基于层次分析法的秦皇岛市垃圾填埋场选址评价

城市垃圾填埋场场址的选择，受到当地经济、交通、气候条件，自然地理条件，环境保护条件，水文地质工程地质条件等诸多因素影响，是一项十分复杂的工程。本文总结了秦皇岛市现有垃圾填埋场的基本情况、存在问题及其产生原因。鉴于层次分析法在多目标决策分析方面的成效，将其运用到秦皇岛市垃圾填埋场选址评价中，对研究区进行适宜性分区，依次划分为最佳场地区、适宜场地区、较适宜场地区、不适宜场地区。     

SBR处理模拟氯苯废水

在SBR中利用光合细菌球形红细菌污泥颗粒进行模拟氯苯废水处理的初步研究,结果表明,采用球形红细菌污泥颗粒处理模拟氯苯废水的SBR系统是可行的,其降解氯苯过程符合Monod一级反应动力学方程。当进水氯苯浓度在125～187.5 mg/L变化时,处理效率都能稳定在90.5%～95.6%之间;其最佳工艺条件为反应时间6 h、DO 4.75～5.0 mg/L、沉淀时间1.5 h、污泥颗粒浓度4 000～6 000 mg/L。在污泥颗粒浓度4 000 mg/L、DO 5.0 mg/L、反应时间6 h的最佳条件下,当进水COD为748.1 mg/L、氯苯浓度100 mg/L时,COD的去除率达90.9%,处理后出水COD满足国家一级排放标准要求。     

超强静磁场对染料脱色菌Escheriehia coli的acpD基因的影响

将大肠杆菌E.coli ATCC8739置于12.0 T超强静磁场(ultra-strong static magnetic field,SMF)中进行处理,获得了磁场处理0.5、1、2、4和8 h的菌株E.coli-SMFn(n=0.5、1、2、4、8)。在37℃、pH 7、静置的条件下,菌株对偶氮染料AR14(I.C.Acid Red 14)的脱色结果指出,当反应进行到4、6和8 h时,E.coli-SMF8的脱色效率分别为18%、55%和96%,远高于E.coli ATCC8739的3%、19%和50%,表明SMF作用显著地增强了菌株的脱色效率。基因组DNA提取、PCR扩增、分子克隆以及基因测序的实验结果进一步表明,全部6例E.coli ATCC8739菌株的偶氮还原酶基因(acpD)序列均与GenBank中报道的完全一致;而E.coli-SMF8菌株的acpD-SMF8核酸序列中缺失了第99位的胞嘧啶。该缺失突变不仅使acpD-SMF8的核酸序列与acpD的存在显著不同,同时得到了具新活性中心的偶氮还原酶AzoR-SMF8。这个新的活性中心具有更强的黄素(FMN)结合能力,因此使该酶与偶氮染料的亲和力大大增加,促进了脱色效率的提高。     

清洁发展机制在石油行业的潜力分析

系统分析了石油行业清洁发展机制项目的潜力,并提出了建议。在统计与石油行业相关的清洁发展机制方法学及其注册项目和温室气体减排量的基础上,给出了各方法学与石油行业的相关性。从勘探与生产、天然气与管道、炼油与化工三大领域,分析了石油行业潜在的清洁发展机制项目领域。最后,提出了对石油行业开展清洁发展机制相关工作的建议。     

Measurement of Fine Particles in Diesel Emissions Using a Real-Time Aerosol Monitor

Abstract

A real-time monitoring methodology to determine diesel fine particles in diesel emissions has been evaluated. The range of particle size captured by the monitor was ～0.1 μm to 1 μm. DustTrak real-time monitors were connected to the dilution tunnel of the vehicle exhaust to measure the emissions during the vehicle tests under both dynamic and steady-state driving conditions, and concentration data were recorded every 5 sec. Test variation of the real-time monitoring among different test days was similar to that measured by traditional filter-based gravi-metric method, whereas the repeatability of the monitor data within the same-day tests was better than that of gravimetric method. Correlations between the two methods were established for different fuels tested on a single light duty vehicle. When the emissions from the reference fuel was used to convert the monitor’s response to diesel fuels, the levels determined by the real-time monitor were consistent with those measured by gravimetric method among different fuels tested. Use of the real-time monitor could provide information on the levels of fine particles that is more relevant to the public health than the total particles.     

Iron improving bio-char derived from microalgae on removal of tetracycline from aqueous system

Novel magnetic carbonaceous bio-char was hydrothermal prepared from microalgae under different loadings of iron and its structures and surface chemistry were characterized with Fourier transform infrared (FTIR), X-ray photoelectron spectroscopy (XPS), scanning electron microscopy (SEM), and nitrogen adsorption-desorption isotherm (BET). The morphology of bio-char changed from sheet to particle as iron loading increased and its surface area also increased. When 3.0 g of dried microalgae and 6.0 mmol iron salt ((NH₄)₂SO₄·FeSO₄·6H₂O) were mixed and treated, the obtained bio-char possessing the highest amount of oxygen-containing functional groups resulted in the best adsorption performance on tetracycline (TC). This adsorption process was fitted to Langmuir adsorption isotherm and the maximum adsorption capacity was 95.86 mg/g, which is higher than other bio-char reported. The iron loading contributed to the higher adsorption capacity of bio-char, which may be due to three factors, the high surface area, more hydrogen bonding, and bridging effects of the structural Fe for TC. Our data suggest that bio-char may have more important role in stabilization of pollutants in the environment.     

