Determination of the insecticide diflubenzuron in mushrooms by kinetic method and high-performance liquid chromatographic method

In the present study, a new sensitive and simple kinetic-spectrophotometric method for the determination of the insecticide diflubenzuron [1-(4-chlorophenyl)-3-(2,6-diflubenzoil)urea] is proposed. The method is based on the inhibited effect of diflubenzuron on the oxidation of sulphanilic acid (SA) by hydrogen peroxide in phosphate buffer in presence Cu(II) ion. Diflubenzuron was determined with linear calibration graph in the interval from 0.31 to 3.1 μg mL?1 and from 3.1 to 31.0 μg mL?1. The optimized conditions yielded a theoretical detection limit of 0.18 μg mL?1 corresponding to 0.036 mg kg(-1)mushroom sample based on the 3S(b) criterion. The RSD is 5.03-1.83 % and 2.81-0.71 % for the concentration interval of diflubenzuron 0.31-3.1 μg mL?1 and 3.1-31.0 μg mL?1, respectively. The reaction was followed spectrophotometrically at 370 nm. The kinetic parameters of the reaction are reported, and the rate equations are suggested. The developed procedure was successfully applied to the rapid determination of diflubenzuron in spiked mushroom samples of different mushroom species. The HPLC method was used like a comparative method to verify results.     

The Formation of Mg3Ca(S04)4 during the Sulfation Reaction of Dolomite

Abstract

Inspection and maintenance programs for motor vehicles in the United States increasingly use loaded mode mass emissions testing (IM240). A method was developed to predict mass emission rates and mass emission changes, particularly from repair benefits, using a low-cost, portable four-gas non-dispersive infrared (NDIR) vehicle exhaust gas analyzer. A single vehicle was tested several times with the analyzer while on the dynamometer and undergoing successive repairs. Excellent correlations for CO and HC were observed. Five vehicles were measured using an on-road driving loop before and after emissions-related repairs, while another three vehicles were tested with no repairs performed. The on-road concentration data used to guide the repair process were converted to grams per gallon; when divided by estimated miles per gallon, this gave grams per mile emissions for comparison to IM240. Correlation coefficients (r²) of 0.87 for CO and 0.76 for HC were achieved for the 13 tests. The linear correlations between IM240 and emissions measured by this method would allow repair facilities to perform a relatively inexpensive test for diagnostic purposes and to estimate repair effectiveness without the need for a dynamometer.     

Identification of magnetic particulates in road dust accumulated on roadside snow using magnetic, geochemical and micro-morphological analyses

The aim of this study is to test the applicability of snow surveying in the collection and detailed characterization of vehicle-derived magnetic particles. Road dust extracted from snow, collected near a busy urban highway and a low traffic road in a rural environment (southern Finland), was studied using magnetic, geochemical and micro-morphological analyses. Significant differences in horizontal distribution of mass specific magnetic susceptibility (χ) were noticed for both roads. Multi-domain (MD) magnetite was identified as the primary magnetic mineral. Scanning electron microscope (SEM) analyses of road dust from both roads revealed: (1) angular-shaped particles (diameter ∼1-300 μm) mostly composed of Fe, Cr and Ni, derived from circulation of motor vehicles and (2) iron-rich spherules (d ∼ 2-70 μm). Tungsten-rich particles (d < 2 μm), derived from tyre stud abrasion were also identified. Additionally, a decreasing trend in χ and selected trace elements was observed with increasing distance from the road edge.     

Marine and farmed fish on the Polish market: comparison of the nutritive value and human exposure to PCDD/Fs and other contaminants

Chemical analyses were performed in nine fish species that are popular on the Polish market. These included Baltic fish (cod, herring, salmon), fish farmed in Poland (carp, trout), marine fish imported from China (Alaska pollock, sole), and farmed fish imported from Vietnam and China (sutchi catfish, tilapia). The nutritional composition (amino acid, micro- and macronutrients, fat-soluble vitamins - A₁, D₃, E) and certain contaminants (organochlorine pesticides, OCPs; indicator polychlorinated biphenyl, PCB₆; polychlorinated dibenzo-paradioxins and polychlorinated dibenzofurans, PCDD/Fs; dioxin-like polychlorinated biphenyls, dl-PCBs; organotin compounds, OCTs; dyes, malachite green and crystal violet; veterinary drug residues, nitrofurans and chloramphenicol; toxic metals, Cd, Pb, Hg) in the muscle tissues of fish were determined. It was confirmed that the fish species analyzed were excellent sources of amino acids, and were rich in phosphorous and selenium. Baltic Sea fish (salmon, herring), fish farmed in Poland (carp and trout), and tilapia were also rich in vitamin D₃.Traces of OCP, PCB₆, OCT, dyes, veterinary drug residues, and heavy metals were detected in concentrations which do not pose a threat to consumers at the current rate of fish consumption in Poland. However, the problem might arise from the content of PCDD/Fs and dl-PCBs in fatty Baltic fish. The fish species analyzed, differed in their nutritional values and degrees of contamination. We suggest that for optimum health and safety, it is advisable that consumers include a variety of different fish species in their diets.     

