基于SPIS的月球表面充电模拟研究

目的研究月球表面不同等离子体环境下航天器表面充放电效应情况。方法利用欧空局开发的SPIS软件建模,并仿真模拟,通过分析表面电流种类、大小,得出不同环境下的一般性的充放电规律。结果月球表面探测器存在表面充电风险,磁鞘层、磁尾瓣、等离子体片及太阳风4种不同典型等离子体环境下表面充电电位差异较大,连接处充电电位存在分布不均匀的渐变现象。表面充电电位区间约为-1784~142 V。结论光照条件能显著影响探测器表面电位,特殊区域充电电位会受到临近区域充放电效应形成的新的小范围等离子体环境的影响。     

基于静止卫星GOCI传感器的大气污染过程AOD监测

针对北京及周边地区2017年11月2~8日的一次污染过程,利用韩国静止卫星COMs1GOCI数据,对北京地区进行AOD监测.AOD反演采用时间序列迭代算法,根据地表反射率随时间慢变而大气气溶胶随时间快变的理论,采取最小值拟合的方式,获取气溶胶光学厚度数据.反演结果与地基AERONET监测结果具有很好的一致性,两者的相关系数R²大于0.89.AOD监测结果表明,GOCI传感器1次/h的监测频率,可以很好地展现北京地区大气污染过程的开始,发展及消散过程,可以展示出一天之内AOD的变化,为大气污染监测以及气候变化研究提供依据.     

Nanoencapsulation of hexavalent chromium with nanoscale zero-valent iron: High resolution chemical mapping of the passivation layer

Solid phase reactions of Cr(Ⅵ) with Fe(0) were investigated with spherical-aberration-corrected scanning transmission electron microscopy(Cs-STEM) integrated with X-ray energy-dispersive spectroscopy(XEDS). Near-atomic resolution elemental mappings of Cr(Ⅵ)–Fe(0) reactions were acquired. Experimental results show that rate and extent of Cr(Ⅵ) encapsulation are strongly dependent on the initial concentration of Cr(Ⅵ) in solution. Low Cr loading in nZⅥ(1.0 wt%) promotes the electrochemical oxidation and continuous corrosion of n ZⅥ while high Cr loading(1.0 wt%) can quickly shut down the Cr uptake. With the progress of iron oxidation and dissolution, elements of Cr and O counter-diffuse into the nanoparticles and accumulate in the core region at low levels of Cr(Ⅵ)(e.g., 10 mg/L). Whereas the reacted n ZⅥ is quickly coated with a newly-formed layer of 2–4 nm in the presence of concentrated Cr(Ⅵ)(e.g., 100 mg/L). The passivation structure is stable over a wide range of pH unless pH is low enough to dissolve the passivation layer. X-ray photoelectron spectroscopy(XPS) depth profiling reconfirms that the composition of the newly-formed surface layer consists of Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxides with Cr(Ⅵ) adsorbed on the outside surface. The insoluble and insulating Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxide layer can completely cover the n ZⅥ surface above the critical Cr loading and shield the electron transfer. Thus, the fast passivation of nZⅥ in high Cr(Ⅵ) solution is detrimental to the performance of nZⅥ for Cr(Ⅵ) treatment and remediation.     

Relationship between physicochemical properties and dewaterability of hydrothermal sludge derived from different source

Sewage sludge (SS) and deinking sludge (DS) were used to comparatively study the hydrothermal dewatering of sludge with different components. For a better overview, an insight into the relationship between physicochemical properties and dewaterability of hydrothermal sludge was provided. Results found that not all kinds of sludge were suitably conditioned by hydrothermal treatment (HT) in term of the elevation of dewaterability. Higher hydrothermal temperature tended to enhance the dewaterability of SS rather than DS, which was supported by the variation of their physicochemical properties (including water distribution, bonding energy, extracellular polymeric substance (EPS), particles size, acid functional groups and zeta potential in this study). In addition, the changes in surface morphology suggested that the reverse effect of HT on sludge dewaterability was mainly due to their dewatering behavior. For SS, the destruction of EPS structure leaded to the release of bound water, thereby strengthening sludge dewatering. Conversely, “Bridging effect” generated by lignocellulose in DS was beneficial for sludge dewatering; however, the increasing hydrothermal temperature degraded part of lignocellulose and weakened “bridging effect”, finally resulting in worse dewaterability of DS.     