活性污泥缺氧转化1-2-7-三氨基-8-羟基-3-6-萘二磺酸

1—2-7-三氨基-8-羟基-3—6-萘二磺酸（TAHNDS）作为偶氮染料的脱色产物很难被常规的厌氧-好氧染料废水处理工艺所去除。研究了未经驯化的活性污泥对TAHNDS的缺氧转化效果。结果表明，只有在特定的缺氧条件下（ORP在-50～-150mV之间），TAHNDS才能被活性污泥所降解转化。当浓度在10—80mg／L范围内，TAHNDS可在72h内转化93％以上。加入100mg／L的硝酸盐和0．64mmol／L的氧化还原介体蒽醌-2-磺酸钠（AQS）可将40mg／L的TAHNDS的转化时间从84h缩短到36h。光谱及HPLC—MS分析表明，TAHNDS在缺氧条件下主要是通过脱氨基和脱磺酸作用生成已知可好氧生物降解的3，5-二氨基4-羟基萘-2-磺酸。因此，缺氧处理有望作为预处理工艺促进废水中TAHNDS的完全降解。     

Degradation of pentachlorobiphenyl by a sequential treatment using Pd coated iron and an aerobic bacterium (H1)

The reductive dechlorination and biodegradation of 2,2^′4,5,5^′-pentachlorobiphenyl (PCB#101) was investigated in a laboratory-scale. Palladium coated iron (Pd/Fe) was used as a catalytic reductant for the chemical degradation of 2,2^′4,5,5^′-pentachlorobiphenyl, and an aerobic bacteria was used for biodegradation following the chemical reaction in this study. Dechlorination was affected by several factors such as Pd loading, initial soil pH and the amount of Pd/Fe used. The results showed that higher Pd loading, higher dosage of Pd/Fe and slightly acid condition were beneficial to the catalytic dechlorination of 2,2^′,4,5,5^′-pentachlorobiphenyl. In laboratory batch experiments, 2,2^′4,5,5^′-pentachlorobiphenyl was reduced in the presence of Pd/Fe bimetal, which was not further degraded by aerobic bacteria. 2,2^′,4-trichlorobiphenyl (PCB#17), a reduction product from 2,2^′4,5,5^′-pentachlorobiphenyl, was readily biodegraded in the presence of a aerobic bacterial strain. It is suggested that an integrated Pd/Fe catalytic reduction-aerobic biodegradation process may be a feasible option for treating PCB-contaminated soil.     

利用烧结脱硫灰制备胶凝材料的研究

研究了烧结烟气半干法脱硫灰复掺矿渣、钢渣，辅之外加剂，制备胶凝材料的可行性。结果表明，采用改性脱硫灰（GXTLH）、钢渣、矿渣及水泥熟料再混磨制备的复合胶凝材料，具有良好的安定性等水化性能和力学性能；当GXTLH 掺入量为20%、CFII 1.5%、减水剂0.5%及水泥熟料23%时，矿渣掺量在12%～44%、钢渣掺量11%～44%之间制备的胶凝材料初凝时间、终凝时间、力学性能满足GB13592-92《钢渣矿渣水泥标准》；矿渣与钢渣比、水泥熟料及外加剂等掺量一定，GXTLH掺量超过30%时，GXTLH胶凝材料的抗压抗折强度均有所下降。     

Enhanced degradation of azo dye alizarin yellow R in a combined process of iron–carbon microelectrolysis and aerobic bio-contact oxidation

Purpose

With the aim of enhanced degradation of azo dye alizarin yellow R (AY) and further removal of the low-strength recalcitrant matter (LsRM) of the secondary effluent as much as possible, our research focused on the combination of aerobic bio-contact oxidation (ABO) with iron/carbon microelectrolysis (ICME) process.

Materials and methods

The combined ABO (with effective volume of 2.4?l) and ICME (with effectively volume of 0.4?l) process were studied with relatively short hydraulic retention time (HRT) of 4 or 6?h.

Results

At the HRT of 6?h with the reflux ratio of 1 and 2, the AY degradation efficiency in the final effluent was >96.5%, and the total organic carbon (TOC) removal efficiency were 69.86% and 79.44%, respectively. At the HRT of 4?h and the reflux ratio of 2, TOC removal efficiency and AY degradation efficiency were 73.94% and 94.89%, respectively. The ICME process obviously enhanced the total AY removal and the generated micromolecule acids and aldehydes then that wastewater backflow to the ABO where they were further biodegraded.

Conclusion

The present research might provide the potential options for the advanced treatment azo dyes wastewater with short HRT and acceptable running costs.