基于JC法尾矿坝稳定性可靠度研究

论述了可靠度理论在尾矿坝稳定性评价中可有效弥补定值法(安全系数法)存在的不足。文中选用JC法作为可靠度分析方法,结合实例对尾矿坝进行稳定性分析,分别求出了尾矿坝在正常和洪水工况下运行时的可靠度指标。并通过与定值法(安全系数法)比较,发现可靠度指标对坝体材料物理力学参数变异性的敏感度高于安全系数,因而得出可靠度方法可以更加全面、客观的反映出尾矿坝稳定性的真实状态。     

煤矿瓦斯爆炸事故的事故树分析与防治

瓦斯爆炸是煤矿生产中的重要灾害,一旦发生事故,会造成巨大的经济损失和人员伤亡.对瓦斯爆炸事故的原因进行了分析,并提出相应的预防措施.     

Some industrial effluents in Durgapur and their impact on the Damodar river

The industrial waste effluents from two industries of Durgapur have been traced along the course of Tamla Nalah at selected sites up to its confluence with the Damodar river and downstream. There are evidences of contamination of the river with toxic pollutants—ammonia, phenol, cyanide, sulphide, and trace mercury from Tamla Nalah. The upstream river water (Durgapur barrage), which is believed to be fairly pure, is actually not much better than the downstream river water. Monitoring data for about a year are presented and discussed.     

土壤粗胡敏素对铜离子的吸附作用及其影响因素

以暗棕壤为供试土壤,应用批量平衡法,研究了不同pH、离子强度、温度、Cu2+浓度和反应时间条件下,粗胡敏素(CHM)对Cu2+的吸附作用,并与相应胡敏酸(HA)的吸附作用进行了比较.结果表明:pH为2～4时,CHM对Cu2+的吸附率较低;随着pH的提高,吸附率增大;pH=7时,吸附率接近100%.随离子强度(0.01～1.00mol·L-1)增加,CHM对Cu2+的吸附量下降,其对Cu2+的吸附包括电性和专性吸附2种作用.随温度(25～45℃)的升高和Cu2+浓度(0～1000mg·L-1)的增加,CHM对Cu2+的吸附量增加,并与Langmuir方程拟合程度最好,25℃和45℃时的最大吸附量分别为12.61mg·g-1和14.31mg·g-1.CHM对Cu2+的吸附动力学过程可划分为快速(0～120min)和慢速(120～1440min)反应阶段,抛物线扩散方程拟合效果最好,与HA相比,CHM对Cu2+的吸附规律与HA相似,但其吸附量低于HA;表观热力学参数(△G、△H、△S)表明,CHM对Cu2+的吸附是自发、吸热和熵增加的过程,Cu2+在CHM上的吸附力大、活动性小、不易解吸,而在HA上的吸附力小、活动性大、容易解吸;活化能(E)和活化热力学参数(△G#、△H#、△S#)表明,CHM对Cu2+吸附所需能量多、活化熵高、吸附速率小,而HA对Cu2+吸附所需能量少、活化熵低、吸附速率大.     

MnO2对海底沉积物ANAMMOX菌的富集培养影响

采用上流式固定床反应器，在常温下连续运行，考察MnO2对海洋性ANAMMOX菌富集培养的影响，其中接种的海洋海底沉积物采自大连市附近海域。结果表明，在反应器运行近150d中，加入MnO2的R1反应器的最大总氮去除速率为137．82gN／（m3·d），比没有加人MnO2的R2反应器高出近20gN／（m3·d）。在低温环境（10～15℃）运行时，R1反应器的氨氮和亚硝氮去除率比R2反应器均高出10％，且Rl反应器对温度变化的适应性和运行稳定性都好于R2反应器。这表明MnO2的加入确实在一定程度上促进了海洋性ANAMMOX细菌的富集，并增强了ANAMMOX反应器对温度变化的适应性，使其能够在较宽的温度范围下运行。     

Occurrence of arsenic in brown rice and its relationship to soil properties from Hainan Island, China

The acquaintance of arsenic concentrations in rice grain is vital in risk assessment. In this study, we determined the concentration of arsenic in 282 brown rice grains sampled from Hainan Island, China, and discussed its possible relationships to the considered soil properties. Arsenic concentrations in the rice grain from Hainan Island varied from 5 to 309 μg/kg, with a mean (92 μg/kg) lower than most published data from other countries/regions and the maximum contaminant level (MCL) for As_i in rice. The result of correlation analysis between grain and soil properties showed that grain As concentrations correlated significantly to soil arsenic speciation, organic matter and soil P contents and could be best predicted by humic acid bound and Fe-Mn oxides bound As fractions. Grain arsenic rises steeply at soil As concentrations lower than 3.6 mg/kg and gently at higher concentrations.     

A novel approach to preparing ultra-lightweight ceramsite with a large amount of fly ash

•Ultra-lightweight ceramsite is prepared with 80% fly ash. •SiO₂, Al₂O₃, and flux contents significantly influence the performance of ceramsite. •The expansion of ceramsite is caused by the formation of a dense glaze and gas. •The bulk density of ultra-lightweight ceramsite is only 340 kg/m³. The disposal of fly ash has become a serious problem in China due to its rapid increase in volume in recent years. The most common method of fly ash disposal is solidification-stabilization-landfill, and the most common reuse is low-value-added building materials. A novel processing method for preparing ultra-lightweight ceramsite with fly ash was developed. The results show that the optimal parameters for preparation of ultra-lightweight ceramsite are as follows: mass ratio of fly ash:kaolin:diatomite= 80:15:5, preheating temperature of 800°C, preheating time of 5 min, sintering temperature of 1220°C, and sintering time of 10 min. The expansion agent is perlite, at 10 wt.% addition. Finally, a ceramsite with bulk density of 340 kg/m³, particle density of 0.68 g/cm³, and cylinder compressive strength of 1.02 MPa was obtained. Because of its low density and high porosity, ultra-lightweight ceramsite has excellent thermal insulation performance, and its strength is generally low, so it is usually used in the production of thermal insulation concrete and its products. The formation of a liquid-phase component on the surface, and generation of a gas phase inside ceramsite during the sintering process, make it possible to control the production of the suitable liquid phase and gas in this system, resulting in an optimization of the expansion behavior and microstructure of ceramsite. These characteristics show the feasibility of industrial applications of fly ash for the production of ultra-lightweight ceramsite, which could not only produce economic benefits, but also conserve land resources and protect the environment.     

Microbial fuel cell system: a promising technology for pollutant removal and environmental remediation

Environmental Science and Pollution Research - The microbial fuel cell (MFC) system is a promising environmental remediation technology due to its simple compact design, low cost, and renewable...