ABR发酵系统运行特性及产氢效能研究

为解决连续流搅拌槽式反应器(CSTR)发酵制氢系统存在的不足,如单位基质氢气转化率低、因搅拌带来的耗能,抗负荷冲击能力不强等问题,开展了厌氧折流板反应器(ABR)发酵产氢的研究.结果表明,在35℃和进水COD 5000mg/L等条件下,ABR系统可在26d达到乙醇型发酵,其比产氢速率为0.13L/(gMLVSS·d),而在同样条件下, CSTR达到乙醇型发酵后,比产氢速率仅为0.06L/(gMLVSS·d).ABR通过生物相的分离,使产氢系统梯级利用有机物并达到深度产氢的目的.与CSTR相比,ABR具有较高的产氢活性、较低能源消耗等优点,是一种较为理想的有机废水发酵制氢反应设备.     

长期储存亚硝化絮状污泥活性的恢复

为探究长期储存亚硝化絮状污泥的脱氮性能,采用CSTR反应器,接种4℃下储存了10个月的亚硝化絮状污泥,考察其活性恢复性能,并采用Mi Seq高通量测序技术分析了污泥中微生物菌群结构的变化情况.结果表明,控制DO为0.4~0.8mg·L~(-1)、pH值8左右、温度为(30±1)℃等条件,长期储存亚硝化絮状污泥的活性可以在15 d内迅速恢复,氨氮去除率和亚硝积累率均达到90%以上;此外,污泥颜色由接种初期的灰黑色迅速恢复至棕黄色,SVI值显著降低,MLVSS/MLSS升高,EPS含量明显增加.随着亚硝化性能的恢复,厌氧、发酵微生物被洗脱,Nitrosomonas等氨氧化细菌相对丰度显著增加,同时,Nitrospria等硝化菌的生长得到了有效抑制.经历长期储存的亚硝化絮状污泥可作为实现短程硝化快速启动的接种污泥,更有利于短程硝化工艺的实际应用.     

利用Ethanoligenens harbinense R3连续培养的CSTR的启动与运行

采用连续流搅拌槽式反应器(CSTR)为实验装置,探讨了利用新型发酵产氢菌R3的生物制氢反应器的启动与运行情况.实验表明,维持反应器内pH在4.5左右、COD启动值为6000 mg·L-1、水力停留时间为8 h等条件,可在30 d内完成反应器内菌种对环境的适应并进入稳定运行阶段,此时系统氧化还原电位(HRT)稳定在-400mV左右.系统内的液相末端发酵产物中乙醇含量最大,占发酵产物总含量的65%,乙醇和乙酸所占比例为95%,系统呈现明显的乙醇型发酵特性.启动和运行阶段的积累产氢量为399.33 L,最大产氢量达15768.8 mL·d-1,最大氢气产率为49.94%.有机氮源可被微生物利用而无机氮源对产氢并无太大影响.使用有机氮源和磷源时积累产气量、积累产氢量和发酵液相末端产物与空白对照相比有所增大.     

两级CSTR亚硝化启动及稳定运行试验研究

采用两级CSTR反应器对实际生活污水亚硝化的启动过程及稳定运行主要影响因素进行了研究.通过向生活污水里投加(NH₄)₂SO₄来提高进水氨氮浓度,并逐渐调整两级反应器的曝气强度至DO浓度分别为(1.5±0.12),(0.35±0.1) mg/L,历经45d即实现了亚硝化的启动,亚硝化率保持在90.3%以上,氨氧化率保持在91.2%以上.低氨氮生活污水运行时,通过第一级反应器中三组DO/ALR的效果对比,表明DO/ALR在1.2~2.0 mg O₂/(gN·d)时亚硝化效果最好.降低氨氮浓度以及增大HRT两种情况下导致ALR改变时,维持上述DO/ALR范围依然可以保证亚硝化的稳定.     

