La2O3-CeO2/γ-Al2O3催化剂还原脱硫耐氧特性及其反应机理研究

用浸渍法制备了一系列稀土催化剂,研究了其催化CO还原SO2为单质硫的耐氧特性及影响其耐氧性能的主要因素,运用XRD技术分析了催化剂物相的变化及脱硫产物成分.结果表明,12% La2O3-8% CeO2/γ-Al2O3复组分催化剂比其他La2O3-CeO2/γ-Al2O3催化剂具有更好的耐氧性能;脱硫温度、催化剂用量、SO2与CO的摩尔比等对催化剂的耐氧性能均有明显的影响.最后,探讨了稀土催化剂脱硫机理,并分析在有O2条件下,引起脱硫率下降的原因是反应过程中O2与CO、S发生了竞争性反应.     

氟苯胺好氧生物降解性能的研究

利用驯化污泥研究了邻氟苯胺、对氟苯胺、2,4-二氟苯胺的好氧生物降解性能.结果表明,3种氟苯胺的好氧生物降解性能从高到低依次为对氟苯胺、邻氟苯胺和2,4-二氟苯胺.降解动力学分析表明,除2,4-二氟苯胺在实验质量浓度8.56 mg/L时为一级反应,其他为零级反应;且它们的降解规律都符合Monod方程;30 ℃、振荡速率140 r/min为氟苯胺的最佳降解条件.同时研究了共基质条件下葡萄糖和苯胺对2,4-二氟苯胺的好氧降解的影响,葡萄糖的引入有促进作用,而苯胺只在一定浓度范围内有促进作用.氟苯胺的生产废水与生活污水合并处理以及多种组分混合废水处理是可行的.     

柱生物曝气法吸附处理含铬废水

利用复合生物吸附剂FY01与活性污泥作为吸附材料,探讨了柱式生物曝气法对高浓度含铬电镀废水的生物吸附效果.研究结果表明,FY01性能稳定,耐进水pH冲击能力较强.当进水pH=2～5、流速为500 mL/h时,10 g FY01和5 g活性污泥联合处理60.4 mg/L含铬电镀废水2 h后,铬的去除率达78%以上;在4℃冰箱和23～28℃实验室保存50 d的FY01对铬的去除分别在78%～83%和77%～84%之间.柱式生物曝气吸附法对含铬废水的处理效果理想,运行稳定.串联处理2000 mL总Cr、Cu2 和COD浓度分别为60.4、4.51和48.2 mg/L的电镀废水2 h后,去除率分别高达92.1%、99.2%和71.4%.     

膨胀珍珠岩负载TiO2光催化脱色性能的研究

以钛酸四丁酯为原料 ,膨胀珍珠岩为载体 ,用溶胶 -凝胶法制备可漂浮于水面的负载型TiO2 。利用该负载型TiO2 对罗丹明B(RB)进行光催化脱色实验 ,结果表明 ,浸渍 3次的负载型TiO2 光催化活性最高 ,催化剂最佳用量为 5 0 0mg/10 0mLRB ,经 5h光照 ,对 10 0mL浓度为 1mg/L和 2 .5mg/LRB脱色率分别为 76 .6 7%和 4 7.2 7% ;该催化剂使用寿命长 ,2 5h后催化剂脱色性能没有减弱 ,可重复使用 ;经 8h光照 ,染料废水脱色效果好。     

负载型TiO2膜太阳光光催化降解活性深蓝K-R的研究

采用抛物线槽型反应装置,研究了玻璃弹簧和微珠负载型TiO2膜太阳光催化降解活性深蓝K-R,结果表明,由于玻璃弹簧具有良好的光透距离,脱色性能显著优于玻璃微珠,玻璃弹簧为载体,水溶液浓度为15 mg/L,pH为3,流速为20 mL/s,太阳光强度在1200 μW/cm2以上,光降解6 h时,脱色率达到96%;该降解反应可用一级反应动力学方程进行描述,反应速率常数(K)与光强I的关系为:K∝I1.92.     

