海口市蔬菜土壤重金属含量特征研究

采用野外调查法结合实验室分析法对海口市郊区蔬菜土壤重金属含量特征进行研究,测定了Cr、As、Cd、Cu、Zn、Pb、Ni、和Hg 8种重金属全量、有效态含量及蔬菜土壤pH值和有机质含量,重金属全量与有效态含量间的相关性及土壤pH值,有机质含量与蔬菜土壤中重金属全量间的相关性。结果表明,海口市蔬菜土壤中各种重金属均表现出一定的累积趋势;8种重金属元素有效态含量与全量呈正相关,重金属有效态占全量比例在1.86%~13.47%之间,其中Cd、Pb和Hg较高,分别为13.47%、10.23%和8.42%,三者表现出较大的潜在污染风险;土壤p H值和有机质含量与重金属全量表现出一定的相关性,相关性大小与重金属种类有关;重金属全量并不能全面正确评价土壤的环境效应,对蔬菜土壤重金属污染程度进行评价时,应把重金属全量、有效态含量与土壤基本理化性质结合起来进行研究。     

庞庄煤矿煤矸石淋溶液对周边水体影响分析

为研究庞庄煤矿张小楼煤矸石堆场淋溶液对其场地和周边地表水、地下水水质影响情况,围绕煤矸石堆场及周边采集13组水样做分析比对。结果表明,煤矸石堆场淋溶液对周边地表水体形成普遍污染,且污染物浓度随着污染距离增加逐步降低,一般化学污染指标主要包括溶解性总固体、硫酸盐、铁、锰、氨氮等,毒理学污染指标包括亚硝酸盐、氟化物、砷,超标倍率约为0.02~5.36。受距离及成井深度等因素影响,地下水体未遭受淋溶液明显的污染和影响。     

COMPARISON OF TWO PESTICIDE LEACHING INDICES1

ABSTRACT: Agriculture is the leading cause of regional‐scale non‐point source (NPS) pollution in the world today. Indices of pesticide leaching in the vadose zone are well suited for estimating the spatial accumulation and distribution of NPS pollutants in the near surface. In this study the Attenuation Factor (AF) and the Leaching index (Li) are used to assess the near‐surface leaching potential for 32 important agrochemicals for world average agricultural soil properties and recharge rates. The AF and Li indices both require the same input data and appear to work well for nonpolar chemicals. In the effort reported here the AF and Li indices produced similar results for the 32 agrochemicals. Pesticides with high and moderate leaching potential are identified. The AF estimates were more constant than the Li estimates for changes in the compliance depth and recharge rate. The AF index is simpler to use than the Li index and, therefore, is more likely to be employed in the future for screening/ranking agrochemicals relative to regional‐scale NPS ground water vulnerability.     

A study of Cr(VI) in ashes from fluidized bed combustion of municipal solid waste: leaching, secondary reactions and the applicability of some speciation methods

The use of the fluidized bed technique for the combustion of municipal solid waste is a rather new concept. This type of combustor produces ash residues with somewhat different properties than the residues generated from the traditional mass burn techniques. Therefore, chemical characterization and the investigation of toxic metals behavior during ash water reactions are necessary for the safe disposal of these residues. In the present work, the total elemental composition, mineralogy and leaching behavior of ashes from the combustion of municipal solid waste in a fluidized bed combustion boiler have been investigated. The cyclone ash and, in particular, the filter ash contained considerable amounts of soluble substances, thus giving leachates with high levels of Cl-, Na+, K+, Ca2 + and Al(IIl). On the other hand, the two ash fractions taken in the boiler, the bottom and hopper ashes, were much more stable with respect to the release of salts and heavy metals. Since Cr(VI) is mobile and toxic its release from combustion residues can pose environmental problem. Even though the total Cr contents were similar in all ashes studied, the bottom ash gave about a thousand times higher levels of Cr(VI) in test leachates than the hopper, cyclone and filter ashes. However, it was found that the leached amount of Cr(VI) from the bottom ash decreased significantly when bottom ash was mixed with the hopper ash. The most probable cause for this decrease is the coupled oxidation of Al(0) to Al(III) and reduction of dissolved Cr(VI) to Cr(III). This finding that the mixing of two ash streams from the same boiler could result in the immobilization of Cr may point at a simple stabilization method. Selective extraction of water soluble, exchangeable and sparingly soluble forms of Cr(VI) was also investigated. Extraction methods were evaluated for their suitability for ash matrixes. It was found that interferences due to the presence of reducing substances in some ash materials may occur.     

Characteristics, treatment and utilization of residues from municipal waste incineration

Beneficial utilization of residues from municipal solid waste incineration is an important objective for integrated waste management in many jurisdictions. When residues are to be used as an aggregate substitute in construction applications, the release of constituents of concern to soils and water through leaching is an important environmental consideration. In this paper, residue characteristics that control constituent leaching and testing approaches for evaluating leaching are discussed. Quality control and potential improvement in case of beneficial application are addressed.     

