电厂脱硫灰烧成硫铝酸盐水泥的试验研究

电厂脱硫灰由于成分复杂和高硫高钙的特点,为其综合利用造成了很多困难.试验证明,只需添加部分CaO或CaCO2,用脱硫灰作生料即可在1 300℃左右烧成硫铝酸盐水泥.这种方式可以完全利用脱硫灰中的游离CaO,CaCO3,Ca(OH)2和含硫矿物CaSO3与CaSO4,使其转化为水泥熟料矿物,如硫铝酸钙(Ca4Al6O12SO4)、硅酸二钙(Ca2SiO4)等,还能完全利用脱硫灰中的未燃烬碳,因而能达到物尽其用,是一种全新高效的利用方式,具有广阔的应用前景.     

水体中常见无机阴离子对TiO2薄膜光催化降解甲醛的影响

选择了5种水体中常见的阴离子（Cl^-,SO4^2-,HPO4^2-/HPO4^2-,HCO3^-/CO3^2-和NO3^-）,分别考查了其对TiO2薄膜光催化降解模拟甲醛废水的反应速率的影响;从上述离子的光吸收,对.OH的捕获及其生成的相应的无机自由基的氧化作用以及与甲醛的竞争吸附3个方面讨论了上述离子影响TiO2薄膜光催化降解模拟甲醛废水的反应速率的原因。结果表明,HCO3^-/CO3^2-对TiO2薄膜光催化降解甲醛具有抑制作用,Cl^-和SO4^2-的影响不大,H2PO4^-/HPO4^2-和NO3-具有促进作用。造成上述结果的主要原因是HCO3^-/CO2^3-具有很强的.OH捕获作用;Cl^-,SO4^2-对.OH捕获作用以及竞争吸附都较弱;H2PO4^-/HPO4^2-在TiO2表面具有较强的吸附能力,释放出的H＋起到了酸催化剂的作用;NO3^-在紫外光的照射下可以产生.OH,此外NO3^-作为电子受体而降低了TiO2表面光生电子和空穴的复合几率。     

电厂烟气中二氧化碳的捕集技术

通过对传统的MEA法和ECO2技术原理以及费用的分析比较，发现ECO2技术费用低、脱除效率高，ECO2技术比MEA法更适于回收CO2，具有广泛的应用前号。     

支持向量机在城市震后火灾损失预测中的应用

针对地震火灾的复杂性和多变性的特点，在综合分析了各种震后火灾损失预测方法的基础上，提出了基于支持向量机的城市震后火灾损失预测模型。以地震火灾的历史资料为依据，建立学习样本和测试样本，并与BP神经网络预测方法相比较，验证了其可行性，也为其它自然灾害的损失预测提供了简单、有效的方法。     

几种阴阳离子对磷钨酸光催化降解甲基橙的影响

以磷钨酸为光催化剂，在紫外灯照射下，对甲基橙溶液进行光催化降解，考察了几种阴阳离子对磷钨酸光催化降解甲基橙溶液的影响。结果表明：Mg²⁺、Ca²⁺、NO^-₃、SO^2-₄和CO^2-₃均对催化活性有促进作用，其中Mg²⁺和Ca²⁺仅有微弱的促进作用；NO^-₃和SO^2-₄随着浓度的增加促进作用也有所增加；CO^2-₃则随着浓度的增加促进作用呈下降趋势；Mn²⁺、Al³⁺和Cl^-对光解反应存在较强的抑制作用，且Al³⁺和Cl^-随着其浓度的增加，抑制作用增强。     

Statistical analysis of sudden chemical leakage accidents reported in China between 2006 and 2011

