过氧化氢催化氧化难降解废水的研究

文章以过氧化氢为氧化剂,以γ-Al2O3为载体采用浸渍法制得不同金属含量的九种催化剂进行催化氧化实验,并优选出以5.0%Co、2.5?(质量百分含量)催化剂CODcr去除率较好,并确定此催化剂在常温常压下,反应时间为30 min,pH=6,氧化剂用量为30g/L时,CODcr的去除率最高为83%,这样不仅提高了BOD5/CODcr值,而且有利于后续生化处理,减轻后续处理装置负荷.     

高锰酸钾与接触氧化协同除锰及硬度对除锰效果的影响

针对日益严重的地表水锰污染，本实验采用高锰酸钾与接触氧化的方法协同除锰；通过调配进水中Ca²⁺、Mg²⁺含量模拟我国不同地区硬度差异显著的地表水，探究水体硬度对锰的去除效果的影响.结果表明：Mn²⁺被高锰酸钾氧化并形成"锰质活性滤膜"，可在停药后实现稳定有效除锰.成熟滤池的除锰效果会显著受到硬度的影响，进水硬度在40、200、400 mg·L^-1及700 mg·L^-1（CaCO₃计）时，接触氧化滤池分别在48、56、64 d及72 d实现稳定除锰，而4根滤柱对Mn²⁺去除的极限浓度分别为1.8、1.7、1.2 mg·L^-1及0.7 mg·L^-1.     

板材成形新技术及其发展趋势(Ⅱ)

介绍了多点成形技术、激光成形技术、冲压智能化技术、成形过程的计算机仿真技术等几种柔性化程度高的板材成形新技术及其发展趋势     

氧化絮凝复合床预处理印染废水的试验研究

在传统铁屑内电解的基础上,提出了氧化絮凝复合床的新技术,并使用该方法对印染废水预处理进行研究,确定了pH值,反应时间等工艺参数的影响。实验结果显示,在酸性条件下,pH为6左右,停留时间为30～45min,处理效果基本达到稳定。COD的去除率可达30%～90%,色度去除率均可达95%以上,且可提高废水的可生化性,为后续生化处理创造了有利条件。另外还研究了加盐Na2CO3,催化剂MnO2,TiO2对印染废水的处理效果。研究表明加以上添加剂后,处理效果均有所提高。该工艺以其设备简单,成本低,操作方便,预处理效果好,以废治废等优点而广受青睐,具有较好的研究价值和工程使用前景。     

混凝沉淀-酸化水解-接触氧化工艺处理聚苯乙烯生产废水

采用混凝沉淀酸化水解生物接触氧化工艺处理聚苯乙烯生产废水,通过治理工程实际运行,结果表明:当废水CODCr平均浓度为1160mg/L时,CODCr去除率为882%,出水水质稳定,能达到设计要求。     

高浓度甲基橙溶液的低压湿式催化氧化处理

以高浓度甲基橙溶液模拟偶氮染料废水,采用低压湿式催化氧化法(LPWCO)进行处理,考察了H2O2投量、温度、FeSO4投量、硫酸浓度、甲基橙浓度等因素对甲基橙脱色率的影响。结果表明,LPWCO法能有效地使高浓度(大于400mg/L)甲基橙溶液脱色,脱色率大于95%,而H2O2投量不到Fenton法的5%。     

水解酸化＋两级生物接触氧化处理高盐度水产品加工废水

介绍了“水解酸化＋两级生物接触氧化”处理水产品加工废水的运行效果和工程实例，结果表明：对C1^-浓度平均6000mg／L的高盐度水产品加工废水，系统对COD、SS、氨氮的去除率分别超过了88％、90％、85％，出水COD、SS、氨氮分别低于100mg／L、70mg／L、15mg／L，出水完全可以达到《污水综合排放标准》（GB8978—1996）一级排放标准。     

Influence of new town development on the urban heat island - The case of the Bundang area

Five new towns have been developed around the Seoul metropolitan area since 1996. However, these new towns generate lots of traffic and related problems in the areas including those new towns and Seoul as a result of increases in population and a lack of ecological-self-sufficiency. Currently, construction of another new town is under deliberation, and what should be a major consider is the notion that the new town be located within a wide, green zone. Many studies have revealed that green space can play an important role in improving urban eco-meteorological capability and air quality. In order to analyze the urban heat island which will be created by the new urban development, and to investigate the local thermal environment and its negative effects caused by a change of land use type and urbanization, Landsat TM images were used for extraction of urban surface temperature according to changes of land use over the last 15 years. These data are analyzed together with digital land use and topographic information. As a study result, it was found the urban heat island of the study area from 198.5 to 1999 rapidly developed which showed a difference of mean temperature above 2.0. Before the Bundang new town construction the temperature of the residential area was the same as a forest, but during the new town construction in 1991 analysis revealed the creation of an urban heat island. The temperature of a forest whose size is over 50% of the investigation area was lowest, and thus the presence of a forest is believed to have a direct cooling effect on the urban environment and its surroundings. The mean temperature of the residential and commercial areas in the study was found to be 4.5 higher than the forest, and therefore this part of land use is believed to be the main factor causing the temperature increase of the urban heat island.     

Decomplexation of Cu-1-hydroxyethylidene-1,1-diphosphonic acid by a three-dimensional electrolysis system with activated biochar as particle electrodes

The feasibility of decomplexation removal of typical contaminants in electroplating wastewater, complexed Cu(II) with 1-hydroxyethylidene-1,1-diphosphonic acid (Cu-HEDP), was first performed by a three-dimensional electric reactor with activated biochar as particle electrodes. For the case of 50 mg/L Cu-HEDP, Cu(II) removal (90.7%) and PO initial pH 7, acid-treated almond shell biochar (AASB) addition 20 g/L, and reaction time 180 min, with second-order rate constants of 1.10 × 10⁻³ and 1.94 × 10⁻⁵ min⁻¹respectively. The growing chelating effect between Cu(II) and HEDP and the comprehensive actions of adsorptive accumulation, direct and indirect oxidation given by particle electrodes accounted for the enhanced removal of Cu-HEDP, even though the mineralization of HEDP was mainly dependent on anode oxidation. The performance attenuation of AASB particle electrodes was ascribed to the excessive consumption of oxygen-containing functionalities during the reaction, especially acidic carboxylic groups and quinones on particle electrodes, which decreased from 446.74 to 291.48 µmol/g, and 377.55 to 247.71 µmol/g, respectively. Based on the determination of adsorption behavior and indirect electrochemical oxidation mediated by in situ electrogenerated H₂O₂ and reactive oxygen species (e.g., •OH), a possible removal mechanism of Cu-HEDP by three-dimensional electrolysis was further proposed.     

新型高效台车式退火炉研制

退火炉采取小燃烧室,对工件实行侧下加热、强化绝热措施复合炉衬、二次均热风管、扩张室沉降等五项措施.目的是为了提高炉的热效率和炉温的均匀度.在耗煤量较低的情况下能保持较高的燃烧室强度.有利于强化燃烧和减少蓄散热损失.实行扩张室沉降,在不加任何除尘装置的条件下烟尘排放浓度达到了国家标准新规定的排放要求,而且大大改善了工人的劳动条件.