紫外辐射下的生物降解及微生物群落的变化

分别采用一体式循环床紫外光/生物膜反应器（PCBBR）和气升式内循环的紫外光/生物膜反应器（ILPBR）,用于苯酚、2,4,6-三氯酚（TCP）和抗生素药物磺胺甲恶唑（SMX）的降解.结果表明,苯酚、TCP和SMX在紫外光解与生物降解的共同作用下,其去除速率分别达到0.65、0.11和0.17 mg.（L.min）–1...     

Determination of ammonium on an integrated microchip with LED-induced fluorescence detection

A simply fabricated microfluidic device integrated with a fluorescence detection system has been developed for on-line determination of ammonium in aqueous samples. A 365-nm light-emitting diode (LED) as an excitation source and a minor band pass filter were mounted into a polydimethylsiloxane (PDMS)-based microchip for the purpose of miniaturization of the entire analytical system. The ammonium sample reacted with o-phthaldialdehyde (OPA) on-chip with sodium sulfite as reducing reagent to produce a fluorescent isoindole derivative, which can emit fluorescence signal at about 425 nm when excited at 365 nm. Effects of pH, flow rate of solutions, concentrations of OPA-reagent, phosphate and sulfite salt were investigated. The calibration curve of ammonium in the range of 0.018-1.8 μupg/mL showed a good linear relationship with R² = 0.9985, and the detection limit was (S/N = 3) 3.6 × 10^-4 μupg/mL. The relative standard deviation was 2.8% (n = 11) by calculating at 0.18 μupg/mL ammonium for repeated detection. The system was applied to determine the ammonium concentration in rain and river waters, even extent to other analytes fluorescence detection by the presented device.     

Efficiency and degradation products elucidation of the photodegradation of mefenpyrdiethyl in water interface using TiO2 P-25 and Hombikat UV100

The photodegradation of mefenpyrdiethyl (MFD), an herbicide safener, was investigated in aqueous suspensions by using Degussa P-25 and Hombikat UV100 titanium oxide under simulated sunlight irradiation. The effects of initial concentration of the herbicide, pH, catalysts and hydrogen peroxide doses as well as their combinations were studied and optimized. Accordingly, the kinetic parameters were determined and the effectiveness of the processes was assessed by calculating the rate constants. A pseudo first-order kinetics was observed. Under experimental conditions, the degradation rate constants were strongly influenced using P-25 and no noticeable effect was observed for Hombikat UV100. DFT calculations with B3LYP/6-311+G(2d,p)//B3LYP/6-31+G(d,p) level of theory were performed to check whether significant conformational changes occur when the charge state of the MFD substrate changes and whether these changes could play a role in the dependency of photodegradation rate constant on the studied pH. High resolution mass spectrometry (FT-ICR/MS) was implemented to identify the main degradation products.     

紫外光降解对生物过滤塔去除氯苯性能的影响机制研究

紫外-生物过滤联合工艺中的紫外单元促进了后续生物过滤单元的氯苯去除性能.为了进一步揭示紫外光降解对生物过滤塔运行性能的影响机制,本研究系统分析了紫外光降解对生物过滤塔填料层pH、生物膜特性和填料层结构特性等方面的影响.结果表明,氯苯紫外光降解产物导致了生物过滤单元填料层pH的下降(从pH 6～8降至pH 4～7);另外,紫外单元产生的臭氧降低了生物过滤单元生物膜厚度和生物膜的EPS含量,改善了生物膜的特性,提高了氯苯和营养物质在生物膜内的传质效率.同时,臭氧可以有效控制生物量过量积累,增加了填料层的比表面积(从784 m2.m-3增加至880 m2.m-3),优化了填料层的结构特性,提高了污染物的反应速率.上述各方面的综合作用最终促进了生物过滤单元的氯苯去除性能.     

山仔水库沉积物蓝藻复苏试验研究

采用正交试验考察了温度、光照、营养盐和物理扰动4个因素对山仔水库冬季沉积物中蓝藻复苏的影响,每个因素设置两个水平,培养周期为6 d,并以蓝藻复苏量为考察指标.结果表明,温度和光照为蓝藻复苏的主要影响因子,上覆水体的营养盐、物理扰动对沉积物中蓝藻门复苏的影响作用不显著,不同的蓝藻种属对温度和光照条件的响应程度不完全一致,蓝藻门微囊藻属(Microcystis)对温度和光照的复苏响应显著,颤藻属(Oscillatoria)仅对温度的复苏响应显著.同时,通过设置6.0~16.0 ℃之间6个温度梯度及50和2000 lx两个光照梯度,进行了沉积物柱状样复苏模拟实验.结果显示,山仔水库冬季沉积物微囊藻属和颤藻属在10 ℃左右开始复苏,微囊藻属对光的敏感性使其更容易处于优势地位.     

