Dynamic pressure induced by a methane–air explosion in a coal mine

The hazardous effect of dynamic pressure and strong gas flows induced by a methane–air mixture explosion in underground coal mines is studied. The dynamic pressure effect of a methane–air explosion was analyzed by numerical simulation, in a duct and tunnel. Compared to the overpressure generated by an explosion that can act on a body, the dynamic pressure caused by the high-speed flow of the gaseous combustion products can cause serious damage as well. At the structural opening of a coal mine, the destruction caused by the dynamic pressure induced by a methane–air explosion is more serious than the overpressure. For a tube or tunnel partially filled by a methane–air mixture, the dynamic pressure is lower than the overpressure in the region occupied by the flammable mixture. Beyond the premixed region, the dynamic pressure is of the same order of magnitude as the overpressure.     

大尺度障碍物与泄爆面对天然气内爆炸的协同作用规律研究

为阐释民用建筑内部大尺度物品与门窗等泄爆面对天然气爆炸灾害的协同作用机制，基于典型厨房空间布局及内部物品特征，借助计算流体动力学技术研究了不同泄爆面开启压力和不同大尺度障碍物体积阻塞率条件下天然气内爆炸火焰速度、爆炸超压的分布规律。研究结果表明:大尺度障碍物与泄爆面对室内天然气爆炸过程具有显著的协同作用，共同促进火焰速度与爆炸超压的显著增长，并缩短峰值超压到达时间；大尺度障碍物的存在虽然显著降低了室内天然气的体积，但从增加房间内湍流源和相对长径比的角度进一步促进了泄爆效应；大尺度障碍物与泄爆面协同作用下，室内火焰速度呈现明显的阶段性特征，并在泄爆面附近发生波动。研究结论可为民用建筑物内气体爆炸事故调查分析和灾害评估提供科学依据。     

矿井巷道火灾烟流逆退数值模拟及临界风速研究

为了研究矿井发生火灾后高温烟流的蔓延规律及影响因素，利用COMSOL软件对火区进行数值模拟，建立巷道三维模型，得到火区风流速度与温度分布。通过改变边界条件，分析火风压作用下，火区烟气在不同控制风速、巷道条件作用下蔓延规律，得出不同因素与临界风速的关系，为选取合理的火灾控制风速提供理论依据。研究结果表明:火源温度一定时，巷道入口风速越低，火源下风侧高温烟流越靠近巷道顶部，随着风速增大，向巷道下部蔓延；风速较低时，在火区火风压的作用下，会产生烟流逆退现象，随着风速的增大，逆流层长度和厚度随之减小；巷道入口通风条件不变时，火区温度越高越容易产生烟流的逆退，影响范围越大；巷道高度越高、上行风坡度越小，越易发生逆退现象；不同影响因素与巷道平均温度不成正比关系，其中下行风坡度5~15°时巷道平均温度较高且易于发生烟流滚退现象，影响范围较大；火源温度、巷道条件与临界风速的数据拟合结果对预测巷道的临界风速有较好的参考价值。     

铁磁流体对煤粒瓦斯解吸性能影响实验研究*

为探究铁磁流体对煤体瓦斯解吸性能的影响，采用水浴恒温吸附解吸系统，开展0.44，0.65，1.14 MPa 3组不同平衡压力下加铁磁流体前后的瓦斯解吸对比实验，根据Langmuir方程经验公式计算瓦斯极限解吸量和初始扩散系数，分析铁磁流体对煤体瓦斯解吸影响的机理。结果表明:在3组不同平衡压力下加入铁磁流体后瓦斯极限解吸量由2.5，10，20 mL/g降低为2.22，3.33，10 mL/g，降低11.2%，66.7%，50%；初始扩散系数由0.997 1，1.629 9，3.888 3 μm2·s降低为0.685 5，0.997 1，2.933 5 μm2·s，降低31.25%，38.82%，24.56%。在铁磁流体的作用下，煤体瓦斯解吸性能得到大幅降低。     

Numerical study on premixing characteristics and explosion process of starch in a vertical pipe under turbulent flow

Fire and explosion accidents are frequently caused by combustible dust, which has led to increased interest in this area of research. Although scholars have performed some research in this field, they often ignored interesting phenomena in their experiments. In this paper, we established a 2D numerical method to thoroughly investigate the particle motion and distribution before ignition. The optimal time for the corn starch dust cloud to ignite was determined in a semi-closed tube, and the characteristics of the flame propagation and temperature field were investigated after ignition inside and outside the tube. From the simulation, certain unexpected phenomena that occurred in the experiment were explained, and some suggestions were proposed for future experiments. The results from the simulation showed that 60–70 ms was the best time for the dust cloud to ignite. The local high-temperature flame clusters were caused by the agglomeration of high-temperature particles, and there were no flames near the wall of the tube due to particles gathering and attaching to the wall. Vortices formed around the nozzle, where the particle concentration was low and the flame spread slowly. During the explosion venting, particles flew out of the tube before the flame. The venting flame exhibited a “mushroom cloud” shape due to interactions with the vortex, and the flame maintained this shape as it was driven upward by the vortex.     

