紫外线与消毒剂联合作用于黄浦江源水的研究

针对黄浦江源水砂滤出水,进行了紫外线单独作用的研究,同时对于紫外线与消毒剂联合消毒时消毒剂的投加方式对灭菌作用和消毒副产物的影响进行了研究。实验结果表明:当紫外线剂量达到42 mJ/cm2时出水水质已达到了生活饮用水卫生标准中对细菌总数和大肠杆菌数的要求,且在相同紫外剂量下,高强度时对细菌的灭活效果要好于低强度时的效果;先紫外消毒后消毒剂消毒对于微生物具有很好的杀灭作用,但是不能减少消毒副产物的产生;紫外线和消毒剂同时作用对于微生物的杀灭作用不佳,但是出水的消毒剂余量高,消毒副产物量少,这样有利于出水的安全稳定性;先消毒剂消毒再紫外消毒,发现对于消毒副产物没有多大的降解作用,更浪费了高的紫外剂量。     

Photocatalytic activity of Fe-doped CaTiO3 under UV-visible light

The photocatalytic degradation of methylene blue（MB） over Fe-doped CaTiO3 under UV-visible light was investigated. The as-prepared samples were characterized using X-ray diffraction（XRD）, scanning electron microscope（SEM） equipped with an energy dispersive spectrometer（EDS） system, Fourier transform infrared spectra（FT-IR）, and UV-visible diffuse reflectance spectroscopy（DRS）. The results show that the doping with Fe significantly promoted the light absorption ability of CaTiO3 in the visible light region. The Fe-doped CaTiO3 exhibited higher photocatalytic activity than CaTiO3 for the degradation of MB.However, the photocatalytic activity of the Fe-doped CaTiO3 was greatly influenced by the calcination temperature during the preparation process. The Fe-doped CaTiO3 prepared at500°C exhibited the best photocatalytic activity, with degradation of almost 100% MB（10 ppm）under UV-visible light for 180 min.     

自然光照对淹水条件下三峡库区消落带典型土壤磷释放影响

为研究淹水条件下光照对土-水界面磷释放的影响,以三峡库区消落带典型土壤为对象,通过室内自然光照试验,讨论了铁还原及有机质降解对磷释放的影响,分析光照对淹水土壤磷释放的影响机制.结果表明,光照对淹水土壤磷释放存在一定程度的抑制作用,光照作用下淹水紫色潮土上覆水体中TP浓度范围为0.018~0.033 mg·L-1,避光处理为0.02~0.057mg·L-1,灰棕紫泥光照下TP浓度范围为0.028~0.045 mg·L-1,避光处理为0.04~0.084 mg·L-1.光照引起淹水土壤中铁氧化物的变化可能是光照抑制磷释放的重要原因.光照导致土壤中铁氧化物饱和程度降低,铁还原和无定形铁生成受阻进一步加深了光照对磷释放的抑制影响.CO2和CH4反映淹水土壤有机质分解情况,光照降低有机碳的转化效率,加速土壤中无机电子受体的消耗,解释了光照作用下铁氧化物的变化.由此可见,光照对淹水土壤磷释放的抑制与淹水土壤中铁还原和有机质分解密切相关.     

脉冲强光对水中枯草杆菌灭活效果的研究

脉冲强光杀菌技术是近年来开发的一种新型冷杀菌技术,利用强烈的白光闪照进行杀菌。以枯草杆菌为目标微生物,对比研究脉冲强光与紫外线对微生物的灭活效果。并通过改变脉冲强光装置的输入电压和闪照次数,研究了影响脉冲强光杀菌的影响因素。     

TiO2/g-C3N4在泡沫陶瓷表面的负载及光催化空气净化性能增强

以市售P25(TiO_2)和g-C_3N_4为原料,以多孔氧化铝泡沫陶瓷为载体,进行了负载型光催化组件的设计与环境应用.运用浸渍提拉-热处理法制备负载P25/g-C_3N_4的泡沫陶瓷组件,对其微结构进行了表征测试,并将其应用于空气中NO的去除.结果表明,P25/g-C_3N_4在氧化铝泡沫陶瓷表面负载牢固,P25/g-C_3N_4禁带结构匹配有利于光生电荷的分离.研究了P25/g-C_3N_4比例对光催化性能的影响,当g-C_3N_4占P25的量为30%时,负载组件的光催化性能最佳,对NO的去除率达到79.6%.在5次循环反应后,负载型光催化剂表现出良好的稳定性.本研究为P25/g-C_3N_4复合光催化剂的空气净化应用提供了思路和技术基础.     