Metallic-phase lead in slag of municipal solid waste incineration ash and leaching characteristics

Metallic phases in slags and their influence on the leaching characteristics were investigated. The proportions of metallic phase in four slags were 0.028%, 0.24%, 1.87%, and 3.05% by weight. The lead content was 10–248 mg/kg in bulk slag after metal removal, while in the metallic phase it was 579–7390 mg/kg. Lead concentrations in the metallic phase were more than ten times higher than in slags after metal removal. Lead was distributed in the metallic phase at 2.0%, 8.3%, 10.3%, and 47.4%. The concentrations of all metallic elements in metallic phases were much higher than in bulk slag. Iron, copper, and nickel had accumulated in magnetic metals, while aluminum and zinc were found in nonmagnetic metals. As regards chromium, manganese, lead, and tin, the proportion of metallic phases depended on the slag samples. By removing metallic phases, both water and pH 4 leachable lead decreased. The basic principles of melting residues containing lead are the separation of lead as a metal in reductive melting, and the containment of lead ions into uniform glassy particles in oxidization melting. Melting slag can be seen to contribute to environmental preservation by facilitating the recycling of materials through the separation of metals from melting slag. Received: February 21, 2000 / Accepted: July 27, 2000     

危险废物浸出毒性试验方法的研究

在分析各国危险废物浸出毒性试验方法的基础上,综合考虑我国气候状况(降雨量、酸雨现状)及工业固体废物处理处置现状,提出我国危险废物浸出毒性研究的技术路线为:通过模拟工业固体废物填埋场在不规范填埋处置且受酸雨影响条件下,有毒物质浸出向地下渗滤造成对地下水的污染,确定浸出毒性的浸取方法.浸出毒性保护目标为地下水,同时还介绍了主要技术参数液固比、浸取剂pH值和类型的确定方法.     

Relationship of surface changes to metal leaching from tungsten composite shot exposed to three different soil types

Physical changes that occur on the surface of fired shots due to firing and impact with soil may increase the dissolution of muniton metals. Increased metal dissolution could potentially increase metal transport and leaching, affecting metal concentrations in surface and groundwater. This research describes the relationship between the surface changes on fired tungsten-nickel-iron (94% W:2% Ni:4% Fe) composite shots and metals leaching from those shots. Tungsten composite shot was fired into, and aged in, three soil types (Silty Sand, Sandy Clay, and Silt) in mesoscale rainfall lysimeters to simulate live-fire conditions and subsequent interactions between the metals of the composite and soil. Leachate, runoff, and soil samples were collected from the lysimeters and analyzed for metal content. The shots were analyzed using scanning electron microscopy (SEM) to evaluate surface changes. SEM results indicated that a soil’s particle size distribution initially affected the amount of metal that was sheared from the surface of the fired W-composite shots. Shearing was greatest in soils with larger soil particles (sand and gravel); shearing was least in soils composed of small soil particles (fines). Increased metallic shearing from the shot’s surface was associated with increased W dissolution, compared to controls, following a simulated 1 year soil aging.     

The effect of environmental conditions on the stability of heavy metal-filter material complex as assessed by the leaching of adsorbed metal ions

In this study the influence of environmental conditions, most likely prevailing in filter beds used for intermittently discharged pollutant streams such as landfill leachate and storm water, on the stability of the heavy metal-filter complex was investigated for 2 filter materials; non-treated and urea treated pine bark, using leaching experiments. The metal-filter complex stability was higher for urea treated than for non-treated pine bark and dependent on the metal adsorbed. The type of environmental condition applied was of less importance for the extent of leaching.     

Behavior of perfluorinated compounds in soils during leaching experiments

Perfluorinated compounds (PFCs) can be detected worldwide in both, soil and water. In order to study the leaching behavior of this heterogeneous group of compounds in soil, flow-through column experiments have been conducted. Ten perfluoro carboxylates and four perfluoro sulfonates ranging from C4 to C14 in chain length, and contaminated sewage sludge, have been used to spike a standard soil. The aqueous column effluent was analyzed using liquid chromatography tandem mass spectrometry (LC-MS/MS) with direct injection. The observed percolation velocity seems to be strongly correlated with the length of the perfluorinated chain. Other factors that additionally contribute to the leaching behavior are the functional group of the PFC, the organic carbon content of the soil and the presence of other adsorbates. A mass balance calculation showed that perfluorobutanoic acid can adsorb strongly to the soil, when no PFC with longer carbon chain are present. Only about 60% of the added perfluorobutanoic acid could be detected in the percolate water. The missing amount started to elute again when longer chain PFC or stearate were added to the soil. Thus it would appear that larger and more lipophilic molecules can displace shorter PFC from their binding sites in the soil.The results of a monitoring study using 32 surface water samples and 150 groundwater samples confirm that the PFC with the highest concentrations in groundwater are the short chain PFC with less than 7 (fluorinated) carbon atoms. The dominating PFC in surface waters are perfluorooctanoic acid and perfluorooctane sulfonic acid.