Growth, photosynthesis and antioxidant responses of two microalgal species, Chlorella vulgaris and Selenastrum capricornutum, to nonylphenol stress

The effect of nonylphenol (NP) on growth, photochemistry and biochemistry of two green microalgae, Chlorella vulgaris and Selenanstrum capricornutum, and their ability to degrade NP were compared. The 96 h EC₅₀ of C. vulgaris and S. capricornutum were greater than 4.0 and 1.0 mg L⁻¹ NP, respectively, suggesting that the former species was more tolerant to NP. Both microalgae acclimated to NP stress through down-regulating their photosynthetic activities, including antenna size (chlorophyll a content), maximal photochemistry (Fv/Fm) and the light absorbed by PSII (ABS/CS₀), but the dissipation of energy from reaction centres (DI₀/RC) increased with the increase of NP concentrations. In C. vulgaris, the changes of these parameters were more significant than in S. capricornutum and recovered completely after a 96 h exposure. The antioxidant responses, such as GSH content, CAT and POD activities in C. vulgaris increased with the increase of NP concentrations after a 24 h exposure, but these changes disappeared with exposure time and recovered to the control levels after 96 h. In S. capricornutum, although GSH content, CAT and POD activities also increased when exposed to low- to moderate-NP concentrations, these values were significantly reduced at a high concentration (4 mg L⁻¹) even after a 96 h exposure, indicating its antioxidant responses were significantly delayed. It is clear that the more NP-tolerant species, C. vulgaris, acclimated better with a faster recovery of its photosynthetic activity from the NP-induced damage, and exhibited more efficient and rapid responses to NP-induced oxidative stress. C. vulgaris also had a higher NP degradation ability than S. capricornutum.     

玻璃纤维-砂浆管试件动态拉伸破坏特性试验研究

为了探究动载作用下GFRP（玻璃纤维）-砂浆管的动态拉伸破坏特性，采用分离式SHPB试验装置对2种空心率的水泥砂浆管和GFRP-砂浆管进行动态拉伸试验。结果表明:空心率越小、冲击气压和壁厚越大，试件峰值抗拉强度越大；GFRP-砂浆管的峰值抗拉强度随GFRP管壁厚的增大而不断增大，在空心率为0.292时，峰值抗拉强度随GFRP管壁厚增大呈对数函数递增，而在空心率0.187时，峰值抗拉强度随GFRP管壁厚增大呈指数函数递增；无GFRP管时水泥砂浆管呈对称四块破碎，GFRP-砂浆管在0.5~0.7 MPa冲击气压下仅有细小裂纹产生，在0.8 MPa冲击气压下，与入射杆接触部分产生“楔形”破坏，但总体保持为管状、破坏程度仍低于水泥砂浆管，表明GFRP管对水泥砂浆管具有较好的保护作用，可有效提高其动态抗拉强度。     

Comparison of surface emissions and subsurface distribution of cis- and trans-1,3-dichloropropne and chloropicrin in sandy field beds covered with four different plastic films

The purpose of this study was to conduct a field study at a Florida field site on surface emissions and subsurface distribution of cis-and trans-1,3-dichloropropene (1,3-D) and chloropicrin (CP) in raised beds injected with Telone C35 with four replications. A total of 16 beds were applied with Telone C35 by chisel injection and covered with four different plastic films, 4 beds for each film. Each bed was installed with five 20-cm long soil pore air probes and a surface air collection pan at arbitrarily locations along the length of each bed for sampling soil pore air and surface air, respectively, for analysis of the three biologically active compounds, cis- and trans-1,3-D and CP. We found that average concentrations of the three compounds at 20-cm depth among the beds covered with four different plastic films generally were not statistically different. Among the four beds covered with the same plastic film, average concentrations of the three compounds were statistically different only in the four metallic PE covered beds at 5 and 24 hours after injection. Volatilization rates of the three compounds among the beds covered with four different plastic films, with the exception of CP at 48 hours after injection, were not statistically different. It appeared that initial upward diffusion and volatilization flux were influenced by solar radiation. Initial subsurface concentrations of the three compounds and volatilization flux, especially cis-1,3-D, were greater in the beds on the east side of the field than that in the beds on the west side of the field. Whether or not difference in initial subsurface concentrations of the compounds between east side beds and west side beds may influence fumigant efficacy remains to be determined.     