Effect of bound residues of metsulfuron-methyl in soil on rice growth

A pot experiment was conducted to appraise the hazards of bound residues of metsulfuron-methyl in soil at six levels (0, 0.050, 0.089, 0.158, 0.281, and 0.500 mg kg(-1)) to the growth of four rice varieties (Xiushui 63, Eryou 810, Liangyoupeijiu, and Zhenong 952). The morphological characteristics of rice roots like root number, total length, surface area of rice roots, and rice biomass were determined. The results showed that the bound residues of metsulfuron-methyl in soil impacted the growth of rice. Root number, total length of roots, surface area of roots, and biomass were restrained by bound residues of metsulfuron-methyl in soil. The inhibition rate of root growth increased from 69.46-81.32% to 85.18-95.97% with the increasing of levels of bound residues of metsulfuron-methyl from 0.05 mg kg(-1) to 0.50 mg kg(-1). The number of rice roots could be taken as a sensitive index to screen the rice varieties endurable to bound residues of metsulfuron-methyl in soil and to predict the potential hazards of bound residues of metsulfuron-methyl in soil to rice. The level of bound residues of metsulfuron-methyl in soil causing the root numbers decreased by 50% (IC50) followed the order of Xiushui 63 < Eryou 810 < Liangyoupeijiu < Zhenong 952.     

Treatment of refectory oily wastewater by electro-coagulation process

Electro-coagulation was used to treat refectory wastewater with high oil and grease contents. Different operational conditions were examined, including pH, current density, reaction time, conductivity, electrode distance and inlet concentration. The optimum current density was 10-14 A m(-2) within 30 min depending on the wastewater properties tested. Conductivity had little effect on the treatment efficiency. Although the addition of extra salts (e.g., sodium chloride) to the wastewater did not help increase the pollutant removal efficiency, it could save the power consumption significantly. The COD(Cr) and oil removal efficiency descended with increasing electrode distance. The optimal electrode distance was determined to be 10 mm for this equipment in consideration of the treatment cost and efficiency together. The pH effect on the performance of the electro-coagulation process was not very significant in the range of 3-10. The removal efficiency of oil and COD(Cr) under normal condition exceeded 95% and 75%, respectively.     

钛白副产硫酸亚铁的综合利用研究

以钛白副产硫酸亚铁、氯化钾和氨水为原料，采用硫酸钾铵法制取硫酸钾。实验结果表明，该工艺生产的产品，其质量达到ZBG-21006-89国家标准，且此工艺流程简单、操作方便、条件易控制，无二次污染。     

水和废水中多氯联苯(PCBs)的测定方法及进展

本文引用了七十余篇近几年国内外的有关著文,对水和废水中的多氯联苯(PCBs)的测定方法进行了评述,全面系统地介绍了水样的采集、富集、净化和分析测定等操作程序,着重于样品的前处理和气相色谱分析,并提出了这一领域今后的发展趋势。     

Catalytic gasification of coal using eutectic salts: recovery,regeneration, and recycle of spent eutectic catalysts

Catalyst recovery studies were conducted for gasified chars produced from steam gasification of Illinois #6 coal catalyzed with two different catalyst systems. A ternary (43.5 mol% Li2CO3-31.5 mol% Na2COr-25 mol% K2CO3) and a binary (29 mol% Na2CO3-71 mol% K2CO3) eutectic catalyst system were used for gasifying coal. Various extraction schemes, such as water extraction, H2SO4 extraction, and acetic acid extraction, were evaluated with respect to their extraction efficiencies. Effects of major process variables, such as solvent-to-char ratio, mixing time, temperature, and concentration, on the extraction efficiency were evaluated. A process schematic for the entire catalyst recovery, regeneration, and recycle scheme was developed and the preliminary process economics were determined based on these extraction schemes. H2SO4 extraction was found to be the most desirable. It also turned out to be more attractive than a once-through throwaway system.