摇动床生物膜反应器和活性污泥法组合技术处理高浓度有机废水的研究

利用摇动床生物膜反应器(简称摇动床)技术具有的容积负荷高与污泥产量低的优点,在普通活性污泥池的前部填充高性能丙烯酸树脂纤维(Biofringe)填料,研究了摇动床和活性污泥法组合技术处理高浓度有机废水的有效性。结果表明,该组合技术具有很强的有机物去除能力,当进水COD平均质量浓度由1500mg/L上升到2514mg/L时,出水COD的平均去除率基本保持在96%以上;整个运行阶段的出水COD浓度均满足《污水综合排放标准》(GB8978—1996)的二级标准;当进水NH4+-N浓度增加时,NH4+-N的去除率由99.7%降低到76.5%,但是在试验运行的整个阶段,摇动床和活性污泥法组合技术系统都表现出较强的硝化能力;活性污泥池中最高的混合液悬浮固体(MLSS)质量浓度为10625mg/L,最高MLSS约为普通活性污泥法的4倍;运行结束后的污泥产率为0.186,污泥产率仅为普通活性污泥法的50%左右。     

A strategy for aromatic hydrocarbon bioremediation under anaerobic conditions and the impacts of ethanol: a microcosm study

Increased use of ethanol-blended gasoline (gasohol) and its potential release into the subsurface have spurred interest in studying the biodegradation of and interactions between ethanol and gasoline components such as benzene, toluene, ethylbenzene and xylene isomers (BTEX) in groundwater plumes. The preferred substrate status and the high biological oxygen demand (BOD) posed by ethanol and its biodegradation products suggests that anaerobic electron acceptors (EAs) will be required to support in situ bioremediation of BTEX. To develop a strategy for aromatic hydrocarbon bioremediation and to understand the impacts of ethanol on BTEX biodegradation under strictly anaerobic conditions, a microcosm experiment was conducted using pristine aquifer sand and groundwater obtained from Canadian Forces Base Borden, Canada. The initial electron accepter pool included nitrate, sulfate and/or ferric iron. The microcosms typically contained 400 g of sediment, 600 approximately 800 ml of groundwater, and with differing EAs added, and were run under anaerobic conditions. Ethanol was added to some at concentrations of 500 and 5000 mg/L. Trends for biodegradation of aromatic hydrocarbons for the Borden aquifer material were first developed in the absence of ethanol, The results showed that indigenous microorganisms could degrade all aromatic hydrocarbons (BTEX and trimethylbenzene isomers-TMB) under nitrate- and ferric iron-combined conditions, but not under sulfate-reducing conditions. Toluene, ethylbenzene and m/p-xylene were biodegraded under denitrifying conditions. However, the persistence of benzene indicated that enhancing denitrification alone was insufficient. Both benzene and o-xylene biodegraded significantly under iron-reducing conditions, but only after denitrification had removed other aromatics. For the trimethylbenzene isomers, 1,3,5-TMB biodegradation was found under denitrifying and then iron-reducing conditions. Biodegradation of 1,2,3-TMB or 1,2,4-TMB was slower under iron-reducing conditions. This study suggests that addition of excess ferric iron combined with limited nitrate has promise for in situ bioremediation of BTEX and TMB in the Borden aquifer and possibly for other sites contaminated by hydrocarbons. This study is the first to report 1,2,3-TMB biodegradation under strictly anaerobic condition. With the addition of 500 mg/L ethanol but without EA addition, ethanol and its main intermediate, acetate, were quickly biodegraded within 41 d with methane as a major product. Ethanol initially present at 5000 mg/L without EA addition declined slowly with the persistence of unidentified volatile fatty acids, likely propionate and butyrate, but less methane. In contrast, all ethanol disappeared with repeated additions of either nitrate or ferric iron, but acetate and unidentified intermediates persisted under iron-enhanced conditions. With the addition of 500 mg/L ethanol and nitrate, only minor toluene biodegradation was observed under denitrifying conditions and only after ethanol and acetate were utilized. The higher ethanol concentration (5000 mg/L) essentially shut down BTEX biodegradation likely due to high EA demand provided by ethanol and its intermediates. The negative findings for anaerobic BTEX biodegradation in the presence of ethanol and/or its biodegradation products are in contrast to recent research reported by Da Silva et al. [Da Silva, M.L.B., Ruiz-Aguilar, G.M.L., Alvarez, P.J.J., 2005. Enhanced anaerobic biodegradation of BTEX-ethanol mixtures in aquifer columns amended with sulfate, chelated ferric iron or nitrate. Biodegradation. 16, 105-114]. Our results suggest that the apparent conservation of high residual labile carbon as biodegradation products such as acetate makes natural attenuation of aromatics less effective, and makes subsequent addition of EAs to promote in situ BTEX biodegradation problematic.     

Influence of Technological Process on Biodegradation of PVA/Waxy Starch Blends in an Aerobic and Anaerobic Environment

Improving biodegradability of PVA/starch blends is a reality already documented by a number of works. Admittedly, mechanical properties of products (for example, tensile strength) are somewhat worse, but suitable composition optimizing or chemical modifying of starch may eliminate the problem to a large degree. This work is an attempt to find another potential effect influencing biodegradability, that of technological procedure for producing films from these blends on an extruder. The procedure with a so-called pre-extrusion step (two-stage) and dry-blend (single-stage) produced blends of slightest differences in achieved biodegradability (virtually within limits of experimental error) in aerobic (76 vs. 79%) as well as anaerobic breakdown (48 vs. 52%). Conversely, morphological analysis exhibited superior homogeneity of films prepared by the two-stage process; their tensile strength was also higher.     

