HPLC-FLD determination of 4-nonylphenol and 4-<Emphasis Type="Italic">tert</Emphasis>-octylphenol in surface water samples

A simple, sensitive and reliable HPLC-FLD method for the routine determination of 4-nonylphenol, 4-NP and 4-tert-octylphenol, 4-t-OP content in water samples was developed. The method consists in a liquid–liquid extraction of the target analytes with dichloromethane at pH  3.0–3.5 followed by the HPLC-FLD analysis of the organic extract using a Zorbax Eclipse XDB C8 column, isocratic elution with a mixed solvent acetonitrile/water 65:35, at a flow rate of 1.0 mL/min and applying a column temperature of 40°C. The method was validated and then applied with good results for the determination of 4-NP and 4-t-OP in Ialomi?a River water samples collected each month during 2006. The concentration levels of 4-NP and 4-t-OP vary between 0.08–0.17 μg/L with higher values of 0.24–0.37 μg/L in the summer months for 4-NP, and frequently <0.05 μg/L but also between 0.06–0.09 μg/L with higher values of 0.12–0.16 μg/L in July and August for 4-t-OP and were strongly influenced by sesonial and anthropic factors. The method was also applied on samples collected over 2 years 2007 and 2008 from urban wastewaters discharged into sewage or directly into the rivers by economic agents located in 30 Romanian towns. Good results were obtained when the method was used for analysis of effluents discharged into surface waters by 16 municipal wastewater treatment plants, during the year 2008.     

In Situ flushing of contaminated soils from a refinery: Organic compounds and metal removals

This article demonstrates the applicability of in situ flushing for the remediation of soil contaminated with petroleum hydrocarbons at a Mexican refinery. The initial average total petroleum hydrocarbon (TPH) concentration for the demonstration field test was 55,156 g/kg. After six weeks of in situ flushing with alternate periods of water and water/surfactant, an average concentration of 1,407 mg/kg was reached, achieving a total removal efficiency of 98 percent. At the end of the process, no hydrocarbons such as diesel; gasoline; benzene, toluene, ethyl benzene, and xylene (BTEX); or petroleum aromatic hydrocarbons (PAHs) were found. Iron washing achieved a removal efficiency of 70 percent, and for vanadium, the removal efficiency was 94.4 percent. The volume of soil treated was 41.6 m³ (38 m²), equivalent to 69.5 tons of soil. A rough calculation of the process costs estimated a total cost of $104.20/m³ ($114.00/m²). Our research indicates that there are a few studies demonstrating in situ flushing experiences under field conditions where both organic (TPH, diesel, gasoline, PAHs, BTEX) and metal (iron and vanadium) removals are reported. © 2004 Wiley Periodicals, Inc.     

Organochlorine contaminants in hair of adolescents from Iassy, Romania

Human hair samples (n=42) from Iassy county (Eastern Romania) collected in 2002-2003 from adolescents were analyzed for hexachlorocyclohexane (HCH) isomers, p,p'-DDT and its metabolites, hexachlorobenzene (HCB), chlordane and metabolites and 5 polychlorinated biphenyl (PCB) congeners. Very low levels were found for HCB and oxychlordane (0.8 and 2.5 ng g(-1)) indicating a low usage of these pesticide formulations in the studied area. In case of HCHs, gamma-HCH isomer was measured at higher median concentrations (79 ng g(-1) hair) compared to the beta-HCH isomer (55 ng g(-1)), which generally is the most prevalent from HCHs. The DDTs profile consisted in p,p'-DDE and p,p'-DDT which levels correspond to 81% of sum DDTs. Very high median concentrations measured for p,p'-DDT (192 ng g(-1)) combined with lower values for p,p'-DDE/p,p'-DDT of 0.4 (from 0.20 to 2.0) in all hair samples suggest recent exposure to "fresh" DDT. When gender was considered, significantly higher concentrations for most of the investigated contaminants were found in girls hair compared to boys. Very high levels were found in the present study for HCHs and DDTs compared to samples from Greece, Western Europe and China. In case of PCBs, the levels found in Romanian samples were found to be in the same range compared to other previously published data.     

