Field evaluation of resistivity sensors for in situ moisture measurement in a bioreactor landfill

The ability of resistance-based sensors to measure in situ waste moisture content in a landfill was examined. One hundred and thirty-five resistance-based sensors were installed in a leachate recirculation well field at a bioreactor landfill in Florida, US. The performance of these sensors was studied for a period of over 6 years. The sensors were found to respond to an increase in moisture resulting from leachate recirculation. It was observed that 78% of sensors worked successfully in the field during the study period. The initial spatial average moisture content determined by the sensor readings (using a laboratory-derived calibration) was 42.8% compared to 23% from gravimetric readings. Eighteen sensors (13%) showed that they were saturated before liquid addition, and no change in moisture content was observed in these sensors during the study period. Laboratory-derived calibration methods resulted in an over-estimation of moisture content. An alternate field-calibration method, where wetted sensor output was assumed equal to the average of gravimetric measurements for wet samples, was evaluated. The final spatial average moisture contents were 64.2% and 44.4% for the laboratory-derived and field-derived calibration methodologies, respectively, compared to 45% measured gravimetrically from excavated waste samples. When moisture content was determined using a mass balance approach, the result was 34.6%. The results suggest that when appropriately calibrated, resistivity-based sensors can be used to obtain a reasonably accurate estimate of local moisture content. However, caution should be taken to extend the moisture content values that are representative of waste surrounding the sensors to estimate the overall moisture content on the landfill-wide scale.     

Water Quality Modeling of Municipal Discharges from Sea Outfalls,Mumbai

The island city of Mumbai with a population of about 10 million generates about 2000 million liters per day (mld) of sewage from the seven service areas of the city sewerage network and discharges it into the adjoining west coast and the two creeks in the Arabian Sea. This has resulted in degradation of coastal water quality, contamination of the adjoining beaches and seafronts. The Municipal Corporation of Greater Mumbai has therefore, undertaken the task of delineating appropriate sewage disposal system to achieve cleaner marine ecosystem through marine outfalls at specific locations. This paper presents the results of the mathematical simulations on the impacts of discharge is-a-vis the length of the outfall and level of land treatment apriori. The results of the simulation indicate the level of bacterial pollution to be higher near the diffuser locations as compared to nearshore regions. 48 hsimulation result analysis shows that FC counts nearthe diffuser location will be in the range of 2000–8000 counts per 100 ml.     

Arsenic accumulation in native plants of West Bengal, India: prospects for phytoremediation but concerns with the use of medicinal plants

Arsenic (As) is a widespread environmental and food chain contaminant and class I, non-threshold carcinogen. Plants accumulate As due to ionic mimicry that is of importance as a measure of phytoremediation but of concern due to the use of plants in alternative medicine. The present study investigated As accumulation in native plants including some medicinal plants, from three districts [Chinsurah (Hoogly), Porbosthali (Bardhman), and Birnagar (Nadia)] of West Bengal, India, having a history of As pollution. A site-specific response was observed for Specific Arsenic Uptake (SAU; mg kg(-1) dw) in total number of 13 (8 aquatic and 5 terrestrial) collected plants. SAU was higher in aquatic plants (5-60 mg kg(-1) dw) than in terrestrial species (4-19 mg kg(-1) dw). The level of As was lower in medicinal plants (MPs) than in non-medicinal plants, however it was still beyond the WHO permissible limit (1 mg kg(-1) dw). The concentration of other elements (Cu, Zn, Se, and Pb) was found to be within prescribed limits in medicinal plants (MP). Among the aquatic plants, Marsilea showed the highest SAU (avg. 45 mg kg(-1) dw), however, transfer factor (TF) of As was the maximum in Centella asiatica (MP, avg. 1). Among the terrestrial plants, the maximum SAU and TF were demonstrated by Alternanthera ficoidea (avg. 15) and Phyllanthus amarus (MP, avg. 1.27), respectively. In conclusion, the direct use of MP or their by products for humans should not be practiced without proper regulation. In other way, one fern species (Marsilea) and some aquatic plants (Eichhornia crassipes and Cyperus difformis) might be suitable candidates for As phytoremediation of paddy fields.     

