Fibre crops as alternative land use for radioactively contaminated arable land

The transfer of radiocaesium, one of the most important and widespread contaminants following a nuclear accident, to the fibre crops hemp (Cannabis sativa L.) and flax (Linum usitatissimum L.) as well as the distribution of radiocaesium during crop conversion were studied for sandy soil under greenhouse and lysimeters conditions. Soil parameters did not unequivoqually explain the transfer factors (TF) observed. TFs to flax stems ranged from 1.34 to 2.80x10(-3) m2 kg(-1). TFs to seeds are about a factor of 4 lower. During the retting process for separating the fibres from the straw, more than 95% of the activity was removed with the retting water. For hemp, the TF to the stem was about 0.6x10(-3) m2 kg(-1). For hemp, straw and fibres were mechanically separated and TF to straw was about 0.5x10(-3) m2 kg(-1) and to fibres 1.0x10(-3) m2 kg(-1). Generally, the TFs to the useable plant parts both for hemp and flax, are low enough to allow for the production of clean end-products (fibre, seed oil, biofuel) even on heavily contaminated land. Given the considerable decontamination during retting, contamination levels in flax fibres would only exceed the exemption limits for fibre use after production in extreme contamination scenarios (>12,300kBq m(-2)). Since hemp fibres are mechanically separated, use of hemp fibres is more restricted (contamination <740kBq m(-2)). Use of stems as biofuel is restricted to areas with contamination levels of <250 and 1050kBq m(-2) for flax and hemp, respectively. Use of seeds for edible oil production and flour is possible almost without restriction for flax but due to the high TFs to seed observed for hemp (up to 3x10(-3) m2 kg(-1)) consumption of hemp seed products should be considered with care.     

Carbonation of MSWI-bottom ash to decrease heavy metal leaching, in view of recycling

The 0.1-2 mm fraction of a MSWI-bottom ash cannot be used as granular construction material because leaching of Cu exceeds Flemish limit values. In addition, leaching of Ba, Mo and Sb exceeds informal limit values. Leaching characteristics thus need to be improved. Carbonation was the chosen treatment method and this was performed by placing samples in a CO2 chamber. The CO2 percentage and the temperature of the chamber atmosphere, as well as the initial humidity of the samples, were varied to optimize carbonation parameters. Metal leaching was tested with the EN 12457 extraction test. Carbonation decreased Cu leaching from 3.3 to 1.0 mg/kg, but not yet to below the official limit value of 0.5 mg/kg. Leaching of Mo and Sb remained fairly constant or even increased after carbonation, but their limit values are only informal. Ba leaching decreased to below the informal limit value. Carbonation also caused Cr leaching to increase, in some cases to above the official limit value. Of the tested parameters, a CO2 percentage of 10% and a carbonation temperature of 50 degrees C in the atmosphere, together with ash humidity between 13% and 25% appeared to give the best leaching results. The main carbonation reactions took place within the first 24 h.     

Clonal variation in heavy metal accumulation and biomass production in a poplar coppice culture. II. Vertical distribution and phytoextraction potential

Short rotation coppice cultures (SRC) are intensively managed, high-density plantations of multi-shoot trees. In April 1996, an SRC field trial with 17 different poplar clones was established in Boom (Belgium) on a former waste disposal site. In December 1996 and January 2001, all shoots were cut back to a height of 5 cm to create a coppice culture. For six clones, wood and bark were sampled at the bottom, middle and top of a shoot in August and November 2002. No significant height effect of metal concentration was found, but for wood, metal concentrations generally increased toward the top of the shoot in August, and decreased toward the top of the shoot in November. Phytoextraction potential of a clone was primarily determined by metal concentration and by biomass production. Shoot size and number of shoots per stool were less important, as a high biomass production could be achieved by producing a few large shoots or many smaller shoots. Clone Fritzi Pauley accumulated 1.4 kg ha(-1) of Al over two years; Wolterson and Balsam Spire showed a relatively high accumulation of Cd and Zn, i.e. averaging, respectively 47 and 57 g ha(-1) for Cd and 2.4 and 2.0 kg ha(-1) for Zn over two years.     

