一起油罐爆炸火灾原因调查及分析

对一起油罐爆炸火灾事故进行了调查，对回流油速度进行了测算，从静电的产生和放电、爆炸性气体混合物的形成进行了分析和研究，指出了火灾原因，提出了应吸取的教训。     

Comparison of the daily global solar radiation from different data sources in Northwest China climate

The solar radiation data are of high importance to the solar energy systems. Conventional methods to obtain the solar radiation data are from weather stations, solar radiation models, commercial software databases, and field measurements. In the present study, a new daily global solar radiation model is proposed, by combining the quadratic function of sunshine fraction and sine function of the day of the year. The solar radiation model calculated data are then compared with China Meteorological Data Sharing System (CMDSS) data, TRNSYS data, and field-measured data in Northwest China climate. It is found that the newly proposed solar radiation model has better performance than the other nine solar radiation models in the literature. The solar radiation model calculated data fit well with the CMDSS annually average data. The TRNSYS data are a bit larger than the CMDSS annually average data in summer half year and a little smaller than those in winter half year. The solar radiation model and the CMDSS annually average data have the best correlation, whereas the TRNSYS data and the field-measured data have the worst correlation. The solar radiation model calculated data have the best correlation with the other three data sources.     

京津冀产业碳排放强度变化及驱动因素研究

为探讨京津冀地区温室气体排放强度变化的影响因素,采用对数平均迪式分解模型及归因分析(LMDI-Attribution)方法,基于1996—2014年数据从细分行业角度进行研究。针对温室气体排放强度作产业结构、能源强度和排放因子三因素LMDI乘法分解,对温室气体排放强度变化的影响效应作归因分析,量化4个行业对分解因素影响效应的贡献,得到以下主要结论:1996—2014年京津冀地区温室气体排放强度主要呈现下降趋势,累计下降23.05%。其中,能源强度是温室气体排放强度下降的主导因素,其影响效应为-61.18%,对这一影响效应贡献最大的是工业,并且四大经济部门均通过能源强度在不同程度上使得温室气体排放强度有所减小,可见"阶梯电价"、"千家企业节能项目"、"十大重点节能项目"等相关政策在工业发展中对提高能源效率的作用明显。产业结构使得温室气体排放强度增加23.53%,其主要贡献者是工业,说明"工业产品出口退税率调整"等一系列政策的效果不明显;然而农业则使得温室气体排放强度降低,贡献值为3.09%。碳排放因子在1996—2014年间对温室气体排放强度的影响为60.47%,是京津冀地区温室气体排放强度增加的主要因素,说明京津冀地区的能源结构不合理。工业对这一效应的贡献最大为55.97%。可见,工业在京津冀地区的温室气体减排工作中起到最为关键的作用。     

Vetoing the future: political constraints and renewable energy

Despite the increased importance of and attention to renewable energy, its share in the overall energy mix has varied significantly across countries and over time. There are many determinants of clean energy transitions; this study focuses on political constraints. Here it is argued that political systems that have fewer political constraints have fewer access points through which powerful status quo veto players can slow the progress of clean energy reforms. To test the theory, a hierarchical model is applied on a dataset of 125 countries over four decades. The results provide significant support for the theory. Furthermore, the effects for political constraints hold even when we distinguish between hydro and non-hydro renewable sources and control for regime type. This study builds on research that recognizes the importance of politics in understanding the challenges and opportunities of clean energy reform.     

微生物-光-电化学耦合技术降解污染物和回收能源的研究进展

微生物电化学技术能同时实现污染物去除和能量回收，但存在污染物去除种类有限及产能效率低的局限，近几年将可再生的太阳能引入微生物电化学技术的微生物-光-电化学耦合技术应运而生。本文简要介绍了微生物-光-电化学耦合技术的发展背景和研究现状，对该技术现有的耦合形式进行分类，并对各种形式的耦合机理进行详细的阐释，最后对其未来的发展进行了展望。     

Comparative study on performances of a heat-pipe PV/T system and a heat-pipe solar water heating system

