Mechanical and toxicological evaluation of concrete artifacts containing waste foundry sand

The creation of metal parts via casting uses molds that are generally made from sand and phenolic resin. The waste generated after the casting process is called waste foundry sand (WFS). Depending on the mold composition and the casting process, WFS can contain substances that prevent its direct emission to the environment. In Brazil, this waste is classified according to the Standard ABNT NBR 10004:2004 as a waste Class II (Non-Inert). The recycling of this waste is limited because its characteristics change significantly after use. Although the use (or reuse) of this byproduct in civil construction is a technically feasible alternative, its effects must be evaluated, especially from mechanical and environmental points of view. Thus, the objective of this study is to investigate the effect of the use of WFS in the manufacture of cement artifacts, such as masonry blocks for walls, structural masonry blocks, and paving blocks. Blocks containing different concentrations of WFS (up to 75% by weight) were produced and evaluated using compressive strength tests (35 MPa at 28 days) and toxicity tests on Daphnia magna, Allium cepa (onion root), and Eisenia foetida (earthworm). The results showed that there was not a considerable reduction in the compressive strength, with values of 35 ± 2 MPa at 28 days. The toxicity study with the material obtained from leaching did not significantly interfere with the development of D. magna and E. foetida, but the growth of the A. cepa species was reduced. The study showed that the use of this waste in the production of concrete blocks is feasible from both mechanical and environmental points of view.     

Distribution and ecological risk of polychlorinated biphenyls (PCBs) and organochlorine pesticides (OCPs) in surface sediments from the Bizerte lagoon,Tunisia

Polychlorinated biphenyls (PCBs) and organochlorine pesticides (OCPs) were determined in 18 surface sediment samples collected from Bizerte lagoon, Tunisia. The total concentrations of ten PCBs (∑PCBs) and of four OCPs (∑OCPs) in the sediments from this area ranged from 0.8 to 14.6 ng g^?1 dw (average value, 3.9 ng g^?1 dw) and from 1.1 to 14.0 ng g^?1 dw (average value, 3.3 ng g^?1 dw), respectively. Among the OCPs, the range of concentrations of dichlorodiphenyltrichloroethane and its metabolites (DDTs) and hexachlorobenzene (HCB) were 0.3–11.5 ng g^?1 dw (1.9 ng g^?1 dw) and 0.6–2.5 ng g^?1 dw (1.4 ng g^?1 dw), respectively. Compositional analyses of the POPs indicated that PCB 153, 138 and 180 were the predominant congeners accounting for 60 % of the total PCBs. In addition, p,p′-DDT was found to be the dominant DDTs, demonstrating recent inputs in the environment. Compared with some other regions of the world, the Bizerte lagoon exhibited low levels of PCBs and moderate levels of HCB and DDTs. The high ratios ΣPCBs/ΣDDTs indicated predominant industrial versus agricultural activities in this area. According to the established guidelines for sediment quality, the risk of adverse biological effects from such levels of OCPs and PCBs, as recorded at most of the study sites, was insignificant. However, the higher concentrations in stations S1 and S3 could cause biological damage.     

Benzo[b]fluoranthene,a Potential Alternative to Benzo[a]pyrene as an Indicator of Exposure to Airborne PAHs in the Vicinity of Söderberg Aluminum Smelters

ABSTRACT

Benzo[b]fluoranthene (B[b]F) was used in relative abundance ratios (RARs), a parameter obtained by dividing the concentration of individual polycyclic aromatic hydrocarbons (PAHs) found in a given sample by the concentration of B[b]F in the same sample. The B[b]F RARs were derived for PAH concentrations measured at stacks and sampling stations in the vicinity of two Söderberg aluminum horizontal stud smelters (HSSs). The samples collected were analyzed by high-performance liquid chromatography using UV and fluorescence detection. A total of 15 PAHs were analyzed, but, due to the inefficiency of the sampling method used in collecting gaseous PAHs, only particulate PAHs were considered. Comparisons between the B[b]F RARs obtained simultaneously at the source (stack) and those obtained at sampling stations at the two smelters showed that B[b]F degrades more slowly than or at the same rate as most other particulate PAHs monitored. Twenty-three months of urban sampling in the vicinity of one of the aluminum HSSs are also presented, and the results indicate that B[b]F is more stable than all other particulate PAHs investigated. Sampling conducted during a smelter shutdown period confirmed that B[b]F was a much better marker of this source than was benzo[a]pyrene (B[a]P), the usual indicator. The remarkable stability of the benzo[k]fluoranthene (B[k]F)/B[b]F ratio is also discussed.     