不同煅烧温度制备的Mn、N掺杂TiO2光催化性能研究

以MnSO4·H2O为锰源,尿素为氮源,采用溶胶-凝胶法制备不同锻烧温度的纯TiO2、Mn-TiO2及Mn-N-TiO2光催化剂,利用X射线衍射、紫外-可见光漫反射光谱及电子自旋共振等技术对样品形貌和结构进行表征,并以罗丹明B的光催化降解为模型反应,考察不同锻烧温度对其光催化活性的影响.结果表明,Mn、N成功掺入TiO2后,有利于提高光催化剂的热稳定性,抑制锐钛矿相向金红石相转化,且光吸收拓展到可见光区域.Mn、N共掺杂样品比单Mn掺杂样品具有更高的光催化活性,400℃下锻烧的Mn-N-TiO2在可见光下对罗丹明B的降解具有最高的光催化活性,光照2h降解率达到100%.高温锻烧Mn-N-TiO2和Mn-TiO2样品在紫外光照射30min后对罗丹明B的降解率在90%以上.     

纳米铁酸镍的制备及可见光催化性能研究

利用水热法制备了纳米铁酸镍,表征了其微观结构和光谱性能,并以罗丹明B溶液作为目标污染物,研究了铁酸镍催化剂的可见光催化性能。结果表明:所制备铁酸镍的微观形貌为由直径200-300 nm左右的类似球形小颗粒组成的大颗粒,平均粒径为95.60 nm,在紫外-可见光谱区均有较强的光吸收。光催化过程中催化剂的适宜用量为0.05 g,少量H2O2的加入有助于提高罗丹明B溶液的降解率。催化剂用量为0.05 g,加入0.4 mL 30%的H2O2,降解50 mL 20 mg/L罗丹明B溶液,模拟太阳光照射240 min后降解率能够达到99.2%。在实际太阳光照射下,240 min后罗丹明B溶液的降解率可以达到85.2%。     

沸石负载介孔TiO_2的制备及其可见光催化性能研究

以人工沸石为载体,采用溶胶-凝胶法,制备出了沸石负载介孔改性TiO2光催化剂。以亚甲基蓝为目标污染物,研究了不同掺杂金属及介孔薄膜制备方法对纳米TiO2可见光催化性能的影响。用扫描电镜(SEM)、紫外-可见吸收光谱(UV-vis)等手段研究了掺杂改性前后TiO2的变化。研究发现,N-Fe掺杂可使催化剂的光吸收谱带红移。当掺杂Fe的比为0.2%,焙烧温度为500℃时制备的TiO2效果最好,在可见光照射2 h后,亚甲基蓝的去除率可达90%。研究表明经十六烷基三甲基溴化铵(CTAB)作为模板剂修饰后的TiO2催化效果有明显提高,通过将经过萃取去除模板剂的共掺TiO2和直接高温焙烧的TiO2对比后发现,前者比后者降解亚甲基蓝的效果要好,原因在于,高温直接焙烧去除模板剂很容易使模板剂形成的骨架塌陷,减小了比表面积,从而影响了其光催化性能。     

紫外辐射对小球藻混凝效果作用途径探讨

针对藻类在常规水处理过程中难以被有效去除的现状,采用紫外辐射对藻类混凝过程进行强化处理.结果表明,随着紫外照射时间的增加,混凝后对藻细胞和浊度的去除均呈先上升后下降的趋势,并在照射50 min时达到最大值.PAC(聚合氯化铝)投加量为5 mg·L~(-1)时,照射样的除藻率和去浊率达到最大,分别比空白样高20.1%和18%左右.pH值在6~9范围内,紫外辐射强化混凝效果的变化较小.溶液pH=8、紫外照射50 min,混凝后的除藻率和去浊率分别达到了93.5%和90.6%.此时,藻细胞Zeta电位最大,同时释放出藻黏液,有利于混凝沉降.而当紫外照射超过60 min后,出现细胞膜破裂,胞内有机物渗出,使得溶液中的有机物浓度急剧上升,Zeta电位开始下降,不利于后续混凝的进行.     

染料探针技术对二级出水中优势污染物的定量检测

分别以刚果红和中性红为染料探针,建立了牛血清蛋白质(BSA)和海藻酸多糖(SA)含量与共振光散射(RLS)发射光谱强度间的线性关系;以甲苯胺蓝为染料探针,建立了腐殖酸(HA)含量与紫外吸光度间的线性关系;优化了3种标准物质的检测浓度范围及溶液p H值条件;考察了染料探针分析方法对标准物的二元和三元混合样品中的回收率.结果表明在适宜的浓度范围内,BSA、HA、SA浓度与染料探针光谱强度间的线性相关系数R0.98,3种标准物在混合样品中的回收率不小于95%,标准误差低于0.11%.以紫外光谱和3D-EEM光谱特征作为城市污水二级出水样品中蛋白质、多糖和腐殖酸的定性依据,确认了4种二级出水样品中的优势污染物.通过染料-探针技术与国标法测得的多糖和蛋白质质量浓度的相对偏差在1.2%~0.04%之间.