东大别地区重大地震事件深部地壳结构特征

本文应用东大别地区层析成像研究结果,对研究区重大地震事件的深部地壳结构特征进行了研究,结果表明：霍山地区的2次MS≥6.0级地震在深部地壳结构上具有一定的相似性;1970年以来的12次MS≥4.0地震在25 km深度的地壳速度结构特征比较接近。     

Observed LATCH use and misuse characteristics of child restraint systems in seven states

INTRODUCTION: Although the LATCH System (Lower Anchors and Tethers for Children) holds the promise of simplifying the installation of a child restraint system (CRS) to the vehicle's seat, many drivers transporting young children have difficulties using this technology. This paper reports on an observation study of LATCH use and misuse. METHOD: Observations of approximately 1,000 children less than 5 years of age in CRSs, in the back seats of vehicles that were equipped with tether and lower anchors, in seven states. RESULTS: Tethers were used for 51% of the children when the forward-facing CRS had tether straps and the vehicle had tether anchors. Lower anchors were used for 58% of the children when the CRS had lower attachments and the vehicle had lower anchors. The most common tether and lower attachment misuses were loose tether straps (18% of cases) and loose lower attachment installation (30% of the cases), respectively. Vehicle safety belts were used in combination with lower attachments in 20% of all lower anchor installations. CONCLUSION: As more caregivers of young children drive vehicles equipped with LATCH, it will be important to promote the proper installation of CRSs using this technology. LATCH education messages must also emphasize that the lower anchors may not always be the safest choice for CRS attachment -- the safest attachment is the one that results in a tight fit and will be used correctly consistently.     

A new THOR shoulder design: a comparison with volunteers, the Hybrid III, and THOR NT

OBJECTIVE: Since the shoulders are rarely seriously injured in frontal or oblique collisions, they have been given low priority in the development of frontal impact crash test dummies. The shoulder complex geometry and its kinematics are of vital importance for the overall dummy kinematics. The shoulder complex also influences the risk of the safety belt slipping off the shoulder in oblique forward collisions. The first aim of this study was to develop a new 50th percentile male THOR shoulder design, while the second was to compare the new shoulder, mounted on a THOR NT dummy, with volunteer, THOR NT, and Hybrid III range of motion and stiffness data. The third aim was to test the repeatability of the new shoulder during dynamic testing and to see how the design behaves with respect to belt slippage in a 45 degrees far-side collision. METHODS: The new 50th percentile THOR shoulder design was developed with the aid of a shell model of the seated University of Michigan Transportation Research Institute (UMTRI) 50th percentile male with coordinates for joints and bony landmarks (Schneider et al., 1983). The new shoulder design has human-like bony landmarks for the acromion and coracoid processes. The clavicle curvature and length are also made similar to that of a male human, as is the range of motion in the anterior-posterior, superior-inferior, and medial-lateral directions. The new shoulder design was manufactured and tested under the same conditions that T?rnvall et al. (2005b) used to compare the shoulder range of motion for the volunteers, Hybrid III, and THOR Alpha. The new design was also tested in two dynamic test configurations: the first was a 0 degrees full-frontal test and the second was a 45 degrees far-side test. The dummy tests were conducted with an R-16 seat with a three-point belt, the Delta V was 27.0+/-0.5 km/h and the maximum peak acceleration was approximately 14.6+/-0.5 g for each test. RESULTS: A new shoulder design with geometry close to that of humans was developed to be retrofitted to the THOR NT dummy. The results showed that the range of motion for the new shoulder complex during static loading was larger by at least a factor of three, for the maximum load (200 N/arm), than that of either the Hybrid III or the THOR NT; this means it was more similar to the volunteers' range of motion. It was observed that the THOR NT with the new shoulder did not slide out of the shoulder belt during a far-side collision. The performance of the new shoulder was reasonably repeatable and stable during both the static tests and the sled tests. CONCLUSION: A new shoulder for the THOR NT has been designed and developed, and data from static range of motion tests and sled tests indicate that the new shoulder complex has the potential to function in a more human-like manner on the THOR dummy.     