Electrochemical determination of anaerobic microbial decay coefficients

The biokinetics of attached and suspended bacteria are an essential component of activated sludge models, anaerobic digestion models and biofilm models. These parameters are often assumed or “confirmed” based on the goodness-of-fit of the bioprocess models. Using a microbial fuel cell with a baffled reactor chamber, the attached- and mixed-growth microbial decay coefficients were evaluated under anaerobic conditions. The capability for real-time voltage recording allows easy and accurate measurement of the anaerobic microbial decay coefficients (b_L, lysis-regrowth approach), which were determined to be 0.11 ± 0.01 and 0.15 ± 0.01 d⁻¹ for attached (to anode) and mixed (present in the anode chamber) growth microorganisms, respectively. The corresponding half-saturation constants using glucose as a substrate were 204 ± 10 and 123 ± 1 mg COD l⁻¹. Hence, like an oxygen uptake rate-based approach to measure the microbial kinetics under aerobic conditions, the electrochemical recording provides an attractive method to measure anaerobic microbial decay coefficients.     

序批式动态膜生物反应器处理低碳氮比废水的试验研究

以序批式动态膜反应器为研究对象,对其处理低碳氮比废水的效果进行了试验研究.试验温度为19 ～ 21℃,MLSS为3～5g/L;好氧阶段溶解氧质量浓度为2 ～4 mg/L,厌氧阶段溶解氧质量浓度为0.2～0.5 mg/L;水力停留时间共12 h,其中好氧阶段8h,厌氧阶段4h.结果表明:当进水COD、TN和NH4+-N质量浓度分别为250～300mg/L、103 ～ 156 mg/L和92～140 mg/L时,反应器对上述污染物表现出较高且稳定的去除效率,COD、TN和NH4+-N平均去除率分别达到76.15％、82.16％和90.13％.同时,反应器系统中污泥的比硝化速率与常规处理装置中的活性污泥相比较高,以NH4+-N的降解量计为0.101 d-1,以NO3--N的积累量计为0.091 d-.     

软/硬质悬浮填料对MBR中EPS的影响

以聚丙烯无纺布为膜组件,向浸渍式膜生物反应器(MBR)中分别投加硬/软质悬浮填料处理人工废水.分析测定EPS、SVI、膜污染阻力及跨膜压力的变化,采用统计分析方法研究了软/硬质悬浮填料对MBR中EPS及SVI的影响;通过扫描电镜(SEM)分析,表征添加软/硬质悬浮填料膜表面的污染状况.结果表明,添加软/硬质悬浮填料膜组件表面滤饼中的溶解性EPSS和结合性EPSB与膜污染阻力的皮尔逊相关系数(rp)分别为0.929～ 0.984和0.798～0.853,EPSS与膜污染阻力之间表现出更强的相关性,EPSS对膜污染阻力的贡献大于EPSB.添加软/硬质悬浮填料MBR污泥混合液的EPS与SVI的皮尔逊系数(rp)分别为0.895和0.798,呈现明显的正相关性.SEM分析也表明,添加软质填料的膜表面污泥覆盖程度大于硬质填料的膜表面,但膜内部的污泥沉积量明显低于硬质填料.与软质悬浮填料相比,硬质悬浮填料能导致MBR污泥混合液的SVI和EPS含量增大,增加膜污染速率和不可逆膜污染阻力,软质悬浮填料具有更好的控制膜不可逆污染的效能.     

Biological treatment of fish processing wastewater: A case study from Sfax City (Southeastern Tunisia)

The present work presents a study of the biological treatment of fish processing wastewater at salt concentration of 55 g/L. Wastewater was treated by both continuous stirred-tank reactor (CSTR) and membrane bioreactor (MBR) during 50 and 100 days, respectively. These biological processes involved salt-tolerant bacteria from natural hypersaline environments at different organic loading rates (OLRs). The phylogenetic analysis of the corresponding excised DGGE bands has demonstrated that the taxonomic affiliation of the most dominant species includes Halomonadaceae and Flavobacteriaceae families of the Proteobacteria (Gamma-proteobacteria class) and the Bacteroidetes phyla, respectively. The results of MBR were better than those of CSTR in the removal of total organic carbon with efficiencies from 97.9% to 98.6%. Nevertheless, salinity with increasing OLR aggravates fouling that requires more cleaning for a membrane in MBR while leads to deterioration of sludge settleability and effluent quality in CSTR.     

A fouling suppression system in submerged membrane bioreactors using dielectrophoretic forces

A novel method was developed to suppress membrane fouling in submerged membrane bioreactors. The method is based on the dielectrophoretic (DEP) motion of particles in an inhomogeneous electrical field. Using a real sample of biomass as feed, the fouling-suppression performance using DEP with different electrical field intensities (60–160 V) and different frequencies (50–1000 Hz) was investigated. The fouling-suppression performance was found to relate closely with the intensity and frequency of the electrical field. A stronger electrical field was found to better recover the filtrate flux. This is because of a stronger DEP force acting on the biomass particles close to the membrane's surface. Above an intensity and frequency value of 130 V and 1 kHz, respectively the permeate flux was reduced due to an electrothermal effect.     

多级A／O膜生物反应器污泥活性研究

采用一种新型的多级A／O膜生物反应器处理污水,对该工艺的污泥活性进行了研究。结果表明,VSS／SS在实验过程中呈较弱的下降趋势,多级A／O池曝气室污泥比硝化速率逐室下降,但各缺氧室污泥比反硝化速率基本一致;污泥释磷、聚磷过程在30 min和1 h内基本完成,反硝化聚磷试验表明污泥中存在DPB的富集,反硝化作用是反硝化细菌与DPB共同作用的结果。