Trace Element Contaminants in Sediments From the Noaa National Status and Trends Programme Compared to Data From Throughout the World

The National Oceanic and Atmospheric Administration's (NOAA) National Status and Trends (NS&T) Programme has analyzed samples of surface sediment collected at almost 300 coastal and estuarine sites throughout the United States since 1984. the overall distributions for concentrations of each element are approximately lognormal allowing a definition of geometric means and of “high” concentrations as those exceeding the mean plus one standard deviation of the lognormal distribution. Those mean and “high” concentrations should be useful for comparing the NS&T data set and with other reports on sediment contamination. A world-wide data set, constructed from data in the literature, was summarized in an identical manner. It was found, after excluding locally extreme values, that the NS&T and world-wide data sets yielded very similar mean and “high” concentrations for Cu, Ni, Pb and Zn. Chromium was the sole element showing higher summary statistics in the NS&T data set, a result attributed to NS&T sampling in areas of naturally (not contaminated) elevated Cr content. It remains undetermined, however, why the world-wide data set, even with exclusion of “hot spots”, yielded higher means and “highs” for Cd, Hg, As, and Ag.     

Sequential removal of heavy metals ions and organic pollutants using an algal-bacterial consortium

The residual algal-bacterial biomass from photosynthetically supported, organic pollutant biodegradation processes, in enclosed photobioreactors, was tested for its ability to accumulate Cu(II), Ni(II), Cd(II), and Zn(II). Salicylate was chosen as a model contaminant. The algal-bacterial biomass combined the high adsorption capacity of microalgae with the low cost of the residual biomass, which makes it an attractive biosorbent for environmental applications. Cu(II) was preferentially taken-up from the medium when the metals were present both separately and in combination. There was no observed competition for adsorption sites, which suggested that Cu(II), Ni(II), Cd(II), and Zn(II) bind to different sites and that active Ni(II), Cd(II) and Zn(II) binding groups were present at very low concentrations. Therefore, special focus was given to Cu(II) biosorption. Cu(II) biosorption by the algal-bacterial biomass was characterized by an initial fast cell surface adsorption followed by a slower metabolically driven uptake. pH, Cu(II), and algal-bacterial concentration significantly affected the biosorption capacity for Cu(II). Maximum Cu(II) adsorption capacities of 8.5+/-0.4 mg g-1 were achieved at an initial Cu(II) concentration of 20 mg l-1 and at pH 5 for the tested algal-bacterial biomass. These are consistent with values reported for other microbial sorbents under similar conditions. The desorption of Cu(II) from saturated biomass was feasible by elution with a 0.0125 M HCl solution. Simultaneous Cu(II) and salicylate removal in a continuous stirred tank photobioreactor was not feasible due to the high toxicity of Cu(II) towards the microbial culture. The introduction of an adsorption column, packed with the algal-bacterial biomass, prior to the photobioreactor reduced Cu(II) concentration, thereby allowing the subsequent salicylate biodegradation in the photobioreactor.     

Levels and distribution of organochlorine pesticides, polychlorinated biphenyls and polybrominated diphenyl ethers in sediments and biota from the Danube Delta, Romania

Concentrations of polychlorinated biphenyls (PCBs), polybrominated diphenyl ethers (PBDEs) and organochlorine pesticides (OCPs), such as dichlorodiphenyltrichloroethane (DDT) and analogues, hexachlorocyclohexanes (HCHs) and hexachlorobenzene (HCB), were measured in sediments and biota (invertebrates, 11 fish species and cormorant tissues) collected in 2001 from the Danube Delta, the biggest European wetland. DDTs were the predominant pollutants in all samples. A high variability in the concentrations of pollutants within the same species was observed and this was related to sampling location, age, length and sex. DDTs were also the main organohalogenated contaminants in cormorant muscle and liver, followed by PCBs, HCHs, HCB and PBDEs. The present levels of DDTs in cormorant tissues are lower than levels measured in cormorant eggs sampled from the Danube Delta in 1982 and 1997, respectively. The variance of delta15N for herbivores was much greater than for carnivores, while carp and bream showed higher delta15N signatures than expected, probably due to a higher dietary proportion of benthos, typically more delta15N enriched relative to pelagic biota.     

