Anaerobic treatment of atrazine bearing wastewater.

Performance of mixed microbial anaerobic culture in treating synthetic waste-water with high Chemical Oxygen Demand (COD) and varying atrazine concentration was studied. Performance of hybrid reactors with wood charcoal as adsorbent, with a dose of 10 g/l and 40 g/l, along with the microbial mass was also studied. All the reactors were operated in sequential mode with Hydraulic Retention Time (HRT) of 5 days. In all the cases, COD removal after 5 days was found to be above 81%. Initial COD was above 1,000 mg/l. From a hybrid reactor COD removal after 2 days was observed to be 90%. Atrazine reduction after 5 days by microbial mass alone was 43.8%, 40% and 33.2% with an initial concentration of 0.5, 1.0 and 2.0 mg/l respectively. MLSS on all the cases were almost same. Increasing MLSS concentration by about 2 fold did not increase the atrazine removal efficiency significantly. Maximum atrazine removal was observed to be 64% from the hybrid reactor with 10 g/l of wood charcoal and 69.4% from the reactor with 40 g/l of wood charcoal. Atrazine removal from the hybrid reactors after 15 days were observed to be 35.7% and 38.7%, which showed that the higher dose of wood charcoal in hybrid reactor did not improve the atrazine removal efficiency significantly. Specific methanogenic activity test showed no inhibitory effect of atrazine on methane producing bacteria. The performance of anaerobic microorganisms in removing atrazine with no external carbon source and inorganic nitrogen source was studied in batch mode. With an initial concentration of 1.0 mg/l, reduction of atrazine by the anaerobic microorganisms in absence of external carbon source after 35 days was observed to be 61.8% where as in absence of external carbon and inorganic nitrogen source the reduction was only 44.2% after 150 days. Volatilization loss of atrazine was observed to be insignificant.     

Epidemiology of occupational acute traumatic hand injuries: a literature review

The purpose of this review was to summarize the literature on occupational, acute, traumatic hand injury and suggest directions for future research. In 1996, the leading occupational injury treated in United States' hospital emergency departments was an acute hand injury (e.g. laceration, crush or fracture). These injuries affected 30% of an estimated 3.3 million injured workers (990,000). Cuts and lacerations of the fingers ranked third after back and leg strains in the number of lost workday cases in the USA in 1994. The incidence rate of hand injuries studied in seven manufacturing environments around the world ranged from 4 to 11 per 100 workers per year. Workers aged 24 years or less had the highest risk of hand injury. Men had higher rates of severe hand injury than women.Despite the high frequency and significant amount of lost work time associated with these injuries, they are poorly understood from an etiological perspective. There is only one case-control study of occupational hand injury in the literature. That study suggested an important role for both fixed (age) and transient risk factors (doing an unusual task) at the time of the injury. More analytic epidemiological research is needed to identify potentially modifiable risk or protective factors (e.g. glove use) for acute hand injuries. In this regard, the case-crossover design, a relatively new epidemiological approach using cases as their own controls, could prove an efficient method for determining transient, modifiable risk factors for acute, occupational hand injury.     

Implications of geometric plasticity for maximizing photosynthesis in branching corals

Reef-building corals are an example of plastic photosynthetic organisms that occupy environments of high spatiotemporal variations in incident irradiance. Many phototrophs use a range of photoacclimatory mechanisms to optimize light levels reaching the photosynthetic units within the cells. In this study, we set out to determine whether phenotypic plasticity in branching corals across light habitats optimizes potential light utilization and photosynthesis. In order to do this, we mapped incident light levels across coral surfaces in branching corals and measured the photosynthetic capacity across various within-colony surfaces. Based on the field data and modelled frequency distribution of within-colony surface light levels, our results show that branching corals are substantially self-shaded at both 5 and 18 m, and the modal light level for the within-colony surface is 50 μmol photons m^?2 s^?1. Light profiles across different locations showed that the lowest attenuation at both depths was found on the inner surface of the outermost branches, while the most self-shading surface was on the bottom side of these branches. In contrast, vertically extended branches in the central part of the colony showed no differences between the sides of branches. The photosynthetic activity at these coral surfaces confirmed that the outermost branches had the greatest change in sun- and shade-adapted surfaces; the inner surfaces had a 50 % greater relative maximum electron transport rate compared to the outer side of the outermost branches. This was further confirmed by sensitivity analysis, showing that branch position was the most influential parameter in estimating whole-colony relative electron transport rate (rETR). As a whole, shallow colonies have double the photosynthetic capacity compared to deep colonies. In terms of phenotypic plasticity potentially optimizing photosynthetic capacity, we found that at 18 m, the present coral colony morphology increased the whole-colony rETR, while at 5 m, the colony morphology decreased potential light utilization and photosynthetic output. This result of potential energy acquisition being underutilized in shallow, highly lit waters due to the shallow type morphology present may represent a trade-off between optimizing light capture and reducing light damage, as this type morphology can perhaps decrease long-term costs of and effect of photoinhibition. This may be an important strategy as opposed to adopting a type morphology, which results in an overall higher energetic acquisition. Conversely, it could also be that maximizing light utilization and potential photosynthetic output is more important in low-light habitats for Acropora humilis.     

Suitability analysis for siting MSW landfills and its multicriteria spatial decision support system: Method,implementation and case study

Multicriteria spatial decision support systems (MC-SDSS) have emerged as an integration of geographical information systems (GIS) and multiple criteria decision analysis (MCDA) methods for incorporating conflicting objectives and decision makers’ (DMs’) preferences into spatial decision models. This article presents a raster-based MC-SDSS that combines the analytic hierarchy process (AHP) and compromise programming methods, such as TOPSIS (technique for order preference by similarity to the ideal solution) and Ideal Point Methods. To the best of our knowledge it is the first time that a synergy of AHP and compromise programming methods is implemented in raster-driven GIS-based landfill suitability analysis. This procedure is supported by a spatial decision support system (SDSS) that was developed within a widely used commercial GIS software package. A real case study in the Thrace region in northeast Greece serves as a guide on how to conduct a suitability analysis for a MSW landfill site with the proposed MC-SDSS. Moreover, the procedure for identifying MSW disposal sites is accomplished by performing four computational models for synthesizing the DMs per criterion preferential system. Based on the case study results, a comparison analysis is performed according to suitability index estimations. According to them Euclidean distance metric and TOPSIS present strong similarities. When compared with Euclidean distance metric, TOPSIS seems to generate results closer to that derived by Manhattan distance metric. The comparison of Chebychev distance metric with all the other approaches revealed the greatest deviations.     

Investigation of seat belt use among the drivers of different education levels

Seat belt use habit has been investigated according to the education level of drivers. Copies of a questionnaire were distributed to 1000 participants of four different education levels. Factors such as seat belt usage habit, restricting factors and crash data have been investigated. Data have been analyzed with SPSS 15.0 software. Increased level of education leads to increased seat belt usage, lower numbers of crashes and crash severities. The factors restricting seat belt use are lack of habit, discomfort and short distance driving. The use of precaution signal and increases in comfort can increase seat belt usage. The primary and high school education on traffic safety and seat belt usage has been serving the purpose.