Metal accumulation in intertidal litter through decomposing leaf blades, sheaths and stems of Phragmites australis

Metal contents of decomposing leaf blades, leaf sheaths and stems of common reed (Phragmites australis) were monitored by a litter bag method on the sediment of an intertidal brackish marsh in the Scheldt estuary (The Netherlands). On monthly intervals, two litter bags were retrieved from the marsh during 9 months for both leaf blades and sheaths and during 16 months for stems. All samples were dried, weighed and analysed for ash and Cd, Cu, Cr, Ni, Pb and Zn contents. Most concentrations increased considerably during the decomposition. Generally, also a very important net metal inflow into the litter bags could be observed. The inflow was highest for leaf blades. High correlations between ash contents and metal concentrations for leaf blades suggest that the increase of leaf blade metal contents can be due to physicochemical sorption of dissolved metals and an important infiltration of mud particles, which were not removed by rinsing the leaf blades with distilled water preceding the analyses. For stems, smaller amounts of inflowing ash and even outflowing ash amounts were found, which suggests that inflow of inorganic particles is not the major factor determining metal accumulation by stems on medium term. Ergosterol concentrations in stem tissue however proved to be correlated with metal contents, which suggests a significant role of fungal litter colonizers in metal accumulation. For leaf sheaths, the effects of physicochemical sorption, infiltration of mud particles and incorporation by microbial litter colonizers do not seem to be as pronounced as for stems and leaf blades.     

A multi-objective optimization framework for surfactant-enhanced remediation of DNAPL contaminations

The occurrence of Dense Non-Aqueous Phase Liquid (DNAPL) contaminations in the subsurface is a threat for drinkwater resources in the western world. Surfactant-Enhanced Aquifer Remediation (SEAR) is widely considered as one of the most promising techniques to remediate DNAPL contaminations in-situ, be it with considerable additional costs compared to classical pump-and-treat remediations. A cost-effective design of the remediation set-up is therefore essential. In this work, a pilot SEAR test is executed at a DNAPL contaminated site in Belgium in order to collect data for the calibration of a multi-phase multi-component model. The calibrated model is used to assess a series of scenario-analyses for the full-scale remediation of the site. The remediation variables that were varied were the injection and extraction rate, the injection and extraction duration, and the surfactant injection concentrations. A constrained multi-objective optimization of the model was applied to obtain a Pareto set of optimal remediation strategies with different weights for the two objectives of the remediation: (i) the maximal removal of DNAPL and (ii) a total minimal cost. These Pareto curves can help decision makers to select an optimal remediation strategy in terms of cost and remediation efficiency. The Pareto front shows a considerable trade-off between the total remediation cost and the removed DNAPL mass.     

Environmental Persistence of Chemicals

- DOI: http://dx.doi.org/10.1065/espr2006.01.008 Background The hazard criterion of persistence as it applies to chemicals in the environment is reviewed and discussed. This quantity can not be measured directly in the environment, thus it must be estimated using models that synthesise information on chemical half-lives and partitioning properties, the nature of the environment and how the chemical is released into the environment. Main Features It is suggested that the preferred criterion is the average residence time of the chemical in the environment, i.e. conceptually the sum of the life-times of all molecules (attributable only to losses by degrading reactions) divided by the number of molecules. If all chemical fate processes are first order, this persistence is independent of the quantity of chemical introduced and whether introduction is steady- or unsteady-state in nature. It is shown that in a multimedia environment persistence is affected not only by degradation kinetics, but also by mode-of-entry and partitioning. For screening level purposes a Level II equilibrium model may be adequate but a Level III model is generally preferable for estimating the average persistence. If a distribution of persistences is required a dynamic Level IV model must be used. Discussion The implications for regulating chemicals on the basis of persistence are discussed. Conclusion It is concluded that the preferred strategy is to use Level II, III, and IV models and that the use of only degradation kinetics or media-specific half-lives can be misleading and uneconomical.     

