Fe-pillared clay as a Fenton-type heterogeneous catalyst for cinnamic acid degradation

Fe-pillared montmorillonite has been used as a Fenton-type heterogeneous catalyst for the removal of cinnamic acid in water. The influences of the cinnamic acid, catalyst and H2O2 concentrations and pH on the removal rate of cinnamic acid have been studied. The results show that the efficiency of Fe-pillared montmorillonite is higher than that of the Fe ions in the homogeneous phase, and less sensitive to pH.     

Influences of Magnesium <Emphasis Type="Italic">tri-</Emphasis>Silicate on the Physical,Mechanical, and Degradable Properties of Ultraviolet (UV) Radiation Cured Plain Board Surface

A series of formulations were prepared with different percentages of oligomer, epoxy diacrylate (EA-1020 ), monomer, 1,6 Hexane diol diacrylate,(HDDA) and different percentages of filler (Magnesium tri-silicate, Mg₂Si₃O₈). Irgacure 369 [2-Benzyl-2-dimethyl-amine-1 (4-morpholinophenyl) butanone-1] was used in the formulations as photoinitiator. Ultraviolet (UV) cured thin polymer films were prepared from these formulating solutions on clean glass plates. Pendulum hardness (PH), gel content and macro scratch hardness (MSH) of the UV cured films were studied. One percent Mg₂Si₃O₈ containing formulation showed the premium properties. The substrates (plain board) were coated by these formulating solutions and cured under the same UV lamp at different intensities of radiation. Various properties of the coated surface such as PH, gloss, adhesion, abrasion and MSH were investigated. The base coat containing 1% Mg₂Si₃O₈ and top coat containing 48% HDDA produced the best performance among all the formulations inspected. The degradable properties in different weathering conditions on PH, gloss, adhesion, abrasion and MSH were measured. The surface cured with the optimized formulation (E) again yielded the minimum loss of the properties.     

US/Fenton试剂协同处理焦化废水的研究

采用US (超声波)协同Fenton试剂氧化法处理焦化废水,考察了H2O2投加量、Fe2 投加量、废水的pH、反应时间和超声波功率对处理效果的影响,确定了最佳工艺条件.结果表明,在H2O2投加量7.0 g/L;Fe2 投加量500 mg/L;pH=3.0; 反应时间 40 min; 超声波功率 600 W 的条件下,COD、NH3-N、CN-和色度的去除率分别达95.8%、71.3%、69.5%和75.2%,出水COD降至41.0 mg/L.在相同条件下,US/Fenton试剂协同法的处理效率比单独Fenton试剂氧化法的处理效率提高了约20%,且反应时间显著缩短.     

The stable isotope signature of methane emitted from plant material under UV irradiation

Recent experiments have shown that dry and fresh leaves, other plant matter, as well as several structural plant components, emit methane upon irradiation with UV light. Here we present the source isotope signatures of the methane emitted from a range of dry natural plant leaves and structural compounds. UV-induced methane from organic matter is strongly depleted in both ¹³C and D compared to the bulk biomass. The isotopic content of plant methoxyl groups, which have been identified as important precursors of aerobic methane formation in plants, falls roughly halfway between the bulk and CH₄ isotopic composition. C3 and C4/CAM plants show the well-established isotope difference in bulk ¹³C content. Our results show that they also emit CH₄ with different δ¹³C value. Furthermore, δ¹³C of methoxyl groups in the plant material, and ester methoxyl groups only, show a similar difference between C3 and C4/CAM plants. The correlation between the δ¹³C of emitted CH₄ and methoxyl groups implies that methoxyl groups are not the only source substrate of CH₄.Interestingly, δD values of the emitted CH₄ are also found to be different for C3 and C4 plants, although there is no significant difference in the bulk material. Bulk δD analyses may be compromised by a large reservoir of exchangeable hydrogen, but no significant δD difference is found either for the methoxyl groups, which do not contain exchangeable hydrogen. The δD difference in CH₄ between C3 and C4 plants indicates that at least two different reservoirs are involved in CH₄ emission. One of them is the OCH₃ group, the other one must be significantly depleted, and contribute more to the emissions of C3 plants compared to C4 plants. In qualitative agreement with this hypothesis, CH₄ emission rates are higher for C3 plants than for C4 plants.     

