in northern China, Mongolia, and the Loess Plateau of China, were observed at Cheongwon. Classified dust aerosol types were distributed on a large-scale over the Yellow Sea region. The average PM10 and PM2.5 ratio to the total mass concentration TSP were 70% and 15%, respectively. However, the mass concentration of PM2.5 among TSP increased to as high as 23% in an episode where dust traveled in by way of an industrial area in eastern China. In the other five episodes of anthropogenic pollutant particles that flowed into the Korean Peninsula from eastern China, the anthropogenic pollutant particles were largely detected in the form of smoke over the Yellow Sea region. The average PM10 and PM2.5 ratios to TSP were 82% and 65%, respectively. The ratio of PM2.5 mass concentrations among TSP varied significantly depending on the origin and pathway of the airborne dust particles. The average AOD for the large-scale transport of anthropogenic pollutant particles in the East Asian region was measured to be 0.42 ± 0.17, which is higher in terms of the rate against atmospheric aerosols as compared with the AOD (0.36 ± 0.13) for airborne dust particles with sandstorms. In particular, the region ranging from eastern China, the Yellow Sea, and the Korean Peninsula to the Korea East Sea was characterized by high AOD distributions. In the episode of anthropogenic polluted aerosols, FW averaged 0.63 ± 0.16, a value higher than that in the episode of airborne dust particles (0.52 ± 0.13) with sandstorms, showing that fine anthropogenic pollutant particles contribute greatly to atmospheric aerosols in East Asia.     

Effect of soil moisture dynamics on dense nonaqueous phase liquid (DNAPL) spill zone architecture in heterogeneous porous media

The amount, location, and form of NAPL in contaminated vadose zones are controlled by the spatial distribution of water saturation and soil permeability, the NAPL spill scenario, water infiltration events, and vapor transport. To evaluate the effects of these processes, we used the three-phase flow simulator STOMP, which includes a new permeability-liquid saturation-capillary pressure (k-S-P) constitutive model. This new constitutive model considers three NAPL forms: free, residual, and trapped. A 2-D vertical cross-section with five stratigraphic layers was assumed, and simulations were performed for seven cases. The conceptual model of the soil heterogeneity was based upon the stratigraphy at the Hanford carbon tetrachloride (CT) spill site. Some cases considered co-disposal of NAPL with large volumes of wastewater, as also occurred at the Hanford CT site. In these cases, the form and location of NAPL were most strongly influenced by high water discharge rates and NAPL evaporation to the atmosphere. In order to investigate the impact of heterogeneity, the hydraulic conductivity within the lower permeability layer was modeled as a realization of a random field having three different classes. For six extreme cases of 100 realizations, the CT mass that reached the water table varied by a factor of two, and was primarily controlled by the degree of lateral connectivity of the low conductivity class within the lowest permeability layer. The grid size at the top boundary had a dramatic impact on NAPL diffusive flux just after the spill event when the NAPL was present near the ground surface. NAPL evaporation with a fine grid spacing at the top boundary decreased CT mass that reached the water table by 74%, compared to the case with a coarse grid spacing, while barometric pumping had a marginal effect for the case of a continuous NAPL spill scenario considered in this work. For low water infiltration rate scenarios, the distribution of water content prior to a NAPL spill event decreased CT mass that reached the water table by 98% and had a significant impact on the formation of trapped NAPL. For all cases simulated, use of the new constitutive model that allows the formation of residual NAPL increased the amount of NAPL retained in the vadose zone. Density-driven advective gas flow from the ground surface controlled vapor migration in strongly anisotropic layers, causing NAPL mass flux to the lower layer to be reduced. These simulations indicate that consideration of the formation of residual and trapped NAPLs and dynamic boundary conditions (e.g., areas, rates, and periods of different NAPL and water discharge and fluctuations of atmospheric pressure) in the context of full three-phase flow are needed, especially for NAPL spill events at the ground surface. In addition, NAPL evaporation, density-driven gas advection, and NAPL vertical movement enhanced by water flow must be considered in order to predict NAPL distribution and migration in the vadose zone.     

Effectiveness of compacted soil liner as a gas barrier layer in the landfill final cover system

A compacted soil liner (CSL) has been widely used as a single barrier layer or a part of composite barrier layer in the landfill final cover system to prevent water infiltration into solid wastes for its acceptable hydraulic permeability. This study was conducted to test whether the CSL was also effective in prohibiting landfill gas emissions. For this purpose, three different compaction methods (i.e., reduced, standard, and modified Proctor methods) were used to prepare the soil specimens, with nitrogen as gas, and with water and heptane as liquid permeants. Measured gas permeability ranged from 2.03x10(-10) to 4.96x10(-9)cm(2), which was a magnitude of two or three orders greater than hydraulic permeability (9.60x10(-13) to 1.05x10(-11)cm(2)). The difference between gas and hydraulic permeabilities can be explained by gas slippage, which makes gas more permeable, and by soil-water interaction, which impedes water flow and then makes water less permeable. This explanation was also supported by the result that a liquid permeability measured with heptane as a non-polar liquid was similar to the intrinsic gas permeability. The data demonstrate that hydraulic requirement for the CSL is not enough to control the gas emissions from a landfill.     

Toxicity of carbaryl,diquat dibromide,and fluoranthene,individually and in mixture,to larval grass shrimp,Palaemonetes pugio

This study examined the toxicity of two pesticides (carbaryl and diquat dibromide) and one polycyclic aromatic hydrocarbon (fluoranthene), both singly and in mixture, to grass shrimp larvae (Palaemonetes pugio). These three chemicals are all present in coastal environments and can easily enter estuarine ecosystems. Fluoranthene was the most toxic chemical with a 96-h LC₅₀ value of 32.45 μ g/L, followed by carbaryl (43.02 μ g/L) and diquat dibromide (1624 μ g/L). In the chemical mixture tests, the binary carbaryl/diquat dibromide mixture and the ternary carbaryl/diquat dibromide/fluoranthene mixture had additive results.