Analysis for Exhaust Gas Hydrocarbons—Nondispersive Infrared Versus Flame-lonizaticn

An investigation has been made of the suitability of a nondispersive infrared analyzer and two flame-ionization analyzers for measuring the total hydrocarbon concentrations of automobile exhaust gas. The investigation consisted of measuring relative responses of various hydrocarbons, checking for possible exhaust gas interferences and finally comparing exhaust hydrocarbon concentrations indicated by the flame-ionization analyzer to those indicated by the infrared analyzer. The infrared analyzer has high relative responses for parraffins and low responses for olefins, acetylenes, and aromatics. Also, the infrared indicated hydrocarbon concentrations must be corrected for exhaust water vapor interference. When the flameionization analyzers are operated at conditions that result in approximately uniform response to hydrocarbons and low oxygen interference, the exhaust hydrocarbon concentrations indicated by either flameionization analyzer are better approximations of the total hydrocarbon concentration than those indicated by the infrared analyzer.     

Oxygen Stratification in Industrial Boiler Stacks

The DSS/2 software system was used to numerically simulate oxygen stratification effects in a typical industrial boiler stack. The model developed for the simulation involves turbulent mass transfer in a tube with a constant, high mass flux from the walls of the tube. The concentration profile is considered to be developing, but the velocity profile is assumed to be fully developed. The model is for a gaseous system at constant temperature and pressure; the transport properties are shown to be constant. The universal velocity profile for turbulent flow and von Karman’s expressions for the turbulent eddy diffusivity are incorporated in the model. An expression for a wall concentration profile corresponding to conditions of high mass flux at the wall is developed. The model is then expressed as a system of partial differential equations which are solved using the numerical method of lines together with the DSS/2 numerical integration system. The resulting concentration profiles are presented for various flux rates which might be encountered in a typical stack. These profiles indicate that a potential for oxygen stratification in stacks does exist; they also suggest that careful placement of the oxygen cell probe can help minimize such errors.     

Evaluating Sources of Indoor Air Pollution

Evaluation of Indoor air pollution problems requires an understanding of the relationship between sources, air movement, and outdoor air exchange. Research is underway to investigate these relationships. A three-phase program is being implemented: 1) Environmental chambers are used to provide source emission factors for specific indoor pollutants; 2) An IAQ (Indoor Air Quality) model has been developed to calculate indoor pollutant concentrations based on chamber emissions data and the air exchange and air movement within the indoor environment; and 3) An IAQ test house is used to conduct experiments to evaluate the model results. Examples are provided to show how this coordinated approach can be used to evaluate specific sources of indoor air pollution. Two sources are examined: 1) para-dichlorobenzene emissions from solid moth repellant; and 2) particle emissions from unvented kerosene heaters.

The evaluation process for both sources followed the three-phase approach discussed above. Para-dichlorobenzene emission factors were determined by small chamber testing at EPA’s Air and Energy Engineering Research Laboratory. Particle emission factors for the kerosene heaters were developed In large chambers at the J. B. Pierce Foundation Laboratory. Both sources were subsequently evaluated in EPA’s IAQ test house. The IAQ model predictions showed good agreement with the test house measurements when appropriate values were provided for source emissions, outside air exchange, in-house air movement, and deposition on “sink” surfaces.     

Particle size distribution of airborne Aspergillus fumigatus spores emitted from compost using membrane filtration

Information on the particle size distribution of bioaerosols emitted from open air composting operations is valuable in evaluating potential health impacts and is a requirement for improved dispersion simulation modelling. The membrane filter method was used to study the particle size distribution of Aspergillus fumigatus spores in air 50 m downwind of a green waste compost screening operation at a commercial facility. The highest concentrations (approximately 8 × 10⁴ CFU m⁻³) of culturable spores were found on filters with pore diameters in the range 1–2 μm which suggests that the majority of spores are emitted as single cells. The findings were compared to published data collected using an Andersen sampler. Results were significantly correlated (p < 0.01) indicating that the two methods are directly comparable across all particles sizes for Aspergillus spores.     

