模拟阳光下Ag／I-TiO2光催化预处理山核桃加工废水

研究了在模拟太阳光下,采用银修饰的碘掺杂二氧化钛光催化剂（Ag／I—TiO2）对某食品厂山核桃加工废水进行光催化预处理的效果。结合x射线衍射（XRD）、比表面积分析（BET）、紫外-可见漫反射光谱（uV—Vis）的表征结果,来分析催化剂结构对于废水处理效果的影响。探讨了Ag含量、废水初始pH（pHi）和光照时间等因素对化学需氧量（COD）去除及水质可生化性（B／C）提高的影响。并得出适宜的反应参数为：3％Ag含量;pHi为6;光照时间为240min。在最佳条件下,COD去除率45％,废水B／C比由0．17上升到0．31。光催化氧化法能够有效降低山核桃加工废水的COD含量,并达到显著提高废水可生化性的目的。     

尿中氚水和总氚的对比分析测定研究

用蒸馏液闪法测量尿中氚水浓度 ,用氧化蒸馏液闪法测量尿中总氚 (氚水和有机氚 )浓度。同时测量了 1999年核设施退役时接触氚人员的高于本底水平的尿中氚水和总氚浓度 72个样品。比较氚水和有机氚浓度 ,得到有机氚浓度占氚水浓度的平均值为 (5 4± 3 7) % ,其值与理论值和动物实验值基本相符     

CONTROL OF LAKE PHOSPHORUS WITH ALUMINUM SULFATE: DOSE DETERMINATION AND APPLICATION TECHNIQUES1

ABSTRACT: Nutrient diversion does not always bring about prompt and sufficient reduction in lake phosphorus concentration due to recycling from nutrient rich sediments. Certain lakes and reservoirs may continue to experience nuisance algal blooms and require additional restorative steps. The phosphorus precipitation/inactivation technique is a procedure to remove phosphorus from the water column and to control its release from sediments in order to achieve P-limiting conditions to algal growth. Aluminum salts have been used in advanced waste water treatment to remove phosphorus and this technology was extended to lake rehabilitation. Guidelines for dose calculation and application are generally lacking, and are provided in this report. The dose determination suggested here allows maximum application of aluminum to bottom sediments and thus emphasizes long term control of phosphorus recycling. Dose can be calculated directly from the alkalinity of the water to be treated. Titration of lake water samples of Varying alkalinity allows the establishment of the relationship between residual dissolved aluminum, alkalinity, and dose which can then be employed for lake scale applications of alum to lakes and reservoirs. Application equipment and procedures are described. These depend on site characteristics and treatment objectives and include lakeside stores, a distribution pipe, and an application barge and manifold. Alum may also be used to meet other restoration objectives including the treatment of problem flows and the reduction of particulate concentrations.     

Ethoxylated Soybean Polyols for Polyurethanes

Soybean polyols prepared by ring opening reactions of epoxidized soybean oil with hydrogen active compounds (water, alcohols, organic or inorganic acids, thiols, hydrogen etc.) have a low reactivity in the reaction with isocyanates because the hydroxyl groups are secondary. This paper presents a simple and convenient method to increase the reactivity of soybean polyols with secondary hydroxyl groups by ethoxylation reactions with the preservation of triglyceride ester bonds. The method uses mild reaction conditions: low alkoxylation temperature of 35–45 °C, low pressure of 0.1–0.2 MPa (15–30 p.s.i.) and a superacid as catalyst (HBF₄). The new soybean polyols have a higher reactivity toward isocyanates in polyurethane formation due to the high percentage of primary hydroxyl groups. The primary hydroxyl content was determined by the second order kinetics of polyol reaction with phenyl isocyanate.     

Packed in-tube solid phase microextraction with graphene oxide supported on aminopropyl silica: Determination of target triazines in water samples

On-line in-tube solid phase microextraction (in-tube SPME) coupled to high performance liquid chromatography and tandem mass spectrometry (HPLC-MS/MS) was successfully applied to the determination of selected triazines in water samples. The method based on the employment of a packed column containing graphene oxide (GO) supported on aminopropyl silica (Si) showed that the extraction phase has a high potential for triazines extraction aiming to its physical-chemical properties including ultrahigh specific surface area, good mechanical and thermal stability and high fracture strength. Injection volume and loading time were both investigated and optimized. The method validation using Si-GO to extract and concentrate the analytes showed satisfactory results, good sensitivity, good linearity (0.2–4.0 µg L^?1) and low detection limits (1.1–2.9 ng L^?1). The high extraction efficiency was determined with enrichment factors ranging from 1.2–2.9 for the lowest level, 1.3–4.9 intermediate level and 1.2–3.0 highest level (n = 3). Although the analytes were not detected in the real samples evaluated, the method has demonstrated to be efficient through its application in the analysis of spiked triazines in ground and mineral water samples.     