Comparison of EDTA-enhanced phytoextraction and phytostabilisation strategies with Lolium perenne on a heavy metal contaminated soil

Phytoremediation is a promising and cost-effective strategy to manage heavy metal polluted sites. In this experiment, we compared simultaneously phytoextraction and phytostabilisation techniques on a Cd and Zn contaminated soil, through monitoring of plant accumulation and leaching. Lolium perenne plants were cultivated for 2 months under controlled environmental conditions in a 27.6 dm³-pot experiment allowing the collect of leachates. The heavy metal phytoextraction was promoted by adding Na-EDTA (0.5 g kg⁻¹ of soil) in watering solution. Phytostabilisation was assessed by mixing soil with steel shots (1%) before L. perenne sowing. Presence of plants exacerbated heavy metal leaching, by improving soil hydraulic conductivity. Use of EDTA for phytoextraction led to higher concentration of heavy metal in shoots. However, this higher heavy metal extraction was insufficient to satisfactory reduce the heavy metal content in soil, and led to important heavy metal leaching induced by EDTA. On the other hand, addition of steel shots efficiently decreased both Cd and Zn mobility, according to 0.01 M CaCl₂ extraction, and leaching. However, improvement of growth conditions by steel shots led to higher heavy metal mass in shoot tissues. Therefore, soil heavy metal mobility and plant metal uptake are not systematically positively correlated.     

Concentrations and profiles of PCDD/Fs in sediments of major Polish rivers and the Gdansk Basin--Baltic Sea

The present state of contamination of bottom sediments in southern part of the Baltic Sea with PCDD/Fs was compared to the findings made for the north-western and eastern Baltic Sea coastal areas of Finland, Sweden and Denmark. The extent of the study area--from marine the Gdańsk Basin, the lower Oder and Vistula Rivers up till W?oc?awek reservoir--allowed to obtain the sediment samples with diversified properties. Dioxin's concentrations in sediments examined in the Polish costal area allows us to evaluate this zone as relatively less contaminated. Higher dioxin concentration has been found in Wloclawek Dam Reservoir. Differences in congener patterns and temporal changes in marine sediment profiles were examined. The highest concentrations of tetra- and penta-congeners still remain in the surface layer of Gdansk Deep, whereas the decline in concentrations of these most toxic congeners, have been observed in the sediments from some other parts of the Baltic coast. Excess concentration of dioxins in sediments has a great impact on human being due to special ability of accumulation in the trophic chain as well as in water (fishes) and land (milk, meat).     

Loofa egyptiaca as a novel adsorbent for removal of direct blue dye from aqueous solution

In this paper, Loofa egyptiaca (LE), an agricultural plant cultivated in Egypt, was used to prepare low-cost activated carbon (LE_C1 and LE_C2) adsorbents. The adsorbents (LE, LE_C1 and LE_C2) were evaluated for their ability to remove direct blue 106 dye from aqueous solutions. Batch mode experiments were conducted using various parameters such as pH, contact time, dye concentration and adsorbent concentration. The surface chemistry of LE, LE_C1 and LE_C2 was analyzed by scanning electron microscopy (SEM). The experimental data were examined using Langmuir, Freundlich, Temkin and Harkins–Jura isotherms. The results showed that the adsorption of direct blue 106 was maximal at the lowest value of pH (pH = 2). Removal efficiency was increased with an increase in dye concentration and a decrease in amount of adsorbent. Maximum adsorption capacity was found to be 57.14, 63.3 and 73.53 mg/g for LE, LE_C1 and LE_C2 respectively. Kinetics were also investigated using pseudo-first-order, pseudo-second-order and intra-particle diffusion models. The experimental data fitted very well with the pseudo-first-order and pseudo-second-order kinetic models. The results indicate that LE, LE_C1 and LE_C2 could be employed as adsorbents for the removal of direct blue dye from aqueous solutions.     