Development and evaluation of a risk management methodology for pedestrian surfaces

This paper describes the development and evaluation of the Pedestrian Surface (PS) priority indicator (PS priority indicator). This tool was developed to comply with Australian Standard AS 4360: 2004 (Risk Management). Pedestrian surfaces should be evaluated to identify hazards and assess the level of risk calculated in order to ensure that the surfaces do not have a significant level of risk. If a significant level of risk is present, then control measures should be implemented. Pedestrian surfaces for the purposes of this research are classified as same level surfaces (excluding stairways) where pedestrians on foot (or by wheelchair) travel from one place to another.     

Effect of two major N-nitroso hexahydro-1,3,5-trinitro-1,3,5-triazine (RDX) metabolites on earthworm reproductive success

Soil and topical tests were employed to investigate the effect of two N-nitroso metabolites of RDX (hexahydro-1,3,5-trinitro-1,3,5-triazine) on earthworm reproduction. The lowest observed effect concentration (LOEC) for cocoon production and hatching was 50mg/kg for both hexahydro-1-nitroso-3,5-dinitro-1,3,5-triazine (MNX) and hexahydro-1,3,5-trinitroso-1,3,5-triazine (TNX) in soil. MNX and TNX also significantly affected cocoon hatching in soil (p<0.001) and in topical tests (p=0.001). The LOECs for cocoon hatching were 1 and 10mg/kg for MNX and TNX in soil, respectively, and 10mg/L in the topical test. Greater than 100mg/kg MNX and TNX completely inhibited cocoon hatching. In soil, the EC20 values for MNX were 8.7 and 8.8mg/kg for cocoon and juvenile production, respectively, compared to 9.2 and 9.1mg/kg for TNX, respectively. The EC20 values for the total number of cocoon hatchlings were 3.1 and 4.7mg/kg for MNX and TNX, respectively, in soil and 4.5 and 3.1mg/L in the topical test. Both MNX and TNX inhibited cocoon production and hatching, suggesting that they may have a negative affect on soil ecosystems at contaminated sites.     

Why do winners keep winning?

Summary Winners of aggressive interactions often continue to win in future encounters. I propose that this phenomenon is a by-product of two other phenomena occurring simultaneously: first, initiators of aggressive interactions typically win those interactions and, second, winners of aggressive encounters often become more likely to initiate future interactions. I propose that these phenomena can be explained, in turn, by selection favoring an individual's initiating an interaction only when it is likely to win that interaction. I found support for this two-step explanation for the winning begets winning phenomenon by observing aggressive interactions among captive dark-eyed juncos (Junco hyemalis oreganus). First, initiators of interactions almost always won. Second, based on characteristics of winners in birds' home aviaries, I could predict which birds would initiate against novel competitors — winners were long-winged males with dark hoods, and birds with these characteristics were more likely to be the first to initiate in novel triads. In addition, aggression was directed preferentially towards other dark-hooded males. The results of this study may expand our understanding of the dynamics of aggressive interactions.     

US Energy Conservation and Efficiency: Benefits and Costs

With increased energy conservation plus the adoption of diverse energy efficient technologies, the US economy could save about 32 quads or about 33% of its current energy consumption, if sound conservation energy use policies were implemented over approximately 10 years. This potential of 32 quads is slightly greater than the current US oil imports. The systems that have the greatest potential to provide major energy savings are transportation, residential energy use, and the food system. Not only saving energy has merit in itself, but it would save US citizens approximately $438 billion per year, helping support the US economy, a high standard of living, and energy security. In addition, this analysis suggests that reducing the $40 billion in taxpayer money spent on subsidies of the energy industries would further increase conservation.     

A simple technique for obtaining high quality chromosome preparations from chorionic villus samples using FdU synchronization

A fluorordeoxyuridine (FdU) synchronization technique was applied to 30 chorionic villus samples (CVS) from patients undergoing first trimester fetal diagnosis. The villi were incubated for 15 h in the presence of FdU. The block in DNA synthesis was subsequently released using thymidine and after an additional 5 h of incubation the mitotic cells were arrested in metaphases using a high concentration of colcemid. This method results in improved morphology of the chromosomes and a high mitotic index. A diagnostic chromosome analysis could be obtained in each clinical case using at least 15 well-spread metaphases. G-banded karyotypes were prepared of four metaphases in each case. The diagnostic procedure was completed within 48 h from the time of CVS. Use of this technique significantly improves the success rate of ‘direct’ chromosome analyses from CVS in a busy cytogenetic laboratory.