A new approach for modelling potential effects in cation adsorption onto binary (hydr) oxides

The current approach for modelling ion adsorption onto binary (hydr)oxides using homogeneous surface complexation models involves the assumption of either an ideal mixture of the two surfaces (i.e. two surface sites on one surface) or a patchwise surface (i.e. two surfaces with one surface site on each surface). As the physical truth should be between these two limiting cases, a model which assumes a patchwise surface constituted of three patches is proposed. Two patches represent the distinct (hydr)oxides, and the third one a mixture of these distinct (hydr)oxides. Using the diffuse layer model, the three approaches are applied to literature data for Cd adsorption onto binary mixtures of alumina-coated silica at total constant Cd concentration and varying amounts of alumina coatings. For Cd adsorption onto these binary (hydr)oxide systems, the new approach explains the observed potential effects. The proposed model, which contains two additional adjustable parameters in terms of site concentrations or one adjustable parameter in terms of specific surface area, is more successful than the two limiting cases. The new model is then validated by predicting Ca and Zn behaviour on the same binary (hydr)oxide system.     

Transport modeling of copper and cadmium with linear and nonlinear retardation factors

The predictive accuracy of using the one-dimensional advection–dispersion equation to evaluate the fate and transport of solute in a soil column is usually dependent on the proper determination of chemical retardation factors. Typically, the distribution coefficient (K_d) obtained by fitting the linear sorption isotherm has been extensively used to consider general geochemical reactions on solute transport in a low-concentration range. However, the linear distribution coefficient cannot be adequately utilized to describe the solute fate at a higher concentration level. This study employed the nonlinear equilibrium-controlled sorption parameters to determine the retardation factor used in column leaching experiments. Copper and cadmium transportation in a lateritic silty-clay soil column was examined. Through the explicit finite-difference calculations with a third-order total-variation-diminishing (TVD) numerical solution scheme, all results of the theoretical copper and cadmium breakthrough curves (BTCs) simulated by using the Freundlich nonlinear retardation factors revealed good agreement with the experimental observations.     

Cd(Ⅱ)-邻菲咯啉络合物极谱吸附波测定水中微量镉

在ＰＨ＝４．７４的０．２ｍｏｌ／ＨＡｃ－ＮａＡｃ缓冲体系中,Ｃｄ（Ⅱ）－邻菲咯啉络合物在单扫描波极谱仪上于－０．７９Ｖ处产生一灵敏的吸附还原波,其二次微分极谱波灵敏度高,波形好。     

低浓度Pb2+、Cd2+对鲫鱼肝脏组织中 HSP70诱导的影响

以鲫鱼(Carassius auratus)作为实验对象,经过40 d Pb2+、Cd2+不同浓度的暴露后,运用SDS-PAGE和Western Blotting方法检测鱼肝脏组织内应激蛋白HSP70的诱导表达情况.结果表明,在实验浓度下,与对照组相比,Pb2+、Cd2+对鱼肝脏内HSP70有显著的诱导(P＜0.05),但在Cd2+浓度为0.2 mg/L有停止表达HSP70的现象,可能是由于浓度过高造成了组织病理损伤而破坏了诱导表达机制.实验还发现,在实验浓度低于国家渔业用水标准时,HSP70仍然表现为明显诱导(P＜0.05),充分说明运用分子生物学指标要比传统的环境检测指标敏感,具有对污染物早期预警的作用.     

植物镉耐性/富集基因的筛选方法

植物耐受/富集镉（Cd）是一个复杂的过程,涉及转运蛋白家族、螯合蛋白家族、抗氧化系统等多个方面的参与。文章综述了植物Cd耐性/富集基因的筛选方法,包括抗性表达文库、Cd抗性突变体的图位克隆、基因差异表达、电子克隆。筛选Cd抗性植物cDNA酵母表达文库可鉴定与金属束缚、隔离及外排相关的膜转运蛋白;筛选重金属敏感拟南芥突变体和图位克隆突变基因可鉴定与谷胱甘肽和植物螯合肽合成相关的酶;第二代测序技术、基因差异表达分析则是鉴定Cd响应基因以及揭示金属型植物与非耐性植物表型差异分子基础的有效方法;电子克隆也被应用在模式植物中鉴定重金属转运蛋白家族的编码基因。在此基础上,简述了Cd耐性/富集基因在改良植物Cd耐性或富集上的应用。     

Effects of dissolved organic matter on the desorption of Cd in freeze–thaw treated Cd-contaminated soils

