Environmental assessment of trace element bioaccumulation in sipunculan from seagrass and wetland sediments

This study is the first measurement of trace elements in sipunculan and their surrounding sediments. The bioaccumulation characteristics of arsenic (As), cadmium (Cd), chromium (Cr), copper (Cu), mercury (Hg), and zinc (Zn) were analyzed and compared in two sipunculan species, Sipuncula nudus and Siphonosoma vastum, which were collected from seagrass beds and wetlands in Taiwan. The sipunculan and sediment samples were analyzed using an inductively coupled plasma mass spectrometer. Both sipunculan in the wetlands and seagrass beds had a high Cu bioaccumulation mechanism. Multivariate analysis, principle component analysis, and partial least squares for discriminant analysis of trace element levels and bioaccumulation factors were used to distinguish the element distributions that corresponded to the two habitats (seagrass beds and wetlands). Different levels of certain trace elements in these two sipunculan species may result not only from the environmental factors of various habitats but also from the accumulation characteristics of various species. The As, Cd, Cr, Cu, Hg, and Zn concentrations were markedly lower in sipunculan than in other invertebrates from the adjacent polluted regions. The public health issues regarding the consumption of sipunculan are also discussed.     

Remediation of soil contaminated with pyrene using ground nanoscale zero-valent iron

The sites contaminated with recalcitrant polycyclic aromatic hydrocarbons (PAHs) are serious environmental problems ubiquitously. Some PAHs have proven to be carcinogenic and hazardous. Therefore, the innovative PAH in situ remediation technologies have to be developed instantaneously. Recently, the nanoscale zero-valent iron (ZVI) particles have been successfully applied for dechlorination of organic pollutants in water, yet little research has investigated for the soil remediation so far. The objective in this work was to take advantage of nanoscale ZVI particles to remove PAHs in soil. The experimental factors such as reaction time, particle diameter and iron dosage and surface area were considered and optimized. From the results, both microscale and nanoscale ZVI were capable to remove the target compound. The higher removal efficiencies of nanoscale ZVI particles were obtained because the specific surface areas were about several dozens larger than that of commercially microscale ZVI particles. The optimal parameters were observed as 0.2 g iron/2 mL water in 60 min and 150 rpm by nanoscale ZVI. Additionally, the results proved that nanoscale ZVI particles are a promising technology for soil remediation and are encouraged in the near future environmental applications. Additionally, the empirical equation developed for pyrene removal efficiency provided the good explanation of reaction behavior. Ultimately, the calculated values by this equation were in a good agreement with the experimental data.     

Removal of Cu(II) from aqueous solution in a fluidized-bed reactor

In this study, a fluidized-bed reactor (FBR) was employed to treat copper-containing wastewater by mean of copper precipitation on the surface of sand grains. The conditions for optimum copper removal efficiency were also investigated. This technology was controlled so as to keep supersaturation low to induce the nucleated precipitation of copper coating on the sand surface in an FBR. The effects of relevant parameters, such as the pH value, the molar ratio of [C(T)] to [Cu(2+)], hydraulic loading and the types of chemical reagents used, were examined. The experimental results indicated that 96% copper removal efficiency could be achieved when the influent copper concentration was 10mg l(-1). The optimum chemical reagent was Na(2)CO(3); the molar ratio of [C(T)]/[Cu(2+)] was 2, and the optimal hydraulic loading was not be more than 25m h(-1). In addition, preventing homogeneous nucleation in the FBR was an important operation parameter. Homogeneous nucleation and molecular growth would lead to undesirable microparticle formation in the effluent. A good mixture of carbonate and copper in the presence of sand grains could reduce the level of homogeneous nucleation in the bottom of the reactor. Energy dispersive analysis (EDS) of X-rays provided insight into the copper coating on the sand surface, and element analysis indicated the weight percentages of CuCO(3) and Cu(OH)(2) in precipitate.     

Organotin contamination in fishes with different living patterns and its implications for human health risk in Taiwan

Contaminated levels of butyl- and phenyltin compounds, tributyltin (TBT), dibutyltin (DBT), monobutyltin (MBT), triphenyltin (TPT), diphenlytin (DPT), and monophenyltin (MPT), were investigated in pelagic, demersal and cultured fish species from different seasons and locations in Taiwan. Seasonal variations were found in fishes from Wuchi and Hsingta fishing harbors for their butyltin levels (winter>summer) with the opposite trend for phenyltins in fishes from Patoutzu fishing harbor and demersal fishes from four fishing harbors (summer>winter). Fish liver contained the lowest percentage of TBT and the highest percentage of TPT among six organotin compounds. Consumption of contaminated pelagic species and fishes from Hsingta fishing harbor had the highest hazard index. However, the hazard quotients and hazard indices were all less than 1, suggesting a daily exposure at these levels of TBT, DBT and TPT may not be likely to cause any deleterious effects during lifetime in human population.     