铬天青S-铝(Ⅲ)-聚乙二醇4000体系的共振散射光谱及其应用

在pH5 0的NaAc HAc缓冲溶液及非离子表面活性剂聚乙二醇 40 0 0存在下 ,铬天青S与铝 (Ⅲ )形成络合物微粒体系 ,在 40 0nm和 5 30nm处出现两个较强的共振散射峰 .共振散射光强度与Al(Ⅲ )的浓度在 0 0 84— 0 84μg·ml- 1 范围内呈良好的线性关系 ,考察了适宜的反应条件及共存物质的影响 .建立了一个共振散射光谱测定水中Al的方法 ,其结果与分光光度法一致 .     

Mitigation of methane and nitrous oxide emissions from drained irrigated rice fields

One of the important cultural practices that affect methane and nitrous oxide emissions from tropical rice plantations is the water drainage system. While drainage can reduce methane emissions, it can also increase nitrous oxide emissions, as well as reduce yields. In this experiment, four different water drainage systems were compared in a rice field in central Thailand including: (1) continuous flooding, (2) mid-season drainage, (3) multiple drainage and (4) a local method (drainage was done according to local cultural practice) in order to find a system of drainage that would optimize yields while simultaneously limiting methane and nitrous oxide emissions. Methane and nitrous oxide emission were observed and compared with rice yield and physical changes of rice plants. It was found that drainage during the flowering period could reduce methane emission. Interestingly, nitrous oxide emission was related to number of drain days rather than the frequency of draining. Fewer drain days can help reduce nitrous oxide emission. The mid-season drainage and the multiple drainage, with 6.9% and 11.4% reduction in rice yield, respectively, had an average methane emission per crop 27% and 35% lower when compared to the local method. Draining with fewer drain days during the flowering period was recommended as a compromise between emissions and yield. The field drainage can be used as an option to reduce methane and nitrous oxide emissions from rice fields with acceptable yield reduction. Mid-season drainage during the rice flowering period, with a shortened drainage period (3 days), is suggested as a compromise between the need to reduce global warming and current socio-economic realities.     

离子强度和SO2-4对土壤吸附Al的影响

研究了离子强度和SO4^2-对土壤吸附Al的影响，结果表明：在所研究的pH范围内，随着NaCl支持电解质浓度的提高，土壤对Al的吸附量基本保持不变，并且当pH＜3．9时，即土壤表面净电荷为正时，土壤对Al的吸附量仍然很大，超过最大吸附量的50％，而用CaCl2作支持电解质时，当pH＜4．5时，在溶液中CaCl2浓度最高的情况下，Al的吸附量最小，在其余两种浓度条件下则基本相等；当pH＞4．5时，Al的吸附量几乎不受CaCl2浓度变化的影响。SO4^2-的加入对土壤吸附Al没有影响。这些都说明土壤吸附Al的作用机制主要为专性吸附。     

pH对铝盐絮凝剂形态分布与混凝除氟性能的影响

对比研究了AlC13和3种不同碱化度的聚合氯化铝(PACl)在不同pH与投量下除氟效果,并对不同形态铝盐除氟机理进行了初步探讨.结果表明,pH对絮凝剂水解后铝形态分布及其除氟效果有重要影响.pH 5 ～6时,Al3+和Al2、Al3等低聚态铝为AlCl3主要形态,且AlCl3更易水解生成可将溶解态氟转化为颗粒态氟的Al(OH)3,从而较PACl具有更佳除氟效果.pH ＞7时,PACl较AlCl3具有更佳除氟效果,且增大PACl碱化度可促进氟的去除,这主要是由于具有较高Al13含量的PACl更容易与电负性F-结合所致;且絮凝剂混凝除氟絮体ζ电位越高,越利于F-在絮体表面吸附.     

砖红壤中Al和Pb的竞争吸附

从pH值和离子加入量两个角度研究了砖红壤中Al和Pb的竞争吸附 .结果表明 ,当低数量的Al和Pb共存时 ,离子的吸附量与其单独存在下的情形相比都有所下降 ,该现象在低pH值的条件下较为明显 ,而随着pH值升高则逐渐减弱 ;若Al和Pb共存时的初始浓度均为 1 0mmol·l- 1 ,两者之间的竞争吸附在pH 3 5至 5 5范围内都较为显著 ;此外 ,当0 1mmol·l- 1 的Pb与 1 0mmol·l- 1 的Al共存时 ,Al的吸附没有受到Pb的影响 ,此时尽管Al和Pb的浓度比为 1 0∶1 ,但土壤对Pb的吸附并没有被Al完全抑制 ,反映出土壤表面某些吸附位对Pb具有高度的选择性