Fermentative hydrogen production from beet sugar factory wastewater treatment in a continuous stirred tank reactor using anaerobic mixed consortia

A low pH, ethanol-type fermentation process was evaluated for wastewater treatment and bio-hydrogen production from acidic beet sugar factory wastewater in a continuous stirred tank reactor (CSTR) with an effective volume of 9.6 L by anaerobic mixed cultures in this present study. After inoculating with aerobic activated sludge and operating at organic loading rate (OLR) of 12 kgCOD?m^-3·d^-1, HRT of 8h, and temperature of 35°C for 28 days, the CSTR achieved stable ethanol-type fermentation. When OLR was further increased to 18 kgCOD?m^-3·d^-1 on the 53rd day, ethanol-type fermentation dominant microflora was enhanced. The liquid fermentation products, including volatile fatty acids (VFAs) and ethanol, stabilized at 1493 mg·L^-1 in the bioreactor. Effluent pH, oxidation-reduction potential (ORP), and alkalinity ranged at 4.1–4.5, -250–(-290) mV, and 230–260 mgCaCO₃?L^-1. The specific hydrogen production rate of anaerobic activated sludge was 0.1 L?gMLVSS^-1·d^-1 and the COD removal efficiency was 45%. The experimental results showed that the CSTR system had good operation stability and microbial activity, which led to high substrate conversion rate and hydrogen production ability.     

MBR+CSTR联合工艺处理精对苯二甲酸生产废水

通过MBR＋CSTR两段好氧法对精对苯二甲酸生产废水进行处理,取得了令人满意的结果。经过MBR反应器,CODCr由5000mg／L降为500mg／L以下,并且很好地控制了系统pH的上升。在CSTR反应器中CODe。能降至35mg／L,达到国家污水综合排放一级标准（GB8978-1996）。     

稀疏数据下复杂流域的水质模拟:以赣江为例

以赣江流域为例,对稀疏数据条件下复杂流域水质模型的建立和参数识别进行了探讨．采用了结构相对比较简单的CSTR模型,将其参数划分为水文参数和水质参数,并分别进行识别．水文参数采用回归方法进行识别,对水文参数的扰动实验表明,水质对于水文参数在可能的取值范围内的变化不敏感,因此在随后的水质参数的识别中,将其固定在回归方法求出的最优值上．水质参数的确定则采用了模型方法和资料方法相结合的手段,综合考虑了赣江流域可获得的数据信息、文献资料中对于参数的经验取值和模拟者在大量数学建模中的经验,最终根据河流的不同类型确定了赣江流域的水质参数,并对模型进行了验证。     

Use of bifurcation analysis for identification of a safe CSTR operability

Exothermic reactions are the most interesting systems for safety analysis because of their potential safety problems and the possibility of exotic behavior like multiple steady states. An operability and safety analysis of an exothermic reaction (hydrolysis of propylene oxide to tri-propylene glycol with consecutive reactions in a CSTR) with cooling is reported in this work. The information obtained from the bifurcation diagram is used to identify a set of unsafe operation points, which have been chosen on the base of requirement of maximal production of the process. An important information of safe reactor operation is the time in which the operator must handle a critical situation. For this reason, dynamics simulation of a failure in the cooling medium flow rate has been done and discussed for each of the selected operation points.     

CSTR水力学模型数值求解方法探讨

CSTR模型是河流水质模拟的常用模型之一,其中水力学模型是影响CSTR模型数值稳定性的关键因素,但迄今为止对CSTR水力学模型数值稳定性鲜有充分的讨论. 以赣江朝阳水厂至八一桥北段为例,采用实测数据,分单箱积分和整体积分2种方式,讨论了Runge-Kutta-Felberg方法(RKF)、经典四阶Runge-Kutta方法(RK4)和二级四阶隐式Runge-Kutta方法(RK2)的数值稳定性、模拟精度和时间效率. 结果表明,与国际上目前常用的单箱积分相比,整体积分具有更好的稳定性. 3种Runge-Kutta方法的稳定性排序是RKFCSTR水力学模型具有较好的优越性.