Preparation of solar-enhanced AlZnO@carbon nano-substrates for remediation of textile wastewaters

Photoactive aluminum doped ZnO(AlZnO) was synthesized by sol-gel method.After that,AlZnO photocatalyst was deposited on five carbon-based materials(CBMs) using ultrasonic route followed by solid-state mixing using ball mill.The CBMs used were poly aniline(PANI),carbon nitride(CN),carbon nanotubes(CNT),graphene(G),and carbon nanofibers(CNF).The crystal phases,elemental compositions,morphological,and optical properties of the AlZnO@CBMs composites were investigated.Experimental results revealed that two of AlZnO@CBMs composites exhibited superior bleaching efficiency(100% removal) and photocatalytic stability(three cycles) for 50 μmol/L Methylene Blue(MB) contaminated water after 60 min irradiation in visible light at pH 6.5,0.7% H_2O_2,and 5 g/L inorganic salts.Under optimum conditions,AlZnO@CBMs nanocomposites were employed for the treatment of mixed dyestuffs composed of MB,Methyl Orange(MO),Astrazone Blue FRR(BB 69),and Rhodamine B(RhB) dyes under dark,ultraviolet,visible,and direct sunlight.For mixed dyestuffs,the AlZnO@G achieved the highest dye sorption capacity(60.91 μmol dye stuffs/g) with kinetic rate 8.22 × 10~(-3) min~(-1) in 90 min via multi-layer physisorption(Freundlich isotherm) on graphene sheet.In additions,AlZnO@CN offered the highest photo-kinetic rate(K_(photo)) of～54.1 × 10~(-3) min~(-1)(93.8% after 60 min) under direct sunlight.Furthermore,the selective radical trapping experiment confirmed that the holes and oxidative superoxide radicals are crucial on dyes photodegradation pathway.Owing to their superior performance,AlZnO@G and AlZnO@CN nanocomposites can offer an effective in-situ solar-assisted adsorption/photocatalytic remediation of textile wastewater effluents.     

Competitive Retention of Lead and Cadmium on an Agricultural Soil

Lead and cadmium contamination of an agricultural soil has been studied using batch and column experiments. Thermodynamics of theretention phenomena may be represented by a Langmuir isotherm foran aqueous metal concentration up to 100 mg L^-1. First order kinetics with respect to the solid phase yield good predictabilityfor both batch and column experiments. Kinetics and thermodynamics of lead retention predominate over those ofcadmium. As a consequence, lead is preferentially retainedand can even displace sorbed cadmium. In the event of anspill involving both metals, cadmium would move further inthe soil and its aqueous concentration downstream could beeven higher than that of the influent solution, increasingpotential risks. A two-region model has been used to fit all the experimental results. Satisfactory predictions for column experiments are obtained with parameters which are consistent with those obtained for the batch experiments, for which sorption is described by a Langmuir isotherm including competitive retention.     

Formulation and Validation of an Empirical Moisture Damage Index

An empirical moisture damage index was developed in order to reduce the subjectivity of the estimation of moisture damage in domestic residences, in relation to occupant health. The database was generated using information gathered from a sample of 164 houses that were examined by civil engineers, and questionnaire data collected from the occupants. The index was formulated to associate with the occupant reported respiratory symptoms by calculating weighted estimates of selected moisture damage attributes using 80% of the sample. The remaining 20% of the sample was used to verify the final index. The index associated strongly with the health symptoms of interest. This index is a tool that may be used as an indicator of moisture damage induced exposure in domestic residences.     

A Spatial Model to Estimate Habitat Fragmentation and Its Consequences on Long-Term Persistence of Animal Populations

The increasing use of the landscape by humans has led to important diminutions of natural surfaces. The remaining patches of wild habitat are small and isolated from each other among a matrix of inhospitable land-uses. This habitat fragmentation, by disabling population movements and stopping their spread to new habitats, is a major threat to the survival of numerous plant and animal species. We developed a general model, adaptable for specific species, capable of identifying suitable habitat patches within fragmented landscapes and investigating the capacity of populations to move between these patches. This approach combines GIS analysis of a landscape, with spatial dynamic modeling. Suitable habitat is identified using a threshold area to perimeter ratio. Potential movement pathways of species between habitat patches are modeled using a cellular automaton. Habitat connectivity is estimated by overlaying habitat patches with movement pathways. The maximum potential population is calculated within and between connected habitat patches and potential risk of inbreeding within meta-populations is considered. The model was tested on a sample map and applied to scenario maps of predicted land-use change in the Peoria Tri-county region (IL). It (1) showed area of natural area alone was insufficient to estimate the consequences on animal populations; (2) underscored the necessity to use approaches investigating the effect of land-use change spatially through the landscape and the importance of considering species-specific life history characteristics; and (3) highlighted the model's potential utility as an indicator of species likelihood to be affected negatively by land-use scenarios and therefore requiring detailed investigation.     

