印染废水处理提标小试研究

利用"水解酸化+强化好氧+深度处理"的工艺技术方案开展印染废水小试研究。在工艺前端采用混流式和升流式两级水解酸化池,后续在曝气池投加活性焦载体,提高污泥浓度,强化好氧池处理能力,最后对生化出水加药混凝,并用生物活性焦滤池进行深度处理。结果表明,该处理工艺适宜处理印染废水,处理效果达到处理提标要求。     

序批式移动床生物膜反应器富集反硝化聚磷菌及其在单污泥系统中的应用

本文介绍了在单污泥系统中选择和富集反硝化聚磷菌的国内外研究进展,对不同研究者提出的选择和富集反硝化聚磷菌的方法进行了分析和评价,并提出将反硝化聚磷菌与移动床生物膜反应器工艺结合起来,在序批式移动床生物膜反应器悬浮填料上选择和富集反硝化聚磷菌,进一步认识了反硝化聚磷菌的生化特征,使其成为反应器中优势菌群,以及该工艺今后的研究重点。     

一体化A/O生物膜反应器低温硝化研究

采用自行设计制作的新型一体化A/O生物膜反应器,研究了温度、进水碱度对反应器硝化性能的影响.结果表明,当反应器温度控制在20,15和10℃时,硝化率分别为98%,90%和60%.此时进水COD和TN浓度分别为100～150 mg/L和65～78 mg/L.总氮去除率分别为50%,30%和20%.当反应器温度控制在8℃,进水中不加有机碳源,随着进水碱度的增加,硝化率从72%提高到95%,在低温下取得了良好的硝化效果.当进水碱度为280 mg/L时,反应器各区出现亚硝酸盐积累,亚硝化率达到80%.详细分析了形成亚硝酸盐积累的原因.     

一体化接触氧化反应器处理景区生活污水

常州某旅游景区采用一体化生活污水处理装置处理该区生活污水,通过试验确定反应器的最佳工艺参数,研究表明采用接触氧化反应器处理农村污水,在反应器内溶解氧维持在2.0~4.0 mg/L,水力负荷为3.53 m3/(m3.d)的运行条件下,对COD、NH3-N及TN去除率分别达80.82%、69.12%、63.16%,出水可稳定达GB18918-2002《城镇污水处理厂污染物排放标准》一级标准。     

Efficacy of natural biocide on control of microbial induced corrosion in oil pipelines mediated by Desulfovibrio vulgaris and Desulfovibrio gigas

We compared the efficacy of a natural biocide with four chemical tetrakishydroxymethyl phosphonium sulfonate, benzyl trimethyl ammonium chloride, and formaldehyde, glutaraldehyde, to control microbial induced corrosion in oil pipelines. The efficacy of biocides were monitored against Desulfovibrio vulgaris and Desulfovibrio gigas in experimental pipes by measuring cell counts, H2S production, Fe(II) production, production of extracellular polymeric substances and structure of biofilm. The treatment with cow urine had minimum planktonic cell counts of 3 102 CFU/mL as well as biofilm cell counts of 9 101 CFU/mL as compared with tetrakishydroxyl methyl phosphonium sulfonate, benzyl trimethyl ammonium chloride, formaldehyde and glutaraldehyde. Sulfide production was the lowest with cow urine (0.08 mmol/L), followed by tetrakishydroxymethyl phosphonium sulfonate 0.72 mmol/L. On day 90 of treatment, Fe(II) production was also found to be the lowest with cow urine. The scanning electron microscopic studies indicated that the biofilm bacteria were killed by cow urine. These results demonstrate the cow urine mediated control of microbially induced corrosion, and this is indicative of its potential as a viable substitute of toxic biocides. To the best of our knowledge, this seems to be the first report which screens possible biocidal activity by cow urine as compared to the most common biocides which oil industry is currently using.     

大孔网状聚氨酯载体MBBR工艺处理低浓度硝基苯废水实验研究

利用大孔网状聚氨酯载体在MBBR工艺条件下,研究了系统挂膜与启动过程,同时利用挂膜成熟稳定的载体进行低浓度硝基苯废水处理实验。研究结果表明,在20℃条件下培养的活性污泥生长状况良好,挂膜速度快,生物膜厚度大,耐冲击负荷。在MBBR反应时间24 h、材料投加量为1/4、硝基苯初始浓度为2.095mg/L的条件下,处理低浓度硝基苯废水的效果最好,CODcr去除率为92.58%,硝基苯去除率为49.82%。     

复合催化膜生物反应器处理一氧化氮废气研究

采用溶胶-凝胶法以聚砜(PSF)中空纤维膜为载体制备了Fe-Ti O_2/PSF复合催化膜,以此构建新型复合催化膜生物反应器(HCMBR),实现膜催化与硝化反硝化耦合烟气脱硝,进一步提高NO去除能力.采用Fe-Ti O_2/PSF复合催化膜生物反应器(HCMBR)处理一氧化氮废气,实现了180 d长时间高效稳定运行,NO去除效率可达93.2%,去除能力可达167.1g·(m~3·h)~(-1).适宜运行条件为:气体停留时间9 s、自然光光照强度670 lx,p H为6.8~7.2,n C/n N=3.7.Fe-Ti O_2/PSF复合催化膜加入,复合催化膜生物反应器去除NO的效率比膜生物反应器提高了1.4%~13%,在Fe-Ti O_2/PSF复合催化膜附着稳定的生物膜后,复合催化膜生物反应器去除NO的效率比湿式膜催化反应器提高了59.5%~66%.     

膜曝气生物膜反应器生物膜影响因素分析

膜曝气生物膜反应器（MABR）是一种利用透气膜进行曝气，可以实现同步硝化反硝化的污水生物处理新工艺。本文阐述了膜曝气生物反应器生物膜的原理和特点，总结了国内外在该领域的研究成果，重点介绍了C／N、氧气压力、流速、生物膜厚度、温度和pH对生物膜性能的影响。     

三级生物接触氧化除油生化池的生物膜特性

将生物接触氧化技术用于油田稠油污水的处理,在三级串联运行的生物接触氧化池中,生物膜特性主要由生物膜上原油成分决定。在沿水流方向上,生物膜上易降解原油组分含量降低,难降解组分含量上升,第一级生化池中的生物膜厚度和优势菌种数量明显超过第二级和第三级,藻类主要生长在一级生化池的后部和二、三级生化池中的生物膜上,原生动物出现在二级和三级生化池生物膜上,而后生动物只出现在三级生化池生物膜上。     

Autotrophic denitrification using hydrogen oxidizing bacteria in continuous flow biofilm reactor

Autotrophic denitrification was investigated in five bench‐scale upflow attached growth reactors using hydrogen oxidizing bacteria under anoxic conditions. The performance of sand, granular activated carbon (GAC), crushed pumice, crushed volcanic rock, and plastic media were evaluated as the support material. The reactors were inoculated with acclimated cultures obtained from domestic sewage treatment plant. A synthetic solution containing nitrate was used as the influent. The reactor performance was evaluated by measuring influent and effluent nitrate concentration. The design parameters demonstrated that the effectiveness of autotrophic denitrification is comparable to that of the heterotrophic process and may be utilized economically for drinking water treatment either as the main process or as a supplemental process for ion exchange regenerant treatment.