Profiles of PAH emission from steel and iron industries

In order to characterize the polycyclic aromatic hydrocarbons (PAHs) emission from steel and iron industries, this study measured the stack emission of twelve steel and iron plants in southern Taiwan to construct a set of source fingerprints. The study sampled the emissions by the USEPA's sampling method 5 with the modification of Graseby for the gas and particulate phase PAH and, then, used Hewlett-Packard 5890 gas chromatograph equipped with mass spectrometer detector to analyze the samples. The steel and iron industries are classified into three categories on the basis of auxiliary energy source: Category I uses coal as fuel, Category II uses heavy oil as fuel and Category III uses electric arc furnace. The pollution source profiles are obtained by averaging the ratios of individual PAH concentrations to the total concentration of 21 PAHs and total particulate matter measured in this study. Results of the study show that low molecular weight PAHs are predominant in gas plus particulate phase for all three categories. For particulate phase PAHs, however, the contribution of large molecular weight compounds increases. Two-ring PAHs account for the majority of the mass, varying from 84% to 92% with an average of 89%. The mass fractions of 3-, 4-, 5-, 6-ring PAHs in Category I are found to be more than those of the other two categories. The mass of Category III is dominated by 7-ring PAHs. Large (or heavy) molecular weight PAHs (HMW PAHs) are carcinogenic. Over all categories, these compounds are less than 1% of the total-PAH mass on the average. The indicatory PAHs are benz[a]anthracene, benzo[k]fluoranthene, benzo[ghi]perylene for Category I, benzo[a]pyrene, acenaphthene, acenaphthylene for Category II and coronene, pyrene, benzo[b]chrycene for Category III. The indicatory PAHs among categories are very different. Thus, dividing steel and iron industry into categories by auxiliary fuel is to increase the precision of estimation by a receptor model. Average total-PAH emission factors for coal, heavy oil and electric arc furnace were 4050 μg/kg-coal, 5750 μg/l-oil, 2620 μg/kW h, respectively. Carcinogenic benzo[a]pyrene for gas plus particulate phase was 2.0 g/kg-coal, 2.4 μg/l-oil and 1.4 μg/kW h for Category I, II and III, respectively.     

Intrauterine intervention in a case of recurrent meconium peritonitis

We present a case of recurrent meconium peritonitis detected in the second trimester and treated by intrauterine intervention. Antenatal ultrasound findings included fetal ascites and intra-abdominal calcification. Aspiration of fetal ascites under ultrasound guidance and determination of the bilirubin concentration established the diagnosis of meconium peritonitis. Paracentesis was repeated to remove irritating intestinal contents and to decrease pressure on the fetal thorax. Although the exact cause of the meconium peritonitis remains unknown, the recurrence of the condition suggests a genetic basis. A possibility of cystic fibrosis was not considered because the clinical picture did not suggest it. Intrauterine intervention helped to establish the diagnosis of meconium peritonitis and may have contributed to the good outcome.     

Optimal nonpoint source pollution control strategies for a reservoir watershed in Taiwan

The purpose of this study is to develop a model for optimal nonpoint source pollution control for the Fei-Tsui Reservoir watershed in Northern Taiwan. Several structural best management practices (BMPs) are selected to treat stormwater runoff. The complete model consists of two interacting components: an optimization model based on discrete differential dynamic programming (DDDP) and a zero-dimensional reservoir water quality model. A predefined procedure is used to locate suitable sites for construction of various selected BMPs in the watershed. In the optimization model, the objective function is to find the best combination of BMP type and placement, which minimizes the total construction and operation, maintenance, and repair (OMR) costs of the BMPs. The constraints are the water quality standards for total phosphorus (TP) and total suspended solids (TSS) concentrations in the reservoir. A zero-dimensional reservoir water quality model of the Vollenweider type is embedded in the optimization framework to simulate pollutant concentrations in Fei-Tsui Reservoir. The resulting optimal cost and benefit of water quality improvement are depicted by the model-derived trade-off curves. The modeling framework developed in the present study could be used as an efficient tool for planning a watershed-wide implementation of BMPs for mitigating stormwater pollution impact on the receiving water bodies.     

Biological responses to environmental forcing: the linear tracking window hypothesis

Determining the relative contributions of intrinsic and extrinsic processes to the regulation of biological populations has been a recurrent ecological issue. Recent discussions concerning ecosystem "regime shifts" again raise the question of whether population fluctuations are mainly controlled by external forcing. Results of nonlinear time series analyses indicate that pelagic populations typically do not passively track stochastic environmental variables. Rather, population dynamics are better described as nonlinear amplification of physical forcing by biological interactions. However, we illustrate that in some cases populations do show linear tracking of the physical environment. To explain why population dynamics can sometimes be linear, we propose the linear tracking window hypothesis: populations are most likely to track the stochastic environmental forcing when their generation time matches the characteristic time scale of the environmental signal. While our observations follow this hypothesis well, our results indicate that the linear tracking window is a necessary but not a sufficient condition.