Large eddy simulation and experimental study of the effect of wire mesh on flame behaviours of methane/air explosions in a semi-confined pipe

Preventing the propagation of flames in a pipeline is an effective measure for avoiding gas explosion accidents and reducing losses. To evaluate the effect of wire mesh, acting as a porous media, experimental and simulation studies are conducted to determine the influence of the wire mesh on the dynamics of premixed methane/air flame propagation in a semi-closed pipe. Four different kinds of wire mesh with different numbers of layers are chosen in the experiments and simulation, and the mechanism of wire mesh quenching of the flame is investigated. The experimental and simulation results are consistent. Flames are quenched when 4 layers of 40-mesh or 3 layers of 60-mesh wire mesh are used; however, once the flame propagates through the wire mesh, the risk of methane combustion may increase. The wire mesh becomes the key factor causing flame folds and acceleration, and the greater the number of layers or the larger the mesh size is, the more obvious the folds after the flame passes through the wire mesh. Moreover, the combination of heat absorption and disruption of the continuous flame surface by the mesh causes flame quenching. Wire mesh can effectively attenuate the flame temperature during premixed flame propagation in a pipe, and the attenuated maximum rate reaches approximately 79% in the case of adding 3 layers of 60-mesh wire mesh.     

金属丝网对甲烷/空气预混火焰管道内传播的影响

为研究管道内金属丝网对甲烷/空气预混火焰传播的影响，通过实验和三维数值模拟研究安装金属丝网的管道内火焰传播特性以及流场、温度场的变化。结果表明:40目4层的金属丝网可以使火焰淬熄，30目4层的金属丝网无法淬熄，但可以使火焰停滞3 ms；大涡模型可以很好地对管道内火焰淬熄现象进行模拟；当火焰穿过30目4层金属丝网时，速度增大，在Kelvin Helmholtz不稳定和Rayleigh Taylor不稳定的耦合作用下形成湍流；金属丝网的目数会影响热量在丝网层中的扩散，当金属丝网为30目4层时，火焰热量扩散快，而当金属丝网为40目4层时，火焰热量扩散慢且温度大幅度衰减，衰减率达到83%。     

侧向风速作用下聚氨酯泡沫双火源火蔓延研究

为探究环境风作用下逆向双点火源聚氨酯泡沫火蔓延及融合行为，开展多组对照实验并从材料传热机理角度分析侧向风速对火蔓延行为中火羽流形态、质量损失和辐射热流场等特征参数的影响。结果表明:风速与上述参数之间存在非线性关系。环境风效应使火焰被拉长且敷贴于预热区表面，增大预热区面积和热反馈；侧向风速的增加对FPU板材质量损失的影响逐渐弱化，且板材的熔滴率与风速呈正相关；无论侧向风是否存在，两侧逆向火焰融合后均达到整个蔓延过程中的峰值温度；风速的存在限制了火焰温度与辐射热通量峰值，也缩短了温度和辐射峰值出现的时间。     

以氢气为主要成分的其他可燃气体对低浓度甲烷爆炸特性的影响

为研究矿井火区中一氧化碳(CO)、氢气(H_2)、乙烯(C_2H_4)和乙烷(C_2H_6)等其他可燃气体对甲烷(CH_4)爆炸特性的影响,利用可视球形气体爆炸系统开展了多元可燃气体爆炸压力特性试验,观察并分析了峰值爆炸压力、最大爆炸压力上升速率及其相应时间。通过高速摄影系统拍摄了视窗范围内爆炸火焰传播图像,基于边缘检测方法确定了火焰前锋位置,继而得到最大火焰传播速度。分析了以氢气为主要成分的其他可燃气体对低浓度CH_4-空气混合物压力特性和火焰传播行为的影响。结果表明,多元可燃气体的存在增加了低浓度CH_4-空气混合物的爆炸危险性。随混合气体体积分数增加,低浓度CH_4-空气混合物的峰值爆炸压力、最大爆炸压力上升速率和最大火焰传播速度非线性增加;此外,到达峰值爆炸压力、最大爆炸压力上升速率的时间显著缩短。     

不同含水率煤尘在瓦斯爆炸诱导下爆炸传播规律研究

为了探究不同含水率煤尘在瓦斯爆炸诱导下的爆炸传播规律,利用自行搭建的直管瓦斯爆炸诱导煤尘二次爆炸实验系统,从冲击波压力和火焰传播速度2个方面,研究了不同含水率沉积煤尘在瓦斯爆炸诱导下的爆炸传播规律和原因。研究结果表明:当煤尘含水率小于40%时,管道内沉积煤尘会在瓦斯爆炸诱导下产生二次爆炸,同时沉积煤尘总量一定时,沉积煤尘二次爆炸产生的冲击波超压峰值和火焰传播速度随着煤尘含水率的增加先增大后减小;当沉积煤尘含水率为20% 时,煤尘二次爆炸产生的冲击波超压峰值、火焰传播速度峰值达到最大值,分别为1.657 MPa和468.060 m/s;当沉积煤尘含水率大于40%时,沉积煤尘无法产生二次爆炸,此时爆炸产生的威力小于单一瓦斯爆炸,火焰传播速度衰减较无煤尘的瓦斯爆炸更快,沉积煤尘起到抑制瓦斯爆炸传播的作用。研究结果可以为防治煤尘二次爆炸提供理论依据。