Experimental Study of the Criteria of Flow Laminarization in Two-Dimensional Dense Gas Plumes

Laminarization of flow in a two-dimensional dense gas plume was experimentally investigated in this study. The plume was created by releasing CO₂ through a ground-level line source into a simulated turbulent boundary layer over an aerodynamically rough surface in a meteorological wind tunnel. The bulk Richardson number (Ri_*), based on negative plume buoyancy, plume thickness, and friction velocity, was varied over a wide range so that the effects of stable stratification on plume laminarization could be observed. A variety of ambient wind speeds as well as three different sizes of roughness arrays were used so that possible effects of roughness Reynolds number (Re_*) on plume laminarization could also be identified. Both flow visualization methods and quantitative measurements of velocity and intermittency of turbulence were used to provide quantitative assessments of plume laminarization.Flow visualization provided an overall picture of how the plume was affected by the negative buoyancy. With increasing Ri_*, both the plume depth and the vertical mixing were significantly suppressed, while upstream propagation of the plume from the source was enhanced. The most important feature of the flow revealed by visualization was the laminarization of flow in the lower part of the plume, which appeared to be closely related to both Ri_* and Re_*.Measurements within the simulated dense gas plumes revealed the influence of the stable stratification on mean velocity and turbulence intensity profiles. Both the mean velocity and turbulence intensity were significantly reduced near the surface; and these reductions systematically depended on Ri_*. The roughness Reynolds number also had considerable influence on the mean flow and turbulence structure of the dense gas plumes.An intermittency analysis technique was developed and applied to the digitized instantaneous velocity signals. It not only confirmed the general flow picture within the dense plume indicated by the flow visualization, but also clearly demonstrated the changes of flow regime with variations in Ri_* and Re_*. Most importantly, based on this intermittency analysis, simple criteria for characterizing different flow regimes are formulated; these may be useful in predicting when plume laminarization might occur.     

精密度--偏性分析质控试验数据处理系统

结合环境监测实验实质量控制数据处理的实际要求，用计算机高级语言，设计开发成功了《精密度－偏性分析质控试验数据处理系统》，该系统具有数据输入，查询，修改，统计分析和打印报告等功能，在实际应用中，取得良好效果。     

微型测定法测定白醋中的总酸度

利用微型滴定法测定白醋中的总酸度，并对常量实验和微型实验的测定结果进行了比较分析。结果两种方法无显著性差异，F检验、t检验均在允许范围内，微型实验的准确度和精密度均达到常量实验的测定水平，完全满足化学分析要求，并且有效地节省了实验试剂，大大降低了实验成本。     

煤与瓦斯突出的物理模拟和数值模拟研究

利用自行设计的实验装置,通过现场采集具有突出倾向的煤样,分别向实验装置煤样中充入吸附能力较大的CO2和吸附能力较小的N2来模拟不同级别的煤与瓦斯突出现象,物理试验结果表明:瓦斯压力越大,突出强度越大;当瓦斯压力相近时,吸附和解吸能力大的瓦斯突出强度大。通过数值模拟对煤与瓦斯突出进行研究,数值模拟再现了煤矿开采过程中诱发的煤与瓦斯突出全过程,同时验证了煤与瓦斯突出是瓦斯压力、地应力及煤岩体的力学性质综合作用的结果,该验证对进一步深入理解认识煤与瓦斯突出的机理具有重要的理论和实践意义。     

管道内瓦斯爆炸温度与压力峰值试验研究

为分析瓦斯爆炸的火焰温度及压力峰值在管道中的传播规律,采用瓦斯管网爆炸测试系统进行试验,通过爆炸压力和爆炸火焰温度采集系统采集数据。在相同点火能量和点火位置的条件下,分析了体积分数对瓦斯爆炸的温度峰值和压力峰值的影响,及温度峰值和压力峰值随管道距离的变化规律。结果表明:当瓦斯体积分数低于9.5%时,温度峰值和压力峰值随瓦斯体积分数增大而增大;同一体积分数下,温度峰值最大值出现在最接近爆源的位置,并呈逐渐下降的趋势,接近爆源的温度峰值下降较明显,随管道延长,温度峰值的下降减慢且趋于平缓;温度峰值与传播距离近似呈三次函数关系;冲击波压力峰值随管道传播呈先上升后下降再上升的波动性变化。     

