Bi2MoO6/纳米棒ZnO异质结对MB的可见光-压电协同降解性能研究

采用水热法合成了一系列不同负载率的Bi₂MoO₆/纳米棒ZnO复合光催化剂.通过XRD、FT-IR、SEM、TEM、XPS、UV-Vis、EPR和PL等分析技术对合成的样品进行表征.在光/超声波条件下,以亚甲基蓝（MB）为目标降解物评价其压电-光催化性能.结果表明：Bi₂MoO₆/ZnO纳米棒（BZ-0.6）的降解速率常数约为ZnO传统光催化的9.25倍,其性能提升的主要原因在于ZnO的压电效应与Bi₂MoO₆/ZnO界面形成的异质结的耦合,有效地促进了电子和空穴的分离和转移.此外,同实验条件下,循环利用5次后Bi₂MoO₆/ZnO复合光催化剂降解率仍保持良好的稳定性.     

多尺度分割与特征优选下的盐碱地提取

土地盐渍化作为一种土壤灾害,严重制约着社会经济与农业的发展。对盐碱地进行实时监测,可为盐碱地的评价改良提供科学依据。由于盐碱地的信息复杂、提取精度不高,因此本文以高分六号（GF-6）卫星遥感影像为数据源,采用分形网络演化算法（fractal net evolution approach,FNEA）进行影像对象的多尺度分割,从面向对象的角度减少高分影像分类结果中的椒盐噪声问题,通过计算图像对象的局部方差和变化率来确定适宜的盐碱地分割尺度。利用基于特征选择的相关性算法（correlations-based feature selection,CFS）与Relief F算法分别对由光谱、纹理、形状、遥感指数构成的初始特征空间进行特征优选,精简特征子集,解决特征数量冗余问题,以此来优化随机森林对盐碱地提取精度。结果表明：CFS约简后的特征子集更小,精度更高,说明在盐碱地提取过程中,筛选特征数目能够减小冗余数据对提取精度的影响。CFS优化后的随机森林对盐碱地的提取效果较好,该方法总体分类精度达到83.7%。     

Cryptic 1p36.3/6q25.2 translocation in three generations ascertained through a foetus with IUGR and cerebral malformations

Here we describe a foetus with intrauterine growth retardation (IUGR), cerebral malformations and a 46,XY,der(1),t(1;6)(p36.3;q25.2) karyotype owing to a familial cryptic translocation segregating in three generations. A balanced translocation was present in the mother, the maternal uncle, the aunt and the grandmother. A female first cousin with dysmorphisms, hydrocephalus and mental retardation was a carrier of a partial trisomy 1p and a partial monosomy 6q. Multiple miscarriages were present in the family pedigree. Parents of the foetus had three other pregnancies: a male with a balanced translocation, and two foetuses with 1p36.3–pter monosomy and 6q25.2–qter trisomy. Copyright © 2003 John Wiley & Sons, Ltd.     

电弧离子镀HY11涂层的1200℃高温氧化行为研究

目的研究真空电弧镀方法制备的超高温金属涂层HY11在1200℃下的高温氧化行为。方法用真空电弧镀技术(AIP)在单晶镍基高温合金DD6上制备超高温金属涂层HY11,采用HB 5258循环氧化方法进行1200℃循环氧化试验,通过试验过程中试样质量变化评价涂层氧化寿命。通过扫描电镜(SEM)分析氧化后的试样显微形貌,用X-射线衍射仪分析涂层材料的相结构,通过氧化速率对涂层材料抗氧化性能进行表征。结果采用单靶真空电弧镀技术制备的HY11涂层,经过1050℃真空条件下扩散2h,涂层厚度为50～60?m,扩散区厚度为10～15μm,涂层微观组织均匀致密,涂层合金界面清晰平整。DD6合金的1200℃循环氧化寿命仅仅为4 h,HY11涂层在1200℃的循环氧化寿命近300 h。沉积态涂层HY11相结构主要以Al_2O_3和Ni3Al为主。氧化后涂层材料表面形成的氧化膜以Al_2O_3为主。结论 HY11涂层在1200℃的循环氧化寿命为298 h,极大地提高了DD6合金在1200℃的循环氧化寿命。     