Atmospheric deposition of heavy metals (Cu, Zn, Cd and Pb) in Varanasi City, India

Rapid growth in urbanization and industrialization in developing countries may significantly contribute in heavy metal contamination of vegetables through atmospheric depositions. In the present study, an assessment was made to investigate the spatial and seasonal variations in deposition rates of heavy metals and its contribution to contamination of palak (Beta vulgaris). Samples of bulk atmospheric deposits and Beta vulgaris for analysis of Cu, Zn, Cd and Pb were collected from different sampling locations differing in traffic density and land use patterns. The results showed that the sampling locations situated in industrial or commercial areas with heavy traffic load showed significantly elevated levels of Cu, Zn and Cd deposition rate as compared to those situated in residential areas with low traffic load. The deposition rates of Cu, Zn and Cd were significantly higher in summer and winter as compared to rainy season, however, Pb deposition rate was significantly higher in rainy and summer seasons as compared to winter season. Atmospheric depositions have significantly elevated the levels of heavy metals in B. vulgaris collected during evening as compared to those collected in morning hours. The study further showed that local population has maximum exposure to Cd contamination through consumption of B. vulgaris. The present study clearly points out the urban and industrial activities of a city have potential to elevate the levels of heavy metals in the atmospheric deposits, which may consequently contaminate the food chain and thus posing health risk to the local population.     

Application of Defined Co-Immobilized Microbial Consortium as a Ready-to-Use Seed Inoculum in Bod Analysis

A number of microorganisms were isolated from sewage. Biochemical Oxygen Demand (BOD-5 day) analysis was carried out by individual pure cultures. The cultures giving higher or equal BOD values as compared to reference GGA solution were selected for the formulation of a defined mixed microbial consortium. This microbial consortium was co-immobilized on calcium-alginate beads. Four synthetic and six industrial samples were tested for BOD by using immobilized beads as well as sewage as source of seeding materials. BOD values obtained with beads for all the synthetic as well as industrial samples were fairly comparable with those obtained with sewage. Reusability of prepared microbial beads was also checked with different synthetic and industrial samples and was compared with reference GGA solution. The same microbial beads can be reused three times for different BOD-5 day estimations. It is recommended that immobilized microbial beads can be used as a ready-to-use seeding material for BOD analysis.     

Dioxin uptake by Indian plant species

Dioxins like various gaseous pollutants and aerosols can be scavenged by appropriate vegetative greenbelts. Based on their stomatal properties and the models for contaminant uptake, uptake of dioxin (2,3,7,8-TCDD) by three important Indian plant species, viz. Eugenia jambolana (Jamun), Azadirachta indica (Neem) and Ficus religiosa (Peepal), has been estimated. 2,3,7,8-TCDD is a contaminant with severe harmful ecological ramifications. Computations show that Ficus religiosa has highest uptake capacity. The present exercise has its utility in designing appropriate green-belts for mitigating adverse environmental and human health impacts due to dioxins. This can be an effective management option for mitigating the damages caused by dioxins.     

Formulation of a landfill pollution potential index to compare pollution potential of uncontrolled landfills

Generally speaking, landfilling is one of the prominent methods of waste disposal around the globe, but some under-developed and developing countries still continue to practice uncontrolled open dumping of waste. These uncontrolled landfills pose a relatively high threat to the various elements of the environment in comparison with the conventional engineered landfills that are used in many developed countries. However, some closed, un-engineered landfills do exist in developing countries. This paper presents a novel approach to compare the pollution potential of uncontrolled landfills using an index. The landfill pollution potential index (LPPI) has been developed using the Delphi technique and is an aggregation of six pollution indices that have already been developed for the quantification of different environmental elements. The LPPI is an increasing scale index, in which a higher index value indicates a higher pollution threat. The LPPI of a landfill in Delhi was calculated and the high LPPI value indicates that the respective landfill poses a significant threat to the environment. The LPPI can be used as an aid to diagnose a landfill's pollution potential relative to other landfills and therefore also to rank remediation investments.