TSLCDM长袋低压脉冲布袋除尘器及其应用

为了使电炉烟气治理过程中污染源的排放达到国家排放标准,提出一种TSLCDM长袋低压脉冲除尘器(简称TSLCDM除尘器)。通过对该除尘器结构、除尘原理以及不同工况下除尘效率和过滤阻力的分析,得到该除尘器的除尘效率>99.9%,压力损失<1200 Pa,最终排出的烟气含尘质量浓度约5.54 mg/m3,满足了国家的超低排放要求,以泉州某公司电炉项目除尘系统为研究对象,证明了该新型脉冲布袋除尘器在电炉烟气治理除尘系统的应用效果,具有很好的经济和环境效益。     

高压脉冲放电等离子体处理活性红X-3B染料废水

采用高压脉冲放电等离子体技术对活性红X-3B染料废水进行处理,考察了废水电导率、脉冲电压、脉冲频率、针板间距以及曝气量对处理效果的影响。实验结果表明,当废水电导率为200μS/cm、脉冲电压为34kV、脉冲频率为60Hz、针板间距为15mm、曝气量为12L/h、处理时间为60m in时,活性红X-3B染料废水脱色率能达到98.6%。     

脉冲厌氧流化床反应器(PAFR反应器)

<正>由广州中环万代环境工程有限公司开发的脉冲厌氧流化床反应器(PAFR反应器),适用于高浓度造纸工业废水处理工艺、工业园区工业废水集中处理、其它高浓度有机工业废水处理工艺。     

TiO2催化高压脉冲放电等离子体降解2，4-二硝基苯酚

采用TiO2催化高压脉冲放电等离子体降解废水中的2,4-二硝基苯酚,对反应进行了动力学研究.研究结果表明,在高压脉冲放电等离子体及TiO2催化高压脉冲放电等离子体反应中,2,4-二硝基苯酚的降解过程均符合表观一级反应动力学方程.加入TiO2催化剂、提高放电电压均可提高2,4-二硝基苯酚的降解反应速率常数.在TiO2加入量为0.15%、放电电压为16 kV时,2,4-二硝基苯酚的降解率为87.4%,TiO2的催化效应增强因子为1.55.     

烧结机机尾除尘系统的改造

叙述某烧结厂烧结机机尾除尘方式由原来的回转反吹扁袋除尘器改为气箱脉冲袋式除尘器的设计及工程实例。介绍原用除尘器的缺点及改造后除尘器的设计安装及运行数据和监测结果等方面的问题。改造后除尘系统已经运行一年,各项指标正常,运行良好。     

Electrochemical and spectroscopic characteristics of dissolved organic matter in a forest soil profile

Dissolved organic matter （DOM） represents one of the most mobile and reactive organic compounds in ecosystem and plays an important role in the fate and transport of soil organic pollutants, nutrient cycling and more importantly global climate change. Electrochemical methods were first employed to evaluate DOM redox properties, and spectroscopic approaches were utilized to obtain information concerning its composition and structure. DOM was extracted from a forest soil profile with five horizons. Differential pulse voltammetry indicated that there were more redox-active moieties in the DOM from upper horizons than in that from lower horizons. Cyclic voltammetry further showed that these moieties were reversible in electron transfer. Chronoamperometry was employed to quantify the electron transfer capacity of DOM, including electron acceptor capacity and electron donor capacity, both of which decreased sharply with increasing depth. FT-IR, UV-Vis and fluorescence spectra results suggested that DOM from the upper horizons was enriched with aromatic and humic structures while that from the lower horizons was rich in aliphatic carbon, which supported the findings obtained by electrochemical approaches. Electrochemical approaches combined with spectroscopic methods were applied to evaluate the characteristics of DOM extracted along a forest soil profile. The electrochemical properties of DOM, which can be rapidly and simply obtained, provide insight into the migration and transformation of DOM along a soil profile and will aid in better understanding of the biogeochemical role of DOM in natural environments.     

NBI加速极电源分布电容数值仿真

离子源是中性束注入器（NBI）的核心部件。离子源负载打火期间,储存在电路中的电容储能超过一定阈值,离子源将会受到严重的损坏。通过对NBI电源系统的分析,得出加速极电源的对地电容是电源系统总杂散电容的主要组成部分。直接求解加速极电源的对地分布电容是十分困难的,根据加速极电源的结构布局,采用数值仿真的方法对加速极电源进行建模和求解,得到了加速极脉冲电源100 kV的等效电容大小,为NBI离子源的设计和安全运行提供了重要依据。     

脉冲电晕放电与CuO/γ-Al2O3协同处理烟气中SO2和NO的实验研究

研究了催化剂CuO/γ-Al2O3与脉冲电晕放电协同作用脱除烟气中的SO2和NO.结果表明, 在100 ℃以下,CuO/γ-Al2O3与脉冲电晕放电协同作用具有较好的脱硫脱氮效果.当脉冲电压40 kV,进口烟气温度80 ℃,出口烟气温度40℃,气体在烟道中的流速为1.3 m/s,SO2的初始质量浓度为1 400 mg/m3,NO的初始质量浓度350 mg/m3,SO2的脱除率达到85%,NO的脱除率达到30%.     

等离子体催化降解有机废水研究

研究了多种因素对高压脉冲介质阻挡放电低温等离子体法处理印染废水效果的影响。通过实验得出结论:随着有效处理时间和峰值外施电压的增加,废水中的有机物的去除率增加;随着水样浓度的增加,废水中有机物的去除率降低;随着催化剂(TiO)2量的增加,废水中有机物的去除率先升高后降低,最佳催化剂的加入量为0.5 g/L TiO2悬浮液0.5 mL。     

高压脉冲电凝-Fenton-生化法处理制药废水

通过高压脉冲电凝-Fenton对制药废水进行预处理,出水进入UASB-AO生化处理系统.研究表明:高压脉冲电凝-Fenton氧化法的最佳工况条件为进水pH值为4.0左右,高压脉冲电凝反应时间为45 min,H2O2投加量为4mL/L,Fenton氧化时间为60min.高压脉冲电凝-Fenton对CODCr去除率为36.5%～39.2%,ρ(BOD5)/ρ(CODCr)从0.13提高到0.32-0.34,废水的可生化性大大提高,UASB厌氧反应器去除率为81.4%～82.1%,AO系统去除率为88.0%～88.5%,而整个生化处理系统对CODCr去除率为95.4%～97.9%,最终出水各项指标可达到GB 8978-1996<污水综合排放标准>中一级标准.