The heat-pipe solar water heating (HP-SWH) system and the heat-pipe photovoltaic/thermal (HP-PV/T) system are two practical solar systems, both of which use heat pipes to transfer heat. By selecting appropriate working fluid of the heat-pipes, these systems can be used in the cold region without being frozen. However, performances of these two solar systems are different because the HP-PV/T system can simultaneously provide electricity and heat, whereas the HP-SWH system provides heat only. In order to understand these two systems, this work presents a mathematical model for each system to study their one-day and annual performances. One-day simulation results showed that the HP-SWH system obtained more thermal energy and total energy than the HP-PV/T system while the HP-PV/T system achieved higher exergy efficiency than the HP-SWH system. Annual simulation results indicated that the HP-SWH system can heat the water to the available temperature (45°C) solely by solar energy for more than 121 days per year in typical climate regions of China, Hong Kong, Lhasa, and Beijing, while the HP-PV/T system can only work for not more than 102 days. The HP-PV/T system, however, can provide an additional electricity output of 73.019 kWh/m², 129.472 kWh/m², and 90.309 kWh/m² per unit collector area in the three regions, respectively.     

Efficiency enhancement in solar air heaters by modification of absorber plate-a review

This paper outlines a complete review on modifications made on the absorber plate of solar air heaters in order to improve the turbulence and heat transfer rate, thereby efficiency. Corrugated sheets, fins, extended surfaces, wire mesh, porous medium, etc., are a few of the modifications used. Most of such alterations in the absorber plate resulted with an increase in efficiency but associated with drawback of increased pumping power due to raising friction factor. Pumping power is considered here as a predominant comparison parameters of various solar air heaters with different absorber plate in terms of effective efficiency.     

Quantifying the rebound effects of residential solar panel adoption

Customers who adopt solar panels can reduce their energy bills and lower the effective average electricity prices they pay. When the price falls, a solar consumer might consume more electricity than before – a solar rebound effect. We provide the first empirical evidence of residential solar rebound effects in the U.S. We use household level hourly and daily electricity meter data as well as hourly solar panel electricity generation data from 277 solar homes and about 4000 non-solar homes from 2013 to 2017 in Phoenix Arizona. Using matching methods and a fixed effects panel regression approach, we find that when solar electricity generation increases by 1 kWh, solar homes increase their total electricity consumption by 0.18 kWh. This indicates that solar rebound effects are estimated at 18%. Building upon our theoretical framework, the increase in consumer surplus from solar panel adoption is estimated at $972/yr.     

Modeling urban solar energy with high spatiotemporal resolution: A case study in Toronto,Canada

This research presents a method to determine the maximum potential for the capturing of solar radiation on the rooftop of buildings in an urban environment. This involves the modeling of solar energy potential and comparison to historical building energy demand profiles through the use of 3-D solar simulation software tools and geographic information systems (GIS). The objective is to accurately identify the amount of surface area that is suitable for solar photovoltaic (PV) installations and to estimate the hourly PV electricity generation potential of existing building rooftops in an urban environment. This study demonstrates a viable approach for modeling urban solar energy and offers valuable information for electricity distributors, policy makers, and urban energy planners to facilitate the substantial design of a green built environment. The developed methodology is comprised of three main sections: (1) determination of suitable rooftop area, (2) determination of the amount of incident solar radiation available per rooftop, and (3) estimation of hourly solar PV electricity generation potential. A case study was performed using this method for Ryerson University, located in Toronto, Canada. It was found that solar PV could supply up to 19% of the study area’s electricity demands during peak consumption hours. The potential benefits of solar PV was also estimated based upon hourly greenhouse gas emission intensity factors as well as Time-of-Use (TOU) savings through the Ontario Feed-in-Tariff (FIT) program, which allows for better representation of the positive impacts of solar technologies.     

Improving photostability and efficiency of polymeric luminescent solar concentrators by PMMA/MgO nanohybrid coatings

MgO nanocrystals were synthesized and doped with different concentrations in poly(methylmethacrylate) (PMMA) to prepare hybrid organic-inorganic coatings based on polymer nanohybrid thin films. The nanoparticles were found to be spherical with 62 nm diameter as determined by X-ray diffraction (XRD) and atomic force microscope (AFM). The coatings were characterized by spectroscopic tools such as optical absorption, transmission and fluorescence spectroscopy. The prepared nanohybrid films were spin-coated on cost-effective luminescent PMMA substrates doped with highly efficient luminescent dyes luminescent solar concentrators (LSCs). The outdoor photostability tests demonstrated enhanced protection against UVA radiation for coated LSCs compared to bare LSC substrates. The current–voltage characteristics of commercially produced LSC prototypes showed that the poor UV response of monocrystalline silicon solar cell can be improved by for LSCs coated by PMMA/MgO nanohybrid films which act as luminescent down shifting layer (LDSL).