苯胺环境标准样品研制中紫外分光光度法的应用

研究了苯胺弱酸性水溶液的紫外吸收特性，并将研究结果运用于苯胺水质标准样品的研制。用紫外分光光度法对标准样品进行均匀性、稳定性和定值测定，从而简化了分析手续，取得了良好的分析结果     

Estimation of Similarity in the Qualitative Composition of Humic Substance in Marine Sediments By Means of an Uv-Spectroscopic Library

In this paper a method for the study of the qualitative similarity of extractable humic substance (EHS) in marine sediments based on the realisation of UV spectral library of EHS is described. the spectral library was built including the digitised spectra of humic substance extracted from several marine sediments (46 samples) and two samples of standard materials (lignin sulphonate and humic substance) in a Statistica data file. the data matrix was elaborated by means of different multivariate statistic techniques such as Cluster Analysis (CA), Principal Components Analysis (PCA) and the univariate technique Spectral Correlation Analysis (SCA). This approach allows us to show the contribution of different organic compounds (aromatic, lipid and acid) to the composition of EHS and moreover it evidences also the structural characteristics of EHS in terms of similarities in the qualitative composition of samples such as presence of terrestrial and/or vegetal contributions. the UV library is an objective tool to study the qualitative composition of EHS and it represents a complementary approach to the most common methods based on the application of spectroscopic (IR, ¹³CNMR), potentiometric and chromatographic techniques.     

絮凝#x02014;微波辐射#x02014;Fenton试剂氧化法深度处理焦化废水

用絮凝#x02014;微波辐射#x02014;Fenton试剂氧化法深度处理焦化废水，研究了微波辐射时间、微波功率、FeSO₄加入量、H₂O₂加入量和废水pH对废水处理效果的影响。实验结果表明：在聚合氯化铝加入量为350mg/L、聚丙烯酰胺加入量为12mg/L、废水pH=5、FeSO₄加入量为250mg/L、H₂O₂总加入量为1400mg/L、H₂O₂分3次投加、微波功率为400W、微波辐射时间为60min的条件下，处理后出水的浊度、色度和COD去除率分别为98.59%，97.62%，86.21%。处理后出水澄清透明，COD为50.34mg/L，满足GB50050#x02014;2007《工业循环冷却水处理设计规范》的要求。     

利用原生质体诱变技术筛选脱落酸高产菌株

以葡萄孢属TB-3菌株为出发菌株制备其原生质体．在纤维素酶浓度为20g／L，蜗牛酶浓度为3g／L的酶解系统中，25℃酶解3h，其原生质体制备数可达67×105mL-1，在KYM上的再生率为46．1％，在KPDA上的再生率为33．6％，经过3轮原生质体紫外线诱变后回复再生，及对大量再生突变株进行发酵筛选，获得高产稳定株TB－3H8，其发酵液中ABA的质量浓度可达1．4g／L     

紫外分光光度法在水中阴离子表面活性剂标准样品研制中的应用

研究了阴离子表面活性剂水溶液的紫外吸收特性，并将研究结果用于阴离子表面活性剂水质标样的稳定性，均匀性和定值工作，简化了操作手续，获得了准确的分析结果。     

水中一氯胺和二氯胺的紫外连续流动测定

本文研究了二氯胺与溴化钾的反应及其产物。采用微孔渗透膜分离－紫外分光测定系统，测定水溶液中的一氯胺与二氯胺。本法的线性范围为２×１０＾－５ｍｏｌ·ｌ＾－１－１×＾－２ｍｏｌ·ｌ＾－１，标准偏差在２×１０＾－４ｍｏｌ·ｌ＾－１时为４．３％。