清浊分流条件下的混凝-臭氧处理棉针织印染清废水

根据污染源头控制和废水回用的要求,对典型棉针织染整厂的不同生产过程废水排水水质特征进行了统计分析,提出了较实用的废水源头清浊分流方案。在此基础上重点研究了混凝-臭氧组合工艺对清废水处理效果,确定了最优的工艺条件。结果表明,清废水主要为洗水,占废水总量的25%～30%;混凝-臭氧组合工艺的最优工艺条件为：pH为6～9,PAC投加量为48 mg/L,PAM投加量为1.0 mg/L,臭氧接触时间为12 min（臭氧浓度为14.5 mg/L）,这时,清废水COD、色度去除率分别为71%和98%,实践证明,出水水质完全能够满足染整生产。     

Phototransformation of herbicide metsulfuron methyl

Phototransformation of the herbicide metsulfuron methyl was investigated on glass surface under sunlight and ultraviolet (UV) light and compared with dark condition. The half-lives of metsulfuron methyl under UV light and sunlight were found to be 0.5 and 7.8 days respectively. Rate of phototransformation followed first order kinetics with significant correlation coefficient. The major photoproducts were identified as methyl-2-sulfonyl-amino-benzoate, 2-amino-6-methoxy-4-methyltriazine and saccharin (O-sulfobenzoimide). Various metabolites from this study were identified by high performance liquid chromatography (HPLC). Authentic samples required for HPLC comparison were prepared in laboratory and characterized on the basis of nuclear magnetic resonance (NMR) and infra red (IR) spectral data. These metabolites were also identified from metsulfuron methyl treated wheat field soil.     

氮掺杂TiO2可见光光催化剂的制备及性能

以尿素和钛酸丁酯为原料,通过溶胶-凝胶法低温下制备了高可见光催化活性的氮掺杂TiO2(NDT)光催化剂,采用XRD、TEM、BET和UV-Vis DRS等测试手段对其进行了表征,并在自制光催化反应器中降解甲基橙评价了样品的光催化活性。结果表明,当氮与钛的摩尔比为0.5∶1时,350℃焙烧的样品(NDT350)具有最佳的可见光光谱吸收和光催化活性,该催化剂为锐钛矿晶相,平均粒径为21 nm,比表面积为89.13 m2/g。可见光辐照下,NDT350降解甲基橙的表观反应速率常数为1.381×10-2min-1,是商业P25催化剂的16.85倍。NDT350优良的可见光催化活性与其大的比表面积和强烈的可见光光谱吸收有关。     

Rain‐washing of foliar deposits of Dimilin®WP‐25 formulated in four different carrier liquids

Abstract

Dimilin^® WP‐25, a wettable powder formulation of diflubenzuron (DFB) [1‐(4‐chlorophenyl)‐3‐(2,6‐difluorobenzoyl) urea], was formulated in four different carrier liquids, viz., water; a light petroleum paraffinic oil, ID 585; a heavy paraffinic oil, Sunspray^® 7N; and a 1:2 mixture of a light petroleum aromatic solvent (Cyclosol^® 63) and canola oil; to provide four end‐use mixtures, Dim‐W, Dim‐585, Dim‐7N and Dim‐Cy‐C respectively, each containing 28 g of DFB per litre. Balsam fir branch tips clipped from greenhouse‐grown seedlings, and sugar maple branch tips clipped from field‐grown young trees, were exposed to uniform‐sized droplets (ranging in diameters from 135 to 190 μm) of the four end‐use mixtures which were atomized using a monodispersed droplet generator. Droplets were collected on the fir and maple branch tips and the initial residue per g fresh weight of foliage was determined by high‐performance liquid chromatography (HPLC). The branch tips were exposed to cumulative rainfall of 3, 6 and 10 mm at an intensity of 5 mm/h and at time intervals of 1, 12, 36 and 72 h after DFB treatment, to test the influence of ‘ageing’ of foliar residues on rainfastness. Foliar samples were collected for residue determination just before the onset of rainfall, and at 0.5 h post‐rain. DFB was quantified by the HPLC method. In the case of fir foliage, the Dim‐W formulation was the most susceptible to rain‐washing and the rainfastness did not increase with the ageing period of foliar deposits. In contrast, the three oil‐based mixtures showed greater rainfastness depending upon the carrier liquid and the ageing period. Rainfastness decreased in the order of Dim‐Cy‐C > Dim‐7N > Dim‐585 > Dim‐W. In contrast, the data on maple foliage indicated that the ageing of deposits increased the rainfastness of all the 4 end‐use mixtures. Dim‐585 was the most susceptible to rain washing, and rainfastness decreased in the order of Dim‐W > Dim‐Cy‐C > Dim‐7N > Dim‐585.     

VARIABILITY IN THERMAL STRATIFICATION IN A RESERVOIR1

ABSTRACT: The thermal stratification characteristics of a flow-augmentation reservoir, Round Valley Reservoir, New Jersey, and attendant driving conditions were documented and analyzed for portions of three years. Substantial differences in the thermal stratification regime of the reservoir occurred in response to the documented changes in meteorological, operating, and light penetration conditions. The features of stratification that were affected included: the depth of the upper mixed layer, the average temperature of the epilimnion, the temperature gradient in the metalimnion, and the average temperature in the hypolimnion.