热障涂层对DD6单晶高温合金高周疲劳性能的影响

目的研究电子束物理气相沉积热障涂层对单晶高温合金高周疲劳性能的影响,为热障涂层在涡轮叶片上的应用提供技术支持。方法采用真空电弧镀和电子束物理气相沉积工艺制备YSZ热障涂层,进行900℃条件下高周疲劳性能测试,采用扫描电镜对测试后的试样表面、断口形貌进行观察与分析。结果在900℃、380 MPa条件下,带涂层的DD6单晶试棒循环次数(Nf)超过了107,420 MPa条件下超过了106。通过对DD6单晶试棒断口分析,失效后的带涂层试棒仍以DD6单晶常见滑移解离形式发生破坏。结论高周疲劳性能测试条件下,带YSZ热障涂层的试棒中粘结层率先产生垂直微裂纹,但是裂纹扩展延伸中发生氧化钝化,之后DD6基体沿正常的滑移方向从表面向内部疲劳扩展,带涂层的试棒疲劳裂纹并非由涂层微裂纹直接扩展形成,热障涂层对DD6单晶高温合金高周疲劳性能影响较小。     

植物根系质外体溶液的提取方法研究:以多环芳烃为例

根系质外体溶液中多环芳烃(PAHs)的分析对于阐明植物根系PAHs吸收运移机制及阻控意义重大.然而,迄今鲜有便捷成熟的植物根系质外体溶液提取方法的报道.为此,本研究以小麦为材料,菲为PAHs的代表,探究了植物根系质外体溶液的真空渗透离心提取方法.结果表明,小麦根系质外体菲提取量随真空度、真空时间、离心速率、离心时间的增加而增大;小麦根系质外体六磷酸葡萄糖脱氢酶(G6PDH)活性随真空度、真空时间、离心速率、离心时间的增加而升高.依据质外体溶液受原生质污染程度小于1%且尽量提取完全的原则,真空渗透离心提取法的最佳真空度为70 k Pa,最佳真空时间为10 min,最佳离心速率为3 068 r·min-1,最佳离心时间为15 min.研究结果可为污染物的植物根系质外体运输研究提供有效、简便的方法支撑.     

The behavioral component in the meaning of places

How do people think about the physical setting in the world around them? Part of the answer to this question may be in terms of the behaviors that occur there. To explore people's knowledge of behavior—place associations, twenty places (shown via color photographs) were assessed in five ways: (a) ratings of the place's suitability for each of eleven behaviors, (b) ratings of the expected frequency of occurrence of the eleven behaviors, (c) free listings of reasons for going to each place, (d) free listings of activities-while-there and (e) free listings of activities associated with the place. Results showed that people can distinguish places on the basis of behaviors, that the behavioral component of place meaning is composed of distinct aspects, and that knowledge of behavior is related to a global, overall representation of a place.     

Contribution of anthropogenic pollutants to the increase of tropospheric ozone levels in the Oporto Metropolitan Area, Portugal since the 19th century

The main purpose of this study was to evaluate the contribution of anthropogenic pollutants to the increase of tropospheric ozone levels in the Oporto Metropolitan Area (Portugal) since the 19th century. The study was based on pre-industrial and recent data series, the results being analyzed according to the atmospheric chemistry. The treatment of ozone and meteorological data was performed by classical statistics and by time-series analysis. It was concluded that in the 19th century the ozone present in the troposphere was not of photochemical origin, being possible to consider the respective concentrations as reference values. For recent data a cycle of 8h for ozone concentrations could be related to traffic. Compared to the 19th century, the current concentrations were 147% higher (252% higher in May) due to the increased photochemical production associated with the increased anthropogenic emissions.