Aerobic degradation of methyl tert-butyl ether by a Proteobacteria strain in a closed culture system

The contamination of methyl ten-butyl ether （MTBE） in underground waters has become a widely concerned problem all over the world. In this study, a novel dosed culture system with oxygen supplied by H2O2 was introduced for MTBE aerobic biodegradation. After 7 d, almost all MTBE was degraded by a pure culture, a member of β-Proteobacteria named as PMI, in a closed system with oxygen supply, while only 40% MTBE was degraded in one without oxygen supply. Dissolved oxygen （DO） levels of the broth in closed systems respectively with and without H2O2 were about 5-6 and 4 mg/L. Higher DO may improve the activity of monooxygemase, which is the key enzyme of metabolic pathway from MTBE to tert-butyl alcohol and finally to CO2, and may result in the increase of the degrading activity of PM1 cell. The purge and trap GC-MS result of the broth in closed systems showed that tea-butyl alcohol, isopronol and acetone were the main intermediate products.     

铅在棉秆基活性炭上的吸附动力学与热力学

以棉秆与棉秆纤维为原料,利用磷酸活化法制备了低成本的高比表面微孔棉秆基活性炭,通过静态实验研究了活性炭对水溶液中铅的吸附特性,测定了溶液pH值、吸附时间、溶液温度对吸附的影响,探讨了吸附动力学、热力学及吸附机制.根据低温液氮(N2/77K)吸附测定数据,以BET方程、BJH法及H-K法对活性炭孔结构进行了表征,以Boehm滴定、FTIR、零电荷点pHPZC测定及元素分析定量表征活性炭表面含氧官能团.结果表明,以棉秆和棉秆纤维为原料制备的活性炭的比表面积分别为1570和1731m2·g-1,含氧酸官能团含量分别为1.43和0.83mmol·g-1,均高于商业活性炭ST1300.静态吸附实验表明,棉秆基活性炭对铅有较大的吸附容量和吸附效率,最大吸附量超过120mg·g-1,溶液pH对吸附有较大的影响,吸附量随时间增大而增大,在5min内可达饱和吸附量的80%;吸附动力学数据符合假二级方程,Freundlich方程能更好地描述等温吸附行为;热力学研究表明,吸附吉布斯自由能(ΔG0)0,而焓变(ΔH0)0,说明吸附为吸热的自发反应过程,升温有利于吸附,离子交换可能在吸附过程中起了重要作用.     

巢湖周围池塘氮、磷和有机质研究

巢湖周围池塘众多,根据池塘位置和地表径流补给差异,池塘可以分为村庄内池塘、毗邻村庄池塘和农田区域池塘(远离村庄的池塘).本研究采集了巢湖周围136口池塘上覆水和沉积物样品,调查巢湖周围池塘中氮、磷以及有机质污染现状.结果表明,池塘上覆水中总氮、氨氮、硝态氮、亚硝态氮、总磷、溶解态磷和COD平均含量分别为2.53、0.65、0.18、0.02、0.97、0.38和51.58mg·L-1;池塘沉积物中总氮、氨氮、硝态氮、亚硝态氮、总磷、无机磷、有机磷和烧失量平均含量分别为1575.36、35.73、13.30、2.88、933.19、490.14、414.75mg·kg-1和5.44%;90%以上的池塘总氮、总磷含量达到或超过富营养化水平.位于村庄内的池塘上覆水和沉积物中总氮和氨氮的含量显著高于位于农田区域的池塘.上覆水和沉积物中无机氮表现为:氨氮硝态氮亚硝态氮.池塘上覆水和沉积物中有机质与总氮、总磷之间存在显著的正相关性.池塘中氮、磷和有机物质主要为陆源性输入,池塘位置和径流补给方式明显影响其中的氮、磷和有机质含量.通过截留径流中的氮、磷和有机质,池塘能够有效减少进入巢湖的营养盐含量.     