近距离上保护层开采最小安全岩柱厚度研究

运用岩石力学知识和数值模拟方法,分析近距离保护层矩形掘进巷道周边的应力分布规律以及巷道塑性区范围的确定方法,并结合平煤集团五矿的保护层开采条件,利用FLAC数值计算程序对该矿近距离上保护层掘进期间不同岩柱厚度条件下的保护层底板塑性破坏范围进行数值模拟,在此基础上,提出合理确定保护层底板安全岩柱厚度的方法,现场观测结果表明,理论计算与数值模拟结果比较吻合,符合生产实际。     

施肥与地膜覆盖对土壤有机质平衡的影响

用田间长期定位试验法研究了施肥与地膜覆盖条件下玉米连作在壤质棕壤中有机质的矿化、积累和平衡。结果表明，土壤有机质矿化率在０．０１０７～０．０４３８／ａ之间，施肥与地膜覆盖有利于土壤有机质的积累与平衡，并加快有机质矿化；在本试验各施肥处理中土壤有机质均有所积累；在连年稳定施肥条件下，有机肥的施用会明显提高土壤有机质平衡值     

“限塑令”政策实施效应与对策研究

分析了"限塑令"的政策安排、实施效果,以及"限塑令"的实行对塑料袋生产、销售、使用相关各方的影响,讨论了政策执行中存在的政策实施目的偏差、缺乏配套政策、回收利用产业发展缓慢、垃圾袋和替代品不环保等问题,提出了保证"限塑令"政策有效实施的对策建议,即应依照少用、回收、替代、降解的原则对待塑料袋的使用。     

上海市一次性塑料饭盒的管理现状分析及建议

梳理了上海市在一次性塑料饭盒管理工作中回收处置系统难以正常运转的主要问题，提出了建立全国一盘棋的格局，将其他塑料废弃物纳入回收处置的管理范畴，并建立对废塑料回收处置的奖励或补贴政策，从而继续控制视觉污染，促进生活垃圾减量化和资源化。     

挥发性有机物气体污染源监测中直接采样法的评价

挥发性有机物气体污染源监测中 ,采样与样品的保存是极其关键的环节 ,文中评价了两种材质的塑料采样袋对样品保存的影响 ,并与玻璃针筒进行比较 ,讨论了塑料袋和玻璃针筒采样中导致样品浓度衰减的主要因素     

Improved method for the formation of recycled resins from depolymerized products of waste fiber-reinforced plastics: simple and effective purification of recovered monomers by washing with water

The synthesis of recycled plastics from recovered monomeric materials obtained from the depolymerization reaction of fiber-reinforced plastics (FRP) was examined. The depolymerization reaction of FRP in the presence of N,N-dimethylaminopyridine (DMAP) smoothly yielded the corresponding monomers, which mainly consisted of dimethyl phthalates. The polymerization reaction with this monomer failed to form the corresponding unsaturated polyesters due to contamination by N-methyl-4-pyridone, a decomposition product of DMAP. An efficient purification of the recovered monomer was achieved by washing with water, and the purified monomer successfully yielded the corresponding polymers. A hardness test revealed that the polymers were as hard as the polyester made from virgin materials. The present modification provides a practical method for the preparation of recycled plastics from depolymerized plastics.     

Chemiluminescence in evaluating the thermal oxidative stability of acrylonitrile-butadiene-styrene (ABS) copolymers. 1. Influence of stabilizers and lubricants

The influence of lubricants, UV stabilizers, antioxidants, and metal deactivators on the resistance of ABS to thermal oxidation was studied by means of the chemiluminescence technique. Neither of the additives seems to affect significantly the induction period of oxidation. At the same time, the influence of various additives on the oxidation rate constant is remarkably different: the introduction of lubricants and UV stabilizers increases its value, while antioxidants and metal deactivators have the opposite effect. For the particular systems studied durability is decreased in samples containing the lubricant and UV stabilizers and increased in samples stabilized with the antioxidant and metal deactivator.