Distribution of organochlorine pesticides, polychlorinated biphenyls and alpha-HCH enantiomers in pork tissues

The distribution of HCH isomers, DDT analogues and selected PCB congeners in pork organs collected from the same individuals raised in Romanian farms was investigated. Organochlorine pesticides (HCHs and DDTs) were the principal contaminants in all samples, while PCB concentrations were low, in accordance with previously reported concentrations from Romanian animal farms. The most part of the pollutant load in the body is retained in the adipose tissue, with HCHs ranging between 16 and 27.7 ng/g lipid and with higher concentrations of DDTs ranging between 65.9 and 334.5 ng/g lipid. The highest PCB levels (up to 32 ng/g lipid) were measured in lung and liver. The lipid-normalized concentrations in the brain were lower than in all other tissues due to the presence of the blood-brain barrier or due to a lower proportion of the neutral lipids such as triglycerides. The highest concentrations of DDTs were measured in muscle and fat, with p,p'-DDE being the principal contributor and with a variable contribution of p,p'-DDD and p,p'-DDT. In liver, p,p'-DDD has a higher contribution to the sum DDTs, while in all analyzed livers, the concentration of p,p'-DDT was very low. beta-HCH was the most persistent HCH isomer in all tissues, accounting for 40-97% of sum HCHs. For all animals, the highest concentrations of beta-HCH and HCHs were found in liver, while the lowest HCH concentrations were measured in brain and spinal marrow. Additionally, the distribution of alpha-HCH enantiomers in the tissues was discussed. In all samples (except 2 brain samples), (+) alpha-HCH was depleted and (-) alpha-HCH was enantioenriched. Enantiomeric ratios in brain were the highest measured values between all organs. For all studied animals, ERs increased in the order fat < muscle < liver < brain.     

Green marketing mix: A case study of Brazilian retail enterprises

The challenges posed by the limited availability of resources means that retail operations and methods must be revised and redesigned. Against the current backdrop of changes, companies are seeking to innovate the way in which they market their wares. Within this context, this article discusses the “green marketing mix” from the perspective of Brazilian retail enterprises. In addition, the study described in this article sought to identify and highlight the elements that should be considered when defining strategically each variable within the green retail marketing mix. As part of this work, a case study was carried out on two Brazilian retail companies. The case analysis revealed that despite defining themselves as “green,” when their retail marketing mix was analyzed, the companies presented differing degrees of sustainability. Furthermore, expanding the theoretical framework for the green retail marketing mix is a crucial issue in the services sector, and it has significant, practical repercussions.     

Trace Element Contaminants in Sediments From the Noaa National Status and Trends Programme Compared to Data From Throughout the World

The National Oceanic and Atmospheric Administration's (NOAA) National Status and Trends (NS&T) Programme has analyzed samples of surface sediment collected at almost 300 coastal and estuarine sites throughout the United States since 1984. the overall distributions for concentrations of each element are approximately lognormal allowing a definition of geometric means and of “high” concentrations as those exceeding the mean plus one standard deviation of the lognormal distribution. Those mean and “high” concentrations should be useful for comparing the NS&T data set and with other reports on sediment contamination. A world-wide data set, constructed from data in the literature, was summarized in an identical manner. It was found, after excluding locally extreme values, that the NS&T and world-wide data sets yielded very similar mean and “high” concentrations for Cu, Ni, Pb and Zn. Chromium was the sole element showing higher summary statistics in the NS&T data set, a result attributed to NS&T sampling in areas of naturally (not contaminated) elevated Cr content. It remains undetermined, however, why the world-wide data set, even with exclusion of “hot spots”, yielded higher means and “highs” for Cd, Hg, As, and Ag.