According to the data from authoritative sources, 1,400 sudden leakage accidents occurred in China during 2006 to 2011 were investigated, in which, 666 accidents were used for statistical characteristic abstracted with no or little damage. The research results were as follows: (1) Time fluctuation: the yearly number of sudden leakage accidents is shown to be decreasing from 2006 to 2010, and a slightly increase in 2011. Sudden leakage accidents occur mainly in summer, and more than half of the accidents occur from May to September. (2) Regional distribution: the accidents are highly concentrated in the coastal area, in which accidents result from small and medium-sized enterprises more easily than that of the larger ones. (3) Pollutants: hazardous chemicals are up to 95 % of sudden leakage accidents. (4) Steps: transportation represents almost half of the accidents, followed by production, usage, storage, and discard. (5) Pollution and casualties: it is easy to cause environmental pollution and casualties. (6) Causes: more than half of the cases were caused by human factor, followed by management reason, and equipment failure. However, sudden chemical leakage may also be caused by high temperature, rain, wet road, and terrain. (7) The results of principal component analysis: five factors are extracted by the principal component analysis, including pollution, casualties, regional distribution, steps, and month. According to the analysis of the accident, the characteristics, causes, and damages of the sudden leakage accident will be investigated. Therefore, advices for prevention and rescue should be acquired.     

热解吸对污染土壤中不同形态汞的去除作用

选取贵州省万山矿区的汞污染土壤样品进行不同形态汞的热解吸去除行为研究。研究了热解吸过程中∑Hg的去除效果及动力学,以及温度和时间对污染土壤中不同形态汞的去除作用。结果表明,热解吸修复技术可有效去除土壤中的汞,土壤中∑Hg的热解吸过程符合二级动力学方程。固定热解吸时间在10 min时,随着热解吸温度的升高,土壤中水溶态汞、盐酸溶态汞和碱溶态汞含量呈现先下降后上升再下降的趋势,王水溶汞和盐酸溶态汞始终呈现下降趋势,说明不同形态的汞之间发生了转化。热解吸温度为250℃时,随着热解吸时间的增加,环境风险大的水溶态汞、盐酸溶态汞、碱溶态汞和硝酸溶态汞的去除率大幅增加,土壤的有机质损失较少,说明在低温下,延长热解吸时间,对生物毒性强的形态汞有良好的修复效果,且此温度下处理后的土壤更容易恢复农田耕作。     

钢铁企业无组织排放特征污染物的监测分析

东部老工业区是济南市大气污染重点防控区域。工业区大型企业的无组织排放废气对区域及周边大气环境质量产生的影响,一直没有引起人们的足够重视,因对其排放量大小和污染物种类不清楚,难以进行监管。本文以济南东部老工业区一家大型钢铁企业为例,选取五项有代表性的特征污染物(苯、甲苯、二甲苯、非甲烷总烃和氨)进行布点监测,在不同气象条件下,分析特征污染物的浓度变化,了解钢铁企业无组织排放特征。经对监测数据的分析得出:与上风向相比,下风向各污染物监测的小时浓度和日均浓度均有不同程度的增加,表明该厂区污染源对周边环境空气质量有一定影响。最后,提出防范或改进措施,如应加严相应的无组织排放标准,增加大气在线监测点位及监测项目,建议企业加强对生产工艺环节无组织排放废气的收集和处理。     

A GIS-based Study for Optimizing the Total Emission Control Strategy in Lanzhou City

A geographic information system (GIS)-based approach with spatial analysis advantages was developed to optimize the total emission control scheme on air pollution in Lanzhou, combined with Models-3 modeling system and a linear programming model. GIS system is mainly used for establishing a multifactor assessment model to quantitatively divide environmental functional zone, and also used for selecting control sites in linear programming model. The results show that most of the urban area belongs to the second type of function, which is 122.8 km² occupying about 76.5% and the third type of about 32.9 km² occupying 20.5%. To reach the air quality up to the national standard in the entire control area, some large-emission factories need to cut emissions from 19% to 27%. For small but low-emission height sources, the cut may be as high 40%. The improvement of the ecological environment is urgently needed for controlling the background particle pollution in Lanzhou city.