Organohalogenated pollutants in human serum from Iassy, Romania and their relation with age and gender

Human serum samples (n=142) from Iassy county (Eastern Romania) collected in 2005 were analyzed for p,p'-DDT and its metabolites, hexachlorobenzene, hexachlorocyclohexane (HCH) isomers, chlordane and metabolites and 14 polychlorinated biphenyl (PCB) congeners. In all samples, p,p'-DDE (principal metabolite of p,p'-DDT) and beta-HCH (most persistent HCH isomer) were the most abundant organochlorine pesticides (OCPs) with median concentrations of 1975 and 923 ng/g lipid weight (lw), respectively. Hexachlorobenzene and p,p'-DDT were also detected in all samples, but at a lower median concentration of 30 and 340 ng/g lw, respectively. The large variation of the ratio p,p'-DDT/p,p'-DDE (range between 0.02 and 0.80) suggests various degrees of exposure to DDT, including recent exposure, at least to some subgroups of the population. Chlordane and its metabolites were in most cases close to the limit of quantification suggesting a very low use of chlordane formulations in Eastern Romania. Unexpectedly, PCBs were present in all samples at sometimes considerable levels (up to 4970 ng/g lw for sum of 14 PCB congeners) indicating a higher exposure of the Romanian population than previously reported. The PCB profile consisted of persistent congeners such as 138, 153, 170 and 180 which contributed for approximately 75% to the sum PCBs. Concentrations of most pollutants correlated significantly with age (r>0.86, p<0.01). Except for p,p'-DDT and gamma-HCH, the mean levels of OCPs in females were statistically higher than in males, while, except for octa-CBs, no gender differences were found for PCBs. Levels of p,p'-DDE, penta-CBs, hexa-CBs and hepta-CBs were significantly higher in individuals with a rural main residence. In a pooled serum sample, 6 polybrominated diphenyl ether (PBDE) congeners were measured at a level of 1.04 ng/g lw. Compared to results available from Central and Eastern European countries, human serum samples from Romania contained higher levels of contamination. This emphasizes that an extensive and rigorous program for the monitoring of OCPs and PCBs in Romanian population is highly needed in the light of possible adverse health effects acknowledged for these pollutants.     

How do transformational leaders foster positive employee outcomes? A self‐determination‐based analysis of employees' needs as mediating links

Although followers' needs are a central aspect of transformational leadership theory, little is known about their role as mediating mechanisms for this leadership style. The present research thus seeks to integrate and extend theorizing on transformational leadership and self‐determination. In particular, we propose that the satisfaction of followers' basic needs (autonomy, competence, and relatedness) mediates the relationship between transformational leadership and employee outcomes (job satisfaction, self‐efficacy, and commitment to the leader). We tested this model in two studies involving employees from a broad spectrum of organizations in Germany (N = 410) and in Switzerland (N = 442). Results revealed largely consistent patterns across both studies. The need for competence fulfillment solely mediated the link between transformational leadership and occupational self‐efficacy; the need for relatedness fulfillment solely mediated the link between transformational leadership and commitment to the leader. The mediating pattern for the link between transformational leadership and job satisfaction varied slightly across studies. In Study 1, only the need for autonomy fulfillment was a significant mediator, whereas in Study 2, all three needs mediated this relationship. Taken together, our study integrates theorizing on transformational leadership and self‐determination by corroborating that need fulfillment indeed is a central mechanism behind transformational leadership. Copyright © 2012 John Wiley & Sons, Ltd.     

High photocatalytic removal of NO gas over SnO2 nanoparticles under solar light

Environmental Chemistry Letters - Tin oxide nanoparticles (SnO2 NPs) with a diameter less than 10&nbsp;nm are usually used in waste water treatment via the photocatalytic reaction. However,...