Effects of irrigation,fertilization and crop straw management on nitrous oxide and nitric oxide emissions from a wheat–maize rotation field in northern China

One-year winter wheat–summer maize rotation is the most popular double cropping system in north-central China, and this highly productive system is an important source of nitrous oxide (N₂O) and nitric oxide (NO) emissions due to the high fertilizer N and irrigation water inputs. To sustain the high crop production and mitigate the detrimental impacts of N₂O and NO emissions, improved management practices are extensively applied. The aim of this study is therefore to evaluate the effects of an improved management practice of irrigation, fertilization and crop straw on grain yield and N₂O and NO emissions for a wheat–maize rotation field in northern China. Using automated and manual chamber measuring systems, we monitored N₂O and NO fluxes for the conventional (CT, 2007–2008), improved (IT, 2007–2008), straw-amended (WS, 2008–2009), straw-not-amended (NS, 2008–2009), and no N-fertilizer treatments (WS–NN, 2008–2009), respectively, for one rotation-year. The grain yields were determined for CT and IT for three rotation-years (2005–2008) and for WS, NS and WS–NN for one rotation-year (2008–2009). The improved management of irrigation and fertilization reduced the annual N fertilization rate and irrigation amount by 17% and 30%, respectively; increased the maize yield by 7–14%; and significantly decreased the N₂O and NO emissions by 7% (p < 0.05) and 29% (p < 0.01), respectively. The incorporation of wheat straw increased the cumulative N₂O and NO emissions in the following maize season by 58% (p < 0.01) and 13%, respectively, whereas the effects of maize straw application were not remarkable. The N₂O and NO emission factors of applied N were 2.32 ± 2.32% and 0.42 ± 1.69% for wheat straw and 0.67 ± 0.23% and 0.54 ± 0.15% for chemical N-fertilizers, respectively. Compared to conventional management practices using high application rates of irrigation water and chemical N-fertilizer as well as the field burning of crop straw, the improved management strategy presented here has obvious environmentally positive effects on grain yield and mitigation of N₂O and NO emissions.     

太湖沉积物酸可挥发性硫化物分布特征及重金属生物有效性评价

对太湖4个湖区沉积物的酸可挥发性硫化物（AVS）和同步可提取重金属（SEM）的水平和垂直分布特征进行了研究,并对沉积物重金属的潜在生态风险进行初步评价.结果表明,氧化还原电位（Eh）与AVS和SEM含量均无显著相关性;表层沉积物中AVS含量分布在研究区差异较大,变异系数达134.28%;∑SEM含量波动较小,变异系数为...     

An abbreviated alternatives assessment process for product designers: a children’s furniture manufacturing case study

Alternatives assessment is becoming increasingly popular to evaluate the potential environmental and human health hazards of materials. A three step process was used to identify and evaluate alternative products for a children's furniture manufacturer. An alternatives assessment framework was developed to analyze alternative mattresses. The framework specifically addresses those environmental and safety attributes applicable to the product and the product components in accordance with the product’s intended use. The result of the assessment allowed the manufacturer to select the most environmentally friendly alternative and eliminate polyvinyl chloride from their product.     

Minimizing leakage from a smelter off-gas system by enhanced control

The off-gas handling system is a vital component of a smelter and it is essential that it operates in accordance with environmental regulations. A key feature of the off-gas management system is maintaining a slightly negative system pressure to prevent gas leakage, such as SO₂, out into the work and external environments. To enhance sustainable development, there is also growing interest in capturing and reusing the significant amount of heat and CO₂ contained within off-gas. The potential incorporation of heat and CO₂ recovery systems places importance on enhancing control to minimize the risk of both gas leakage and disturbance of the smelting process. With these requirements in mind, an easily implementable feedforward control enhancement to existing control schemes is proposed to help provide improved performance.