The Properties of Poly(<Emphasis Type="SmallCaps">l</Emphasis>-Lactide) Prepared by Different Synthesis Procedure

Different synthesis methods were applied to determine optimal conditions for polymerization of (3S)-cis-3,6-dimethyl-1,4-dioxane-2,5-dione (l-lactide), in order to obtain poly(l-lactide) (PLLA). Bulk polymerizations (in vacuum sealed vessel, high pressure reactor and in microwave field) were performed with tin(II) 2-ethylhexanoate as the initiator. Synthesis in the vacuum sealed vessel was carried out at the temperature of 150 °C. To reduce the reaction time second polymerization process was carried out in the high pressure reactor at 100 °C and at the pressure of 138 kPa. The third type of rapid synthesis was done in the microwave reactor at 100 °C, using frequency of 2.45 GHz and power of 150 W at the temperature of 100 °C. The temperature in this method was controlled via infrared system for in-bulk measuring. The solution polymerization (with trifluoromethanesulfonic acid as initiator) was possible even at the temperature of 40 °C, yielding PLLA with narrow molecular weight distribution in a very short period of time (less than 6 h). The obtained polymers had the number-average molecular weights ranging from 43,000 to 178,000 g mol⁻¹ (polydispersity index ranging from 1 to 3) according to the gel permeation chromatography measurements. The polymer structure was characterized by Fourier transform infrared and NMR spectroscopy. Thermal properties of the obtained polymers were investigated using thermogravimetry and differential scanning calorimetry.     

Origin and transport of U and Ra in riverine,estuarine and marine sediments of the Krka River,Croatia

Spatial distribution of ²³⁸U and ²²⁶Ra activities in sediment columns along the Krka River and estuary, were studied using gamma spectrometry. Markedly different ²³⁸U and ²²⁶Ra activities between riverine, estuarine and marine sediments were observed. Distribution of these radionuclides, as well as their anthropogenic and natural origin, was evaluated by activity measurements, taking into account sedimentation rates estimated by ¹³⁷Cs distribution in sediment columns.     

Evaluation and validation of two different chromatographic methods (HPLC and LC-MS/MS) for the determination and confirmation of ochratoxin A in pig tissues

This study was undertaken to compare two different analytical methods for the determination and confirmation of ochratoxin A (OTA) in blood serum, kidney and liver of pigs. Sample clean-up was based on liquid-liquid phase extraction. The detection of OTA was accomplished with high-performance liquid chromatography (HPLC) combined either with fluorescence detection (FL) or electro spray ionization (ESI+) tandem mass spectrometry (MS–MS). Comparative method evaluation was based on the investigation of 90 samples of blood serum, kidney and liver per animal originating from different regions of Serbia. The analytical results are discussed in view of the respective method validation data and the corresponding experimental protocols. In general, analytical data obtained with (LC–MS–MS) liquid chromatography electro spray tandem mass spectro metry detection offered comparable good results at the sub-ppb concentration level. The results indicate that the liquid chromatography electro spray tandem mass spectrometric (LC-MS/MS) method was more specific and sensitive for the analysis and confirmation of ochratoxin A in pig tissues then high pressure liquid chromatography (HPLC) method after methylation of OTA.     

Determination and potential importance of diterpene (kaur-16-ene) emitted from dominant coniferous trees in Japan

Reactive volatile organic compounds (VOCs) are known to affect atmospheric chemistry. Biogenic VOCs (BVOCs) have a significant impact on regional air quality due to their large emission rates and high reactivities. Diterpenes (most particularly, kaur-16-ene) were detected in all of the 205 enclosure air samples collected over multiple seasons at two different sites from Cryptomeria japonica and Chamaecyparis obtusa trees, the dominant coniferous trees in Japan,. The emission rate of kaur-16-ene, was determined to be from 0.01 to 7.1 μg dwg⁻¹ h⁻¹ (average: 0.61 μg dwg⁻¹ h⁻¹) employing branch enclosure measurements using adsorbent sampling followed by solid phase-liquid extraction techniques. The emission rate was comparable to that of monoterpenes, which is known major BVOC emissions, collected from the same branches. In addition, total emission of kaur-16-ene at 30 °C was estimated to exceed that of total anthropogenic VOC emissions.     

Altered toxicity of organic pollutants in water originated from simultaneous exposure to UV photolysis and CdSe/ZnS quantum dots

The paper reports unforeseen results of increased toxicity of water, subsequent to interactions between CdSe/ZnS quantum dots (QDs), phenol and toluene under UV irradiation. The consistent pattern of changes in measured toxicity (TU) was observed and correlated with degradation of phenol and/or toluene. Spearman rank coefficients (SRCs) for data pairs sum-parameters vs. TU were calculated. The highest correlation between toxicity and degradation by-products was observed for hydroquinone (0.86) and catechol (0.89). The presence of QDs in tested concentration range in the absence of UV has shown low toxicity and no interactions with phenol and/or toluene. The leak of constituent core and shell metal ions was observed. The minor differences in physical characteristics of tested QDs of the same chemical composition led to rather different degradation patterns of phenol and toluene, and the amount of leak of the metal ions as well.