RISK ASSESSMENT METHODOLOGY FOR KARST AQUIFERS: (2) SOLUTE-TRANSPORT MODELING

Ground-water flow and solute-transport simulation modeling are major components of most exposure and risk assessments of contaminated aquifers. Model simulations provide information on the spatial and temporal distributions of contaminants in subsurface media but are difficult to apply to karst aquifers in which conduit flow is important. Ground-water flow and solute transport in karst conduits typically display rapid-flow velocities, turbulent-flow regimes, concentrated pollutant-mass discharge, and exhibit open-channel or closed-conduit flow. Conventional ground-water models, dependent on the applicability of Darcy`s law, are inappropriate when applied to karst aquifers because of the (1) nonapplicability of Darcian-flow parameters, (2) typically nonlaminar flow regime, and (3) inability to locate the karst conduits through which most flow and contaminant transport occurs. Surface-water flow and solute-transport models conditioned on a set of parameters determined empirically from quantitative ground-water tracing studies may be effectively used to render fate-and-transport values of contaminants in karst conduits. Hydraulic-flow and geometric parameters developed in a companion paper were used in the surface-water model, TOXI5, to simulate hypothetical slug and continuous-source releases of ethylbenzene in a karst conduit. TOXI5 simulation results showed considerable improvement for predicted ethylbenzene-transport rates and concentrations over qualitative tracing and analytical ground-water model results. Ethylbenzene concentrations predicted by TOXI5 simulations were evaluated in exposure and risk assessment models.     

Modeling photocatalytic destruction of the organic contaminants in continuous stir flow reactor

Thin-film technique is becoming an industry standard for the preparation of TiO₂-based photocatalyst for organic destruction. The catalyst provides several advantages over the conventional powder TiO₂ in the treatment of wastewater and groundwater. In this study, a continuous stir flow reactor model is developed capable of describing the photocatalytic process. The model incorporates the following fundamental mechanisms: adsorption, diffusion, liquid-film transfer, UV attenuation, and photocatalytic reaction. All of the simulation results indicate that there exists a highly nonlinear relation between each of these parameters and the destruction rate. Various incident light intensities also are incorporated to simulate the energy efficiency. The simulations illustrate that the photocatalytic model can be used to elucidate the effect of process variables. It is also possible to “custom-design” a catalyst for the treatment of a particular waste stream.     

Modeling rhizofiltration: heavy-metal uptake by plant roots

The discovery of phytoaccumulation potential of plant species has led to its application for remediation of heavy-metal-contaminated soil and wastewater, which is termed as phytoextraction/rhizofiltration. For prediction, analysis, planning and cost-effective design of such systems, mathematical models not only are used as a screening tool but also provide optimal parameters like harvesting time, irrigation schedule, etc. Several laboratory and field scale studies have been carried out in the past, and mathematical expressions have been developed by various researchers for different phenomena like metal adsorption in soil, plant root growth with time, moisture and metal uptake by plant root, moisture movement in unsaturated zone, soil moisture relationship, etc. The complete design of any such phytoremediation program would require the knowledge of behavior of heavy-metal movement in soil, water and plant root system. In this paper, a model for simulating heavy-metal dynamics in soil, water and plant root system is developed and discussed. The governing non-linear partial differential equation is solved numerically by implicit finite difference method using Picard's iterative technique, and the formulation has been illustrated using a characteristic example. The source code is written in MATLAB.     

Test of a Modelling System for Estimating Nitrogen Leaching – A Pilot Study in a Small Agricultural Catchment

Nitrogen leaching is a world-wide concern for the quality of ground- and surfacewater. Measures to abate this is still limited by a lack of understanding mechanisms behind all factors describing the leaching process, time lags between countermeasures and improvement in waterquality and spatial distribution of nitrogen leaching. The purpose of this study was to do an initial test of the SOILNDB model system which is built on the existing mechanistic SOIL and SOILN models and an automatic parameterization procedure for use of simplified input data. The test was done by simulating nitrogen leaching from each of the 150 fields in a small catchment during a three-year study period. The simulated mean root-zone nitrogen leaching rate from all the fields in the catchment was compared to measurements of nitrogen flow in the stream draining the catchment and showed good agreement in between-year dynamics.     

Assessing land use impacts on flood processes in complex terrain by using GIS and modeling approach

A distributed hydrologic modeling and GIS approach is applied for the assessment of land use impact in the Steinsel sub-basin, Alzette, Grand-Duchy of Luxembourg. The assessment focuses on the runoff contributions from different land use classes and the potential impact of land use changes on runoff generation. The results show that the direct runoff from urban areas is dominant for a flood event compared with runoff from other land use areas in this catchment, and tends to increase for small floods and for the dry season floods, whereas the interflow from forested, pasture and agricultural field areas contributes to the recession flow. Significant variations in flood volume, peak discharge, time to the peak, etc., are found from the model simulation based on the three hypothetical land use change scenarios.