序批式动态膜生物反应器处理低碳氮比废水的试验研究

以序批式动态膜反应器为研究对象,对其处理低碳氮比废水的效果进行了试验研究.试验温度为19 ～ 21℃,MLSS为3～5g/L;好氧阶段溶解氧质量浓度为2 ～4 mg/L,厌氧阶段溶解氧质量浓度为0.2～0.5 mg/L;水力停留时间共12 h,其中好氧阶段8h,厌氧阶段4h.结果表明:当进水COD、TN和NH4+-N质量浓度分别为250～300mg/L、103 ～ 156 mg/L和92～140 mg/L时,反应器对上述污染物表现出较高且稳定的去除效率,COD、TN和NH4+-N平均去除率分别达到76.15％、82.16％和90.13％.同时,反应器系统中污泥的比硝化速率与常规处理装置中的活性污泥相比较高,以NH4+-N的降解量计为0.101 d-1,以NO3--N的积累量计为0.091 d-.     

基于正交模拟试验的矿用空气幕结构优化

为了降低空气幕的能耗,依据空气动力学理论,建立了以双三次方曲线为整流器外轮廓线的矿用空气幕模型,采用正交模拟试验方法,以出风口速度分布均匀性及阻力损失为评价指标,研究了不同结构参数下矿用空气幕内流场分布规律,计算出矿用空气幕出风口断面的速度分布均匀性参数及压力损失,得到了最优的矿用空气幕结构模型,该模型风流速度均匀性参数为0.038 5,压力损失为98.3Pa.结果表明,压力漩涡的大小及流速滞留区的范围与整流器密切相关.对矿用空气幕出风口速度分布均匀性影响最大的是供风器出风口宽度,其次为导流体中截面半径;对矿用空气幕压力损失影响最大的是供风器出风口宽度,其次为整流器及供风器长度.当导流体为圆锥体时,矿用空气幕的性能最优.     

Rider preferences and economic values for equestrian trails

Recreational horseback riding is an important, but less studied, component of human interaction with the natural environment and often occurs alongside other outdoor recreational activities. Using choice experiment data collected from a survey conducted in Kentucky, this study assesses rider preferences and economic values associated with various equestrian trail attributes for daylong horseback riding trips in rural trail systems. Results indicate that while individuals have different opinions, trail attributes such as length of trail, scenic views, and travel distance from home all have significant economic implications. In addition, riders prefer trails that are restricted for horse riding only. Willingness to pay estimates of all attributes increase substantially when the travel cost to reach the trail is also considered. Policy implications on maintaining current and creating new trails in a multi-user setting are given, such as the opportunities for separating horseback riders from other users while still providing other beneficial attributes like options for longer trails and scenic views to all groups.     

喷嘴直径对降尘效果影响的试验研究

为提高喷雾降尘效率,以改善作业环境,有必要研究喷嘴直径与降尘效果间的关系。基于自行设计的喷雾降尘试验系统,采用马尔文实时高速喷雾粒度分析仪、高速摄像仪及粉尘浓度测定仪对不同直径喷嘴的雾化特性参数和降尘效率进行测定。结果表明,在相同喷雾压力下,随着喷嘴直径的增大,全尘降尘效率持续增加,而呼吸性粉尘降尘效率先增加后减小,并在喷嘴直径为1.5 mm时达到最大值;在耗水量相同的情况下,随着喷嘴直径的增大,全尘和呼吸性粉尘降尘效率均下降。在井下喷雾降尘中,当耗水量不受限制时,为同时确保全尘和呼吸性粉尘降尘效率,宜选择直径为1.5 mm的喷嘴;当耗水量受限制时,宜选择直径为1.2 mm的喷嘴。     

关于气溶胶颗粒物沉积率系数平均方法模型的改进研究

气溶胶颗粒物在壁面的沉积率系数模型的研究已经成为现代气溶胶动力学研究的重要课题.本文通过实验腔测量和理论分析相结合,对Koivisto等(2012)提出的平均方法模型(AM)中的关键参数(即时间间隔)的选取和对测量数据量的要求两个问题进行研究.选取目前广泛使用的最小二乘法模型(LSM)和Lai和Nazaroff(2000)提出的理论分析模型进行对比.研究发现,AM模型中的时间间隔这一关键参数,应由目前的50矫正为20;AM模型和LSM模型均要求实验测量数据个数等于或者大于10,但是AM模型在小数据量情况下的预测结果更精确.