Methane generation in tropical landfills: simplified methods and field results

This paper deals with the use of simplified methods to predict methane generation in tropical landfills. Methane recovery data obtained on site as part of a research program being carried out at the Metropolitan Landfill, Salvador, Brazil, is analyzed and used to obtain field methane generation over time. Laboratory data from MSW samples of different ages are presented and discussed; and simplified procedures to estimate the methane generation potential, Lo, and the constant related to the biodegradation rate, k are applied. The first order decay method is used to fit field and laboratory results. It is demonstrated that despite the assumptions and the simplicity of the adopted laboratory procedures, the values Lo and k obtained are very close to those measured in the field, thus making this kind of analysis very attractive for first approach purposes.     

Impact of training programs on decision-making and situation awareness of trainee watch officers

This paper examines the impact of training programs on the ability of trainee watch officers to make decisions in collision avoidance situations.It draws on previous studies which have shown that experts are able to manage complex situations in an acceptable way. However, observations of students on simulators have revealed that many of them are unable to manage such situations or even to recall their main features. It is therefore necessary to identify new training tools that will give trainees the capacity to assess a situation quickly and accurately, and to perform satisfactory actions. These would be in addition to formal regulations.Exercises were designed to evaluate the impact of such tools on the decision-making process of trainees. The impact of the type of navigation experienced by trainees during their on-the-job training was also evaluated.Results showed that decision-making exercises did tend to improve the trainees’ capacity to analyse a complex situation; however, they did not have a clear impact on the manoeuvre performed. On the contrary, there was an obvious difference between the trainees who experienced complex avoidance situations during their on-the-job training period and those who did not.At a time where ship-owners are looking to reduce the length of the “on-the-job” training period, these results point to its vital importance.     

Physicochemical characteristics,mutagenicity and genotoxicity of airborne particles under industrial and rural influences in Northern Lebanon

In this work, the main objectives were to assess the mutagenic and genotoxic effects of fine particulate matter collected in an industrial influenced site in comparison with a non-industrial influenced one (rural site) and to relate the particulate matter (PM) composition to the observed genotoxic effects. At the industrial influenced site, higher concentrations of phosphates, trace metals, and polycyclic aromatic hydrocarbons (PAHs) in particles could be related to the contributions of quarries, fertilizer producer, cement plants, and tires burning. Gasoline and diesel combustion contributions were evidenced in particles collected at both sites. Particles collected under industrial influence showed a higher mutagenic potential on three tested strains of Salmonella typhimurium (TA98, YG1041, and TA102), and especially on the YG1041, compared to particles from the rural site. Furthermore, only particles collected in the vicinity of the industrial site showed a tendency to activate the SOS responses in Escherichia coli PQ37, which is indicative of DNA damage as a result of exposure of the bacteria cells to the action of mutagenic samples. The mutagenicity and genotoxicity of the industrial PM_2.5–0.3 particulates may be attributed to its composition especially in organic compounds. This study showed that proximity of industries can affect local PM composition as well as PM genotoxic and mutagenic potential.     

The impact of pesticides on oxidative stress level in human organism and their activity as an endocrine disruptor

Pesticides cause serious environmental and health problems both to humans and animals. The aim of this review is to discuss selected herbicides and fungicides regarding their mode of action and their influence on basic oxidative stress parameters and endocrine disruption properties tested in selected cell cultures in vitro. Because of numerous difficulties which animal studies are subject to, cell cultures are an excellent experimental model reflecting human exposure to different pesticides through all relevant routes. This experimental model can be used to monitor aggregate and cumulative pesticide exposures.