Dynamic strength tests for low elongation lanyards.

Lanyards are still important and common components of personal systems protecting against falls from a height. Experience with dynamic strength tests of lanyards indicates that test methods based on EN and ISO standards do not make objective assessment possible. This paper presents the results of theoretical and laboratory investigations of the performance of adjustable lanyards during fall arrest. The obtained results indicate that methods of testing and assessment based on those standards demonstrate considerable shortcomings when applied to low elongation lanyards. The assumptions for improved requirements and test methods of lanyards made of, e.g., steel wire and aramid ropes are also presented.     

Canopy profiles of photosynthetic parameters under elevated CO2 and N fertilization in a poplar plantation

A poplar plantation has been exposed to an elevated CO2 concentration for 5 years using the free air CO2 enrichment (FACE) technique. Even after such a long period of exposure, leaves of Populus x euramericana have not shown clear signs of photosynthetic acclimation. Only at the end of the growing season for shade leaves was a decrease of maximum velocity of carboxylation (Vcmax) observed. Maximum electron transport rate (Jmax) was increased by FACE treatment in July. Assimilation rates at CO2 partial pressure of 400 (A400) and 600 (A600) micromol mol(-1) were not significantly different under FACE treatment. Most notably FACE significantly decreased stomatal conductance (g(s)) both on upper and lower canopy leaves. N fertilization increased N content in the leaves on mass basis (Nm) and specific leaf area (SLA) in both CO2 treatments but did not influence the photosynthetic parameters. These data show that in poplar plantations the long-term effects of elevated CO2 on photosynthesis do not differ considerably from the short-term ones even with N deposition.     

Ammonium removal from waste solutions by precipitation of MgNH4PO4 I. Ammonium removal with use of commercial reagents

The method of ammonium ion removal from industrial waste solutions was investigated and parameters for MgNH₄PO₄ precipitation were determined. A solution laden with NH₄⁺ ions was brought to pH 1–2 by the use of H₃PO₄; MgO was then added and the pH adjusted to 9–10 with the use of NaOH solution. Stirring of the suspension was carried out during a prolonged period of time ( 3 hours), with final filtration or sedimentation. By this method the ammonium ion content in the filtrate may be reduced to concentrations below 1 mg/l. The MgNH₄PO₄·6H₂O sediment produced is considered to be a long-term fertilizer, suitable for agricultural use.     

Long-term study of environmental levels of dioxins and furans in the vicinity of a municipal solid waste incinerator

From 1975 to 2004, a municipal solid waste incinerator (MSWI) was operating in Montcada (Barcelona, Catalonia, Spain). Because of the potential health risks derived from emission of pollutants by the facility, especially polychlorinated dibenzo-p-dioxins (PCDDs) and dibenzofurans (PCDFs), a long-term monitoring program focused on measuring the environmental levels of PCDD/Fs near the facility, and to assess the health risks for the population living in the neighborhood, was established between 1996 and 2002. A total number of 111 soil and 121 herbage samples were analyzed for PCDD/Fs during this period. Human health risks for the individuals living near the MSWI (500 and 1,000 m) were also assessed before (1998) and after modernization (2000) of the facility. It included PCDD/F inhalation, dermal contact, soil and dust ingestion, and food intake. All these data are here summarized. The environmental levels of PCDD/Fs showed that the MSWI was not the main responsible of the atmospheric pollution by these compounds. In turn, human health risks for the population living in the vicinity of the facility after introduction of a modern technology were negligible in comparison with the dietary PCDD/F exposure.     

Self-assessment of hearing status and risk of noise-induced hearing loss in workers in a rolling stock plant

Noise measurements and questionnaire inquiries were carried out for 124 workers of a rolling stock plant to develop a hearing conservation program. On the basis of that data, the risk of noise-induced hearing loss (NIHL) was evaluated. Additionally, the workers' hearing ability was assessed with the (modified) Amsterdam inventory for auditory disability and handicap, (m)AIADH. The workers had been exposed to noise at A-weighted daily noise exposure levels of 74-110 dB for 1-40 years. Almost one third of the workers complained of hearing impairment and the (m)AIADH results showed some hearing difficulties in over half of them. The estimated risk of hearing loss over 25 dB in the frequency range of 3-6 kHz was 41-50% when the standard method of predicting NIHL specified in Standard No. ISO 1999:1990 was used. This risk increased to 50-67% when noise impulsiveness, coexposure to organic solvents, elevated blood pressure and smoking were included in calculations.     

Determination of bismuth in environmental samples by slurry sampling graphite furnace atomic absorption spectrometry using combined chemical modifiers

Persistence behavior of insecticides chlorpyriphos, profenofos, triazophos, cypermethrin, and deltamethrin following the use of three combination formulations Action 505 (chlorpyriphos?+?cypermethrin), Roket 44EC (profenofos?+?cypermethrin), and Anaconda Plus (triazophos?+?deltamethrin) was studied in cabbage following the spray application at the recommended and double doses. Bio-efficacy of these formulations was also evaluated against mustard aphids (Lipaphis erysimi Kaltenbach) and diamondback moth (Plutella xylostella L.). The residues of different insecticides persisted for 5–8 days at low dose and 8–12 days at high dose. The residues dissipated with time and 87–100 % dissipation was recorded on the 8th day. The half-life values varied from 0.4 to 1.6 days. Based on the acceptable daily intake (ADI) values, a safe waiting period of 1 day has been suggested for the formulations Action 505 and Roket 44EC and 3 days for Anaconda Plus at the recommended dose of application. Action (1.6 L/ha) treatment was found to be the best as it significantly reduced the diamondback moth (DBM) (~60 %) and aphid population (~70 %) besides giving the highest yield (170 % increase over control).     

Potential ecological risk assessment and predicting zinc accumulation in soils

Environmental Geochemistry and Health - The aims of this study were to investigate zinc content in the studied soils; evaluate the efficiency of geostatistics in presenting spatial variability of...