Ecotoxicity evaluation of Cu- and Fe-CNT complexes based on the activity of bacterial bioluminescence and seed germination

The toxic effects of the composites of Fe~0 and Cu~0 with different percentages of CNTs were examined based on the activity of bacterial bioluminescence and seed germination. In terms of the EC_50 values, the toxic effects of Cu~0 on bacterial bioluminescence and seed germination were approximately 2 and 180 times greater than that of Fe~0, respectively. The toxicity increased with increasing CNT content in the Cu-CNT mixtures for both organisms,whereas opposite results were observed with Fe-CNT mixtures. The mean toxic effects of Cu-CNT(6%) were approximately 1.3–1.4 times greater than that of Cu-CNT(0%), whereas the toxic effects of Fe-CNT(6%) were approximately 2.1–2.5 times lower than that of Fe-CNT(0%) for both the bioluminescence activity and seed germination. The causes of this phenomenon are unclear at this point. More research will be needed to elucidate the mechanism of the toxicity of nano-mixture materials and the causes of the different patterns of toxicity with Cu-and Fe-CNT mixtures.     

基于SOM-SVM组合分类器的涂层防护性能研究

目的为避免EIS,EN技术可能出现的问题,建立一个准确、高效的评价模型,以探究现役军用有机涂层防护性能。方法利用电化学阻抗谱(EIS)、电化学噪声(EN)技术分析了两种军车有机涂层在循环暴露试验中的腐蚀行为,提取低频阻抗模值|Z|_(0.1 Hz)与涂层噪声电阻R_n两种电化学评价参数作为自组织神经网络(SOM)的输入训练样本,同时结合支持向量机(SVM)方法建立涂层防护性能组合分类器。结果将涂层失效过程自适应地分为涂层防护性能良好、防护性能下降、基本失效三个阶段。结论所建立的SOM-SVM组合分类器对于辅助分析涂层防护性能具有可行性。     

水稻土中五氯酚的降解转化动态及其对微生物群落的影响

采用室内培养实验,研究厌氧条件下水稻土中五氯酚(Pentachlorophenol,PCP)的还原转化与微生物群落组成变化。结果表明,室内培养实验条件下,PCP在水稻土样品中降解比较迅速,在反应17 d时,实验添加的PCP能够完全被还原转化。高通量测序结果显示PCP的添加明显改变了水稻土壤的微生物群落结构,其微生物多样性显著下降,在PCP降解完之后逐渐恢复。原始土壤以及添加PCP的土壤样品中其优势微生物主要分布在变形菌门(Proteobacteria)。PCP添加刺激了水稻土中伯克氏菌科(Burkholderiaceae)、丛毛单胞菌科(Comamonadaceae)、地杆菌科(Geobacteraceae)、红环菌科(Rhodocyclaceae)和假单胞菌科(Pseudomonadaceae)等脱氯相关的微生物菌群繁殖,成为PCP降解过程中的优势菌群,有利于PCP还原降解。本研究结果可为水稻土中有机氯农药污染物的微生物降解脱毒提供理论依据。     

小流域综合治理新设计研究——猪沼果模式

近年来,小流域综合治理的主旨思想改变了,其工作重心在于巩固和发展治理开发的成果,提升综合治理的科技含量,增加治理带来的经济效益。于是将小流域的治理与生产联系起来成为了当前科研人员的研究方向。文章对目前部分地区大力推广的"猪-沼-果"模式在小流域治理方面的概念、发展及综合效益等方面做了一些综述。总的来说,猪沼果模式能够增加农村的能源,增加农民收入,并保护绿植,促进小流域治理。     

基于医疗大数据的空气污染类疾病信息分析研究

世界卫生组织表示,空气污染为造成全球疾病负担的一项重要因素,能够导致心血管疾病、呼吸系统疾病等各种疾病的发生,空气污染问题已经成为公共卫生领域关注的重点问题,对基于医疗大数据的空气污染类疾病信息进行分析。利用半参数广义相加的泊松回归模型,在控制时间、长期趋势、气象因素等一些复杂条件的基础上,对2012年1月1日至2016年12月31日,某市空气中SO2、PM10和NO2等一些主要空气污染物的监测浓度值与呼吸系统疾病(肺炎以及支气管炎与哮喘)住院人数的相关性进行研究,研究结果表明,空气颗粒物PM10对患病率的影响相对于气态污染物SO2、NO2更为严重。     

盐酸萘乙二胺比色法测定大气中硝基苯、苯胺浓度的改进

本文探讨了盐酸萘乙二胺比色方法测定大气中硝基苯、苯胺浓度的最佳反应条件,如酸度、试剂加入量、反应温度、反应时间等。简化了过滤、洗涤操作,精密度高、显色稳定。