Lab-scale experiments were conducted to investigate the effects of dissolved organic matter (DOM) on the desorption of Cd in freeze–thaw treated Cd-contaminated soils. The results indicated that DOM significantly facilitated the desorption of Cd from freeze–thaw treated soils when comparing with that of non-frozen soils. Effects of DOM on the Cd desorption were highly dependent on the soil type and contamination concentration. The maximum desorption ratios of Cd by DOM generated from straw and sludge were 15.6% and 13.65%, respectively, in brown soils, and the maximum desorption ratios reached 14.7% and 9.3%, respectively, when using black soils through the same treatment. The higher the Cd contamination concentration in soils, the higher the ratio of Cd desorption by DOM. This was because of the integrated effects of the soil properties changed by the freeze–thaw treatment and the species transformation of Cd. The characteristics of DOM, such as its concentration and properties, had shown obvious impacts on the Cd desorption by DOM. The desorption was promoted with the increased DOM concentration and the hydrophilic fraction, and lowered pH and the low-molecular-weight of DOM.     

Modelling the kinetics and equilibrium properties of cadmium biosorption by river green alga and water hyacinth weed

Cadmium biosorption properties of non-living, dried river green alga from a river source, and water hyacinth weed, Eichhornia crassipes from a lake in Zimbabwe have been investigated. The cadmium uptake was found to depend on initial pH, uptake being apparently minimal at low pH values and increasing with an increase in pH. Cadmium biosorption kinetics by both samples is fast, with 80% of total uptake occurring within 60?min. The effect of initial solution pH and initial cadmium concentration on cadmium biosorption from a cadmium solution has been studied. The data for algal biomass fitted the Langmuir monolayer adsorption isotherm, while the biosorption of the metal by water hyacinth weed fitted the Freundlich adsorption isotherm with 1/n values all less than 1. Maximum metal uptake capacities were recorded using 0.35?g of biomass and a 250?mg?L^?1 cadmium solution at pH 6.5 and at 25°C and these were about 85 and 50?mg?L^?1 for water hyacinth weed and green alga, respectively, showing that water hyacinth weed offered a greater potential for cadmium uptake. The absorption was described by pseudo-second order rate model and the rate constant and equilibrium sorption capacity are reported.     

Toxicity of cadmium to the green alga Parachlorella kessleri: Producing Cd-loaded algae for feeding experiments

The effects of Cd at environmental concentrations (0–32 µg/L) on the green alga Parachlorella kessleri were investigated. At about 3 µg Cd/L, toxic effects of Cd are becoming evident, much lower than reported previously. At 8 µg/L and higher, pronounced adverse effects on growth, cell morphology, size, and physiological state are seen. Therefore, levels lower than 2 µg Cd/L should be employed to produce Cd-carrying algae for feeding experiments with organisms on the next trophic level, e.g. mussels, to avoid reduced food uptake. These findings also suggest that aquatic ecosystem conditions can be indirectly influenced via the impairment of the nutritional value of algae since they are the basic organisms of aquatic food chains.     

Interaction of selenium and cadmium in wheat at different salinities

Abstract

Interaction of Se up to 8?mg?kg^?1 soil and Cd at 5 and 15?mg?kg^?1 soil in wheat at different salinities was evaluated. Se concentrations in wheat shoots were progressively increased in parallel to Se in soil but decreased by addition of Cd. With increasing salinity, Cd concentrations increased and Se decreased. At low salinity, low addition of Se to the soil reduced Cd accumulation. At moderate and high salinities, only high Se amendment led to decline in Cd uptake, at the expense of reduction in biomass yield. Se at 0.5?mg?kg^?1 soil alleviated the negative effect of Cd on shoot yield.     

The use of the embryo‐culture techniques in the research on the Teratogenic and Mutagenic properties of metals†

Actually, embryos can be cultured from the one‐cell stage up to the blastocyst stage, and their development can be easily monitored at any time: severe effects caused by toxic compounds are traduced by rapid embryonic death, less pronounced effects can be expressed by a lowered cleavage activity or by an arrest of the development from a particular stage. The system can be improved by transferring the embryos at the blastocyst stage in another more complete medium where they can “implant”; and form an inner cell mass with differentiated ectoderm and endoderm. Since last years, it has also become possible to culture postimplantation rodent embryos for short periods involving a number of particularly critical stages of organogenesis, such as the formation and closure of the anterior neuropore. Embryo‐culture also represents a useful system to study cytogenetic effects of chemicals which are often linked to lethal or teratogenic effects. These different possibilities are illustrated by examples of studies already performed with metals, and dealing with their teratogenic and/or cytogenetic effects on pre‐ and postimplantation rodents.